Managing Nile perch using slot size: is it possible?

The fishery of Lake Victoria became a major commercial fishery with the introduction of Nile perch in 1950s and 1960s. Biological and population characteristics point to a fishery under intense fishing pressure attributed to increased capacity and use of illegal fishing gears. Studies conducted between 1998 to 2000 suggested capture of fish between slot size of 50 to 85 cm TL to sustain the fishery. Samples from Kenya and Uganda factories in 2008 showed that 50% and 71% of individuals processed were below the slot size respectively. This study revealed that fish below and above the slot has continued being caught and processed. This confirms that the slot size is hardly adhered to by both the fishers and the processors. The paper explores why the slot size has not been a successful tool in management of Nile perch and suggests strategies to sustain the fishery

Effects of particle size ratio on single particle motion in colloidal dispersions

The motion of a single Brownian particle of arbitrary size through a dilute colloidal dispersion of neutrally buoyant bath spheres of another characteristic size in a Newtonian solvent is examined in two contexts. First, the particle in question, the probe particle, is subject to a constant applied external force drawing it through the suspension as a simple model for active and nonlinear microrheology. The strength of the applied external force, normalized by the restoring forces of Brownian motion, is the Péclet number, Pe. This dimensionless quantity describes how strongly the probe is upsetting the equilibrium distribution of the bath particles. The mean motion and fluctuations in the probe position are related to interpreted quantities of an effective viscosity of the suspension. These interpreted quantities are calculated to first order in the volume fraction of bath particles and are intimately tied to the spatial distribution, or microstructure, of bath particles relative to the probe. For weak Pe, the disturbance to the equilibrium microstructure is dipolar in nature, with accumulation and depletion regions on the front and rear faces of the probe, respectively. With increasing applied force, the accumulation region compresses to form a thin boundary layer whose thickness scales with the inverse of Pe. The depletion region lengthens to form a trailing wake. The magnitude of the microstructural disturbance is found to grow with increasing bath particle size -- small bath particles in the solvent resemble a continuum with effective microviscosity given by Einstein's viscosity correction for a dilute dispersion of spheres. Large bath particles readily advect toward the minimum approach distance possible between the probe and bath particle, and the probe and bath particle pair rotating as a doublet is the primary mechanism by which the probe particle is able to move past; this is a process that slows the motion of the probe by a factor of the size ratio. The intrinsic microviscosity is found to force thin at low Péclet number due to decreasing contributions from Brownian motion, and force thicken at high Péclet number due to the increasing influence of the configuration-averaged reduction in the probe's hydrodynamic self mobility. Nonmonotonicity at finite sizes is evident in the limiting high-Pe intrinsic microviscosity plateau as a function of bath-to-probe particle size ratio. The intrinsic microviscosity is found to grow with the size ratio for very small probes even at large-but-finite Péclet numbers. However, even a small repulsive interparticle potential, that excludes lubrication interactions, can reduce this intrinsic microviscosity back to an order one quantity. The results of this active microrheology study are compared to previous theoretical studies of falling-ball and towed-ball rheometry and sedimentation and diffusion in polydisperse suspensions, and the singular limit of full hydrodynamic interactions is noted.

Second, the probe particle in question is no longer subject to a constant applied external force. Rather, the particle is considered to be a catalytically-active motor, consuming the bath reactant particles on its reactive face while passively colliding with reactant particles on its inert face. By creating an asymmetric distribution of reactant about its surface, the motor is able to diffusiophoretically propel itself with some mean velocity. The effects of finite size of the solute are examined on the leading order diffusive microstructure of reactant about the motor. Brownian and interparticle contributions to the motor velocity are computed for several interparticle interaction potential lengths and finite reactant-to-motor particle size ratios, with the dimensionless motor velocity increasing with decreasing motor size. A discussion on Brownian rotation frames the context in which these results could be applicable, and future directions are proposed which properly incorporate reactant advection at high motor velocities.

