Comparação do ajuste dos modelos de morgan-mercer-flodin e de johnson-mehl-avrami na reação de precipitação na liga cu-3%al-5%ag

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Study of the thermal behavior of the transition phase of Co(II)-diclofenac compound by non-isothermal method

The Co(II)-diclofenac complex was evaluated by simultaneous thermogravimetry-differential thermal analysis (TG-DTA) and differential scanning calorimetry (DSC). The DTA curve profile shows one exothermic peak because of the transition phase of the compound between 170 and 180 A degrees C, which was confirmed by X-ray powder diffractometry. The transition phase behavior was studied by DSC curves at several heating rates of a sample mass between 1 and 10 mg in nitrogen atmosphere and in a crucible with and without a lid. Thus, the kinetic parameters were evaluated using an isoconversional non-linear fitting proposed by Capela and Ribeiro. The results show that the activation energy and pre-exponential factor for the transition phase is dependant on the different experimental conditions. Nevertheless, these results indicate that the kinetic compensation effect shows a relationship between them.

Generalização de um modelo linear de impedância eletroquímica

Em geral, a função de um modelo de impedância para processos de eletrodo simples é deduzida de um modelo elétrico equivalente, denominado circuito de Randles. Neste trabalho estudou-se a generalização dessa função, mediante a introdução de um parâmetro não-elétrico, relacionado com a flexibilidade do ângulo de fase e da magnitude. A função foi ajustada às medidas experimentais de impedância obtidas de um sistema constituído de uma liga Ti-10%Al (m/m) em solução de cloreto de sódio 0,9%, variando-se a amplitude de perturbação. Verificou-se que a função generalizada foi adequada para descrever a impedância do sistema analisado, reduzindo as distorções entre a curva experimental e a curva teórica. Além disso, os melhores resultados foram obtidos para sinais de perturbação do sistema com amplitude igual a 10 mV.

Comparação entre análises para permanência no rebanho de vacas Nelore utilizando modelo linear e modelo de limiar

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Quantidade e Duração Silábicas em Português do Brasil

Análise das relações existentes entre as predições dos modelos fonológicos não-lineares (em especial, o de Hayes, 1995) a respeito da quantidade das sílabas e a efetiva realização fonética dessas sílabas em termos de duração, através da consideração de dados extraídos do Projeto Gramática do Português Falado.

Mathematical tool to size rural digesters

Os biodigestores têm sido objetos de grande destaque devido a atual crise de energia e conseqüente busca de fontes alternativas. Outro fator que coloca os biodigestores em evidência é o intenso processo de modernização da agropecuária, que além da grande demanda de energia, produz um volume de resíduos animais e de culturas, que ocasiona muitas vezes problemas de ordem sanitária. O objetivo deste trabalho é fornecer uma ferramenta matemática para determinação de parâmetros para projetos de construção de biodigestores rurais, levando-se em consideração o atendimento de necessidades energéticas, obedecendo os dimensionamentos dos sistemas, fatores de rendimento e garantindo a funcionalidade. Para isto, foram formulados modelos de otimização não lineares, de fácil resolução, para os três principais tipos de biodigestores rurais. Com a resolução destes modelos são determinados a altura e o diâmetro que levem a um volume mínimo para cada tipo, com isto reduz-se a quantidade necessária de materiais de alvenaria e consequentemente o custo do biodigestor é diminuído.

Comportamento da Curva de Lactação de Cabras Mestiças Saanen em Função da Suplementação de Concentrado e do Sistema de Produção

Estudaram-se o comportamento da curva de lactação em 31 cabras mestiças Saanen e o efeito de duas estratégias de suplementação de concentrado: 30% das exigências em energia líquida da 3ª semana até o final da lactação (ESC.1); 60% das exigências em energia líquida diária da 3ª à 13ª semana, e 15% da 14ª semana até o final da lactação (ESC.2), em sistemas de produção semi-confinamento e pastagem. Os seguintes modelos foram avaliados: Wood linear e não-linear, Morant linear e não-linear, D-set e Grossman. O modelo Wood não linear foi o que melhor descreveu o comportamento da curva de lactação. A resposta da estratégia de suplementação com concentrado variou em função do sistema de produção. A estratégia de suplementação com concentrado afetou mais intensamente o comportamento da curva de lactação no sistema de produção semi-confinamento. A estratégia ESC.2, de suplementação com concentrado, resultou em mais dias para atingir o pico de produção, no sistema semi-confinamento, e maior produção no pico em ambos sistemas.

Dark energy parametrizations and their effect on dark halos

There are a plethora of dark energy parametrizations that can fit current supernovae Ia data. However, these data are only sensitive to redshifts up to order one. In fact, many of these parametrizations break down at higher redshifts. In this paper we study the effect of dark energy models on the formation of dark halos. We select a couple of dark energy parametrizations which are sensible at high redshifts and compute their effect on the evolution of density perturbations in the linear and non-linear regimes. Using the Press-Schechter formalism we show that they produce distinguishable signatures in the number counts of dark halos. Therefore, future observations of galaxy clusters can provide complementary constraints on the behaviour of dark energy.

