Study of EEPN mitigation using modified RF pilot and Viterbi-Viterbi based phase noise compensation

We propose - as a modification of the optical (RF) pilot scheme -a balanced phase modulation between two polarizations of the optical signal in order to generate correlated equalization enhanced phase noise (EEPN) contributions in the two polarizations. The method is applicable for n-level PSK system. The EEPN can be compensated, the carrier phase extracted and the nPSK signal regenerated by complex conjugation and multiplication in the receiver. The method is tested by system simulations in a single channel QPSK system at 56 Gb/s system rate. It is found that the conjugation and multiplication scheme in the Rx can mitigate the EEPN to within 1/2 orders of magnitude. Results are compared to using the Viterbi-Viterbi algorithm to mitigate the EEPN. The latter method improves the sensitivity more than two orders of magnitude. Important novel insight into the statistical properties of EEPN is identified and discussed in the paper. © 2013 Optical Society of America.

Fetal growth restriction results in remodeled and less efficient hearts in children

Background— Fetal growth restriction (FGR) affects 5% to 10% of newborns and is associated with increased cardiovascular mortality in adulthood. The most commonly accepted hypothesis is that fetal metabolic programming leads secondarily to diseases associated with cardiovascular disease, such as obesity, diabetes mellitus, and hypertension. Our main objective was to evaluate the alternative hypothesis that FGR induces primary cardiac changes that persist into childhood. Methods and Results— Within a cohort of fetuses with growth restriction identified in fetal life and followed up into childhood, we randomly selected 80 subjects with FGR and compared them with 120 normally grown fetuses, matched for gender, birth date, and gestational age at birth. Cardiovascular assessment was performed in childhood (mean age of 5 years). Compared with control subjects, children with FGR had a different cardiac shape, with increased transversal diameters and more globular cardiac ventricles. Although left ejection fraction was similar among the study groups, stroke volume was reduced significantly, which was compensated for by an increased heart rate to maintain output in severe FGR. This was associated with subclinical longitudinal systolic dysfunction (decreased myocardial peak velocities) and diastolic changes (increased E/E' ratio and E deceleration time). Children with FGR also had higher blood pressure and increased intima-media thickness. For all parameters evaluated, there was a linear increase with the severity of growth restriction. Conclusions— These findings suggest that FGR induces primary cardiac and vascular changes that could explain the increased predisposition to cardiovascular disease in adult life. If these results are confirmed, the impact of strategies with beneficial effects on cardiac remodeling should be explored in children with FGR.

Achievable performance gain of IEEE 802.11 multi-rate link adaptation algorithm with cross-layer design

Link quality-based rate adaptation has been widely used for IEEE 802.11 networks. However, network performance is affected by both link quality and random channel access. Selection of transmit modes for optimal link throughput can cause medium access control (MAC) throughput loss. In this paper, we investigate this issue and propose a generalised cross-layer rate adaptation algorithm. It considers jointly link quality and channel access to optimise network throughput. The objective is to examine the potential benefits by cross-layer design. An efficient analytic model is proposed to evaluate rate adaptation algorithms under dynamic channel and multi-user access environments. The proposed algorithm is compared to link throughput optimisation-based algorithm. It is found rate adaptation by optimising link layer throughput can result in large performance loss, which cannot be compensated by the means of optimising MAC access mechanism alone. Results show cross-layer design can achieve consistent and considerable performance gains of up to 20%. It deserves to be exploited in practical design for IEEE 802.11 networks.

Some Comments on Q-Irresolute and Quasi-Irresolute Functions

The aim of this paper is to continue the study of θ-irresolute and quasi-irresolute functions as well as to give an example of a function which is θ-irresolute but neither quasi-irresolute nor an R-map and thus give an answer to a question posed by Ganster, Noiri and Reilly. We prove that RS-compactness is preserved under open, quasi-irresolute surjections.

Deformation Lemma, Ljusternik-Schnirellmann Theory and Mountain Pass Theorem on C1-Finsler Manifolds

∗Partially supported by Grant MM409/94 Of the Ministy of Science and Education, Bulgaria. ∗∗Partially supported by Grant MM442/94 of the Ministy of Science and Education, Bulgaria.

Reach improvement of mode division multiplexed systems using fiber splices

This letter proposes the introduction of discrete modal crosstalk (XT) through fiber splices for the improvement of the distance reach (DR) of mode division multiplexed (MDM) transmission systems over few mode fibers (FMFs). The proposed method increases the DR, reducing the time spread of the FMFs' impulse response. The effectiveness of this method is assessed through simulation considering 3 × 136-Gbit/s MDM-coherently-detected polarization-multiplexed quadrature-phase-shift-keying ultralong haul transmission systems employing inherently low differential mode delay (DMD) FMFs or DMD compensated FMFs. A maximum DR increase factor of 1.9 is obtained for the optimum number of splices per span and optimum splice XT level. © 1989-2012 IEEE.

