Fluid dynamics of air in a packed bed: velocity profiles and the continuum model assumption

Air flow through packed beds was analyzed experimentally under conditions ranging from those that reinforce the effect of the wall on the void fraction to those that minimize it. The packing was spherical particles, with a tube-to-particle diameter ratio (D/dp) between 3 and 60. Air flow rates were maintained between 1.3 and 4.44 m3/min, and gas velocity was measured with a Pitot tube positioned above the bed exit. Measurements were made at various radial and angular coordinate values, allowing the distribution of air flow across the bed to be described in detail. Comparison of the experimentally observed radial profiles with those derived from published equations revealed that at high D/dp ratios the measured and calculated velocity profiles behaved similarly. At low ratios, oscillations in the velocity profiles agreed with those in the voidage profiles, signifying that treating the porous medium as a continuum medium is questionable in these cases.

ZERO SOUND-VELOCITY IN PI, RHO-MESON GASES

Sharp transitions are perhaps absent in QCD, so that one looks for physical quantities which may reflect the phase change. One such quantity is the sound velocity which was shown in lattice theory to become zero at the transition point for pure glue. We show that even in a simple bag model the sound velocity goes to zero at temperature T = T(v) not-equal 0 and that the numerical value of this T(v) depends on the nature of the meson. The average thermal energy of mesons goes linearly with T near T(v), with much smaller slope for the pion. The T(v) - s can be connected with the Boltzmann temperatures obtained from transverse momentum spectrum of these mesons in heavy-ion collision at mid-rapidity. It would be interesting to check the presence of different T(v) - s in present day finite T lattice theory.

Microhabitat and plant structure of Characeae (Chlorophyta) populations in streams from São Paulo State, southeastern Brazil

Microhabitat distribution was investigated in five populations of Characeae (two of Chara guairensis, two of Nitella subglomerata and one of Nitella sp.) to determine the distributional patterns, the morphometric and reproductive adaptations to varying environmental conditions and niche width on a scale of few centimeters. Variations in physical variables revealed some general trends of microhabitat distribution for the Characeae populations studied, with occurrence under the following conditions: slow and narrow current velocities; substrata predominantly composed of small particle size (sand-clay); variable and generally low depths. In terms of morphological adaptations, we found some general patterns: plants with longer whorl branchlets also had longer internodes in all populations studied, whereas longer plants had also thicker axis. The former were generally associated with higher biomass (percent cover). Few correlations of morphological characters were observed with environmental variables (e.g. plant length with irradiance: negative in two populations and positive in one population). Despite the general patterns of occurrence mentioned above, our results also indicated that each population differed in its responses to environmental variables and had particular morphological and reproductive adaptations. The Characean populations occurred under a narrower range of microhabitat conditions than other macroalgae from lotic habitats, particularly lower current velocity (6.7-9.8 cm s(-1)) and a more specific substratum type (sand-clay). Niche width values (0.60-0.99) of the Characeae populations studied indicate a high degree of habitat specialization and are among the highest yet found in lotic macroalgae. The relatively narrow variations in microhabitat conditions and high niche widths here reported for Characean populations, suggest a lower tolerance to variations in current velocity, depth, irradiance and substratum type. These characteristics probably explain the relatively restricted distribution of Characeae species in streams of S (a) over tildeo Paulo State with low frequency of records in most regions.

Foundry sand recycling in the troughs of blast furnaces: a technical note

The foundry sand agglomerated with alkaline phenolic resin, used for the manufacture of molds, was found to be a residue which is able to be recycled, minimizing the costs of disposal and the environmental impact. This paper analyzes the thermomechanical regeneration and leaching processes and also assesses the influence of additives on the improvement of the mechanical properties of the sands. Besides, the industrial experiments carried out at CSN aiming at the foundry sand recycling in the covering of the blast furnace troughs are presented. (C) 2003 Elsevier B.V. All rights reserved.

Laboratory essays on solid residues from an area of sand mining activities at Analandia, São Paulo, Brazil, and implications to the water resources quality

This investigation reports the results of tests performed in a laboratory with solid waste samples from an area belonging to Sibelco Mineracao Ltd., which is located around Analandia municipality, nearly in the center of São Paulo State, Brazil. Dissolution and leaching essays were realized under different experimental conditions in four samples collected from the mining front and decantation pool, with the aim of evaluating the possibility of release of several constituents to the liquid phase.

Relationships and significance of lactate minimum, critical velocity, heart rate deflection and 3 000 m track-tests for running

