El Salvador: impacto socioeconómico, ambiental y de riesgo por la baja presión asociada a la tormenta tropical Ida en noviembre de 2009

Incluye Bibliografía

Técnicas de confección de prótesis facials

Facial prostheses are a integral part of rehabilitation of patients underwent face damages, being of pathologic, traumatic or congenital origin. Although success of treatment with facial prostheses is associated with artistic ability of professional to reproduce lost structures, we can not to obviate the good adaptability of prostheses regards association of material and techniques used to make buccomaxillofacial prostheses.

Fatigue behaviour study on repaired aramid fiber/epoxy composites

Aramid fiber reinforced polymer composites have been used in a wide variety of applications, such as aerospace, marine, sporting equipment and in the defense sector, due to their outstanding properties at low density. The most widely adopted procedure to investigate the repair of composites has been by repairing damages simulated in composite specimens. This work presents the structural repair influence on tensile and fatigue properties of a typical aramid fiber/epoxy composite used in the aerospace industry. According to this work, the aramid/epoxy composites with and without repair present tensile strength values of 618 and 680MPa, respectively, and tensile modulus of 26.5 and 30.1 GPa, respectively. Therefore, the fatigue results show that in loads higher than 170 MPa, both composites present a low life cycle (lower than 200,000 cycles) and the repaired aramid/epoxy composite presented low fatigue resistance in low and high cycle when compared with non-repaired composite. With these results, it is possible to observe a decrease of the measured mechanical properties of the repaired composites.

Justiça penal autoritária e consolidação do estado punitivo no Brasil

The Brazilian democratic transition, still underway today, has run up against enormous difficulty in incorporating penal action. Or, put in yet stronger terms, we could say that the boundaries of democratization processes, delineated through the action of that sector of the State, reveal the possibility that the juridical field remains immune to democratizing change. Although prevailing discourse among law professionals asserts that Penal Justice is undergoing democratization, what we have observed in practice is a strong resistance within the juridical field to assuming political responsibilities within the consolidation of democracy. This article reports analyses and conclusions formulated through observation of the Brazilian penal justice system that gave origin to the thesis entitled Penal Justice in Brazil today: democratic discourse, authoritarian practice. The research sought to reflect on contemporary criminal justice policy, which has been guided by the widening of repression and the continued use of incarceration. Such policy, carried out in Brazil since the beginning of the 1985 political opening has adjusted itself to the liberal project that is also currently underway in the country, as well as in almost the entire Western capitalist world. As we can observe, Penal Justice, even during the execution of sentences, operates in authoritarian and exclusive ways, suppressing the rights guaranteed by law to those who have been sentenced and adopting extremely repressive forms as demonstrated by the extremely sparse benefits that it concedes. Thus, in Brazil, criminality has generally been responded through severe sentences, reflected in the absence of guarantees of constitutional rights and ample recourse to incarceration. In this vein, our contemporary democratic governments have frequently adopted a punitive stance that seeks to reaffirm the State's aptitudes for punishing and controlling criminality. © 2009 Revista de Sociologia e Política.

Economics of climate change in Latin America and the Caribbean: summary 2009

Includes bibliography

Los efectos de los desastres en 2004 y 2005: la necesidad de adaptación de largo plazo

Incluye Bibliografía

Socio-economic vulnerability to natural disasters in Mexico: rural poor, trade and public response

Includes bibliography

The use of current transformers for noise detection due to sparking in insulators strings in high voltage transmission lines

In a general way, in an electric power utility the current transformers (CT) are used to measurement and protection of transmission lines (TL) 1 The Power Line Carriers systems (PLC) are used for communication between electrical substations and transmission line protection. However, with the increasing use of optical fiber to communication (due mainly to its high data transmission rate and low signal-noise relation) this application loses potentiality. Therefore, other functions must be defined to equipments that are still in using, one of them is detecting faults (short-circuits) and transmission lines insulator strings damages 2. The purpose of this paper is to verify the possibility of using the path to the ground offered by the CTs instead of capacitive couplings / capacitive potential transformers to detect damaged insulators, since the current transformers are always present in all transmission lines (TL's) bays. To this a comparison between this new proposal and the PLC previous proposed system 2 is shown, evaluating the economical and technical points of view. ©2010 IEEE.

