Analytical expressions for the FM and AM responses of an integrated laser-modulator

The need for low-chirp and compact transmitters for high-bit-rate optical links has led to the development of integrated laser electroabsorption modulators (ILM). We have investigated feedback effects inducing frequency chirp by developing a model treating the ILM as a whole and obtained analytical expressions of the FM and AM responses. The variation of the frequency chirp with the residual facet reflectivity of the modulator section is calculated. The model predicts the unusual peak in the measured frequency responses and has been used to define design rules.

Optic neuropathy in sheep associated with overdosage of closantel

This report describes clinical and pathological findings in 2 flocks in Brazil where blindness and deaths in sheep occurred after closantel overdosage. Depression, weakness, and blindness affected 37 animals and 17 died in 2 flocks of 190 animals. Two animals submitted for ophthalmic examination showed no inflammation in the anterior segment of both eyes; posterior segment evaluation by indirect ophthalmoscopy suggested retinal degeneration. One postmortem evaluation local spongy vacuolization was in several regions of the brain and the optical nerves had severe axonal degeneration.

Escape in a nonideal electro-mechanical system

In this work a particular system is investigated consisting of a pendalum whose point of support is vibrated along a horizontal guide by a two bar linkage driven from a DC motor, considered as a limited power source. This system is nonideal since the oscillatory motion of the pendulum influences the speed of the motor and vice-versa, reflecting in a more complicated dynamical process. This work comprises the investigation of the phenomena that appear when the frequency of the pendulum draws near a secondary resonance region, due to the existing nonlinear interactions in the system. Also in this domain due to the power limitation of the motor, the frequency of the pendulum can be captured at resonance modifying completely the final response of the system. This behavior is known as Sommerfield effect and it will be studied here for a nonlinear system.

Electro-hydraulic actuator tester for fly-by-wire aircrafts

An 8051-based microcontroller tester has been designed to reduce troubleshooting time of the Electro-Hydraulic Actuators (EHA) installed in fly-by-wire aircrafts. The tester algorithm first evaluates EHA pressure and position sensor signals to emit either a pass or fail message. The evaluation is based on predefined ranges of EHA pressure and position signals. Next, the instrument tests the EHA response capability - a way of dynamic response evaluation, again issuing a suitable response. The instrument proved to be reliable after being successfully evaluated in laboratory and in a real model test airplane. © 2007 IEEE.

Swarm control designs applied to a micro-electro-mechanical gyroscope system (MEMS)

This paper analyzes the non-linear dynamics of a MEMS Gyroscope system, modeled with a proof mass constrained to move in a plane with two resonant modes, which are nominally orthogonal. The two modes are ideally coupled only by the rotation of the gyro about the plane's normal vector. We demonstrated that this model has an unstable behavior. Control problems consist of attempts to stabilize a system to an equilibrium point, a periodic orbit, or more general, about a given reference trajectory. We also developed a particle swarm optimization technique for reducing the oscillatory movement of the nonlinear system to a periodic orbit. © 2010 Springer-Verlag.

Factors affecting the adoption of supply chain management practices: Evidence from the Brazilian electro-electronic sector

This study on the factors affecting the adoption of supply chain management (SCM) practices develops four hypotheses based on a literature review, and tests them using survey data of Brazilian electro-electronic firms. The results reveal the big picture of the SCM practices in the sector and suggest that contextual factors such as size, position and bargaining power affect the adoption of SCM practices, which are also more customer oriented. Sector characteristics are very important in analysing SCM practices. Contrary to the findings of literature, the relationship between competitive priorities and SCM practices was not supported statistically. © 2011.

