The productivity effects of cattle tick (Boophilus microplus) infestation on cattle, with particular reference to Bos indicus cattle and their crosses

In response to uncertainty among cattle producers in Australia regarding the need to treat Bos indices and B. indicus crossbreeds, the scientific literature relating to the productivity effects of Boophilus microplus on cattle of all breeds was reviewed. Estimates of the mean effect of each engorging tick (damage coefficient, d) were made from a simple analysis of the reported data. On average, each engorging female tick is responsible for the loss of 1.37 +/- 0.25 g bodyweight in B. taunts cattle. The comparable value for B. taurus x B. indicus cattle is 1.18 +/- 0.21 g/engorging tick. These values were not statistically significantly different, indicating that if a threshold approach to tick control were taken, then the threshold number of standard ticks would be the same regardless of cattle genotype. No studies provided useable estimates of the effect of tick infestation on pure B. indices cattle. An economic threshold for treatment, below which acaricide application is not beneficial, can be predicted, using known values for the cost of acaricide application and the price of beef. However, the application of a threshold approach to control has not been embraced by government advisers and runs contrary to the accepted principals of strategic control programs. (C) 2006 Elsevier B.V. All rights reserved.

Crystallography of carbide-free bainite in a hard bainitic steel

The convergent beam Kikuchi line diffraction technique has been used to accurately determine the orientation relationships between bainitic ferrite and retained austenite in a hard bainitic steel. A reproducible orientation relationship has been uniquely observed for both the upper and lower bainite. It is [GRAPHICS] However, the habit plane of upper bainite is different from that of lower bainite. The former has habit plane that is either within 5 degrees of (221)(A) or of (259)(A). The latter only corresponds with a habit plane that is within 5 degrees of (259)(A). The determined orientation relationship is completely consistent with reported results determined using the same technique with an accuracy of +/- 0.5 degrees in lath martensite in an Fe-20 wt.% Ni-6 wt.% Mn alloy and in a low carbon low alloy steel. It also agrees well with the orientation relationship between granular bainite and austenite in an Fe-19 wt.% Ni-3.5 wt.% Mn-0.15 wt.% C steel. Hence it is believed that, at least from a crystallographic point view, the bainite transformation has the characteristics of martensitic transformation. (c) 2006 Elsevier B.V. All rights reserved.