Synopses of research on shrimps: 1. The common shrimp species of Sierra Leone's coastal waters: their distribution, abundance and size composition

The authors present quantitative information on the shrimp resources of Sierra Leone waters. Four of the nine species present have been studied, of which Paenaeus duorarum notialis is dominant in the fishery. Synoptic surveys were undertaken in June 1977, and March 1978, to determine the abundance of the shrimp stock on the inshore shelf. The temperature-salinity-depth curves for the fishing ground show the existence of three water masses. The majority of fish caught were sciaenids, with some sparids also being taken. Detailed discussion of distribution and abundance of individual species of shrimp is given. The surveys have shown that the Banana Islands are the most productive shrimp grounds in the country, and the authors believe that they can support a viable shrimp industry for several years to come at present rates of exploitation

Investigation of the influence of the aberration induced by a plane interface on STED microscopy

The structure of the inhibition patterns is important to the stimulated emission depletion (STED) microscopy. Usually, Laguerre-Gaussian (LG) beam and the central zero-intensity patterns created by inserting phase masks in Gaussian beams are used as the erase beam in STED microscopy. Aberration is generated when focusing beams through an interface between the media of the mismatched refractive indices. By use of the vectorial integral, the effects of such aberration on the shape of depletion patterns and the size of fluorescence emission spot in the STED microscopy are studied. Results are presented as a comparison between the aberration-free case and the aberrated cases. (C) 2009 Optical Society of America

Binding site size limitations of imidazole-pyrrole polyamides for recognition in the minor groove of DNA

The discovery that the three ring polyamide Im-Py-Py-Dp containing imidazole (Im) and pyrrole (Py) carboxamides binds the DNA sequence 5'-(A,T)G(A,T)C(A,T)-3' as an antiparallel dimer offers a new model for the design of ligands for specific recognition of sequences in the minor groove containing both G,C and A,T base pairs. In Chapter 2, experiments are described in which the sequential addition of five N- methylpyrrolecarboxamides to the imidazole-pyrrole polyamide Im-Py-Py-Dp affords a series of six homologous polyamides, Im-(Py)_2-7-Dp, that differ in the size of their binding site, apparent first order binding affinity, and sequence specificity. These results demonstrate that DNA sequences up to nine base pairs in length can be specifically recognized by imidazole-pyrrole polyamides containing three to seven rings by 2:1 polyamide-DNA complex formation in the minor groove. Recognition of a nine base pair site defines the new lower limit of the binding site size that can be recognized by polyamides containing exclusively imidazole and pyrrolecarboxamides. The results of this study should provide useful guidelines for the design of new polyamides that bind longer DNA sites with enhanced affinity and specificity.

In Chapter 3 the design and synthesis of the hairpin polyamide Im-Py-Im-Py-γ-Im- Py-Im-Py-Dp is described. Quantitative DNase I footprint titration experiments reveal that Im-Py-Im-Py-γ-Im-Py-Im-Py-Dp binds six base pair 5'-(A,T)GCGC(A,T)-3' sequences with 30-fold higher affinity than the unlinked polyamide Im-Py-Im-Py-Dp. The hairpin polyamide does not discriminate between A•T and T•A at the first and sixth positions of the binding site as three sites 5'-TGCGCT-3', 5'-TGCGCA-3', and 5 'AGCGCT- 3' are bound with similar affinity. However, Im-Py-Im-Py-γ-Im-Py-Im-PyDp is specific for and discriminates between G•C and C•G base pairs in the 5'-GCGC-3' core as evidenced by lower affinities for the mismatched sites 5'-AACGCA-3', 5'- TGCGTT-3', 5'-TGCGGT-3', and 5'-ACCGCT-3'.

In Chapter 4, experiments are described in which a kinetically stable hexa-aza Schiff base La³⁺ complex is covalently attached to a Tat(49-72) peptide which has been shown to bind the HIV-1 TAR RNA sequence. Although these metallo-peptides cleave TAR site-specifically in the hexanucleotide loop to afford products consistent with hydrolysis, a series of control experiments suggests that the observed cleavage is not caused by a sequence-specifically bound Tat(49-72)-La(L)³⁺ peptide.

Coulomb explosion of hydrogen clusters irradiated by an ultrashort intense laser pulse

The explosion dynamics of hydrogen clusters driven by an ultrashort intense laser pulse has been analyzed analytically and numerically by employing a simplified Coulomb explosion model. The dependence of average and maximum proton kinetic energy on cluster size, pulse duration, and laser intensity has been investigated respectively. The existence of an optimum cluster size allows the proton energy to reach the maximum when the cluster size matches with the intensity and the duration of the laser pulse. In order to explain our experimental results such as the measured proton energy spectrum and the saturation effect of proton energy, the effects of cluster size distribution as well as the laser intensity distribution on the focus spot should be considered. A good agreement between them is obtained.

Impact of laser-accelerated micron-size projectile on dense plasma

The impact of a laser-accelerated micron-size projectile on a dense plasma target is studied using two-dimensional particle-in-cell simulations. The projectile is first accelerated by an ultraintense laser. It then impinges on the dense plasma target and merges with the latter. Part of the kinetic energy of the laser-accelerated ions in the projectile is deposited in the fused target, and an extremely high concentration of plasma ions with a mean kinetic energy needed for fusion reaction is induced. The interaction is thus useful for laser-driven impact fusion and as a compact neutron source.

