HVAC system size – getting it right

There is evidence that many heating, ventilating & air conditioning (HVAC) systems, installed in larger buildings, have more capacity than is ever required to keep the occupants comfortable. This paper explores the reasons why this can occur, by examining a typical brief/design/documentation process. Over-sized HVAC systems cost more to install and operate and may not be able to control thermal comfort as well as a “right-sized” system. These impacts are evaluated, where data exists. Finally, some suggestions are developed to minimise both the extent of, and the negative impacts of, HVAC system over-sizing, for example: • Challenge “rules of thumb” and/or brief requirements which may be out of date. • Conduct an accurate load estimate, using AIRAH design data, specific to project location, and then resist the temptation to apply “safety factors • Use a load estimation program that accounts for thermal storage and diversification of peak loads for each zone and air handling system. • Select chiller sizes and staged or variable speed pumps and fans to ensure good part load performance. • Allow for unknown future tenancies by designing flexibility into the system, not by over-sizing. For example, generous sizing of distribution pipework and ductwork will allow available capacity to be redistributed. • Provide an auxiliary tenant condenser water loop to handle high load areas. • Consider using an Integrated Design Process, build an integrated load and energy use simulation model and test different operational scenarios • Use comprehensive Life Cycle Cost analysis for selection of the most optimal design solutions. This paper is an interim report on the findings of CRC-CI project 2002-051-B, Right-Sizing HVAC Systems, which is due for completion in January 2006.

Situated case-based reasoning as a constructive memory model for design reasoning

This paper describes an extended case-based reasoning model that addresses the notion of situatedness in designing through constructive memory. The model is illustrated through an application for predicting the corrosion rate for a specific material on a specific building.

Web-based public participatory GIS

Decision support systems (DSS) have evolved rapidly during the last decade from stand alone or limited networked solutions to online participatory solutions. One of the major enablers of this change is the fastest growing areas of geographical information system (GIS) technology development that relates to the use of the Internet as a means to access, display, and analyze geospatial data remotely. World-wide many federal, state, and particularly local governments are designing to facilitate data sharing using interactive Internet map servers. This new generation DSS or planning support systems (PSS), interactive Internet map server, is the solution for delivering dynamic maps and GIS data and services via the world-wide Web, and providing public participatory GIS (PPGIS) opportunities to a wider community (Carver, 2001; Jankowski & Nyerges, 2001). It provides a highly scalable framework for GIS Web publishing, Web-based public participatory GIS (WPPGIS), which meets the needs of corporate intranets and demands of worldwide Internet access (Craig, 2002). The establishment of WPPGIS provides spatial data access through a support centre or a GIS portal to facilitate efficient access to and sharing of related geospatial data (Yigitcanlar, Baum, & Stimson, 2003). As more and more public and private entities adopt WPPGIS technology, the importance and complexity of facilitating geospatial data sharing is growing rapidly (Carver, 2003). Therefore, this article focuses on the online public participation dimension of the GIS technology. The article provides an overview of recent literature on GIS and WPPGIS, and includes a discussion on the potential use of these technologies in providing a democratic platform for the public in decision-making.

Youth Festival Music Performance : Kingston

Research Background - Young people with negative experiences of mainstream education often display low levels of traditional academic achievement. These young people tend to display considerable cultural and social resources developed through their repeated experiences of adversity. Education research has a duty to provide these young people with opportunities to showcase, assess and translate their social and cultural resources into symbolic forms of capital. This creative work addresses the research question, how can educators maximise the social and cultural capital they help young people acquire through live music performances and studio recordings? Research Contribution - This live music performance, built on existing artistic reputations of the artists, saw the lads support one of their local heroes from Brisbane Hip Hop music scene. In doing so they showcased what their three years of concerted musical engagement can achieve within supportive flexible learning environments. The new knowledge derived from this research focuses on the academic and self confidence benefits for disengaged young people using festival performances as authentic learning activities. Research Significance - This research is significant because it aims to maximise the number of tangible outcomes related to a school-based arts project. The young participants gained technical, artistic, social and commercial status during this project. Individual performances were distributed and downloaded via creative commons licences at the Australian Creative Resource Archive. This performance also contributed to their certified qualifications and acted as pilot research data for two competitively funded ARC grants (DP0209421 & LP0883643)

A forward and backward secure key management in wireless sensor networks for PCS/SCADA

Process Control Systems (PCSs) or Supervisory Control and Data Acquisition (SCADA) systems have recently been added to the already wide collection of wireless sensor networks applications. The PCS/SCADA environment is somewhat more amenable to the use of heavy cryptographic mechanisms such as public key cryptography than other sensor application environments. The sensor nodes in the environment, however, are still open to devastating attacks such as node capture, which makes designing a secure key management challenging. In this paper, a key management scheme is proposed to defeat node capture attack by offering both forward and backward secrecies. Our scheme overcomes the pitfalls which Nilsson et al.'s scheme suffers from, and is not more expensive than their scheme.

