Light hydrocarbons in gas pockets and sediments of ODP Site 131-808

A suite of gas samples obtained from gas pockets and sediments of the Nankai accretionary prism (Site 808) has been analyzed for their gas composition and carbon and hydrogen isotope ratios. Gases collected from gas pockets between 10 and 555 mbsf consist of CH4 and CO2. Stable carbon isotope ratios of these two components point to a bacterial formation of methane via CO2-reduction that is also supported by D/H ratios of methane. Methane desorbed from sediments by a vacuum/acid treatment is of bacterial and thermal origin. Mixing between these gas types is indicated by molecular composition and carbon isotope ratios. Diagenetic processes at low temperatures can explain ethane to pentane concentrations from 0 to 850 mbsf. Between 850 mbsf and the basaltic basement hydrocarbon occurrences are related to catagenetic processes at elevated temperatures. Thermal alteration of organic matter is reflected through different gas parameters. Propane carbon isotope values of a sample from the zone of the frontal thrust indicate that the gas likely migrated from sediments of a higher maturity into the immature sediments at 366 mbsf.

Clay mineralogy of ODP Site 131-808 sediments

Drill core recovered at Ocean Drilling Program Site 808 (Leg 131) proves that the wedge of trench sediment within the central region of the Nankai Trough comprises approximately 600 m of hemipelagic mud, sandy turbidites, and silty turbidites. The stratigraphic succession thickens and coarsens upward, with hemipelagic muds and volcanic-ash layers of the Shikoku Basin overlain by silty and sandy trench-wedge deposits. Past investigations of clay mineralogy and sand petrography within this region have led to the hypothesis that most of the detritus in the Nankai Trough was derived from the Izu-Honshu collision zone and transported southwestward via axial turbidity currents. Shipboard analyses of paleocurrent indicators, on the other hand, show that most of the ripple cross-laminae within silty turbidites of the outer marginal trench-wedge facies are inclined to the north and northwest; thus, many of the turbidity currents reflected off the seaward slope of the trench rather than moving straight down the trench axis. Shore-based analyses of detrital clay minerals demonstrate that the hemipelagic muds and matrix materials within sandy and silty turbidites are all enriched in illite; chlorite is the second-most abundant clay mineral, followed by smectite. In general, the relative mineral percentages change relatively little as a function of depth, and the hemipelagic clay-mineral population is virtually identical to the turbidite-matrix population. Comparisons between different size fractions (<2 µm and 2-6 µm) show modest amounts of mineral partitioning, with chlorite content increasing in the coarser fraction and smectite increasing in the finer fraction. Values of illite crystallinity index are consistent with conditions of advanced anchimetamorphism and epimetamorphism within the source region. Of the three mica polytypes detected, the 2M1 variety dominates over the 1M and 1Md polytypes; these data are consistent with values of illite crystallinity. Measurements of mica bo lattice spacing show that the detrital illite particles were eroded from a zone of intermediate-pressure metamorphism. Collectively, these data provide an excellent match with the lithologic and metamorphic character of the Izu-Honshu collision zone. Data from Leg 131, therefore, confirm the earlier interpretations of detrital provenance. The regional pattern of sediment dispersal is dominated by a combination of southwest-directed axial turbidity currents, radial expansion of the axial flows, oblique movement of suspended clouds onto and beyond the seaward slope of the Nankai Trough, and flow reflection back toward the trench axis.

Benkei and the Moon at Daimotsunoura, from One Hundred Aspects of the Moon

Tsukioka Yoshitoshi; woodcut (Oban)

Nantō enkaku shiron /

Mode of access: Internet.

Sekai shōkan /

Mode of access: Internet.

Lyot-filter based multiwavelength random distributed feedback fiber laser

Multiwavelength lasing in the random distributed feedback fiber laser is demonstrated by employing an all fiber Lyot filter. Stable multiwavelength generation is obtained, with each line exhibiting sub-nanometer line-widths. A flat power distribution over multiple lines is also obtained, which indicates the contribution of nonlinear wave mixing towards power redistribution and equalization in the system. The multiwavelength generation is observed simultaneously in first and second Stokes waves. © 2014 SPIE.

Modeling of the spectrum in a random distributed feedback fiber laser within the power balance modes

The simplest model for a description of the random distributed feedback (RDFB) Raman fiber laser is a power balance model describing the evolution of the intensities of the waves over the fiber length. The model predicts well the power performances of the RDFB fiber laser including the generation threshold, the output power and pump and generation wave intensity distributions along the fiber. In the present work, we extend the power balance model and modify equations in such a way that they describe now frequency dependent spectral power density instead of integral over the spectrum intensities. We calculate the generation spectrum by using the depleted pump wave longitudinal distribution derived from the conventional power balance model. We found the spectral balance model to be sufficient to account for the spectral narrowing in the RDFB laser above the threshold of the generation. © 2014 SPIE.

