Correlation among order-disorder, electronic levels, and photoluminescence in amorphous CT : Sm

Ca0.95Sm0.05TiO3 (CT:Sm) powder was prepared by the polymeric precursor method (PPM). Order-disorder at short and long range has been investigated by means of Raman spectroscopy, X-ray diffraction (XRD), and photoluminescence emission (PL) experimental techniques. The broad PL band and the Sm emission spectrum measured at room temperature indicate the increase of structural order with annealing temperature. The measured PL emission reveals that the PL intensity changes with the degree of disorder in the CT: Sm. The electronic structures were performed by the ab initio periodic method in the DFT level with the hybrid nonlocal B3LYP approximation. Theoretical results are analyzed in terms of DOS, charge densities, and Mulliken charges. Localized levels into the band gap of the CT: Sm material favor the creation of the electron-hole pair, supporting the observed room-temperature PL phenomenon.

Physicochemical parameters involved in the lethal toxicity of N,N-[(dimethylamino)ethyl]-4-substituted benzoate hydrochlorides: A QSAR study

A set of sixteen para-substituted N,N-[(dimethylamino)ethyl] benzoate hydrochlorides structurally related to procaine was synthesized. The apparent partition coefficients were determined by either shake-flask or HPLC methods and were taken as hydrophobic parameters. The IR stretching frequencies of the carbonyl group were determined in chloroform and taken as one of the electronic parameters. Additional physicochemical parameters were either taken from the literature: pi, sigma, T and R, MR4, or calculated: log P. The lethal potency was determined in the mouse via the LD50. In order to verify the nature and the relative contributions of the physicochemical parameters to lethal toxicity, QSAR equations were derived using regression analysis. A major contribution of hydrophobicity to ether with a smaller but still significant contribution of electronic or polar properties was found to a describe the toxicity within this set of compounds.

Kinetic parameters of polymer degradation by SAPO-37

High density poly(ethylene) has been submitted to thermal degradation alone, and in the presence of silicoaluminophosphate SAPO-37. The processes were carried out in a reactor connected on line to a gas chromatograph/mass spectrometer in order to analyze the evolved products. Polymer degradation was also evaluated by thermogravimetry, from room temperature until 800 degreesC, under nitrogen dynamic atmosphere, with multiple heating rates. From TG curves, the activation energy related to degradation process was calculated using the Flynn and Wall multiple heating rate kinetic model for pure polymer (PE) and for polymer in the presence of catalyst (PE/S37). SAPO-37 showed good selectivity for low molecular mass hydrocarbons in PE catalytic degradation.

Antibiosis associated to Lactobacillus acidophilus growth .2. Optimization of some culture parameters in whey and soy milk medium

Whey supplemented with soy milk has been used as a low-cost alternative in the growth of Lactobacillus acidophilus for the production of antimicrobial compounds. Response Surface Metodology has been employed in order to study the effects of initial pH, incubation temperature and soy milk rate for supplementation in the production of antimicrobial substance. It has been observed that both tested microrganisms used (S. aureus and E. coli) were inhibited by antimicrobial substance produced by L. acidophilus. The results obtained with E. coli inhibition did not follow the employed statistical model. on the other hand, when the tested microorganism S. aureus was used, the best inhibition results have been obtained when L. acidophilus was incubated at 36.80 degrees C in whey with 5.6 initial pH and 31,90% (v/v) rate supplemented with soy milk. The analysed antimicrobial substances were nor acids neither hidrogen peroxid.

On bifurcation and symmetry of solutions of symmetric nonlinear equations with odd-harmonic forcings

In this work we study existence, bifurcation, and symmetries of small solutions of the nonlinear equation Lx = N(x, p, epsilon) + mu f, which is supposed to be equivariant under the action of a group OHm, and where f is supposed to be OHm-invariant. We assume that L is a linear operator and N(., p, epsilon) is a nonlinear operator, both defined in a Banach space X, with values in a Banach space Z, and p, mu, and epsilon are small real parameters. Under certain conditions we show the existence of symmetric solutions and under additional conditions we prove that these are the only feasible solutions. Some examples of nonlinear ordinary and partial differential equations are analyzed. (C) 1995 Academic Press, Inc.