High performance liquid level monitoring system based on polymer fiber Bragg gratings embedded in silicone rubber diaphragm

Liquid-level sensing technologies have attracted great prominence, because such measurements are essential to industrial applications, such as fuel storage, flood warning and in the biochemical industry. Traditional liquid level sensors are based on electromechanical techniques; however they suffer from intrinsic safety concerns in explosive environments. In recent years, given that optical fiber sensors have lots of well-established advantages such as high accuracy, costeffectiveness, compact size, and ease of multiplexing, several optical fiber liquid level sensors have been investigated which are based on different operating principles such as side-polishing the cladding and a portion of core, using a spiral side-emitting optical fiber or using silica fiber gratings. The present work proposes a novel and highly sensitive liquid level sensor making use of polymer optical fiber Bragg gratings (POFBGs). The key elements of the system are a set of POFBGs embedded in silicone rubber diaphragms. This is a new development building on the idea of determining liquid level by measuring the pressure at the bottom of a liquid container, however it has a number of critical advantages. The system features several FBG-based pressure sensors as described above placed at different depths. Any sensor above the surface of the liquid will read the same ambient pressure. Sensors below the surface of the liquid will read pressures that increase linearly with depth. The position of the liquid surface can therefore be approximately identified as lying between the first sensor to read an above-ambient pressure and the next higher sensor. This level of precision would not in general be sufficient for most liquid level monitoring applications; however a much more precise determination of liquid level can be made by linear regression to the pressure readings from the sub-surface sensors. There are numerous advantages to this multi-sensor approach. First, the use of linear regression using multiple sensors is inherently more accurate than using a single pressure reading to estimate depth. Second, common mode temperature induced wavelength shifts in the individual sensors are automatically compensated. Thirdly, temperature induced changes in the sensor pressure sensitivity are also compensated. Fourthly, the approach provides the possibility to detect and compensate for malfunctioning sensors. Finally, the system is immune to changes in the density of the monitored fluid and even to changes in the effective force of gravity, as might be obtained in an aerospace application. The performance of an individual sensor was characterized and displays a sensitivity (54 pm/cm), enhanced by more than a factor of 2 when compared to a sensor head configuration based on a silica FBG published in the literature, resulting from the much lower elastic modulus of POF. Furthermore, the temperature/humidity behavior and measurement resolution were also studied in detail. The proposed configuration also displays a highly linear response, high resolution and good repeatability. The results suggest the new configuration can be a useful tool in many different applications, such as aircraft fuel monitoring, and biochemical and environmental sensing, where accuracy and stability are fundamental. © (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.

Pseudo-Compact Semi-Topological Groups

Митрофан М. Чобан, Петър Ст. Кендеров, Уорън Б. Муурс - Полу-топологична група (съответно, топологична група) е група, снабдена с топология, относно която груповата оперция произведение е частично непрекъсната по всяка от променливите (съответно, непрекъсната по съвкупност от променливите и обратната операция е също непрекъсната). В настоящата работа ние даваме условия, от топологичен характер, една полу-топологична група да е всъщност топологична група. Например, ние показваме, че всяка сепарабелна псевдокомпактна полу-топологична група е топологична група. Показваме също, че всяка локално псевдокомпактна полу-топологична група, чиято групова операция е непрекъсната по съвкупност от променливите е топологична група.

Measurement and compensation of pivot point positional error on five-axis machines

Measuring and compensating the pivot points of five-axis machine tools is always challenging and very time consuming. This paper presents a newly developed approach for automatic measurement and compensation of pivot point positional errors on five-axis machine tools. Machine rotary axis errors are measured using a circular test. This method has been tested on five-axis machine tools with swivel table configuration. Results show that up to 99% of the positional errors of the rotary axis can be compensated by using this approach.

The impact of parametric noise amplification on long haul transmission throughput

Advanced signal processing, such as multi-channel digital back propagation and mid span optical phase conjugation, can compensate for inter channel nonlinear effects in point to point links. However, once such are effects are compensated, the interaction between the signal and noise fields becomes dominant. We will show that this interaction has a direct impact on the signal to noise ratio improvement, observing that ideal optical phase conjugation offers 1.5 dB more performance benefit than DSP based compensation.