Semiconductor saturable absorber mirror passively Q-switched 2.97 μm fluoride fiber laser

A diode-cladding-pumped mid-infrared passively Q-switched Ho 3+-doped fluoride fiber laser using a reverse designed broad band semiconductor saturable mirror (SESAM) was demonstrated. Nonlinear reflectivity of the SESAM was measured using an in-house Yb3+-doped mode-locked fiber laser at 1062 nm. Stable pulse train was produced at a slope efficient of 12.1% with respect to the launched pump power. Maximum pulse energy of 6.65 μJ with a pulse width of 1.68 μs and signal to noise ratio (SNR) of ~50 dB was achieved at a repetition rate of 47.6 kHz and center wavelength of 2.971 μm. To the best of our knowledge, this is the first 3 μm region SESAM based Q-switched fiber laser with the highest average power and pulse energy, as well as the longest wavelength from mid-infrared passively Q-switched fluoride fiber lasers. © 2014 SPIE.

Switching among pulse-generation regimes in passively mode-locked fibre laser by adaptive filtering

We show both numerically and experimentally that dispersion management can be realized by manipulating the dispersion of a filter in a passively mode-locked fibre laser. A programmable filter the dispersion of which can be software configured is employed in the laser. Solitons, stretched-pulses, and dissipative solitons can be targeted reliably by controlling the filter transmission function only, while the length of fibres is fixed in the laser. This technique shows remarkable advantages in controlling operation regimes in ultrafast fibre lasers, in contrast to the traditional technique in which dispersion management is achieved by optimizing the relative length of fibres with opposite-sign dispersion. Our versatile ultrafast fibre laser will be attractive for applications requiring different pulse profiles such as in optical signal processing and optical communications.

Geochemistry of basement basaltic rocks of ODP Hole 131-808C

Major- and trace-element analyses, mineral chemistry, and Sr-Nd isotopic determinations were obtained on representative igneous rocks drilled from the Nankai accretionary complex (Site 808) during Ocean Drilling Program Leg 131. For the first time, the oceanic basement of the subducting plate below an accretionary prism has been reached. The Nankai Trough basement was encountered at a depth of 1289.9 mbsf and a total of 37.1 m of igneous rocks, middle Miocene (15.6 Ma) in age, was penetrated. Two main lithological units have been distinguished from the top downward; sill-like rocks (Unit I: Cores 105, 106, 107) and pillow lavas (Unit II: Core 108). Basalts are predominantly nonvesicular, hypocrystalline, aphyric to slightly phyric with intersertal to intergranular textures. Alteration is generally slight to moderate. All the basaltic rocks are cut by ramifying veins of varying widths. Secondary mineral assemblages (including vein fillings) are typical of submarine alteration and zeolite to low greenschist facies metamorphism. The order of crystallization of primary minerals is: olivine, plagioclase, clinopyroxene. This, together with mineral chemistry, characterized by forsteritic olivine (Fo 84-85), highly anorthitic Plagioclase (up to An 90), and in particular the composition of clinopyroxene, are typical of normal mid-ocean ridge basalts (MORB). In terms of Zr/Y (2.9-3.8) and Zr/Nb (21-58), all the analyzed samples plot in the normal MORB field. The chondrite-normalized REE patterns confirm the close affinity with normal MORB type (LaN/SmN: 0.6-0.8). Note that such magmatism does not reveal any evidence of subduction-related geochemical components. The 87Sr/86Sr isotopic ratios range from 0.70339 in pillow lavas to 0.70317 in the least-altered basalts of sill units (ratios reduced to 0.70265-0.70271 by HC1 2.5 N hot leaching), whereas 143Nd/144Nd ratios are 0.51314-0.51326. These values conform with those of normal MORB. Stratigraphy, petrography, and geochemistry of the basaltic rocks recovered at Site 808 appear very similar to those from the Shikoku Basin basement (particularly Sites 442 and 443, DSDP Leg 58), analogously identified as normal MORB.

(Table 2) Age determination of sediment cores from the Tasman Plateau

Various biomarkers (n-alkanes, n-alcohols, and sterols) have been studied in a piston core TSP-2PC taken from the Southern Ocean to reconstruct the paleoenvironmental changes in the subantarctic region for the last two deglaciations. Mass accumulation rates of terrestrial (higher molecular weight n-alkanes and n-alcohols) and marine (dinosterol and brassicasterol) biomarkers increased significantly at the last two glacials and stayed low during interglacial peaks (early Holocene and the Eemian). These records indicate that the enhanced atmospheric transport of continental materials and the increased marine biological productivity were synchronously linked in the Southern Ocean at the last two glacials. This suggests that increased glacial dust inputs have relieved iron limitation in the subantarctic Southern Ocean. These two processes, however, were not linked at the cooling phase from the Eemian to marine isotope stage (MIS) 5d. During this period, paleoproductivity may have been influenced by the latitudinal migration of the high-production zone associated with the Antarctic Polar Front.

(Table T1) Carbon contents, alkenone concentrations, alkenone unsaturation index, and SST in sediments of ODP Leg 190 sites

We have preliminarily generated the downcore records of total organic carbon (TOC) content, total alkenone concentration, alkenone unsaturation index, and the estimated sea-surface temperature (SST) in the northern three sites (Sites 1175, 1176, and 1178) of the Muroto Transect, Nankai Trough. The TOC content will be used for the evaluation of the burial of organic matter, which plays a role in the generation of natural gas and the formation of gas hydrate in this region. The downcore records of alkenone SST will benefit studies for the paleoceanography of the northwestern Pacific. Because those sites are located in the main path of the Kuroshio Current, the records provide the temperature change of the Kuroshio water, which is an end-member water mass in the northwestern Pacific.