The structure of the mixed OH+H2O overlayer on Pt{111}

The structure of the mixed p(3x3)-(3OH+3H(2)O) phase on Pt{111} has been investigated by low-energy electron diffraction-IV structure analysis. The OH+H2O overlayer consists of hexagonal rings of coplanar oxygen atoms interlinked by hydrogen bonds. Lateral shifts of the O atoms away from atop sites result in different O-O separations and hexagons with only large separations (2.81 and 3.02 angstrom) linked by hexagons with alternating separations of 2.49 and 2.81/3.02 A. This unusual pattern is consistent with a hydrogen-bonded network in which water is adsorbed in cyclic rings separated by OH in a p(3x3) structure. The topmost two layers of the Pt atoms relax inwards with respect to the clean surface and both show vertical buckling of up to 0.06 angstrom. In addition, significant shifts away from the lateral bulk positions have been found for the second layer of Pt atoms. (C) 2005 American Institute of Physics.

Effects of sulphur nutrition during potato cultivation on the formation of acrylamide and aroma compounds during cooking

Lack of sulphur nutrition during potato cultivation has been shown to have profound effects on tuber composition, affecting in particular the concentrations of free asparagine, other amino acids and sugars. This is important because free asparagine and sugars react at high temperatures to form acrylamide, a suspect carcinogen. Free amino acids and sugars also form a variety of other compounds associated with colour and flavour. In this study the volatile aroma compounds formed in potato flour heated at 180 °C for 20 min were compared for three varieties of potato grown, with and without sulphur fertiliser. Approximately 50 compounds were quantified in the headspace extracts of the heated flour, of which over 40 were affected by sulphur fertilisation and/or variety. Many of the 41 compounds found at higher concentrations in the sulphur-deficient flour were Strecker aldehydes and compounds formed from their condensation, whereas only one compound, benzaldehyde, behaved in the same way as did acrylamide and was found at higher concentrations in the sulphur-sufficient flour. The reasons for these effects are discussed.

Hydrogen-bond assisted stabilization of the less favored conformation of a tridentate Schiff base ligand in dinuclear nickel(II) complex: an experimental and theoretical study

The Schiff base ligand, HL (2-[1-(3-methylamino-propylimino)-ethyl]-phenol), the 1:1 condensation product of 2-hydroxy acetophenone and N-methyl-1,3-diaminopropane, has been synthesized and characterized by X-ray crystallography as the perchlorate salt [H2L]ClO4 (1). The structure consists of discrete [H2L](+) cations and perchlorate anions. Two dinuclear Ni-II complexes, [Ni2L2(NO2)(2)] (2), [Ni2L2(NO3)(2)] (3) have been synthesized using this ligand and characterized by single crystal X-ray analyses. Complexes 2 and 3 are centrosymmetric dimers in which the Ni-II ions are in distorted fac- and mer-octahedral environments, respectively, bridged by two mu(2)-phenolate ions of deprotonated ligand, L. The plane of the phenyl rings and the Ni2O2 basal plane are nearly coplanar in 2 but almost perpendicular in 3. We have studied and explained this different behavior using high level DFT calculations (RI-BP86/def2-TZVP level of theory). The conformation observed in 3, which is energetically less favorable, is stabilized via intermolecular non-covalent interactions. Under the excitation of ultraviolet light, characteristic fluorescence of compound 1 was observed; by comparison fluorescence intensity decreases in case of compound 3 and completely quenched in compound 2.

In situ formation of ligand 2,2'-[(E)-diazene-1,2-diyldicarbonothioyl]diphenol and structural characterization of its binuclear rhodium(V) complex containing RhO2+

The ligand 2,2'-[(E)-diazene-1,2-diyldicarbonothioyl]diphenol has been synthesised in situ by aerial oxidation of o-hydroxythiobenzhydrazide [H(htbh)] in presence of rhodium(III) in DMSO. Each ligand binds two RhO2+ ions through its N and S atoms and the O atom of its deprotonated hydroxy group. Each RhO2+ contains two cis-Rh = O bonds. The sixth coordination site of each rhodium(v) is occupied by the O of DMSO.

Influence of the Photorhabdus luminescens phosphomannose isomerase gene, manA, on mannose utilization, exopolysaccharide structure, and biofilm formation

Extracellular polysaccharide (EPS) is produced by diverse bacterial pathogens and fulfills assorted roles, including providing a structural matrix for biofilm formation and more specific functions in virulence, such as protection against immune defenses. We report here the first investigation of some of the genes important for biofilm formation in Photorhabdus luminescens and demonstrate the key role of the phosphomannose isomerase gene, manA, in the structure of functional EPS. Phenotypic analyses of a manA-deficient mutant showed the importance of EPS in motility, insect virulence, and biofilm formation on abiotic surfaces as well as the requirement of this gene for the use of mannose as the sole carbon source. Conversely, this defect had no apparent impact on symbiosis with the heterorhabditid nematode vector. A more detailed analysis of biofilm formation revealed that the manA mutant was able to attach to surfaces with the same efficiency as that of the wild-type strain but could not develop the more extended biofilm matrix structures. A compositional analysis of P. luminescens EPS reveals how the manA mutation has a major effect on the formation of a complete, branched EPS.

