BIOSENSORS FOR GLUCOSE NEEDLE-SHAPED FOR IN-VIVO MONITORING

Different procedures for obtaining a needle biosensor for the determination of glucose to be inserted subcutaneously in vivo, have been compared. Platinum wires with a diameter of 75 mum, teflon-coated were inserted in hypodermic needles and fixed with a two-component epoxy resin. Using a dip-coating procedure, several layers were deposited on electrodes. The first coating was cellulose acetate, the second was immobilized glucose oxidase (GOD) mixed with bovine serum albumin (BSA) and glutaraldheyde, the third coating was a polyurethane coating obtained with commercially available products. A large number of electrodes have been tried and statistically evaluated but they seem to be affected by poor reproducibility evidenced by a large spreading in successive calibration curves. Then, the polyurethane coating has been replaced by a thin polycarbonate membrane salinized and fixed on the tip of the needle. Reproducible results were achieved and first results of in vivo measurements on rabbits are reported.

Treatment of ligature-induced peri-implantitis by lethal photosensitization and guided bone regeneration: A preliminary histologic study in dogs

Background: the purpose of this pilot study was to evaluate the healing potential and reosseointegration in ligature-induced peri-implantitis defects adjacent to various dental implant surfaces following lethal photosensitization.Methods: A total of 36 dental implants with 4 different surface coatings (9 commercially pure titanium surface [CPTi]; 9 titanium plasma-sprayed [TPS]; 9 hydroxyapatite [HA]; and 9 acid-etched [AE]) were inserted in 6 male mongrel dogs 3 months after extraction of mandibular premolars. After a 2-month period of ligature-induced peri-implantitis and 12 months of natural peri-implantitis progression, only 19 dental implants remained. The dogs underwent surgical debridement of the remaining dental implant sites and lethal photosensitization by combination of toluidine blue O (100 mug/ml) and irradiation with diode laser. All exposed dental implant surfaces and bone craters were meticulously cleaned by mechanical means, submitted to photodynamic therapy, and guided bone regeneration (GBR) using expanded polytetrafluoroethylene (ePTFE) membranes. Five months later, biopsies of the implant sites were dissected and prepared for ground sectioning and analysis.Results: the percentage of bone fill was HA: 48.28 +/- 15.00; TPS: 39.54 +/- 12.34; AE: 26.88 +/- 22.16; and CPTi: 26.70 +/- 16.50. The percentage of reosseointegration was TPS: 25.25 +/- 11.96; CPTi: 24.91 +/- 17.78; AE: 17.30 +/- 15.41; and HA: 15.83 +/- 9.64.Conclusion: These data suggest that lethal photosensitization may have potential in the treatment of peri-implantitis.

FINE-STRUCTURE AND MORPHOGENESIS OF THE MICROPYLE APPARATUS IN BEES EGGS

The present paper deals with the description of the formation of the micropylar apparatus in some species of Apidae bees. The features of the cells located in the anterior pole of the oocyte chamber are described at light microscopy and with SEM and TEM. The resulting micropylar region has the form of a sieved plate, slightly elevated in relationship to the oocyte surface. It is not clear if all the holes in the sieve are opened.

Testicular biopsy with Tru-Cut needle in conjunction with fibrin adhesive or nylon suture: assessment of post-biopsy testicular function in rams

Testicular biopsy has been a complementary technique for clinical and research purposes to evaluate reproductive function in males. However, hemorrhage, inflammation, degeneration, and adhesion are factors that might limit the use of this procedure. In order to minimize these potential problems, fibrin glue derived from snake venom, a tissue adhesive with sealing, hemostatic, and healing properties, was used in conjunction with bilateral testicular biopsy with the Tru-Cut needle and was compared with a more conventional technique that uses nylon suture. Thirty mature rams were randomly assigned to three groups of 10 animals each, as follows: nonsurgical control group (no scrotal surgery, or biopsy); biopsy + glue group (fibrin glue on puncture sites and skin incisions) and biopsy + suture group (compression with swab on puncture sites and suturing of skin incision). The surgeries of the rams in the biopsy groups were performed on the same day, which was designated Day 0 for all three groups. Data of scrotal circumference, number of spermatozoa per ejaculum, percentage of morphologically abnormal spermatozoa, spermatozoa motility, and serum testosterone concentrations from Days -7, 20, 40, 60, 80 and 100 were evaluated. There were no significant differences between groups within days for any of the parameters evaluated. In conclusion, the testicular biopsy procedure using the Tru-Cut needle in conjunction with conventional nylon suture or the more novel fibrin glue in rams did not affect any of the parameters of testicular function evaluated in this study and was shown to be relatively simple, safe and efficient. (C) 2002 Published by Elsevier B.V. B.V.

New X-ray powder diffraction data and Rietveld refinement for Gd2O3 monodispersed fine spherical particles

Nominally pure Gd2O3 C-form structure from basic carbonate fine spherical particles and its differences concerning the XRD data among literature patterns using Rietveld method is reported. Gd2O3: Eu3+ from basic carbonate and Gd2O3 from oxalate were also investigated. All samples, except the one from oxalate precursor, are narrow sized, 100-200 nm. Only non-doped Gd2O3 from basic carbonate presents XRD data with smaller d(hkl) values than the literature ones. From Rietveld refinement, non-doped Gd2O3 from basic carbonate has the smallest crystallite size and from oxalate shows the greatest one. Also, the unit cell parameters indicate a plan contraction of the Gd2O3 from basic carbonate. The presence of Eu3+ increases crystallite size when basic carbonate precursor is used to prepare Gd2O3 and avoids plan contraction. The structural differences observed among Gd2O3 samples obtained are related to the type of precursor and to the presence or not of doping ion. (C) 2003 Elsevier B.V. (USA). All rights reserved.