Metodologia para conversão de veículos equipados com motores a combustão interna para tração elétrica: aplicação de motor síncrono de ímã permanente com fluxo magnético radial a um furgão, Brasil. 2009.

Questões climáticas, atmosféricas e de poluição ambiental têm tornado o uso final da energia assunto de interesse mundial. Sistemas com tração elétrica oferecem a oportunidade de redução de emissões. O mix de energia caracterizado pela matriz energética brasileira viabiliza o desenvolvimento desta tecnologia. É desenvolvida aqui uma metodologia para conversão de veículos equipados com motores a combustão interna para tração elétrica. A metodologia considera fatores como o peso e tamanho, o torque de partida, transmissão e potência, entre outros. Ferramentas matemáticas e a prática corrente fornecem a base para a elaboração deste trabalho, que descreve a análise de desempenho de veículos elétricos, os componentes utilizados, as equações mecânicas e os critérios para escolha do veículo ideal para conversão. É apresentada a execução de um projeto de conversão de uma Kombi para tração elétrica, cujo objetivo tem caráter educativo, buscando assim promover os benefícios da tecnologia veicular elétrica. Para viabilização do experimento, o trabalho conclui que é necessário ampliar a demanda por nacionalização de tecnologia, o que tornaria o projeto uma realidade comercialmente viável. Além disto, há necessidade de políticas públicas para o incentivo da tecnologia veicular elétrica no Brasil. Este trabalho apresenta uma contribuição para converter veículos para tração elétrica, visto que sistematiza as etapas de projeto, a partir das quais outros poderão seguir, utilizando componentes encontrados no mercado nacional.

Análisis del mercado eléctrico EPEX SPOT (Austria, Alemania, Suiza, Francia)

El objetivo de este trabajo es analizar el mercado EPEX Spot, con el fin de ver si mediante la integración de mercados se consigue converger los precios de la electricidad de Francia, Alemania, Suiza y Austria. En primer lugar se hará una breve descripción del proceso de liberalización llevado a cabo por los países que forman este mercado. A continuación, se introducirá EPEX Spot explicando el funcionamiento y los tipos de mercados que contiene. En la tercera sección se definirá el proceso de la armonización del mercado europeo. Por último, se hará un análisis más exhaustivo de la estructura de mercado de cada país y se examinará la evolución de los precios.

Some observations on the temporal variations of size of copepods and some answers to questions on their biology. [Translation from: Internationale Revue der Gesamten Hydrobiologie und Hydrographie 17 99-114, 1927.]

Until now observations on the temporal variation of size of freshwater copepods have not provided much information. Other observers only mention in passing this or that phenomenon from which it is possible to deduct termporal variations. In this study Cyclops strenuus s.l., a freshwater species of fairly wide distribution, is studied in two water bodies. The author studies the systematic, placing of inhabitants described as C. strenuus Fischer in both locations, their annual life cycle, and their annual size variations.

On the methods of determining size/weight characteristics of food organisms of fish. (Determination of the length of Copepoda in larval stages by egg-laying females of the free living freshwater Copepoda). [Translation from: Voprosy Ikhtiologii 14, 182-194, 1960. ]

As is known, copepods play an important role in the nutrition of fish. Therefore with a view to facilitating research on the study of the quantitative side of feeding, there have recently appeared a considerable number of papers devoted to the development of methods for determining the wet. weight of these crustaceans. For the further facilitating of research in the nutrition of fish it would be of great interest to clarify the problem, is there not some kind of rule in the growth of the crustaceans during metamorphosis, and if there is such a rule is it not possible, to determine the length of the larvae at each stage, not by measuring them, but by using the formulae derived on the basis of these rules. This article examines the growth curves of different species of freshwater Copepoda, obtained on the basis of experimental observations in cultures or by way of measurement of mass material at all stages of development in samples from water-bodies. The authors study in particular the ratio of the mean diameter of the eggs to the mean length of the egg-bearing females.

Studies on the mouth size of fish larvae. Method and conclusions only [Translation from: Bulletin of the Japanese Society of Scientific Fisheries 36, 353-368, 1970]

This study was conducted to look into the relationship between mouth size and the total length of larval fish, and the growth in total length of larval fish in one or within a one-year period. Study material was gathered in the South China Sea, the Bay of Bangkok and the Vietnamese coast. This translation focuses on methods and conclusions of the original (longer) paper.