Fatal contact shot to the chest caused by the gas jet from a muzzle-loading pistol discharging only black powder and no bullet: case study and experimental simulation of the wounding effect.

In modern medico-legal literature, only a small number of publications deal with fatal injuries from black powder guns. Most of them focus on the morphological features such as intense soot soiling, blast tattooing and burn effects in close-range shots or describe the wound ballistics of spherical lead bullets. Another kind of "unusual" and potentially lethal weapons are handguns destined for firing only blank cartridges such as starter and alarm pistols. The dangerousness of these guns is restricted to very close and contact range shots and results from the gas jet produced by the deflagration of the propellant. The present paper reports on a suicide committed with a muzzle-loading percussion pistol cal. 45. An unusually large stellate entrance wound was located in the precordial region, accompanied by an imprint mark from the ramrod and a faint greenish discoloration (apparently due to the formation of sulfhemoglobin). Autopsy revealed an oversized powder cavity, multiple fractures of the anterior thoracic wall as well as ruptures of the heart, the aorta, the left hepatic lobe and the diaphragm. In total, the zone of mechanical destruction had a diameter of approx. 15 cm. As there was no exit wound and no bullet lodged in the body, the injury was caused exclusively by the inrushing combustion gases of the propellant (black powder) comparable with the gas jet of a blank cartridge gun. In contact shots to ballistic gelatine using the suicide's pistol loaded with black powder but no projectile, the formation of a nearly spherical cavity could be demonstrated by means of a high-speed camera. The extent of the temporary cavity after firing with 5 g of black powder roughly corresponded to the zone of destruction found in the suicide's body.

Loss to follow-up of HIV-infected women after delivery: The Swiss HIV Cohort Study and the Swiss Mother and Child HIV Cohort Study.

INTRODUCTION HIV-infected pregnant women are very likely to engage in HIV medical care to prevent transmission of HIV to their newborn. After delivery, however, childcare and competing commitments might lead to disengagement from HIV care. The aim of this study was to quantify loss to follow-up (LTFU) from HIV care after delivery and to identify risk factors for LTFU. METHODS We used data on 719 pregnancies within the Swiss HIV Cohort Study from 1996 to 2012 and with information on follow-up visits available. Two LTFU events were defined: no clinical visit for >180 days and no visit for >360 days in the year after delivery. Logistic regression analysis was used to identify risk factors for a LTFU event after delivery. RESULTS Median maternal age at delivery was 32 years (IQR 28-36), 357 (49%) women were black, 280 (39%) white, 56 (8%) Asian and 4% other ethnicities. One hundred and seven (15%) women reported any history of IDU. The majority (524, 73%) of women received their HIV diagnosis before pregnancy, most of those (413, 79%) had lived with diagnosed HIV longer than three years and two-thirds (342, 65%) were already on antiretroviral therapy (ART) at time of conception. Of the 181 women diagnosed during pregnancy by a screening test, 80 (44%) were diagnosed in the first trimester, 67 (37%) in the second and 34 (19%) in the third trimester. Of 357 (69%) women who had been seen in HIV medical care during three months before conception, 93% achieved an undetectable HIV viral load (VL) at delivery. Of 62 (12%) women with the last medical visit more than six months before conception, only 72% achieved an undetectable VL (p=0.001). Overall, 247 (34%) women were LTFU over 180 days in the year after delivery and 86 (12%) women were LTFU over 360 days with 43 (50%) of those women returning. Being LTFU for 180 days was significantly associated with history of intravenous drug use (aOR 1.73, 95% CI 1.09-2.77, p=0.021) and not achieving an undetectable VL at delivery (aOR 1.79, 95% CI 1.03-3.11, p=0.040) after adjusting for maternal age, ethnicity, time of HIV diagnosis and being on ART at conception. CONCLUSIONS Women with a history of IDU and women with a detectable VL at delivery were more likely to be LTFU after delivery. This is of concern regarding their own health, as well as risk for sexual partners and subsequent pregnancies. Further strategies should be developed to enhance retention in medical care beyond pregnancy.

Functionally Optimized Neuritogenic Farinosone C Analogs: SAR-Study and Investigations on Their Mode of Action

Several natural products derived from entomopathogenic fungi have been shown to initiate neuronal differentiation in the rat pheochromocytoma PC12 cell line. After the successful completion of the total synthesis program, the reduction of structural complexity while retaining biological activity was targeted. In this study, farinosone C served as a lead structure and inspired the preparation of small molecules with reduced complexity, of which several were able to induce neurite outgrowth. This allowed for the elaboration of a detailed structure-activity relationship. Investigations on the mode of action utilizing a computational similarity ensemble approach suggested the involvement of the endocannabinoid system as potential target for our analogs and also led to the discovery of four potent new endocannabinoid transport inhibitors.