Genetic and modifying factors that determine the risk of brain tumors

Some modifying factors may determine the risk of brain tumors. Until now, it could not be attempted to identify people at risk and also to improve significantly disease progression. Current therapy consists of surgical resection, followed by radiation therapy and chemotherapy. Despite of these treatments, the prognosis for patients is poor. In this review, we highlight general aspects concerning genetic alterations in brain tumors, namely astrocytomas, glioblastomas, oligodendrogliomas, medulloblastomas and ependymomas. The influence of these genetic alterations in patients' prognosis is discussed. Mutagen sensivity is associated with cancer risk. The convincing studies that linked DNA damages and DNA repair alterations with brain tumors are also described. Another important modifying factor is immunity. General immune response against cancer, tumor microenvironment and immune response, mechanisms of tumor escape, CNS tumor immunology, immune defects that impair anti-tumor systemic immunity in brain tumor patients and local immunosuppressive factors within CNS are also reviewed. New hope to treatment perspectives, as dendritic-cell-based vaccines is summarized too. Concluding, it seems well established that there is association between brain tumor risk and mutagen sensivity, which is highly heritable. Primary brain tumors cause depression in systemic host immunity; local immunosuppressive factors and immunological characteristics of tumor cells may explain the poor prognosis and DNA damages responses can alert immune system. However, it is necessary to clarify if individuals with both constitutional defects in immune functions and genetic instability have higher risk of developing brain tumors. Cytogenetic prospective studies and gene copy number variations analysis also must be performed in peripheral lymphocytes from brain tumor patients. © 2011 Bentham Science Publishers Ltd.

Environmental value, valuation methods, and natural disaster damage assessment

Includes bibliography

Histochemical and ultrastructural analysis of hepatic glycogen and collagen fibers in alloxan-induced diabetic rats submitted to long-term physical training

Alterations in liver functions are common among diabetic patients, and many symptoms in the liver have been reported, including changes in glycogen stores and in the amount of collagen fibers. The practice of physical training and its morphological effects in this organ, however, are scarcely studied. In order to observe the morphological effects of alloxan-induced diabetes and the alterations arising from the practice of long-term chronic physical training in the liver, samples were collected and processed, and then analyzed by means of the histochemical techniques Periodic Acid-Schiff and Picrosirius-Hematoxylin, and ultrastructural cytochemical test of Afzelius. Through evaluation of the tissue, it was observed a drastic reduction in hepatic glycogen stores of sedentary diabetics, recovered in trained diabetic rats. Furthermore, it was detected a decrease in the content of perisinusoidal collagen fibers in the diabetic liver, also recovered due to the development of a training protocol. On ultrastructural level, cytochemical analysis confirmed the loss of glycogen and the recovery obtained by training. In conclusion, the practice of a long-term chronic physical training protocol may be considered an important assistant in the treatment of diabetes, mitigating the occurrence of possible damages to liver tissue. © 2011 Elsevier Ltd.

Adaptive filter feature identification for structural health monitoring in aeronautical panel

This paper presents an approach for structural health monitoring (SHM) by using adaptive filters. The experimental signals from different structural conditions provided by piezoelectric actuators/sensors bonded in the test structure are modeled by a discrete-time recursive least square (RLS) filter. The biggest advantage to use a RLS filter is the clear possibility to perform an online SHM procedure since that the identification is also valid for non-stationary linear systems. An online damage-sensitive index feature is computed based on autoregressive (AR) portion of coefficients normalized by the square root of the sum of the square of them. The proposed method is then utilized in a laboratory test involving an aeronautical panel coupled with piezoelectric sensors/actuators (PZTs) in different positions. A hypothesis test employing the t-test is used to obtain the damage decision. The proposed algorithm was able to identify and localize the damages simulated in the structure. The results have shown the applicability and drawbacks the method and the paper concludes with suggestions to improve it. ©2010 Society for Experimental Mechanics Inc.

Estimativa do tempo de produção de chorume em aterro controlado por meio de medidas de resistividade elétrica

Landfill is an engineering work that aims at to accommodate residues in the smallest possible space in the soil, with minimum damages to the environment and the public health. One in the constructive forms of a controlled landfill is the excavation of ditches with appropriate dimensions, for disposition of solid residues without compactation or impermeabilization. Liquid effluents generated for similar volumes of residues, disposed in ditches with ages different from closing, it should result in physical and chemical alterations you correlated at the time of residence materials. With base in this hypothesis, measures of electric resistivity were accomplished through the of Eletrical Resistivity geophysical method, on residues ditches closed annually between 12/2001 and 12/2007, localized in control landfill of the Cordeirópolis city (SP). The leachate is a liquid effluent generated by the decomposition of organic matter and characterized by high content in total dissolved solids, whose interaction with geological environment results in alterations in terms of electrical resistivity susceptible to detection for the geophysical instrumental. The results suggest a resistivity reduction for leachate percolation produced for ditches recently and increase progressive of the resistivity for older ditches. The statistical comparative analysis with reference values for the area suggests ages of the finish production and percolation leachate for soil and rock below the ditches.