Supply Chain Management practices in the electro-electronics sector in Brazil: Evolutionary approach, information technology adoption and management actions

This paper examines the current level of adoption of Supply Chain Management (SCM) practices in the electro-electronic sector in Brazil and aims to identify the management and Information Technology (IT) actions that have been implemented to support the adoption of those practices. An e-mail survey was conducted. Descriptive statistics techniques were employed for data analysis. This study makes contributions to the electro-electronics sector and to the topics related to SCM, such as identifi cation and level of adoption of SCM practices. Another contribution of this research is the investigation of whether approaches such as Enterprise Resources Planning (ERP), Workshop with Customers, Electronic Data Interchange (EDI), Workshop with Suppliers and electronic Kanban are commonly used to support SCM practices. So far, this is the fi rst research on SCM practices in the electro-electronics sector in Brazil. Copyright © 2012 Inderscience Enterprises Ltd.

Electrocatalytic activity under oscillatory regime: The electro-oxidation of formic acid on ordered Pt3Sn intermetallic phase

Despite the considerable progress in the understanding of the mechanistic aspects of the oscillatory electro-oxidation of C1 molecules, there are apparently no systematic studies concerning the impact of surface modifiers on the oscillation dynamics. Herein we communicate on the oscillatory electro-oxidation of formic acid on ordered Pt3Sn intermetallic phase, and compare the results with those obtained on a polycrystalline platinum electrode. Overall, the obtained results were very reproducible, robust and allowed a detailed analysis on the correlation between the catalytic activity and the oscillation dynamics. The presence of Sn in the intermetallic electrode promotes drastic effects on the oscillatory dynamics. The decrease in the mean electrode potential and in the oscillation frequency, as well as the pronounced increase in the number oscillations (and also in the oscillation time), was discussed in connection with the substantial catalytic enhancement of the Pt3Sn towards the electro-oxidation of formic acid. The self-organized potential oscillations were used to probe the electrocatalytic activity of the Pt3Sn electrode and compare it with that for polycrystalline Pt. The presence of Sn resulted in a significant decrease (2-11 times, depending on the applied current) of the rate of surface poisoning. © 2012 Elsevier B.V.

Optimal linear control to parametric uncertainties in a micro electro mechanical system

This paper, a micro-electro-mechanical systems (MEMS) with parametric uncertainties is considered. The non-linear dynamics in MEMS system is demonstrated with a chaotic behavior. We present the linear optimal control technique for reducing the chaotic movement of the micro-electromechanical system with parametric uncertainties to a small periodic orbit. The simulation results show the identification by linear optimal control is very effective. © 2013 Academic Publications, Ltd.

The electro-oxidation of carbon monoxide and ethanol on supported Pt nanoparticles: The influence of the support and catalyst microstructure

The sluggish kinetics of ethanol oxidation on Pt-based electrodes is one of the major drawbacks to its use as a liquid fuel in direct ethanol fuel cells, and considerable efforts have been made to improve the reaction kinetics. Herein, we report an investigation on the effect of the Pt microstructure (well-dispersed versus agglomerated nanoparticles) and the catalyst support (carbon Vulcan, SnO2, and RuO2) on the rate of the electrochemical oxidation of ethanol and its major adsorbed intermediate, namely, carbon monoxide. By using several structural characterization techniques such as X-ray diffraction, X-ray absorption spectroscopy, and transmission electron microscopy, along with potentiodynamic and potentiostatic electrochemical experiments, we show that by altering both the Pt microstructure and the support, the rate of the electrochemical oxidation of ethanol can be improved up to a factor of 12 times compared to well-dispersed carbon-supported Pt nanoparticles. As a result of a combined effect, the interaction of Pt agglomerates with SnO2 yielded the highest current densities among all materials studied. The differences in the activity are discussed in terms of structural and electronic properties as well as by mass transport effects, providing valuable insights to the development of more active materials. © 2013 Springer-Verlag Berlin Heidelberg.

