925 resultados para Glass manufacture


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Sand-sized basaltic glass fragments were recovered in the liner of Core 203-1243B-19R, the deepest recovery from Hole 1243B. Microprobe analysis of 582 glassy cuttings cluster into five compositionally distinct groups, most of which are unlike the lithologic units described on board ship. Drilling operations intended to sweep cuttings from the caving hole and differences between the cuttings and geochemically distinct lithologic units of the upper part of the basement indicate that the cuttings came mainly, if not entirely, from the lower part of the hole. They give information about the part of Hole 1243B that had poor core recovery. Enriched mid-ocean-ridge basalt (MORB) from the upper part of the hole and transitional MORB from two groups of cuttings from sources low in the hole may be a trace of the Galápagos plume on the Pacific plate or may be a normal consequence of eruptions from two distinct magmas on fast-spreading crust.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The Ocean Drilling Program (ODP) Site 959 was drilled in the northern border of the Côte d'Ivoire-Ghana Ridge at a water depth of 2100 m. Pleistocene total thickness does not exceed 20 m. Winnowing processes resulted in a low accumulation rate and notable stratigraphic hiatuses. During the Late Pleistocene, bottom circulation was very active and controlled laminae deposition (contourites) which increased the concentration of glauconitic infillings of foraminifera, and of volcanic glass and blue-green grains more rarely, with one or several subordinate ferromagnesian silicates. Volcanic glass generally was X-ray amorphous and schematically classified as basic to intermediate (44-60% SiO2). Opal-A or opal-CT suggested the beginning of the palagonitisation process, and previous smectitic deposits may have been eroded mechanically. The blue-green grains presented two main types of mineralogic composition: (1) neoformed K, Fe-smectite associated with zeolite (like phillipsite) and unequal amounts of quartz and anorthite; (2) feldspathic grains dominated by albite but including quartz, volcanic glass and smectites as accessory components. They were more or less associated with the volcanic glass. On the basis of their chemical composition, the genetic relationship between the blue-green grains and the volcanic glass seemed to be obvious although some heterogeneous grains seemed to be primary ignimbrite and not the result of glass weathering. The most reasonable origin of these pyroclastic ejecta would be explosive events from the Cameroon Volcanic Ridge, especially from the Sao Thome and Principe Islands and Mount Cameroon area. This is supported both by grain geochemistry and the time of volcanic activity, i.e. Pleistocene. After westward wind transport (some 1200 km) and ash fall-out, the subsequent winnowing by bottom currents controlled the concentration of the volcanic grains previously disseminated inside the hemipelagic sediment. Palagonitisation, and especially phillipsite formation, may result from a relatively rapid reaction during burial diagenesis (<1 m.y.), in deep-sea deposits at relatively low sedimentation rate. However, it cannot be excluded that the weathering had begun widely on the Cameroon Ridge before the explosive event.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Transmission electron microscopy observations and rock magnetic measurements reveal that alteration of fine- and large-grained iron-titanium oxides can occur at different rates. Fine-grained titanomagnetite occurs as a crystallization product within interstitial glass that originated as an immiscible liquid within a fully differentiated melt; in several samples with ages to 32 Ma it displays very little or no oxidation (z = ca. 0). In contrast, samples with ages of 10 Ma or older are observed to also contain highly oxidized (z >/= 0.66) large-grained titanomaghemite. These large grains, having originated by direct crystallization from melt, are associated with pore space. Such pore space can serve as a conduit for fluids that promote alteration, whereas fine grains may have been "armored" against alteration by the glass matrix in which they are embedded. Apparently, alteration of oceanic crust is a heterogeneous process on a microscopic scale. The existence of pristine, fine-grained titanomagnetite in the interstitial glass of older ocean-floor basalts that have undergone significant alteration implies that such glassy material is capable of carrying original thermal remanent magnetization and may be suitable for paleointensity determinations.