MF_2:Eu,Ce(M=Ca,Sr,Ba)中稀土离子的价态变化

我们已经实验证明并报道了Eu-Tb之间、Ce-Yb之间的电荷转移.本文首次实验证实了Ce~(3+)离子和Eu~(3+)离子之间电荷转移现象的存在,进一步阐述了稀土价态与其电子组态共轭特征的相关性.1 实验部分1.1 试剂CaF_2,SrF_2,BaF_2,NH_4HF_2、氢氟酸、盐酸均为分析纯,EuF_3和CeF_3分别由高纯Eu_2O_3(99.95%)及CeO_2(99.99%)自制.1.2 MF_2:Eu,Ce体系的合成按化学计量比(MF_2:X%CeF_2,y%EuF_3;X=1,y=0,0.1,0.3,0.5,1;X=0,0.05,0.1,0.3,0.5,y=1)准确称取原料,放人玛瑙研钵中充分研混后装入刚玉柑涡中,置于管状炉内(用氢气

氟化镁锶中铕和铽的电荷迁移及其平衡解析

在氩气氛中，合成了SrMgF4：xEu，yTb复合组化物磷光体．该体系中Eu3+和Eu2+共存．随共掺入Tb浓度的增加，Eu3+的荧光发射强度降低，Eu2+的发光增强；并且Eu2+的ESR信号增强．认为Eu3+和Tb3+之间存在电荷迁移．即Eu3+＋Tb3+→Eu2+＋Tb4+.通过半定量手段研究了这一电荷迁移反应的平衡常数

稀土离子和肌质网(Ca~(2+)+Mg~(2+))-ATP酶相互作用的研究

研究了稀土离子对肌质网(Ca~(2+)+MG~(2+))-ATP酶活性的影响及其作用机制,结果表明,低浓度Gd~(3+)对肌质网膜上(Ca~(2+)+Mg~(2+)),ATP酶有激活作用,较高浓度Gd~(3+)抑制其活性,Gd~(3+)抑制纯化酶的活性,低浓度Gd~(3+)对磷脂酸(FA)、心磷脂(CL)重组酶有激活作用,而对磷脂酰胆碱(PC)、磷脂酰胆碱(PC)与磷脂酰乙醇胺(Pe)混合物(PC/PE)及磷脂酰丝氨酸(PS)重组酶无激活作用,低浓度Tb~(3+)对肌质网膜与纯化酶上Ca~(2+)结合位点的影响不同。

INTERLAMINAR FRACTURE OF CARBON THERMOPLASTIC POLYIMIDE COMPOSITES

Mode I interlaminar fracture of a novel amorphous thermoplastic polyimide reinforced with unidirectional carbon fibre has been studied experimentally using double cantilever beam specimens and scanning electron microscopy. Three kinds of composite were ma

ON THE ANALYSIS OF THE END-NOTCHED FLEXURE SPECIMEN FOR MEASURING MODE-II FRACTURE-TOUGHNESS OF COMPOSITE-MATERIALS

This paper deals with the correction of mode II strain energy release rate, G(II), of composite laminates measured with the end-notched flexure (ENF) specimen. A derivation is given of the expressions for compliance and strain energy release rate, in whic

掺铈、钆、铽的三磷酸镧的合成及其光谱

本文首次采用溶液沉淀法合成了一系列LaP_3O_9:Ce、Gd、Tb磷光体.经X射线结构分析表明、它们是较纯的LaP_3O_9相,系环状结构,属于正交晶系,其晶胞参数为a=11.19(?),b=8.54(?),c=7.28(?).测定了这些化合物的激发和发射光谱、相对亮度及Ce~(3+)的荧光寿命,观察到在此基质中Ce~(3+)与Gd~(3+)光谱重叠,它们之间存在着一定的相互作用,Ce~(3+)能有效地敏化Tb~(3+),从而大大地增强Tb~(3+)的发射,LaP_3O_9:Ce、Tb可能成为一种新的高效绿色发光材料.在Ce-Tb共掺的体系中加入少量Gd却使发光亮度稍有下降,这可能是由于Gd~(3+)的竞争吸收和独立发射所致.从Ce~(3+)的荧光寿命变化可知,Ce~(3+)对Gd~(3+)的能量传递较弱,而Ce~(3+)对Tb~(3+)则很有效.

