Sensitivity of wear rates in the micro-scale abrasion test to test conditions and material hardness

Micro-scale abrasion (ball cratering) tests were performed with different combinations of ball and bulk specimen materials, under different test conditions, such as load and abrasive slurry concentration. Wear modes were classified into two types: with rolling particle motion and with grooving particle motion. Wear rates observed with rolling particle motion were relatively insensitive to test conditions, whereas with grooving motion they varied much more. It is suggested that rolling abrasion is therefore a more appropriate mode if reproducible test results are desired. The motion of the abrasive particles can be reliably predicted from the knowledge of hardnesses and elastic properties of the ball and the specimen, and from the normal load and the abrasive slurry concentration. General trends in wear resistance measured in the micro-scale abrasion test with rolling particle motion are similar to those reported in tests with fixed abrasives with sliding particle motion, although the variation in wear resistance with hardness is significantly smaller. © 2004 Published by Elsevier B.V.

Sources of variability in the free-ball micro-scale abrasion test

In the 'free-ball' version of the micro-scale abrasion or ball-cratering test the rotating ball rests against a tilted sample and a grooved drive shaft. Tests under nominally identical conditions with different apparatus commonly show small but significant differences in measured wear rate. An indirect method has been developed and demonstrated for continuous on-line measurement of the coefficient of friction in the free-ball test. Experimental investigation of the effects of sample tilt angle and drive shaft groove width shows that both these factors influence the stability of the rotation of the ball, and the shape of the abrasive slurry pool, which in turn affect the coefficient of friction in the wear scar area and the measured wear rate. It is suggested that in order to improve the reproducibility of this method the geometry of the apparatus should be specified. For the apparatus used in this work with a steel ball of 25 mm diameter, a sample tilt angle of 60-75° and a shaft groove width of about 10mm provided the most stable ball motion and a wear rate which showed least variability. © 2004 Elsevier B.V. All rights reserved.

Who's working on fishing gear design and construction for small-scale fisheries?

The findings are presented of a search conducted on traditional fishing gear design and construction using the ASFA database (1971-90) and the ICLARM Library and professional staff collections.

Low cost breeding and hatching techniques for the catfish (Heteropneustes fossilis) for small-scale farmers

The high demand for the stinging catfish (Heteropneustes fossilis) and declining wild stocks led the Centre for Aquaculture Research and Extension of India to look for methods for the culture of the species. This paper presents a low-cost, simple breeding technique developed and tested by the Centre that can be easily adopted by rural farmers.

Portable canvas tanks for culture of hybrid catfish (Clarias gariepinus x Clarias macrocephalus) by small-scale farmers in Malaysia

This paper describes the trials made with a simple portable canvas-tarpaulin tank system developed at the University Sains Malaysia for culture of hybrid catfish (Clarias gariepinus x Clarias macrocephalus) by Malaysia small scale farmers.

Determinants of women's economic participation in the small-scale fisheries sector, Peninsular Malaysia

This paper specifically examines the main determinants of women participation in income-earning activities in Peninsular Malaysian small scale fisheries.

Seasonal changes in growth of coho salmon (Oncorhynchus kisutch) off Oregon and Washington and concurrent changes in the spacing of scale circuli

In this study we present new information on seasonal variation in absolute growth rate in length of coho salmon (Oncorhynchus kisutch) in the ocean off Oregon and Washington, and relate these changes in growth rate to concurrent changes in the spacing of scale circuli. Average spacing of scale circuli and average rate of circulus formation were significantly and positively correlated with average growth rate among groups of juvenile and maturing coho salmon and thus could provide estimates of growth between age groups and seasons. Regression analyses indicated that the spacing of circuli was proportional to the scale growth rate raised to the 0.4−0.6 power. Seasonal changes in the spacing of scale circuli reflected seasonal changes in apparent growth rates of fish. Spacing of circuli at the scale margin was greatest during the spring and early summer, decreased during the summer, and was lowest in winter or early spring. Changes over time in length of fish caught during research cruises indicated that the average growth rate of juvenile coho salmon between June and September was about 1.3 mm/d and then decreased during the fall and winter to about 0.6 mm/d. Average growth rate of maturing fish was about 2 mm/d between May and June, then decreased to about 1 mm/d between June and September. Average apparent growth rates of groups of maturing coded-wire−tagged coho salmon caught in the ocean hook-and-line fisheries also decreased between June and September. Our results indicate that seasonal change in the spacing of scale circuli is a useful indicator of seasonal change in growth rate of coho salmon in the ocean.

Small-scale Commercial Culturing of Northern Bay Scallops, Argopecten irradians irradians, in Atlantic United States and Canada

In recent decades, hatchery-growout culture of oysters, Crassostrea virginica, and northern quahogs, Mercenaria mercenaria, has been commercially successful in Atlantic United States and oysters in Atlantic Canada. Culturists have not had success, as yet, with northern bay scallops, Argopecten irradians irradians. Large mortalities occur during the culture process, mainly because the scallops are relatively delicate and some die when handled. In addition, too little edible meat, i.e. the adductor muscle, is produced for the culture operation to be profitable. However, three companies, one in Massachusetts, one in New Brunswick, and one on Prince Edward Island, Canada, have discovered that they can produce bay scallops successfully by harvesting them when partially-to fully-grown and selling them whole. In restaurants, the scallops are cooked and served with all their meats (adductor muscles and rims) and also with the shells, which have been genetically-bred for bright colors. The scallop seed are produced in hatcheries and then grown in lantern or pearl nets and cages to market size. Thus far, production has been relatively small, just beyond the pilot-scale, until a larger demand develops for this product.

Extending the Bajo de Sico, Puerto Rico, Seasonal Closure: An Examination of Small-scale Fishermen’s Perceptions of Possible Socio-economic Impacts on Fishing Practices, Families, and Community

Despite considerable conservation efforts, many reef fish fisheries around the world continue to be in peril. Many are vulnerable to overexploitation because they have predictable and highly aggregated spawning events. In U.S. Caribbean waters, fishery managers are increasingly interested in advancing the use of closed areas as a means for rebuilding reef fisheries, protecting coral reef habitats, and furthering ecosystem-based management while maintaining the sustained participation of local fishing communities. This study details small-scale fishermen’s views on the Caribbean Fishery Management Council’s proposals to lengthen the current Bajo de Sico seasonal closure off the west coast of Puerto Rico to afford additional protection to snapper-grouper spawning populations and associated coral reef habitats. Drawing on snowball sampling techniques, we interviewed 65 small-scale fishermen who regularly operate in the Bajo de Sico area. Snowball sampling is a useful method to sample difficult-to-find populations. Our analysis revealed that the majority of the respondents opposed a longer seasonal closure in the Bajo de Sico area, believing that the existing 3-month closure afforded ample protection to reef fish spawning aggregations and that their gear did not impact deep-water corals in the area. Whilst fishermen’s opposition to additional regulations was anticipated, the magnitude of the socio-economic consequences described was unexpected. Fishermen estimated that a year round closure would cause their gross household income to fall between 10% and 80%, with an average drop of 48%. Our findings suggest that policy analysts and decision-makers should strive to better understand the cumulative impacts of regulations given the magnitude of the reported socio-economic impacts; and, more importantly, they should strive to enhance the existing mechanisms by which fishermen can contribute their knowledge and perspectives into the management process.