(Table 1) Physical properties at DSDP Hole 72-516F

Forty indurated sediment samples from Site 516 were studied to determine the cause of acoustic anisotropy in carbonate- bearing deep-sea sediments. Recovered from sub-bottom depths between 388 and 1222 m, the samples have properties exhibiting the following ranges: wet-bulk density, 1.90-2.49 g/cm3; fractional porosity, 0.45-0.14; carbonate content, 33-88%; compressional-wave velocity (at 0.1 kbar pressure), 1.87-4.87 km/s; and anisotropy, 1-13%. Velocities were measured in three mutually perpendicular directions through the same specimen in 29 of the 40 samples studied. Calcite fabric has been estimated by X-ray pole figure goniometry. The major findings of this study are: 1) Carbonate-bearing deep-sea sediments may be regarded as transversely isotropic media with symmetry axes normal to bedding. 2) Calcite c-axes are weakly concentrated in a direction perpendicular to bedding, but the preferred orientation of calcite does not contribute significantly to velocity anisotropy. 3) The properties of bedded and unbedded samples are distinctly different. Unbedded sediments exhibit low degrees of acoustic anisotropy (1-5%). By contrast, bedded samples show higher degrees of anisotropy (to 13%), and anisotropy increases markedly with depth of burial. Thus, bedding must be regarded as the principal cause of acoustic anisotropy in calcareous, deep-sea sediments.

(Table 1) Grain size composition of recent sediments from the eastern Barents Sea shelf

Based on materials on geomorphology, hydrology, lithology, and sedimentation dynamics obtained during cruises of the P.P. Shirshov Institute of Oceanology in the Barents Sea, the author prepared a number of charts on content of the main particle size facies in shelf surface sediments, as well as a chart of lithologic types of sediments in the Barents Sea. Factors of sedimentation control and basic features of distribution of sedimentary material over its bottom area are taken into consideration.

(Table 1) Pollen analysis of clay-gyttja layers obtained in 1966 near Hitzhusen, north Germany

Bereits im Jahre 1956 wurde bei Baugrund-Aufschlußbohrungen für das zweite Kurmittelhaus in Bad Bramstedt bei einer Serie von 11 Bohrungen - ausgeführt durch die Firma Fritz Eising K. G. in Hamburg - in drei benachbart gelegenen Bohrpunkten an der südlichen Ecke des Gebäudes in einer Teufe von ca. 10 m u. T. eine offensichtlich organogene Schicht von ca. 2 m Mächtigkeit erbohrt. Eines dieser Bohrprofile hat folgenden Aufbau: -5,8 m Fein-Mittelsand, -7,7 m Mittelsand, Fein-Mittelkies, -10,0 m Mittelsand, wenig Kies, -12,0 m Gyttja, -15,0 m Mittelsand, Grobsand. Die bereits wiedergegebene Teufenangabe ist insofern recht interessant, als im Jahre 1966 bei der Brücke über die Bramau bei Hitzhusen, demnach in der Talaue der Bramau in einer Teufe von 8,55 m ebenfalls eine Gyttja erbohrt wurde. Die Tiefenlagen beider Vorkommen scheinen sich demnach relativ zu entsprechen. Das gesamte Profil bei Hitzhusen ist in einigen Punkten abweichend ausgebildet und enthält vor allem noch ein zweites Gyttja-Band in 11,25 m Teufe. Im Einzelnen wurde hier durch die Bohrfirma Paul Hammers A. G., Hamburg, diese Schichtfolge angetroffen: -1.55 m Fein-Mittelsand, Humus, -3,10 m Mittel-Grobsand, Kies, Steine, etwas Lehm, -4,50 m Mittel-Grobsand, -7,20 m Mittel-Grobsand, Kies, -8,00 m Grobsand, -8,55 m Grobsand, Kies, -8,65 m Schluff-Gyttja, -9,70 m Fein-Grobsand, -10,25 m Mittel-Grobsand, Kies, -10,75 m Mittel-Grobsand, -11,25 m Mittel-Grobsand, Schluffstreifen, -11,40 m Schluff-Gyttja, -12,10 m Mittelsand, -12,30 m Mittel-Grobsand, Kies, -17,85 m Geschiebemergel. Die gewonnenen Proben der Schluff-Gyttjen wurden näher untersucht. Da es sich in beiden Fällen um geringmächtige Lagen handelt (0,1 m resp. 0,15 m), und das Material durchaus als stark feinsandig bis schluffig zu bezeichnen ist (das spricht für eine wesentlich schnellere Sedimentation, als die einer reinen biogenen Gyttja), ist der Effekt einer 'Mischprobe' weitgehend ausgeschlossen. Außerdem lagen die Proben - obgleich wahrscheinlich mit einem Ventilbohrer gefördert - als relativ ungestörte Brocken mit erhaltengebliebener Feinschichtung vor. Auf den Schichtflächen waren gröbere Pflanzenreste erkennbar (in der Tabelle angegeben). Der sehr hohe mineralische Anteil läßt zunächst den Verdacht auf sekundären Pollen aufkommen. Keines der beiden pollenanalytisch ermittelten Vegetationsbilder liefert dagegen irgendeine Bestätigung hierfür.