Ethanol electro-oxidation in an alkaline medium using Pd/C, Au/C and PdAu/C electrocatalysts prepared by electron beam irradiation

Carbon-supported Pd, Au and bimetallic PdAu (Pd:Au 90:10, 50:50 and 30:70 atomic ratios) electrocatalysts were prepared using electron beam irradiation. The obtained materials were characterized by energy dispersive X-ray analysis (EDX), X-ray diffraction (XRD) and transmission electron microscopy (TEM), and their catalytic activities toward ethanol electro-oxidation were evaluated in an alkaline medium using electrochemical techniques, in situ attenuated total reflectance Fourier transformed infrared spectroscopy (ATR-FTIR) analysis and a single alkaline direct ethanol fuel cell (ADEFC). EDX analyses showed that the actual Pd: Au atomic ratios were very similar to the nominal ones. X-ray diffractograms of PdAu/C electrocatalysts evidenced the presence of Pd-rich (fcc) and Au-rich (fcc) phases. TEM analysis showed a homogeneous dispersion of nanoparticles on the carbon support, with an average size in the range of 3-5 nm and broad size distributions. Cyclic voltammetry (CV) and chronoamperometry (CA) experiments revealed the superior ambient activity toward ethanol electro-oxidation of PdAu/C electrocatalysts with Pd: Au ratios of 90:10 and 50:50. In situ ATR-FTIR spectroscopy measurements have shown that the mechanism for ethanol electro-oxidation is dependent on catalyst composition, leading to different reaction products, such as acetaldehyde and acetate, depending on the number of electrons transferred. Experiments on a single ADEFC were conducted between 50 and 900 C, and the best performance of 44 mW cm-2 in 2.0molL-1 ethanol was obtained at 850C for the Pd:Au 90:10 catalysts. This superior performance is most likely associated with enhancement of ethanol adsorption on Pd, oxidation of the intermediates, the presence of gold oxide-hydroxyl species, low mean particle diameters and better distribution of particles on the support. © 2013 Elsevier Ltd. All rights reserved.

Colaboración entre los países miembros del CAME y los de América Latina en la construcción de centrales hidroeléctricas y en otras esferas de la industria electro-energética: situación actual y perspectivas

Incluye Bibliografía

Estudo da orientação dipolar fotoassistida de grupos azobenzênicos em filmes finos através de medidas da atividade eletro-óptica

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Periostin as a modulator of chronic cardiac remodeling after myocardial infarction

OBJECTIVE: After acute myocardial infarction, during the cardiac repair phase, periostin is released into the infarct and activates signaling pathways that are essential for the reparative process. However, the role of periostin in chronic cardiac remodeling after myocardial infarction remains to be elucidated. Therefore, the objective of this study was to investigate the relationship between tissue periostin and cardiac variables in the chronic cardiac remodeling induced by myocardial infarction. METHODS: Male Wistar rats were assigned to 2 groups: a simulated surgery group (SHAM; n = 8) and a myocardial infarction group (myocardial infarction; n = 13). After 3 months, morphological, functional and biochemical analyses were performed. The data are expressed as means±SD or medians (including the lower and upper quartiles). RESULTS: Myocardial infarctions induced increased left ventricular diastolic and systolic areas associated with a decreased fractional area change and a posterior wall shortening velocity. With regard to the extracellular matrix variables, the myocardial infarction group presented with higher values of periostin and types I and III collagen and higher interstitial collagen volume fractions and myocardial hydroxyproline concentrations. In addition, periostin was positively correlated with type III collagen levels (r = 0.673, p = 0.029) and diastolic (r = 0.678, p = 0.036) and systolic (r = 0.795, p = 0.006) left ventricular areas. Considering the relationship between periostin and the cardiac function variables, periostin was inversely correlated with both the fractional area change (r = -0.783, p = 0.008) and the posterior wall shortening velocity (r = -0.767, p = 0.012). CONCLUSIONS: Periostin might be a modulator of deleterious cardiac remodeling in the chronic phase after myocardial infarction in rats.

Long-Lasting Oscillations in the Electro-Oxidation of Formic Acid on PtSn Intermetallic Surfaces

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)