Pore structure characterization of North American shale gas reservoirs using USANS/SANS, gas adsorption, and mercury intrusion

Small-angle and ultra-small-angle neutron scattering (SANS and USANS), low-pressure adsorption (N2 and CO2), and high-pressure mercury intrusion measurements were performed on a suite of North American shale reservoir samples providing the first ever comparison of all these techniques for characterizing the complex pore structure of shales. The techniques were used to gain insight into the nature of the pore structure including pore geometry, pore size distribution and accessible versus inaccessible porosity. Reservoir samples for analysis were taken from currently-active shale gas plays including the Barnett, Marcellus, Haynesville, Eagle Ford, Woodford, Muskwa, and Duvernay shales. Low-pressure adsorption revealed strong differences in BET surface area and pore volumes for the sample suite, consistent with variability in composition of the samples. The combination of CO2 and N2 adsorption data allowed pore size distributions to be created for micro–meso–macroporosity up to a limit of �1000 Å. Pore size distributions are either uni- or multi-modal. The adsorption-derived pore size distributions for some samples are inconsistent with mercury intrusion data, likely owing to a combination of grain compression during high-pressure intrusion, and the fact that mercury intrusion yields information about pore throat rather than pore body distributions. SANS/USANS scattering data indicate a fractal geometry (power-law scattering) for a wide range of pore sizes and provide evidence that nanometer-scale spatial ordering occurs in lower mesopore–micropore range for some samples, which may be associated with inter-layer spacing in clay minerals. SANS/USANS pore radius distributions were converted to pore volume distributions for direct comparison with adsorption data. For the overlap region between the two methods, the agreement is quite good. Accessible porosity in the pore size (radius) range 5 nm–10 lm was determined for a Barnett shale sample using the contrast matching method with pressurized deuterated methane fluid. The results demonstrate that accessible porosity is pore-size dependent.

Neutralization of acid sulfate solutions using bauxite refinery residues and its derivatives

This investigation has shown that by transforming free caustic in red mud (RM) to Bayer hydrotalcite (during the seawater neutralization (SWN) process) enables a more controlled release mechanism for the neutralization of acid sulfate soils. The formation of hydrotalcite has been confirmed by X-ray diffraction (XRD) and differential thermalgravimetric analysis (DTG), while the dissolution of hydrotalcite and sodalite has been observed through XRD, DTG, pH plots, and ICP-OES. Coupling of all techniques enabled three neutralization mechanisms to be determined: (1) free alkali, (2) hydrotalcite dissolution, and (3) sodalite dissolution. The mechanisms are determined on the basis of ICP-OES and kinetic information. When the mass of RM or SWN-RM is greater than 0.08 g/50 mL, the pH of solution increases to a suitable value for plant life with aluminum leaching kept at a minimum. To obtain a neutralization pH greater than 6 in 10 min, the following ratio of bauxite residue (g) in 50 mL with a known iron sulfate (Fe2(SO4)3) concentration can be determined as follows: 0.04 g:50 mL:0.1 g/L of Fe2(SO4)3.

A picture is worth a thousand words : a cross-curricular approach to learning about visuals in STEM

Visuals are a central feature of STEM in all levels of education and many areas of employment. The wide variety of visuals that students are expected to master in STEM prevents an approach that aims to teach students about every type of visual that they may encounter. This paper proposes a pedagogy that can be applied across year levels and learning areas, allowing a school-wide, cross-curricular, approach to teaching about visual, that enhances learning in STEM and all other learning areas. Visuals are classified into six categories based on their properties, unlike traditional methods that classify visuals according to purpose. As visuals in the same category share common properties, students are able to transfer their knowledge from the familiar to unfamiliar in each category. The paper details the classification and proposes some strategies that can be can be incorporated into existing methods of teaching students about visuals in all learning areas. The approach may also assist students to see the connections between the different learning areas within and outside STEM.

Citation success over time : theory or empirics?

This study investigates the citation patterns of theoretical and empirical papers published in a top economics journal, namely American Economic Review, over a period of almost 30 years, while also exploring the determinants of citation success. The results indicate that empirical papers attract more citation success than theoretical studies. However, the pattern over time is very similar. Moreover, among empirical papers it appears that the cross-country studies are more successful than single country studies focusing on North America data or other regions.