Grain size analysis on core plugs of sediment core CRP-1 (Table 1, 2)

Twenty four core samples from CRP-1, seven from Quaternary strata (20-43.55 meters below sea floor or mbsf) and seventeen from early Miocene strata (43.55 to 147.69 mbsf), have been analysed for their grain-size distribution using standard sieve and Sedigraph techniques. The results are in good agreement with estimates of texture made as part of the visual core description for the 1 :20 core logs for CRP-1 (Cape Roberts Science Team, 1998). Interpretation of the analyses presented here takes into account the likely setting of the site in Quaternary times as it is today, with CRP-1 high on the landward flank of a well-defined submarine ridge rising several hundred metres above basins on either side. In contrast, seismic geometries for strata deposited in early Miocene times indicate a generally planar sea floor dipping gently seaward. Fossils from these strata indicate shallow water depths (< 100 m), indicating the possibility that waves and tidal currents may have influenced sea floor sediments. The sediments analysed here are considered in terms of 3 textural facies: diamict, mud (silt and clay) and sand. Most of the Quaternary section but only 30% of the early Miocene section is diamict, a poorly sorted mixture of sand and mud with scattered clasts, indicating little wave or current influence on its texture. Although not definitive, diamict textures and other features suggest that the sediment originated as basal glacial debris but has been subsequently modified by minor winnowing, consistent with the field interpretation of this facies as ice-proximal and distal glaciomarine sediment. Sediments deposited directly from glacier ice appear to be lacking. Mud facies sediments, which comprise only 10% of the Quaternary section but a third of the early Miocene section, were deposited below wave base and largely from suspension, and show features (described elsewhere in this volume) indicative of the influence of both glacial and sediment gravity flow processes. Sand facies sediments have a considerable proportion of mud, normally more than 20%, but a well-sorted fine-very fine sand fraction. In the context of the early Miocene coastal setting we interpret these sediments as shoreface sands close to wave base.

(Table 1) Carbon and carbonate at DSDP Leg 71 Holes

Leg 71 sediments were analyzed for total carbon and acid-insoluble (organic) carbon, using the Leco WR-12 analyzer, according to the standard technique outlined below. The 3 cm**3 sediment samples were first dried and ground into a homogeneous powder. The ground sediment was redried at 105 to 110°C, and two samples, a 0.1 g and a 0.5 g sample, were weighed into Leco clay crucibles. The 0.5 g sample was acidified with 10% hydrochloric acid and washed with distilled water. The sample was then dried and analyzed for acid-insoluble carbon. The 0.1 g sample was analyzed for total carbon without further treatment. If the sample contained less that 10% CaCO3, an additional 0.5 g sample was analyzed for greater accuracy. The calcium carbonate percentages were calculated as follows: (% total C - % organic C) x 8.33 = % CaCO3. Although other carbonates may be present, all acid-soluble carbon was calculated as calcium carbonate.