Effects of dominant follicle aspiration and treatment with recombinant bovine somatotropin (BST) on ovarian follicular development in Nelore (Bos indicus) heifers

Follicle ablation has been recognized as an efficient method of follicular wave synchronization. Treatment with recombinant bovine somatotropin (BST) has been shown to enhance follicular development in <(Bos taurus)under bar>. This experiment assessed the effects of these treatments in Nelore (<(B. indicus)under bar>) heifers. Eight cycling Nelore heifers were randomly assigned to 3 different treatments. on Day 2 of a synchronized cycle (Day 0 = day of ovulation), heifers assigned to Treatments 1 and 2 received 2 mL of saline, whereas heifers assigned to Treatment 3 received 320 mg of BST. on Day 5, the first-wave dominant follicle was ablated by ultrasoundguided transvaginal aspiration in heifers in Treatments 2 and 3, and all heifers received an injection of prostaglandin on Day 11. Aspiration of the dominant follicle advanced and synchronized (P < 0.05) the day of second-wave emergence (6.9 +/- 0.1 vs. 8.4 +/- 0.4) and the day of the pre-wave FSH peak (6.0 +/- 0.0 vs. 6.9 +/- 0.4), and increased FSH peak concentrations (381 +/- 21 vs. 292 +/- 30; pg/mL; P < 0.01). Recombinant bovine somatotropin treatment caused a two-fold increase in plasma insulin-like growth factor-I (IGF-I) concentrations (P < 0.001) and resulted in a 36% increase in the number of small follicles (<5 mm; P < 0.001) compared with saline-treated heifers. In summary, in agreement with previous reports on <(B. taurus)under bar>, dominant follicle aspiration synchronized ovarian follicular development, and BST treatment increased peripheral concentrations of IGF-I in Nelore heifers. Recombinant bovine somatotropin also increased the number of small follicles, but this response appeared to be inferior to that reported for <(B. taurus)under bar>. (C) 2000 by Elsevier B.V.

Damage Characterization Using Guided-Wave Linear Arrays and Image Compounding Techniques

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influence of sire breed (Bos indicus versus Bos taurus) and interval from slaughter to oocyte aspiration on heat stress tolerance of in vitro-produced bovine embryos

Based on in vitro experiments, Bos indicus embryos were more resistant to heat stress (HS) than Bos taurus embryos. To increase knowledge regarding differences between Bos indicus and Bos taurus in resistance to HS, the primary objective of this study was to determine if tolerance to HS is due to the breed, origin of the oocyte, sperm, or both. Additionally, the influence of the interval between ovary acquisition (in the abattoir) and oocyte aspiration in the laboratory, on early embryo development was ascertained. Oocytes were collected from Nelore and Holstein cows in an abattoir; 4.0 or 6.5 h later, oocytes were aspired in the laboratory, and then matured and fertilized using semen from Nelore (N), Gir (GIR), or Holstein (H) bulls. Ninety-six h post insemination (hpi), embryos with >= 16 cells were divided in two groups: control and HS. In the control group, embryos were cultured at 39 degrees C, whereas in the HS group, embryos were subjected to 41 degrees C for 12 h, and then returned to 39 degrees C. Rates of cleavage, and formation of morula and blastocysts were higher (P < 0.05) for oocytes aspirated at 4.0 versus 6.5 h after ovaries were acquired. Heat stress decreased rates of blastocyst formation for all breeds (N X N; H x H; and H X GIR) and in both time intervals (4.0 and 6.5 h). However, N X N had higher cleavage rate (P < 0.05) in both time intervals when compared with H X H and H X GIR. In addition, Nelore oocytes fertilized with Nelore semen (N X N) had higher blastocyst yields (P < 0.05) in the control and HS group, when compared with the other two breeds (H X H and H X GIR). We concluded that the breed of origin of the oocyte was more important than that of the sperm for development of thermotolerance, because bull breed did not influence embryo development after HS, and in vitro early embryonic development was impaired by increasing (from 4 to 6.5 h) the interval between ovary acquisition and oocyte aspiration. (C) 2011 Elsevier B.V. All rights reserved.

Renal Evaluation of Aotus azarai infulatus by Ultrasonography and Serum Chemistry Profile

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Ovarian and Uterine Ultrasonography in Aotus azarai infulatus

We evaluated the uterus and ovaries of owl monkeys (Aotus azarai infulatus) via gynecological ultrasound examination. We evaluated the subjects in 2 different time periods. The first period (P1) was characterized by the absence of mating, with daily examinations, during 4 mo (n = 10). At the end of P1, we paired the subjects for 30 d, but without ultrasonographic evaluation. The second period (P2) was characterized by the presence of mating, with examinations once a week, during 7 consecutive months (n = 9). We evaluated the uterus and ovaries in sagittal and transverse scans, using a 5-12 MHz linear array probe. The uterine volume (UV) was directly proportional to the number of previous parturitions. The right ovary volume (RtOV) is greater than the left (LtOV) in P1 and P2. There is a positive correlation (p < 0.05) between the females' mass, RtOV (r = 0.28) and LtOV (r = 0.16).