Age and chemical composition of apatites from five DSDP and ODP Sites in the Pacific, Atlantic and Indian Oceans

Since studies on deep-sea cores were carried out in the early 1990s it has been known that ambient temperature may have a marked affect on apatite fission track annealing. Due to sluggish annealing kinetics, this effect cannot be quantified by laboratory annealing experiments. The unknown amount of low-temperature annealing remains one of the main uncertainties for extracting thermal histories from fission track data, particularly for samples which experienced slow cooling in shallow crustal levels. To further elucidate these uncertainties, we studied volcanogenic sediments from five deep-sea drill cores, that were exposed to maximum temperatures between ~10° and 70°C over geological time scales of ~15-120 Ma. Mean track lengths (MTL) and etch pit diameters (Dpar) of all samples were measured, and the chemical composition of each grain analyzed for age and track length measurements was determined by electron microprobe analysis. Thermal histories of the sampled sites were independently reconstructed, based on vitrinite reflectance measurements and/or 1D numerical modelling. These reconstructions were used to test the most widely used annealing models for their ability to predict low-temperature annealing. Our results show that long-term exposure to temperatures below the temperature range of the nominal apatite fission track partial annealing zone results in track shortening ranging between 4 and 11%. Both chlorine content and Dpar values explain the downhole annealing patterns equally well. Low chlorine apatite from one drill core revealed a systematic relation between Si-content and Dpar value. The question whether Si-substitution in apatite has direct and systematic effects on annealing properties however, cannot be addressed by our data. For samples, which remained at temperatures <30°C, and which are low in chlorine, the Laslett et al. [Laslett G., Green P., Duddy I. and Gleadow A. (1987) Thermal annealing of fission tracks in apatite. Chem. Geol. 65, 1-13] annealing model predicts MTL up to 0.6 µm longer than those actually measured, whereas for apatites with intermediate to high chlorine content, which experienced temperatures >30°C, the predictions of the Laslett et al. (1987) model agree with the measured MTL data within error levels. With few exceptions, predictions by the Ketcham et al. [Ketcham R., Donelick R. and Carlson W. (1999) Variability of apatite fission-track annealing kinetics. III: Extrapolation to geological time scales. Am. Mineral. 84/9, 1235-1255] annealing model are consistent with the measured data for samples which remained at temperatures below ~30°C. For samples which experienced maximum temperatures between ~30 and 70°C, and which are rich in chlorine, the Ketcham et al. (1999) model overestimates track annealing.

Radionuclides in ice cores I and II from Vernagferner, Austria

Fission product (90Sr-90Y, 137Cs, total beta) and 21OPb-210Po activities were measured in core samples from the temperate vernagtferner (3150 m altitude, Oetztal Alps, Austria). The results show that the investigated fission products are transported with water resulting from melting processes, and are sorbed on dust or dirt horizons. These products are, therefore, not suited for dating temperate glaciers. 210Pb is also transported with water and displaced from its original deposition. However, despite large fluctuations, the specific activity of 210Pb decreases with depth, and can be used to estimate accumulation rates and the age of the ice. The average annual accumulation rate amounts to about 80 cm water equivalent, and the deepest sample (81 m i.e. ab. 65 m w. e.) was deposited in the beginning of this century. These results agree with data obtained from other observations on this glacier and show that the 210Pb_method is suitable to date temperate glaciers, if the ice cores cover a time interval of about 100 years (i.e. ab. 4 half-lives of 210Pb). The surface activity of 210Pb was found to be 5 ± 1 dpm per kg of ice in agreement with other locations in the Alps and with measurements of fresh snow.