(Table 1) Composition of organic matter in bottom sediments from the Kuril-Kamchatka Trench

From results of analyses of sediment samples collected on a profile crossing the Kuril-Kamchatka Trench distribution of organic D, N. carbohydrates, lipids and humic substances was established, as well as nature of their relationship with amorphous silica and clay fraction. Sum of the main biochemical groups of organic matter in the surface layer of sediments (0-1 cm) from the Kuril-Kamchatka Trench amounts to about 15%; neogenetic forms not encountered in living organisms make up 85% of organic matter. Among such forms 26% comprise humic substances formed during initial stages of polymerization of decomposition products of biochemical macromolecules.

(Table 1) Magnetic characteristic properties of selected samples of ODP Hole 134-831B

During Ocean Drilling Program Leg 134 (Vanuatu), geological high sensitivity magnetic tools (GHMT) developed by CEA-LETI and TOTAL were used at two drill sites. GHMT combine two sensors, a proton magnetometer for total magnetic field measurements with an operational accuracy of 0.1 nanoteslas (nT), and a highly sensitive induction tool to measure the magnetic susceptibility with an operational accuracy of a few 10**-6 SI units. Hole 829A was drilled through an accretionary prism and the downhole measurements of susceptibility correlate well with other well-log physical properties. Sharp susceptibility contrasts between chalk and volcanic silt sediment provide complementary data that help define the lithostratigraphic units. At Hole 831B magnetic susceptibility and total field measurements were performed through a 700-m reef carbonate sequence of a guyot deposited on top of an andesitic volcano. The downhole magnetic susceptibility is very low and the amplitude of peak-to-peak anomalies is less than a few 10**-5 SI units. Based on the repeatability of the measurements, the accuracy of the magnetic logging measurements was demonstrated to be excellent. Total magnetic field data at Hole 831B reveal low magnetic anomalies of 0.5 to 5 nT and the measurement of a complete repeat section indicates an accuracy of 0.1 to 0.2 nT. Due to the inclination of the earth's magnetic field in this area (~-40°) and the very low magnetic susceptibility of the carbonate, the contribution of the induced magnetization to the total field measured in the hole is negligible. Unfortunately, because the core recovery was extremely poor (<5%) no detailed comparison between the core measurements and the downhole magnetic data could be made. Most samples have a diamagnetic susceptibility and very low intensity of remanent magnetization (< 10**-4 A/m), but a few samples have a stable remanent magnetization up to 0.005 A/m. These variations of the intensity of the remanent magnetization suggest a very heterogeneous distribution of the magnetization in the carbonate sequence that could explain the magnetic field anomalies measured in these weakly magnetized rocks.

(Table 1) Compositional variation with depth in a nodule of sediment sample RVG-10D

A detailed study of a nodule from the Somali Basin dated by 230Thexcess was correlated with the paleoceanographic events recorded in Site 236 (Leg 24) Deep Sea Drilling Project (DSDP) cores. Tentative indications are that the phase of nodule accretion starting with the development of pillar structure at a depth of 20 mm in the nodule around 13 Ma coincides with increased Antarctic Bottom Water (AABW) flow and an elevated calciumcarbonate compensation depth (CCD). The Late Miocene lowering of the CCD is represented by the mottled zones between 8 and 18 mm in the nodule is characterised by an abundant silicate component (>20%) of aeolian origin. The Miocene/Pliocene boundary (5 Ma) occurs at a depth of about 8 mm and is represented by the development of pillar structure and a minimum of aeolian dust (10.3%). The increased biological productivity of the Somali surface water since the Middle Miocene is demonstrated by the increasing Corg content of the nodule (from 0.11 to 0.19%) towards its surface.

(Table 1) Conditions of vertical near-bottom profiling and the main parameters of the benthic boundary layer in several regions of the Black Sea shelf

Measurements of 14 vertical profiles of currents and hydrological parameters in the near-bottom layer with depth resolution of 0.1 m were carried out in several regions of the Black Sea shelf, at five points over the continental slope, and in three deep water regions. The upper boundary of the benthic boundary layer (BBL) was reliably determined at a point at distance from 5-7 to 35-40 m from the bottom where the gradients of density and current velocity changed. Experimental data obtained were used to determine the coefficient of bottom friction, friction velocity, coefficients of vertical diffusion of momentum and density, and vertical fluxes of temperature and salinity in the BBL.