钐-铽-2-噻吩甲酰三氟丙酮-氯代甲基三烷基铵-Triton X-100荧光体系的研究及其分析应用

本文研究了铽(Tb~(3-))对钐(Sm~(3-))-2-噻吩甲酰三氟丙酮(TTA)-氯代甲基三烷基铵(N_(263))-Triton X-100荧光体系的共发光效应,结果表明:Tb~(3-)的浓度1×10~(-5)～5×10~(-5)mol/L范围内体系的荧光强度最大.Sm~(3-)的浓度在1.0×10~(-9)～1.0×10~(-7)mol/L范围内与荧光强度呈线性关系,检测限为1.0X10~(-11)mol/L,方法灵敏,简便,用于混合稀土样品中痕量Sm~(3-)的测定,结果满意。

A NEW THERMOPLASTIC POLYIMIDE COMPOSITE PREPARED BY THE POLYMERIZATION OF MONOMER REACTANTS APPROACH

A novel amorphous thermoplastic polyimide (PTI) is being developed as a potential matrix resin for advanced composites. This paper describes the manufacture of the resin, prepreg, and processing of the composite. The chemical and physical behavior of the resin during the processing was determined by infrared spectroscopy and rheology. The influence of processing conditions on the composite properties was investigated. Mechanical properties of the unidirectional carbon fiber/PTI laminates were also presented.

DETERMINATION OF INITIATION VALUE OF MODE-I INTERLAMINAR FRACTURE-TOUGHNESS OF UNIDIRECTIONAL POLYMER COMPOSITES

The use of interlaminar fracture tests to measure the delamination resistance of unidirectional composite laminates is now widespread. However, because of the frequent occurrence of fiber bridging and multiple cracking during the tests, it leads to artificially high values of delamination resistance, which will not represent the behavior of the laminates. Initiation fracture from the crack starter, on the other hand, does not involve bridging, and should be more representative of the delamination resistance of the composite laminates. Since there is some uncertainty involved in determining the initiation value of delamination resistance in mode I tests in the literature, a power law of the form G(IC) = A.DELTA alpha(b) (where G(IC) is mode I interlaminar fracture toughness and DELTA alpha is delamination growth) is presented in this paper to determine initiation value of mode I interlaminar fracture toughness. It is found that initiation values of the mode I interlaminar fracture toughness, G(IC)(ini), can be defined as the G(IC) value at which 1 mm of delamination from the crack starter has occurred. Examples of initiation values determined by this method are given for both carbon fiber reinforced thermoplastic and thermosetting polymers.

SYNTHESES AND CRYSTAL STRUCTURES OF THE COMPLEXES OF RARE EARTH WITH FUMARIC ACID

Six compounds of M2F3 center dot 1.2H(2)O (M=EU, Ga, Tb, Y, Er, LU: H2F=Fumaric acid) have been synthesized. The structures of Eu(III), T b(III), Y(III), Er(III) and Lu(III) compounds have been determined by singal crystal X-ray diffraction method. The complex of Eu(III) crystallizes in tri-clinic space group P (1) over bar, and the coordination number of Eu3+ is ten. The other four complexes crystallize in monclinic space P2(1)/c, and the coordination numbers of the metal ions are eight. Each of the complexes shows a three-dimensional net structures.