Genetic parameters estimates for milk, fat and protein yield analyzed by test day models for Murrah buffaloes in Brazil

The objectives of this study were to estimate genetic parameters for test-day milk, fat and protein yields, in Murrah buffaloes. In this study 4,757 complete lactations of Murrah buffaloes were analyzed. The (co) variance components were estimated by restricted maximum likelihood using MTDFREML software. The bi-trait animal test-day models included genetic additive direct and permanent environment effects, as random effects, and the fixed effects of contemporary group (herds-year-month of control) and age of the cow at calving as linear and quadratic covariable. The heritability estimate at first control was 0.19, increased until the third control (0.24), decreasing thereafter, reaching the lowest value at the ninth control (0.09). The highest heritability estimates for fat and protein yield were 0.23 (first control) and 0.33 (third control), respectively. For milk yield, genetic and phenotypic correlation estimates ranged from 0.37 to 0.99 and from 0.52 to 0.94, respectively. Genetic correlations were higher than phenotypic ones. For fat and protein yields, genetic correlation estimates ranged from 0.42 to 0.97.

Exercise mode affects the time to achieve VO2max without influencing maximal exercise time at the intensity associated with VO2max in triathletes

The objective of this study was to analyze, in triathletes, the possible influence of the exercise mode (running x cycling) on time to exhaustion (TTE) and oxygen uptake (VO2) response during exercise performed at the intensity associated with the achievement of maximal oxygen uptake (IVO2max). Eleven male triathletes (21.8 +/- 3.8 yr) performed the following tests on different days on a motorized treadmill and on a cycle ergometer: 1) incremental tests in order to determine VO2max and IVO2max and, 2) constant work rate tests to exhaustion at IVO2max to determine TTE and to describe VO2 response (time to achieve VO2max-TAVO(2max) and time maintained at VO2max-TMVO2max). No differences were found in VO2max, TTE and TMVO2max obtained on the treadmill tests (63.7 +/- 4.7 ml.kg(-1).min(-1); 324.6 +/- 109.1 s; 178.9 +/- 93.6 s) and cycle ergometer tests (61.4 +/- 4.5 ml.kg(-1).min(-1); 390.4 +/- 114.4 s; 213.5 +/- 102.4 s). However, TAVO(2max) was influenced by exercise mode (145.7 +/- 25.3 vs. 176.8 +/- 20.1 s; in treadmill and cycle ergometer, respectively; p = 0.006). It is concluded that exercise modality affects the TAVO(2max) without influencing TTE and TMVO2max during exercise at IVO2max in triathletes.

Serum and plasma hormonal concentrations are sensitive to periods of intensity and volume of soccer training

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Third body perturbation using a single averaged model considering elliptic orbits for the disturbing body

In the present work, we expanded the study done by Solorzanol(1) including the eccentricity of the perturbing body. The assumptions used to develop the single-averaged analytical model are the same ones of the restricted elliptic three-body problem. The disturbing function was expanded in Legendre polynomials up to fourth-order. After that, the equations of motion are obtained from the planetary equations and we performed a set of numerical simulations. Different initial eccentricities for the perturbing and perturbed body are considered. The results obtained perform an analysis of the stability of a near-circular orbits and investigate under which conditions this orbit remain near-circular.

Reproductive Parameters of Mangalarga Marchador Mares in a Commercial Embryo Transfer Programme

ContentsThe objective of this study is to evaluate the reproductive efficiency in donors and recipient Mangalarga Marchador mares in commercial programmes of embryo transfer (ET) and the effects of some reproductive characteristics and ET methodology on conception rates in the recipient mares. A total of 1140 flushing procedures were performed and 830 embryos (72.8%) were recovered. There were no differences between the rates of embryonic recovery in the different breeding seasons (p > 0.05) and 92.8% of the recovered embryos were 8-9 days old. There was no difference in the embryonic recovery regarding the collection order from the first to the ninth embryo collection along the breeding season, as well as among mares inseminated during the foal heat or subsequent cycles (p > 0.05). Pregnancy rates observed in the total period of all reproductive seasons at 15, 30, 45 and 60 days of pregnancy were 73.4, 69.9, 66.7 and 64.5%, respectively. Differences in pregnancy rate and early embryonic loss rates were not observed between embryos transferred immediately after collection (66.8% and 13.5%) and embryos transported at room temperature for periods of < 1 h (62.9% and 14.4%; p > 0.05). Pregnancy rates were higher when the interval between ovulations of donor and recipient mares remained between -3 and -2 days (p < 0.05), and the lowest rates were observed for intervals of -6 days (p < 0.05) with intermediary values for intervals of -1, 0 and +1 (p > 0.05). Embryonic loss rates, however, did not differ between intervals of ovulation's synchronism between donor and recipient mares (p > 0.05). This flexibilization in the ovulatory synchronism between donor and recipient mares optimizes the use of recipient mares, thus reducing costs and facilitating management of horse breeding farms.