Influência de protocolos de jateamento na rugosidade da superfície de uma cerâmica de zircônia tetragonal parcialmente estabilizada por ítria

Objective: To evaluate the influence of different air abrasion protocols on the surface roughness of an yttria-stabilized polycrystalline tetragonal zirconia) (Y-TZP) ceramic, as well as the surface topography of the ceramic after the treatment. Method: Fifty-four specimens (7.5×4×7.5mm) obtained from two ceramic blocks (LAVA, 3M ESPE) were flattened with fine-grit sandpaper and subjected to sintering in the ceramic system's specific firing oven. Next, the specimens were embedded in acrylic resin and the surfaces to be treated were polished in a polishing machine using sandpapers of decreasing abrasion (600- to 1,200-grit) followed by felt discs with 10μm and 3μm polishing pastes and colloidal silica. The specimens were then randomly assigned to 9 groups, according to factors particle and pressure(n=6): Gr1- control; Gr2- Al 2O 3(50μm)/2.5 bar; Gr3- Al 2O 3(110μm)/2.5 bar; Gr4- SiO 2(30μm)/2.5 bar; Gr5- SiO 2(30μm)/2.5 bar; Gr6- Al 2O 3(50μm)/3.5 bar; Gr7- Al2O3(110μm)/3.5 bar; Gr8- SiO 2(30μm)/3.5 bar; Gr9- SiO 2(30μm)/3.5 bar. After treatments, surface roughness was analyzed by a digital optical profilometer and the morphology was examined by scanning electron microscopy (SEM). Data (μm) were subjected to statistical analysis by Dunnett's test (5%), two-way ANOVA and Tukey's test (5%). Results: The type of particle (p=0.0001) and the pressure (p=0.0001) used in the air abrasion protocols influenced the surface roughness values among the experimental groups (ANOVA). The mean surface roughness values (μm) obtained for the experimental groups (Gr2 to Gr9) were, respectively: 0.37 D; 0.56 BC; 0.46 BC; 0.48 CD; 0.59 BC; 0.82 A; 0.53B CD; 0.67 AB. The SEM analysis revealed that Al 2O 3, regardless of the particle size and pressure used, caused damage to the surface of the specimens, as it produced superficial damages on the ceramic, in the form of grooves and cracks. Conclusion: Al2O3 (110 μm/3.5 bar) air abrasion promoted the highest surface roughness on the ceramics, but it does not mean that this protocol promotes better ceramic-cement union compared to the other air abrasion protocols.

Análise espermática de perdizes (Rhynchotus rufescens) criadas em cativeiro e suplementadas com selênio

Due to the commercial importance of the red-winged tinamou (Rhynchotus rufescens), for the past few years, the employment of reproductive biotechnologies has been attempted. Thirty animals were randomly assigned into two groups: control group (no selenium) and treatment group (supplemented with 0,2 a 0,8 mg selenium/ 1000 kg ration). Animals were allocated at the FCAV - UNESP/Jaboticabal (2007-2008). Semen collections were performed by digital manipulation and divided in pools of at least 150 μL. After the immediate evaluation of motility, vigour, concentration and morphology, an aliquot of 20 μL was diluted in 300 μL of physiologic solution in order to test acrosome and membrane integrities, which were performed by counting 200 cells for each test. Cells were evaluated as follows: 1) Intact acrosome: lilac acrosome; Non-intact acrosome: pink acrosome; 2) Live cells: non stained; Dead: stained. Data was statistically analysed using the SAS System for Windows. No differences were found between treatment and control groups for volume, motility, vigour, mean number of spermatozoa per animal, concentration, Intact acrosome, Intact membrane. The difference found on midpiece sperm defect (Se = 1,33 ± 0,53 and control = 3,78 ± 0,69, p = 0.0107) may be due to the damages caused by the selenium deficiency to the architecture of the midpiece, which compromises sperm mobility and fertilization capacity.