Weighted composition followed by differentiation between weighted Banach spaces of holomorphic functions

2010 Mathematics Subject Classification: 47B33, 47B38.

Vaccines

Vaccines continue to offer the key line of protection against a range of infectious diseases; however, the range of vaccines currently available is limited. One key consideration in the development of a vaccine is risk-versus-benefit, and in an environment of perceived low risk, the benefit of vaccination may not be recognised. To address this, there has been a move towards the use of subunit-based vaccines, which offer low side-effect profiles but are generally weakly immunogenic. This can be compensated for by the development of effective adjuvants. Nanotechnology offers key attributes in this field through the ability of nanoparticulates to incorporate and protect antigens from rapid degradation, combined with their potential to effectively deliver the antigens to appropriate cells within the immune system. These characteristics can be exploited in the development of new adjuvants. This chapter will outline the applications of nanosystems in vaccine formulations and consider the mechanisms of action behind a range of formulations.

The effect of self-focusing on laser space-debris cleaning

A ground-based laser system for space-debris cleaning will use powerful laser pulses that can self-focus while propagating through the atmosphere. We demonstrate that for the relevant laser parameters, this self-focusing can noticeably decrease the laser intensity on the target. We show that the detrimental effect can be, to a great extent, compensated for by applying the optimal initial beam defocusing. The effect of laser elevation on the system performance is discussed.

Passive mode locking in erbium-doped fibre laser by carbon nanotubes

Passively mode locked fibre lasers have a variety of applications ranging from telecommunication to medical photonics. Carbon nanotubes (CNTs) have attracted recently a great deal of attention as a promising solution for saturable absorber elements required for laser mode locking (see e.g. [1-3] and references therein). CNTs can be used as a saturable absorber in passively mode locked fibre laser directly [1,2] or as a CNTs polymer composites [3]. An attractive feature of CNT-based solutions in fibre lasers is a possibility to maintain the compactness, robustness of all-fibre format and low cost through using all standard telecom compatible components. The two important technical challenges in such type of lasers are: (i) to achieve stable polarization properties of the generated radiation without using complex control elements, and, (ii) to avoid low frequency instabilities of the mode-locked pulse train. In this paper we report results of the experiments on mode-locked soliton fibre laser using the following standard components: 1m of highly doped erbium fibre (Liekki Er80-8/125) serves as the gain medium with nominal absorption of 80 dB/m at 1530 nm; a 976 nm laser diode providing up to 310mW power is used to pump the laser via a 980/1550 wavelength division multiplexing; an isolator is employed to ensure single direction oscillation; SMF-28 is used to create necessary amount of anomalous dispersion to form soliton pulse making the total cavity length around 7.83 m; the CNT-polyvinyl alcohol polymer saturable absorber sandwiched in the FC/PC connector is used as a mode-locker device (see [3] for details). © 2011 IEEE.

Help in finding the right balance:leadership, work-family balance and employee outcomes

Although much research has examined employees’ experience of the work-family interface, its conceptualization has been rather problematic, ranging from work and family as mutually constraining through to mutually enriching and, more recently, to work-family balance (WFB). Building on Greenhaus and Allen’s (2011) conceptualization of WFB as comprising satisfaction and effectiveness components, I proposed and tested a model of he antecedents and outcomes of WFB. Based on work-family border theory, I hypothesised that family-supportive supervisor behaviours (FSSB) facilitate WFB and hat the relationship is stronger when the organisation also offers formal support (availability of family-friendly practices (FFPs); enhancement effect). Furthermore, I integrated the leadership and work-family interface literatures by proposing authentic eadership as an antecedent of FSSB. Based on role accumulation theories, I proposed life satisfaction and health as outcomes of WFB satisfaction and WFB effectiveness and job performance as an outcome of only WFB effectiveness. I tested my hypotheses with individual-level data in Study 1 (two waves of data; employees from Germany and the UK) and nested data (individuals nested in teams; two waves of data; employee and supervisor ratings; Germany and the UK) in Study 2. The obtained findings largely supported the hypothesized model and showed that both authentic leadership (Study 1) and team authentic leadership (Study 2) predicted FSSB which, in turn, increased WFB satisfaction and WFB effectiveness. Contrary to my prediction, both studies revealed that FSSB and (team) availability of FFPs compensated for each other, only impacting WFB satisfaction/effectiveness if the other form of family support was not available. Furthermore, both components were positively related to life satisfaction and health, while WFB effectiveness was only related to self-rated performance (Study 1) and not supervisor-rated performance (Study 2). Lastly, the serial moderated mediation model hat tested the conditional indirect effect of (team) authentic leadership on the outcomes received mixed support.