Fusion of in-vehicle sensor data to develop Intelligent Driver Training System (IDTS)

The over represented number of novice drivers involved in crashes is alarming. Driver training is one of the interventions aimed at mitigating the number of crashes that involve young drivers. To our knowledge, Advanced Driver Assistance Systems (ADAS) have never been comprehensively used in designing an intelligent driver training system. Currently, there is a need to develop and evaluate ADAS that could assess driving competencies. The aim is to develop an unsupervised system called Intelligent Driver Training System (IDTS) that analyzes crash risks in a given driving situation. In order to design a comprehensive IDTS, data is collected from the Driver, Vehicle and Environment (DVE), synchronized and analyzed. The first implementation phase of this intelligent driver training system deals with synchronizing multiple variables acquired from DVE. RTMaps is used to collect and synchronize data like GPS, vehicle dynamics and driver head movement. After the data synchronization, maneuvers are segmented out as right turn, left turn and overtake. Each maneuver is composed of several individual tasks that are necessary to be performed in a sequential manner. This paper focuses on turn maneuvers. Some of the tasks required in the analysis of ‘turn’ maneuver are: detect the start and end of the turn, detect the indicator status change, check if the indicator was turned on within a safe distance and check the lane keeping during the turn maneuver. This paper proposes a fusion and analysis of heterogeneous data, mainly involved in driving, to determine the risk factor of particular maneuvers within the drive. It also explains the segmentation and risk analysis of the turn maneuver in a drive.

Economic issues in funding and supplying public sector information

In May 2005, a research team began to investigate whether designing and implementing a whole-of-government information licensing framework was possible. This framework was needed to administer copyright in relation to information produced by the government and to deal properly with privately-owned copyright on which government works often rely. The outcome so far is the design of the Government Information Licensing Framework (GILF) and its gradual uptake within a number of Commonwealth and State government agencies. However, licensing is part of a larger issue in managing public sector information (PSI); and it has important parallels with the management of libraries and public archives. Among other things, managing the retention and supply of PSI requires an ability to search and locate information, ability to give public access to the information legally, and an ability to administer charges for supplying information wherever it is required by law. The aim here is to provide a summary overview of pricing principles as they relate to the supply of PSI.

Transactions with chance in the garden

This paper discusses change and chance in order to develop a language that can then be used to discuss change in the garden. In the process, it puts forward the idea that to garden is to meddle with the teleonomy of the plants, their “will” to grow as they should. Different design conceptions of change are discussed, particularly the relation of style to design, suggesting that there is the possibility for a material language that both the discourses of gardening and landscape architecture shares that could negotiate this breach. A model or “transactions” between gardener and garden is put forward to begin to get to grips with the particular methods of “working at a remove”, that is, curating conditions rather than designing objects. The paper finally proposes that landscape architecture has to move away from a paranoid engagement with specifiable objects, to one where the designer grooms conditions and sensibilities, and gets out of the office.

Living walls - a way to green the built environment

Actions Towards Sustainable Outcomes Environmental Issues/Principal Impacts The increasing urbanisation of cities brings with it several detrimental consequences, such as: • Significant energy use for heating and cooling many more buildings has led to urban heat islands and increased greenhouse gas emissions. • Increased amount of hard surfaces, which not only contributes to higher temperatures in cities, but also to increased stormwater runoff. • Degraded air quality and noise. • Health and general well-being of people is frequently compromised, by inadequate indoor air quality. • Reduced urban biodiversity. Basic Strategies In many design situations, boundaries and constraints limit the application of cutting EDGe actions. In these circumstances, designers should at least consider the following: • Living walls are an emerging technology, and many Australian examples function more as internal feature walls. However,as understanding of the benefits and construction of living walls develops this technology could be part of an exterior facade that enhances a building’s thermal performance. • Living walls should be designed to function with an irrigation system using non-potable water. Cutting EDGe Strategies • Living walls can be part of a design strategy that effectively improves the thermal performance of a building, thereby contributing to lower energy use and greenhouse gas emissions. • Including living walls in the initial stages of design would provide greater flexibility to the design, especially of the facade, structural supports, mechanical ventilation and watering systems, thus lowering costs. • Designing a building with an early understanding of living walls can greatly reduce maintenance costs. • Including plant species and planting media that would be able to remove air impurities could contribute to improved indoor air quality, workplace productivity and well-being. Synergies and References • Living walls are a key research topic at the Centre for Subtropical Design, Queensland University of Technology: http://www.subtropicaldesign.bee.qut.edu.au • BEDP Environment Design Guide: DES 53: Roof and Facade Gardens • BEDP Environment Design Guide: GEN 4: Positive Development – Designing for Net Positive Impacts (see green scaffolding and green space frame walls). • Green Roofs Australia: www.greenroofs.wordpress.com • Green Roofs for Healthy Cities USA: www.greenroofs.org

