999 resultados para ATLAS, Pixel Detector, ROD, LHC, CERN
Resumo:
Sulfadiazine is an antibiotic of the sulfonamide group and is used as a veterinary drug in fish farming. Monitoring it in the tanks is fundamental to control the applied doses and avoid environmental dissemination. Pursuing this goal, we included a novel potentiometric design in a flow-injection assembly. The electrode body was a stainless steel needle veterinary syringe of 0.8-mm inner diameter. A selective membrane of PVC acted as a sensory surface. Its composition, the length of the electrode, and other flow variables were optimized. The best performance was obtained for sensors of 1.5-cm length and a membrane composition of 33% PVC, 66% onitrophenyloctyl ether, 1% ion exchanger, and a small amount of a cationic additive. It exhibited Nernstian slopes of 61.0 mV decade-1 down to 1.0×10-5 mol L-1, with a limit of detection of 3.1×10-6 mol L-1 in flowing media. All necessary pH/ionic strength adjustments were performed online by merging the sample plug with a buffer carrier of 4-(2-hydroxyethyl)-1-piperazineethanesulfonic acid, pH 4.9. The sensor exhibited the advantages of a fast response time (less than 15 s), long operational lifetime (60 days), and good selectivity for chloride, nitrite, acetate, tartrate, citrate, and ascorbate. The flow setup was successfully applied to the analysis of aquaculture waters. The analytical results were validated against those obtained with liquid chromatography–tandem mass spectrometry procedures. The sampling rate was about 84 samples per hour and recoveries ranged from 95.9 to 106.9%.
Resumo:
Dissertação de Mestrado em Gestão do Território, Área de Especialização em Detecção Remota e Sistemas de Informação Geográfica
Resumo:
Dissertação apresentada para cumprimento dos requisitos necessários à obtenção do grau de Mestre em Gestão do Território,
Resumo:
Dissertação apresentada como requisito parcial para obtenção do grau de Mestre em Estatística e Gestão de Informação.
Resumo:
Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.
Resumo:
O desenvolvimento das tecnologias associadas à Detecção Remota e aos Sistemas de Informação Geográfica encontram-se cada vez mais na ordem do dia. E, graças a este desenvolvimento de métodos para acelerar a produção de informação geográfica, assiste-se a um crescente aumento da resolução geométrica, espectral e radiométrica das imagens, e simultaneamente, ao aparecimento de novas aplicações com o intuito de facilitar o processamento e a análise de imagens através da melhoria de algoritmos para extracção de informação. Resultado disso são as imagens de alta resolução, provenientes do satélite WorldView 2 e o mais recente software Envi 5.0, utilizados neste estudo. O presente trabalho tem como principal objectivo desenvolver um projecto de cartografia de uso do solo para a cidade de Maputo, com recurso ao tratamento e à exploração de uma imagem de alta resolução, comparando as potencialidades e limitações dos resultados extraídos através da classificação “pixel a pixel”, através do algoritmo Máxima Verossimilhança, face às potencialidades e eventuais limitações da classificação orientada por objecto, através dos algoritmos K Nearest Neighbor (KNN) e Support Vector Machine (SVM), na extracção do mesmo número e tipo de classes de ocupação/uso do solo. Na classificação “pixel a pixel”, com a aplicação do algoritmo classificação Máxima Verosimilhança, foram ensaiados dois tipos de amostra: uma primeira constituída por 20 classes de ocupação/uso do solo, e uma segunda por 18 classes. Após a fase de experimentação, os resultados obtidos com a primeira amostra ficaram aquém das espectativas, pois observavam-se muitos erros de classificação. A segunda amostra formulada com base nestes erros de classificação e com o objectivo de os minimizar, permitiu obter um resultado próximo das espectativas idealizadas inicialmente, onde as classes de interesse coincidem com a realidade geográfica da cidade de Maputo. Na classificação orientada por objecto foram 4 as etapas metodológicas utilizadas: a atribuição do valor 5 para a segmentação e 90 para a fusão de segmentos; a selecção de 15 exemplos sobre os segmentos gerados para cada classe de interesse; bandas diferentemente distribuídas para o cálculo dos atributos espectrais e de textura; os atributos de forma Elongation e Form Factor e a aplicação dos algoritmos KNN e SVM. Confrontando as imagens resultantes das duas abordagens aplicadas, verificou-se que a qualidade do mapa produzido pela classificação “pixel a pixel” apresenta um nível de detalhe superior aos mapas resultantes da classificação orientada por objecto. Esta diferença de nível de detalhe é justificada pela unidade mínima do processamento de cada classificador: enquanto que na primeira abordagem a unidade mínima é o pixel, traduzinho uma maior detalhe, a segunda abordagem utiliza um conjunto de pixels, objecto, como unidade mínima despoletando situações de generalização. De um modo geral, a extracção da forma dos elementos e a distribuição das classes de interesse correspondem à realidade geográfica em si e, os resultados são bons face ao que é frequente em processamento semiautomático.