NONLINEAR SCALAR COUPLING MODELS AND PROTON-NUCLEUS SCATTERING OBSERVABLES

The effects of nonlinear scalar field couplings on elastic proton-nucleus scattering observables are investigated using a relativistic impulse approximation. Nonlinear couplings affect in a nontrivial way the effective nucleon mass and the nuclear scalar and vector densities. Modifications on the densities might have observable consequences on scattering observables. Our investigation indicates that the description of the observables for the reactions p-O-16 and p-Ca-40 at 200 MeV are not greatly modified with the use of nonlinear models in comparison with the description using linear models.

On non-ideal simple portal frame structural model: Experimental results under a non-ideal excitation

We present measurements of the non-linear oscillations of a portal frame foundation for a non-ideal motor. We consider a three-time redundant structure with two columns, clamped in their bases and a horizontal beam. An electrical unbalanced motor is mounted at mid span of the beam. Two non-linear phenomena are studied: a) mode saturation and energy transfer between modes; b) interaction between high amplitude motions of the structure and the rotation regime of a real limited power motor. The dynamic characteristics of the structure were chosen to have one-to-two internal resonance between the anti-symmetrical mode (sway motions) and the first symmetrical mode natural frequencies. As the excitation frequency reaches near resonance conditions with the 2nd natural frequency, the amplitude of this mode grows up to a certain level and then it saturates. The surplus energy pumped into the system is transferred to the sway mode, which experiences a sudden increase in its amplitude. Energy is transformed from low amplitude high frequency motion into high amplitude low frequency motion. Such a transformation is potentially dangerous.We consider the fact that real motors, such as the one used in this study, have limited power output. In this case, this energy source is said to be non-ideal, in contrast to the ideal source whose amplitude and frequency are independent of the motion of the structure. Our experimental research detected the Sommerfeld Effect: as the motor accelerates to reach near resonant conditions, a considerable part of its output energy is consumed to generate large amplitude motions of the structure and not to increase its own angular speed. For certain parameters of the system, the motor can get stuck at resonance not having enough power to reach higher rotation regimes. If some more power is available, jump phenomena may occur from near resonance to considerably higher motor speed regimes, no stable motions being possible between these two.

Efficient linear programming algorithm for the transmission network expansion planning problem

The transmission network planning problem is a non-linear integer mixed programming problem (NLIMP). Most of the algorithms used to solve this problem use a linear programming subroutine (LP) to solve LP problems resulting from planning algorithms. Sometimes the resolution of these LPs represents a major computational effort. The particularity of these LPs in the optimal solution is that only some inequality constraints are binding. This task transforms the LP into an equivalent problem with only one equality constraint (the power flow equation) and many inequality constraints, and uses a dual simplex algorithm and a relaxation strategy to solve the LPs. The optimisation process is started with only one equality constraint and, in each step, the most unfeasible constraint is added. The logic used is similar to a proposal for electric systems operation planning. The results show a higher performance of the algorithm when compared to primal simplex methods.

An implicit BEM formulation to model strong discontinuities in solids

A boundary element method (BEM) formulation to predict the behavior of solids exhibiting displacement (strong) discontinuity is presented. In this formulation, the effects of the displacement jump of a discontinuity interface embedded in an internal cell are reproduced by an equivalent strain field over the cell. To compute the stresses, this equivalent strain field is assumed as the inelastic part of the total strain. As a consequence, the non-linear BEM integral equations that result from the proposed approach are similar to those of the implicit BEM based on initial strains. Since discontinuity interfaces can be introduced inside the cell independently on the cell boundaries, the proposed BEM formulation, combined with a tracking scheme to trace the discontinuity path during the analysis, allows for arbitrary discontinuity propagation using a fixed mesh. A simple technique to track the crack path is outlined. This technique is based on the construction of a polygonal line formed by segments inside the cells, in which the assumed failure criterion is reached. Two experimental concrete fracture tests were analyzed to assess the performance of the proposed formulation.

The influence of sintering process and atmosphere on the non-ohmic properties of SnO2 based varistor

The non-ohmic properties of the 98.95% SnO2 + 1.0 CoO + 0.05 Nb2O5 (all in mole%) system, as well as the influence of sintering temperature and atmosphere on these properties, were characterized in this study. The maximum non-linear coefficient (alpha = 32) was obtained for a sintering temperature of 1300 degrees C in an oxygen atmosphere and this maximum is associated with the presence of O in SnO2 grain boundaries, as interface defects. Experimental results also indicate thermionic-type conduction mechanisms, which are associated with the potential barrier of Schottky or Poole-Frenkel types.

Electrical properties of the SnO2-based varistor

The non-linear electrical properties of CoO-doped and Nb205-doped SnO2 ceramics were characterized. X-ray diffraction and scanning electron microscopy indicated that the system is single phase. The electrical conduction mechanism for low applied electrical field was associated with thermionic emission of the Schottky type. An atomic defect model based on the Schottky double-barrier formation was proposed to explain the origin of the potential barrier at the ceramic grain boundaries. These defects create depletion layers at grain boundaries, favouring electron tunnelling at high values of applied electrical field. © 1998 Chapman & Hall.

Droplet formation in cold asymmetric nuclear matter in the quark-meson-coupling model

The quark-meson-coupling model is used to study droplet formation from the liquid-gas phase transition in cold asymmetric nuclear matter. The critical density and proton fraction for the phase transition are determined in the mean field approximation. Droplet properties are calculated in the Thomas-Fermi approximation. The electromagnetic field is explicitly included and its effects on droplet properties are studied. The results are compared with the ones obtained with the NL1 parametrization of the non-linear Walecka model. © 2000 Elsevier Science B.V.