The city is connections : Seoul as an urban network

With the rise of ubiquitous computing in recent years, concepts of spatiality have become a significant topic of discussion in design and development of multimedia systems. This article investigates spatial practices at the intersection of youth, technology, and urban space in Seoul, and examines what the author calls ‘transyouth’: in the South Korean context, these people are between the ages of 18 and 24, situated on the delicate border between digital natives and immigrants in Prensky’s (2001) terms. In the first section, the article sets out the technosocial environment of contemporary Seoul. This is followed by a discussion of social networking processes derived from semi-structured interviews conducted in 2007-8 with Seoul transyouth about their ‘lived experiences of the city.’ Interviewees reported how they interact to play, work, and live with and within the city’s unique environment. The article develops a theme of how technosocial convergence (re)creates urban environments and argues for a need to consider such user-driven spatial recreation in designing cities as (ubiquitous) urban networks in recognition of its changing technosocial contours of connections. This is explored in three spaces of different scales: Cyworld as an online social networking space; cocoon housing – a form of individual residential space which is growing rapidly in many Korean cities – as a private living space; and u-City (ubiquitous City) as the future macro-space of Seoul.

Students’ perceptions of a blended web-based learning environment

The enhanced accessibility, affordability and capability of the Internet has created enormous possibilities in terms of designing, developing and implementing innovative teaching methods in the classroom. As existing pedagogies are revamped and new ones are added, there is a need to assess the effectiveness of these approaches from the students’ perspective. For more than three decades, proven qualitative and quantitative research methods associated with learning environments research have yielded productive results for educators. This article presents the findings of a study in which Getsmart, a teacher-designed website, was blended into science and physics lessons at an Australian high school. Students’ perceptions of this environment were investigated, together with differences in the perceptions of students in junior and senior years of schooling. The article also explores the impact of teachers in such an environment. The investigation undertaken in this study also gave an indication of how effective Getsmart was as a teaching model in such environments.

Promoting interdisciplinarity through mathematical modelling

This article presents one approach to addressing the important issue of interdisciplinarity in the primary school mathematics curriculum, namely, through realistic mathematical modelling problems. Such problems draw upon other disciplines for their contexts and data. The article initially considers the nature of modelling with complex systems and discusses how such experiences differ from existing problem-solving activities in the primary mathematics curriculum. Principles for designing interdisciplinary modelling problems are then addressed, with reference to two mathematical modelling problems— one based in the scientific domain and the other in the literary domain. Examples of the models children have created in solving these problems follow. A reflection on the differences in the diversity and sophistication of these models raises issues regarding the design of interdisciplinary modelling problems. The article concludes with suggested opportunities for generating multidisciplinary projects within the regular mathematics curriculum.

Redundancy in interface design and its impact on intuitive use of a product in older users

Many older adults have difficulty using modern consumer products due to their complexity both in terms of functionality and interface design. It has been observed that older people also have more problems learning new systems. It was hypothesised that designing technological products that are more intuitive for older people to use can solve this problem. An intuitive interface allows a user’s to employ prior knowledge, thus minimizing the learning needed for effective interaction. This paper discusses an experiment investigating the effectiveness of redundancy in interface design. The primary objective of this experiment was to find out if using more than one modality for a product’s interface improves the speed and intuitiveness of interactions for older adults. Preliminary analysis showed strong correlation between technology familiarity and time on tasks, but redundancy in interface design improved speed and accuracy of use only for participants with moderate to high technology familiarity.

Assessment of Speech Dialog Systems using Multi-Modal Cognitive Load Analysis and Driving Performance Metrics

In this paper, cognitive load analysis via acoustic- and CAN-Bus-based driver performance metrics is employed to assess two different commercial speech dialog systems (SDS) during in-vehicle use. Several metrics are proposed to measure increases in stress, distraction and cognitive load and we compare these measures with statistical analysis of the speech recognition component of each SDS. It is found that care must be taken when designing an SDS as it may increase cognitive load which can be observed through increased speech response delay (SRD), changes in speech production due to negative emotion towards the SDS, and decreased driving performance on lateral control tasks. From this study, guidelines are presented for designing systems which are to be used in vehicular environments.

Interventions for co-occurring addictive and other mental disorders (AMDs)

While research on the management of co-occurring addictive and mental disorders (AMDs) has grown substantially in recent years, we still have little guidance on specific strategies. Consideration of epidemiological research and ethical principles can supplement existing clinical trials in providing a way forward. High frequencies of co-occurring disorders, equity of access for affected individuals and potential clashes between services in priorities and procedures, suggest that a stepped model of care by a single service may often be required. Typically, problems are multiple rather than dual, with potential for mutual influence, suggesting a need for interventions that are sensitive to and encompass complex co-occurring problems. Motivational problems are endemic, initial gains are often partial and unstable, and relapses potentially have serious consequences, suggesting a need for long-term, assertive follow-up. Principles such as these provide a solid framework for designing both services and interventions. However, there is a continuing need for controlled trials that unpack effective components of interventions, and increase their impact.