Resumo:
Application of Experimental Design techniques has proven to be essential in various research fields, due to its statistical capability of processing the effect of interactions among independent variables, known as factors, in a system’s response. Advantages of this methodology can be summarized in more resource and time efficient experimentations while providing more accurate results. This research emphasizes the quantification of 4 antioxidants extraction, at two different concentration, prepared according to an experimental procedure and measured by a Photodiode Array Detector. Experimental planning was made following a Central Composite Design, which is a type of DoE that allows to consider the quadratic component in Response Surfaces, a component that includes pure curvature studies on the model produced. This work was executed with the intention of analyzing responses, peak areas obtained from chromatograms plotted by the Detector’s system, and comprehending if the factors considered – acquired from an extensive literary review – produced the expected effect in response. Completion of this work will allow to take conclusions regarding what factors should be considered for the optimization studies of antioxidants extraction in a Oca (Oxalis tuberosa) matrix.
Resumo:
In this thesis was investigated the radiation hardness of the building blocks of a future flexible X-ray sensor system. The characterized building blocks for the pixel addressing and signal amplification electronics are high mobility semiconducting oxide transistors (HMSO-TFTs) and organic transistors (OTFTs), whereas the photonic detection system is based on organic semiconducting single crystals (OSSCs). TFT parameters such as mobility, threshold voltage and subthreshold slope were measured as function of cumulative X-ray dose. Instead for OSSCs conductivity and X-ray sensitivity were analysed after various radiation steps. The results show that ionizing radiation does not lead to degradation in HMSO-TFTs. Instead OTFTs show instability in mobility which is reduced up to 73% for doses of 1 kGy. OSSC demonstrate stable detector properties for the tested total dose range. As conclusion, HMSO-TFTs and OSSCs can be readily employed in the X-ray detector system allowing operation for total doses exceeding 1 kGy of ionizing radiation.
Resumo:
PURPOSE: To illustrate the radiological findings and review the current literature concerning a rare congenital abnormality of the posterior arch of the atlas. CASE REPORT: An adult female without neurological symptoms presented with an absent posterior arch of the atlas, examined with plain films and helical computerized tomography. Complete agenesis of the posterior arch of the atlas is a rare entity that can be easily identified by means of plain films. Although it is generally asymptomatic, atlantoaxial instability and neurological deficits may occur because of structural instability. Computerized tomography provides a means of assessing the extent of this abnormality and can help evaluate the integrity of neural structures. Although considered to be rare entities, defects of the posterior arch of the atlas may be discovered as incidental asymptomatic findings in routine cervical radiographs. Familiarity with this abnormality may aid medical professionals in the correct management of these cases.
Resumo:
Positioning technologies are becoming ubiquitous and are being used more and more frequently for supporting a large variety of applica- tions. For outdoor applications, global navigation satellite systems (GNSSs), such as the global positioning system (GPS), are the most common and popular choice because of their wide coverage. GPS is also augmented with network-based systems that exploit existing wireless and mobile networks for providing positioning functions where GPS is not available or to save energy in battery-powered devices. Indoors, GNSSs are not a viable solution, but many applications require very accurate, fast, and exible positioning, tracking, and navigation functions. These and other requirements have stim- ulated research activities, in both industry and academia, where a variety of fundamental principles, techniques, and sensors are being integrated to provide positioning functions to many applications. The large majority of positioning technologies is for indoor environments, and most of the existing commercial products have been developed for use in of ce buildings, airports, shopping malls, factory plants, and similar spaces. There are, however, other spaces where positioning, tracking, and navigation systems play a central role in safety and in rescue operations, as well as in supporting speci c activities or for scienti c research activities in other elds. Among those spaces are underground tunnels, mines, and even underwater wells and caves. This chapter describes the research efforts over the past few years that have been put into the development of positioning systems for underground tun- nels, with particular emphasis in the case of the Large Hadron Collider (LHC) at CERN (the European Organization for Nuclear Research), where localiza- tion aims at enabling more automatic and unmanned radiation surveys. Examples of positioning and localization systems that have been devel- oped in the past few years for underground facilities are presented in the fol- lowing section, together with a brief characterization of those spaces’ special conditions and the requirements of some of the most common applications. Section 5.2 provides a short overview of some of the most representative research efforts that are currently being carried out by many research teams around the world. In addition, some of the fundamental principles and tech- niques are identi ed, such as the use of leaky coaxial cables, as used at the LHC. In Section 5.3, we introduce the speci c environment of the LHC and de ne the positioning requirements for the envisaged application. This is followed by a detailed description of our approach and the results that have been achieved so far. Some last comments and remarks are presented in a nal section.
Resumo:
v.1
Resumo:
v.2
Resumo:
v.3
Resumo:
v.4