Rheological Analysis of Water Clay Compositions in Order to Investigate Mudflows Developing in Canals

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

DNA hybridization mechanism in an interfacial environment: What hides beneath first order k (s(-1)) kinetic constant?

The scientific question addressed in this work is: what hides beneath first order kinetic constant k (s(-1)) measured for hybridization of a DNA target on a biosensor surface. Kinetics hybridization curves were established with a 27 MHz quartz microbalance (9 MHz, third harmonic) biosensor, constituted of a 20-base probe monolayer deposited on a gold covered quartz surface. Kinetics analysis, by a known two-step adsorption-hybridization mechanism, is well appropriate to fit properly hybridization kinetics curves, for complementary 20-base to 40-base targets over two concentration decades. It was found that the K-1 (M-1) adsorption constant, relevant to the first step, concerns an equilibrium between non hybridized targets and hybridized pre-complex and increases with DNA target length. It was established that k(2) (s(-1)), relevant to irreversible formation of a stable duplex, varies in an opposite way to K-1 with DNA target length. (C) 2012 Published by Elsevier B.V.

Short-period variation of cosmic-ray intensity and ozone density observed in the stratosphere

The energy deposition by slowing-down of energetic ionizing particles in the atmosphere enhances the production of constituent concentration which perturbs and eventually destroys the ozone (OZ) layer. Near the Brazilian anomaly region the cosmic-ray (CR) intensity varies greatly due to the magnetic activity in that region. In order to study these variations, stratospheric balloons were launched to measure, simultaneously, the CR and OZ fluxes in the atmosphere. The Fourier-analysed data collected during the flight on April 22, 1989 show evidences of a short-period variation for both fluxes measured. Attempts to verify the physical mechanisms which associate the CR change with the OZ one are not conclusive due to limited data observed on that event. © 1993 Società Italiana di Fisica.

Fourth-order method for solving the Navier-Stokes equations in a constricting channel

A fourth-order numerical method for solving the Navier-Stokes equations in streamfunction/vorticity formulation on a two-dimensional non-uniform orthogonal grid has been tested on the fluid flow in a constricted symmetric channel. The family of grids is generated algebraically using a conformal transformation followed by a non-uniform stretching of the mesh cells in which the shape of the channel boundary can vary from a smooth constriction to one which one possesses a very sharp but smooth corner. The generality of the grids allows the use of long channels upstream and downstream as well as having a refined grid near the sharp corner. Derivatives in the governing equations are replaced by fourth-order central differences and the vorticity is eliminated, either before or after the discretization, to form a wide difference molecule for the streamfunction. Extra boundary conditions, necessary for wide-molecule methods, are supplied by a procedure proposed by Henshaw et al. The ensuing set of non-linear equations is solved using Newton iteration. Results have been obtained for Reynolds numbers up to 250 for three constrictions, the first being smooth, the second having a moderately sharp corner and the third with a very sharp corner. Estimates of the error incurred show that the results are very accurate and substantially better than those of the corresponding second-order method. The observed order of the method has been shown to be close to four, demonstrating that the method is genuinely fourth-order. © 1977 John Wiley & Sons, Ltd.

Uso de resíduos agroindustriais nas produções de cana-de-açúcar, açúcar e álcool

In order to study the effect of gypsum, lime and the mixture of lime-gypsum, associated with syrup in the agricultural and industrial production and in the rooting of sugar-cane (Saccharum spp.), var. IAC 58-480, one experiment was carried out in soil Terra Roxa Estrutura. Sugar-cane was planted in November 1986, and the cane-plant harvesting in September 1988. Three successive harvests were collected.The experiment was set in a randomized block design with seven treatments and four replications .The treatments were: T1 - 1.2 ton/ha of lime; T2 - 0.8 ton/ha of lime + 0.4 ton/ha of gypsum; T3 - 0.6 ton/ha of lime + 0.6 ton/ha of gypsum; T4 - 0.4 ton/ha of lime + 0.8 ton/ha of gypsum; T5 - 1.2 ton/ha of gypsum; T6 - 2.4 ton/ha of gypsum; T7 - control. Syrup was applied at the amount of 45 m3/ha.In September 1990, after the third harvesting, the second application of the treatments was made, the gypsum being applied in amounts four times greater than those of that put into practice at the planting. During harvest, the following parameters were evaluated: number, length and average diameter of the stalks; yield; and probable sugar and theoretical alcohol production per hectare.The results showed that the second application of the treatments recuperated the crop. Greater yields were achieved when the gypsum was associated with lime or syrup.