Synthesis and X-ray crystal structure of the triethylammonium magnesium β-octamolybdate(VI)salt[Et3NH]2[Mg(H2O)6Mo8O26]·2H2O

[Et3NH]4[Mo8O26] reacted with MgCl2 giving the triethylammonum magnesium β-octamolybdate(VI) salt [Et3NH]2[Mg(H2O)6Mo8O26]·2H2O (3) and the triethylammonium hydronium β-octaamolybdate(VI) salt [Et3NH]3[(H3O)Mo8O26·2H2O (4), respectively. A small amount of [Et3NH]2[Mo6O269] was formed as a by-product. The salts 3 and 4 were characterized by X-ray crystallography. The [Mg(H2O)6Mo8O26]2− moiety in 3 is polymeric, with each octahedral [Mg(H2O)6]2+ ion sandwiched between two β[Mo8O26]4− ions, being hydrogen bonded to three terminal MOO oxygen atoms on one face of each β[Mo8O26]4− ion. The X-ray crystal structure of 4 corresponds to the reported previously. IR and conductivity data are given for 3 and 4.

Synthesis and X-ray crystal structure of the copper(I) dicarboxylic acid complex [Cu(η1-bdoaH)(PPh3)3] (bdoaH2 = benzene-1,2- dioxyacetic acid)

The copper(II) complex [Cu(bdoa)(H2O)2] (bdoaH2 = benzene-1,2-dioxyacetic acid) reacts with triphenylphosphine (1:4 mol ratio) to give the colourless copper(I) complex [Cu(η1-bdoaH)(PPh3)3] (1) in good yield. The X-ray crystal structure of the complex shows the copper atom at the centre of a distorted tetrahedron, and is ligated by the phosphorus atoms of the three triphenylphosphines and one carboxylate oxygen atom of the bdoaH− ligand. Significant intermolecular hydrogen-bonding exists between the pendant carboxylate OH function of one molecule and the uncoordinated “ketonic” oxygen of a neighbouring molecule. Complex 1 is non-conducting in chloroform but ionizes readily in acetonitrile. The cyclic voltammogram of an acetonitrile solution of 1 shows a single irreversible anodic peak for the oxidation of the PPh3 ligands and the copper(I) centre, and a single irreversible cathodic peak for the reduction of the bdoaH− ion. IR and mass spectral data for 1 are given.

Synthesis of the first-membered ring compound containing three tin atoms and one oxygen. The crystal structure of the species [O{Sn(C6H3Et2-2,6)2}3]

Aerial oxidation of the novel homocyclic tetratin species [{SnAr2}3SnArBr] (1) [1] (Ar  C6H3Et2-2,6) affords the tritin heterocycle [O{Sn(C6H3Et2-2,6)2}3] (2), which has been crystallographically characterised; 2 is the first reported oxatristannacyclobutane, and the first heterocyclic tin species having both tintin and tinheteroatom bonds.

Tin–osmium cluster formation with a monomeric tin(II) alkyl: the formation, crystal structure and reactivity of [Os3(µ-H)SnR(CO)10], a formal stannyne complex of the osmium triangle {R = C(SiMe3)2C5H4N-2}

The monomeric tin(II) species SnR2{R = C(SiMe3)2C5H4N-2} reacts with [Os3(H)2(CO)10] in hexane to give [Os3(µ-H)SnR(CO)10]1 quantitatively; 1 is the first formal stannyne complex of the triosmium nucleus, in which the picoline nitrogen is coordinated to the tin atom, and which is itself also reactive, being a potential precursor to high nuclearity SnOs clusters.

Substituent and counterion effects on the formation of p-dimer dications of end-capped heptathienoacenes

We have investigated the impact of the functionalization and the chemical nature of counterions on the p-dimer dications formation in two end-capped heptathienoacenes. Radical cations of an a-substituted heptathienoacene with triisopropylsilyl groups do not p-dimerize, while those of an a,b-substituted heptathienoacene with four n-decyl side chains show a high propensity toward p-dimerization, increased by PF6 ÿ counterions.

Where do drama teacher’s come from? Initial investigations into the formation of professional identity

The article reports on research into what may have influenced trainees on four post-graduate teacher training courses in England to become specialist drama teachers rather than pursue careers in the world of professional entertainment. It goes on to explore how the trainees regarded an understanding of performance, and an ability to both use and demonstrate performance techniques, as integral to their professional role. The subsequent discussion examines how a drama teacher’s professional identity may be seen as being made up of the three inter-connected elements, self, role and character. While all teaching may be regarded as a performing art, this paper suggests that, for the drama specialist, an understanding of what constitutes ‘performance’ has a particular importance. A conclusion drawn from the research is that recognising the place of performance in their practice may result in experienced teachers of drama regarding themselves as artists whose art is teaching drama.

The dependence of contrail formation on the weather pattern and altitude in the North Atlantic

Aircraft flying through cold ice-supersaturated air produce persistent contrails which contribute to the climate impact of aviation. Here, we demonstrate the importance of the weather situation, together with the route and altitude of the aircraft through this, on estimating contrail coverage. The results have implications for determining the climate impact of contrails as well as potential mitigation strategies. Twenty-one years of re-analysis data are used to produce a climatological assessment of conditions favorable for persistent contrail formation between 200 and 300 hPa over the north Atlantic in winter. The seasonal-mean frequency of cold ice-supersaturated regions is highest near 300 hPa, and decreases with altitude. The frequency of occurrence of ice-supersaturated regions varies with large-scale weather pattern; the most common locations are over Greenland, on the southern side of the jet stream and around the northern edge of high pressure ridges. Assuming aircraft take a great circle route, as opposed to a more realistic time-optimal route, is likely to lead to an error in the estimated contrail coverage, which can exceed 50% for westbound north Atlantic flights. The probability of contrail formation can increase or decrease with height, depending on the weather pattern, indicating that the generic suggestion that flying higher leads to fewer contrails is not robust.