Health status of Thai migrants in Brisbane : findings from a cross-sectional investigation

Australia is a multi-ethnic, multi-cultural country with a long history of migration. In 2006, 22% of the population was born overseas. Thai migrants accounted for 0.2% of the population at this time, with a nearly 40% increase from around 19,000 in 1996 to 30,555 in 2006.1 Despite this, little is known about the health of this migrant group. We investigated the health status and health service utilisation of a Thai community through a cross-sectional postal survey conducted from May to September 2010. Participants were members of a Brisbane Thai temple, aged 18 years and older, who self identified as being Thai. Current health status was assessed using the SF-36v22 and self-report of diagnosed medical conditions. Use of health services was assessed using questions adapted from the Welsh Health Survey.3 Socio-demographic variables included gender, age, language spoken at home, year of arrival in Australia and type of health care insurance.

A cross-sectional analysis of patterns of obesity in a cohort of working nurses and midwives in Australia, New Zealand, and the United Kingdom

Objective The aim of this study was to examine the prevalence of overweight and obesity and the association with demographic, reproductive work variables in a representative cohort of working nurses and midwives. Design A cross sectional study of self reported survey data. Settings Australia, New Zealand and the United Kingdom. Methods Measurement outcomes included BMI categories, demographic (age, gender, marital status, ethnicity), reproductive (parity, number of births, mother's age at first birth, birth type and menopausal status) and workforce (registration council, employment type and principal specialty) variables. Participants 4996 respondents to the Nurses and Midwives e-Cohort study who were currently registered and working in nursing or midwifery in Australia (n=3144), New Zealand (n=778) or the United Kingdom (n=1074). Results Amongst the sample 61.87% were outside the healthy weight range and across all three jurisdictions the prevalence of obesity in nurses and midwives exceeded rates in the source populations by 1.73% up to 3.74%. Being overweight or obese was significantly associated with increasing age (35–44 yrs aOR 1.71, 95% CI 1.41–2.08; 45–55 yrs aOR 1.90, 95%CI 1.56–2.31; 55–64 aOR 2.22, 95% CI 1.71–2.88), and male gender (aOR 1.46, 95% CI 1.15–1.87). Primiparous nurses and midwives were more likely to be overweight or obese (aOR 1.37, 95% CI 1.06–1.76) as were those who had reached menopause (aOR 1.37, 95% CI 1.11–1.69). Nurses and midwives in part-time or casual employment had significantly reduced risk of being overweight or obese, (aOR 0.81, 95% CI 0.70–0.94 and aOR 0.75, 95% CI 0.59–0.96 respectively), whilst working in aged carried increased risk (aOR 1.37, 95% CI 1.04–1.80). Conclusion Nurses and midwives in this study have higher prevalence of obesity and overweight than the general population and those who are older, male, or female primiparous and menopausal have significantly higher risk of overweight or obesity as do those working fulltime, or in aged care. The consequences of overweight and obesity in this occupational group may impact on their workforce participation, their management of overweight and obese patients in their care as well as influencing their individual health behaviours and risks of occupational injury and chronic disease.

Learning environments – Laboratories at the cross roads

Laboratories and technical hands on learning have always been a part of Engineering and Science based university courses. They provide the interface where theory meets practice and students may develop professional skills through interacting with real objects in an environment that models appropriate standards and systems. Laboratories in many countries are facing challenges to their sustainable operation and effectiveness. In some countries such as Australia, significantly reduced funding and staff reduction is eroding a once strong base of technical infrastructure. Other countries such as Thailand are seeking to develop their laboratory infrastructure and are in need of staff skill development, management and staff structure in technical areas. In this paper the authors will address the need for technical development with reference to work undertaken in Thailand and Australia. The authors identify the roads which their respective university sectors are on and point out problems and opportunities. It is hoped that the cross roads where we meet will result in better directions for both.

Factors associated with suboptimal adherence to antiretroviral therapy in Viet Nam: A cross-sectional study using audio computer-assisted self-interview (ACASI)