水溶液中稀土离子与甘氨酸、丝氨酸、天冬氨酸作用的~(13)C NMR研究

测定了酸性水溶液中甘氨酸、丝氨酸和天冬氨酸稀土络合物(Ln=La、Pr、Nd、Eu、Tb、Dy、Ho、Er、Tm和Yb)的~(13)C诱导位移。对位移试剂的分析指出,三种氨基酸通过α-羧基以双齿形式配位于稀土,配位键长为0.23nm～0.25nm,天冬氨酸的y-羧基也是配位基团。由本文与文献中已报道的各种氨基酸稀土络合物的~(13)C诱导位移的系统分析表明,配体~(13)C超精细偶合常数A值和结构因子G值有如下规律:(1)│A(C_0)│<│A(C_α)│;A(C_0)为正,A(C_α)为负;(2)│G(C_0)│>│G(C_α)│;配体碳核的G均为负值。

镧系元素钼系双11系列杂多蓝的离析和性质研究

本文首次报道了镧系元素钼系双11系列两电子杂多蓝K_yH_z[Ln(XMo_(11)O_(39)_2]·nH_2O(X=P,Ln=La、Ce、Pr、Nd、Sm、Gd;X=Si,Ln=Ce、Pr、Sm、Tb、Dy;X=Ge、Ln=Dy)的制备和离析方法.并通过元素分析、红外光谱、可见-紫外光谱、极谱、循环伏安、热分析、ESR、~(31)P NMR、XPS对产物进行了表征及性质研究.结果表明:杂多蓝阴离子结构较之还原前发生了轻微畸变,还原电子具有一定的离域性.在溶液中杂多蓝较还原前的杂多酸(盐)具有略强的氧化能力.溶液中杂多蓝的氧化能力Ln-P(2)>Ln-Si(2).热稳定性Ln-P(2)>Ln-Si(2).该系列杂多蓝还具有较好的抗碱解能力.

稀土混合共发光效应的研究——(铽-钆-钇)-铕-噻吩甲酰三氟丙酮-氯化甲基三烷基铵-Triton X-100荧光体系

本文研究了铽(Tb)、钇(Y)、钆(Gd)及它们的混合物对铕(Eu)-噻吩甲酰三氟丙酮(TTA)-氯化甲基三烷基铵(N_(263))-Triton X-100体系的共发光效应,发现稀土离子混合物的共发光效应具有线性加和性,用混合共发光体系不仅能保持单个稀土离子的共发光体系的增敏性,而且抗干扰能力增强,并经过实际样品分析的验证,结果令人满意。

反丁烯二酸稀土配合物的合成及晶体结构

合成了反丁烯二酸C_4H_4O_4与六种稀土(Eu,Gd,Tb,Y,Er,Lu)的配合物M_2F_3·12H_2O(H_2F=C_4H_4O_4).用X 射线衍射法测定了它们的晶体学参数,并测定了其中五种配合物的结构.指出存在两类不同的结构,其中铕配合物为三斜晶系,空间群P(?),铕离子配位数为10.(?)、钇、铒、镥配合物为单斜晶系,空间群为P2_1/c,配位数为8.配合物均具有三维网状结构.

MOLECULAR-GEOMETRY AND CHAIN ENTANGLEMENT - PARAMETERS FOR THE TUBE MODEL

The tube diameter in the reptation model is the distance between a given chain segment and its nearest segment in adjacent chains. This dimension is thus related to the cross-sectional area of polymer chains and the nearest approach among chains, without effects of thermal fluctuation and steric repulsion. Prior calculated tube diameters are much larger, about 5 times, than the actual chain cross-sectional areas. This is ascribed to the local freedom required for mutual rearrangement among neighboring chain segments. This tube diameter concept seems to us to infer a relationship to the corresponding entanglement spacing. Indeed, we report here that the critical molecular weight, M(c), for the onset of entanglements is found to be M(c) = 28 A/([R2]0/M), where A is the chain cross-sectional area and [R2]0 the mean-square end-to-end distance of a freely jointed chain of molecular weight M. The new, computed relationship between the critical number of backbone atoms for entanglement and the chain cross-sectional area of polymers, N(c) = A0,44, is concordant with the cross-sectional area of polymer chains being the parameter controlling the critical entanglement number of backbone atoms of flexible polymers.