The running velocities associated to lactate minimum (V-lm), heart rate deflection (V-HRd), critical velocity (CV), 3000 M (V-3000) and 10000 m performance (V-10km) were compared. Additionally the ability of V-lm and VHRd on identifying sustainable velocities was investigated.Methods. Twenty runners (28.5 +/- 5.9 y) performed 1) 3000 m running test for V3000; 2) an all-out 500 in sprint followed by 6x800 m incremental bouts with blood lactate ([lac]) measurements for V-lm; 3) a continuous velocity-incremented test with heart rate measurements at each 200 m for V-HRd; 4) participants attempted to 30 min of endurance test both at V-lm(ETVlm) and V-HRd(ETVHRd). Additionally, the distance-time and velocity-1/time relationships produced CV by 2 (500 m and 3000 m) or 3 predictive trials (500 m, 3000 m and distance reached before exhaustion during ETVHRd), and a 10 km race was recorded for V-10km.Results. The CV identified by different methods did not differ to each other. The results (m(.)min(-1)) revealed that V-.(lm) (281 +/- 14.8)< CV (292.1 +/- 17.5)=V-10km (291.7 +/- 19.3)< V-HRd (300.8 +/- 18.7)=V-3000 (304 +/- 17.5) with high correlation among parameters (P < 0.001). During ETVlm participants completed 30 min of running while on the ETVHRd they lasted only 12.5 +/- 8.2 min with increasing [lac].Conclusion. We evidenced that CV and Vim track-protocols are valid for running evaluation and performance prediction and the parameters studied have different significance. The V-lm reflects the moderate-high intensity domain (below CV), can be sustained without [lac] accumulation and may be used for long-term exercise while the V-HRd overestimates a running intensity that can be sustained for long-time. Additionally, V-3000 and V-HRd reflect the severe intensity domain (above CV).

Interval training at 95% and 100% of the velocity at VO2 max: effects on aerobic physiological indexes and running performance

The objective of this study was to analyze the effect of two different high-intensity interval training (HIT) programs on selected aerobic physiological indices and 1500 and 5000 m running performance in well-trained runners. The following tests were completed (n = 17): (i) incremental treadmill test to determine maximal oxygen uptake (VO2max), running velocity associated with VO2 max (VVO2max), and the velocity corresponding to 3.5 mmol/L of blood lactate concentration (vOBLA); (ii) submaximal constant-intensity test to determine running economy (RE); and (iii) 1500 and 5000 m time trials on a 400 m track. Runners were then randomized into 95% vVO(2max) or 100% vVO(2max) groups, and undertook a 4 week training program consisting of 2 HIT sessions (performed at 95% or 100% vVO(2max), respectively) and 4 submaximal run sessions per week. Runners were retested on all parameters at the completion of the training program. The VO2 max values were not different after training for both groups. There was a significant increase in post-training vVO(2 max), RE, and 1500 in running performance in the 100% vVO(2 max) group. The vOBLA and 5000 m running performance were significantly higher after the training period for both groups. We conclude that vOBLA and 5000 m running performance can be significantly improved in well-trained runners using a 4 week training program consisting of 2 HIT sessions (performed at 95% or 100% vVO(2max)) and 4 submaximal run sessions per week. However, the improvement in vVO(2 max), RE, and 1500 in running performance seems to be dependent on the HIT program at 100% vVO(2 max).

Hydrochemistry on a waste disposal area of sand mining activities at Analandia, Sao Paulo State, Brazil, and their implications on the mobilization of uranium

Groundwaters and surface waters from an area of treatment of sand for industrial purposes at Analandia municipality, nearly in the center of Sao Paulo State, Brazil, were chemically and isotopically analyzed with two aims: to evaluate if the anthropogenic activities that has taken place for the last 6 years is affecting the quality of the hydrological resources and to relate the hydrogeochemical behaviour of the uranium isotopes 234U and 238U with the pattern of circulation of groundwaters.

Effect of different plot coverings on emergence and early development of seven palm species (arecaceae)

The Arecaceae family comprises plants with economical importance in many Brazilian regions, for agricultural exploration or for landscaping. In great portion, species of this family present low germination velocity and percentage. This work meant to evaluate the germination and early development of seven palm species (Archontophoenix alexandrae H. Wendl. et Drude, Copernicia prunifera (Miller) H.E. Moore, Latania commersonii Gmel., Livistona chinensis R. Br., Syagrus campos-portoana Bondar, Syagrus coronata (Mart.) Beccari, Syagrus picrophylla Barb. Rod.), submitted to three kinds of seed bed plot coverings. Three 10 x 2 m seedbeds were built and filled with a mixture of sand, soil and chicken manure (1:3:0.5 proportion), where two lines were sown with each specie. On top of each seedbed, plastic covering and fifty percent screen were set allowing one third of the seedbed to full sunlight exposure. Seedbeds were irrigated by dripping system. All species had the same germination rate, regardless of the covering, by the end of the experiment (146 days after sowing), eventhough, A. alexandrae under plastic covering conditions, L. commersonii at full sunlight exposure and Syagrus campos-portoana under fifty percent shade, had reached that percentage around 51 days after sowing. The remaining species reached the greatest germination percentage earlier with some of the coverings, rather than at full sunlight exposure. For the studied conditions, covering type had no effect in leaf length and width. For leaf number, there was interaction between species x covering type for Livistona chinensis and Copernicia prunifera.

Sand-water slurry erosion of API 5L X65 pipe steel as quenched from intercritical temperature

The objective of this study was to analyze the erosion of API 5L X65 pipe steel whose microstructure consisted of ferrite and martensite obtained by quenching from intercritical temperature (770 °C). Jet impingement tests with sand-water slurry were used. The changes in mechanical properties, caused by heat treatment carried out, did not induce changes in either the mechanism or erosion resistance. The erosion rate increased with angle of attack until 30° and later decreased until 90°. The microtexture of the eroded surfaces, at angles of attack of 30° and 90°, were similar for both conditions and were composed of craters and platelets at several stages of evolution. The erosion mechanism was by extrusion with the forming and forging of platelets.