Background: Optimal adherence to antiretroviral therapy (ART) is necessary for people living with HIV/AIDS (PLHIV). There have been relatively few systematic analyses of factors that promote or inhibit adherence to antiretroviral therapy among PLHIV in Asia. This study assessed ART adherence and examined factors associated with suboptimal adherence in northern Viet Nam. Methods: Data from 615 PLHIV on ART in two urban and three rural outpatient clinics were collected by medical record extraction and from patient interviews using audio computer-assisted self-interview (ACASI). Results: The prevalence of suboptimal adherence was estimated to be 24.9% via a visual analogue scale (VAS) of past-month dose-missing and 29.1% using a modified Adult AIDS Clinical Trial Group scale for on-time dose-taking in the past 4 days. Factors significantly associated with the more conservative VAS score were: depression (p < 0.001), side-effect experiences (p < 0.001), heavy alcohol use (p = 0.001), chance health locus of control (p = 0.003), low perceived quality of information from care providers (p = 0.04) and low social connectedness (p = 0.03). Illicit drug use alone was not significantly associated with suboptimal adherence, but interacted with heavy alcohol use to reduce adherence (p < 0.001). Conclusions: This is the largest survey of ART adherence yet reported from Asia and the first in a developing country to use the ACASI method in this context. The evidence strongly indicates that ART services in Viet Nam should include screening and treatment for depression, linkage with alcohol and/or drug dependence treatment, and counselling to address the belief that chance or luck determines health outcomes.

The implications of cross-regional differences for the design of In-vehicle Information Systems : a comparison of Australian and Chinese drivers

The increasing global distribution of automobiles necessitates that the design of In-vehicle Information Systems (IVIS) is appropriate for the regions to which they are being exported. Differences between regions such as culture, environment and traffic context can influence the needs, usability and acceptance of IVIS. This paper describes two studies aimed at identifying regional differences in IVIS design needs and preferences across drivers from Australia and China to determine the impact of any differences on IVIS design. Using a questionnaire and interaction clinics, the influence of cultural values and driving patterns on drivers' preferences for, and comprehension of, surface- and interaction-level aspects of IVIS interfaces was explored. Similarities and differences were found between the two regional groups in terms of preferences for IVIS input control types and labels and in the comprehension of IVIS functions. Specifically, Chinese drivers preferred symbols and Chinese characters over English words and were less successful (compared to Australians) at comprehending English abbreviations, particularly for complex IVIS functions. Implications in terms of the current trend to introduce Western-styled interfaces into other regions with little or no adaptation are discussed.

Cross-calbration of push-broom 2D LIDARs and cameras in natural scenes

This paper addresses the problem of automatically estimating the relative pose between a push-broom LIDAR and a camera without the need for artificial calibration targets or other human intervention. Further we do not require the sensors to have an overlapping field of view, it is enough that they observe the same scene but at different times from a moving platform. Matching between sensor modalities is achieved without feature extraction. We present results from field trials which suggest that this new approach achieves an extrinsic calibration accuracy of millimeters in translation and deci-degrees in rotation.

Improved design rules for fixed ended cold-formed steel columns subject to flexural-torsional buckling

This paper has presented the details of an investigation into the flexural and flexuraltorsional buckling behaviour of cold-formed structural steel columns with pinned and fixed ends. Current design rules for the member capacities of cold-formed steel columns are based on the same non-dimensional strength curve for both fixed and pinned-ended columns. This research has reviewed the accuracy of the current design rules in AS/NZS 4600 and the North American Specification in determining the member capacities of cold-formed steel columns using the results from detailed finite element analyses and an experimental study of lipped channel columns. It was found that the current Australian and American design rules accurately predicted the member capacities of pin ended lipped channel columns undergoing flexural and flexural torsional buckling. However, for fixed ended columns with warping fixity undergoing flexural-torsional buckling, it was found that the current design rules significantly underestimated the column capacities as they disregard the beneficial effect of warping fixity. This paper has therefore proposed improved design rules and verified their accuracy using finite element analysis and test results of cold-formed lipped channel columns made of three cross-sections and five different steel grades and thicknesses.

Carnivore : an investigation into the ways that serial killers in the Silence of the Lambs, American Psycho and Darkly Dreaming Dexter are representative of consumers

Serial killers are among the most popular and enduring character types in contemporary culture. In this exegesis I investigate one of the reasons for this popularity by examining the representational relationships between serial killers and serial consumers. I initially establish that all monsters, whether they are vampires, werewolves or serial killers, emerge from cultural anxieties and signify the anxiety which gave them birth. I go on to identify that the cultural anxiety at play with serial killers is consumerism and in doing so, I identify two key parallels between the serial killer and the consumer, namely a sense of lack and a desire for transformation. I then examine the ways in which the serial killer is representative of the consumer in three exemplar texts, The Silence of the Lambs by Thomas Harris, American Psycho by Bret Easton Ellis and Darkly Dreaming Dexter by Jeff Lindsay. I go on to self-reflexively examine the creation of my novel Carnivore, the accompanying draft of which has been influenced by both the exemplar texts and the findings of the exegesis.