Time-order errors and standard-position effects in duration discrimination: An experimental study and an analysis by the sensation-weighting model

Studies have shown that the discriminability of successive time intervals depends on the presentation order of the standard (St) and the comparison (Co) stimuli. Also, this order affects the point of subjective equality. The first effect is here called the standard-position effect (SPE); the latter is known as the time-order error. In the present study, we investigated how these two effects vary across interval types and standard durations, using Hellström’s sensation-weighting model to describe the results and relate them to stimulus comparison mechanisms. In Experiment 1, four modes of interval presentation were used, factorially combining interval type (filled, empty) and sensory modality (auditory, visual). For each mode, two presentation orders (St–Co, Co–St) and two standard durations (100 ms, 1,000 ms) were used; half of the participants received correctness feedback, and half of them did not. The interstimulus interval was 900 ms. The SPEs were negative (i.e., a smaller difference limen for St–Co than for Co–St), except for the filled-auditory and empty-visual 100-ms standards, for which a positive effect was obtained. In Experiment 2, duration discrimination was investigated for filled auditory intervals with four standards between 100 and 1,000 ms, an interstimulus interval of 900 ms, and no feedback. Standard duration interacted with presentation order, here yielding SPEs that were negative for standards of 100 and 1,000 ms, but positive for 215 and 464 ms. Our findings indicate that the SPE can be positive as well as negative, depending on the interval type and standard duration, reflecting the relative weighting of the stimulus information, as is described by the sensation-weighting model.

The Cambridge Companion to Herodotus. Carolyn Dewald and John Marincola (eds.). Cambridge, Cambridge University Press, 2006. 378 pp.

Fil: Barandica, María Guadalupe.

Physics, geochemistry and bulk sedimentology on cores from the Peru Basin

Empirical relationships between physical properties determined non-destructively by core logging devices and calibrated by carbonate and opal measurements determined on discrete samples allow extraction of carbonate and opal records from the non-destructive measurements in biogenic settings. Contents of detrital material can be calculated as a residual. For carbonate and opal the correlation coefficients (r) are 0.954 and ?0.916 for sediment density, ?0.816 and 0.845 for compressional-wave velocity, 0.908 and ?0.942 for acoustic impedance, and 0.886 and ?0.865 for sediment color (lightness). Carbonate contents increase in concert with increasing density and acoustic impedance, decreasing velocity and lighter sediment color. The opposite is true for opal. The advantages of deriving the sediment composition quantitatively from core logging are: (i) sampling resolution is increased significantly, (ii) non-destructive data can be gathered rapidly, and (iii) laboratory work on discrete samples can be reduced. Applied to paleoceanographic problems, this method offers the opportunity of precise stratigraphic correlations and of studying processes related to biogenic sedimentation in more detail. Density is most promising because it is most strongly affected by changes in composition.

Growth of the Firm and Economic Backwardness: A Case Study and Analysis of China's Mobile Handset Industry

Economic backwardness often influences the growth of firms in developing countries. In this paper, we investigate the growth conditions and paths available for latecomers competing with first movers. Employing the concepts of boundaries of the firm and the disadvantage of backwardness, we present a case study of China's mobile handset industry and proceed to develop a simple model. We find that although significant disadvantage does not allow latecomers to grow, there are possibilities for changing the conditions of growth if latecomers can utilize outside resources and/or indigenous advantages.

Preliminary Study and Proposal for Restoring a Jesuit College at Saragossa, Spain

A historical study and a construction pathology survey were conducted prior to proposing a solution for restoring the upper windows on the south side of Old San Carlos College at Saragossa (16th-17th centuries), wich had been forteited to add a third storey to the cloister. Althought initially designed to a simple large hall format, the church is a harmonius blend of Aragonese Gothic architecture and typical Jesuit scheme, consisting in a central nave flanket by chapel-confessional and raised galleries for the community. A subsequent enlargement of the roof, wich rests on the original framing over the central nave, reduced the mechanical strength of the principal rafters on the opposite side, prompting a concomitant imbalance of forces that has affected the entire structure. In view of the foregoing, in addition to restituting the upper window, the proposal solution envisages restoring the roof over the central nave to its original design, and with the interior lighting in the church.

Analytical study and evaluation results of power optimizers for distributed power conditioning in PV arrays

The use of modular or ‘micro’ maximum power point tracking (MPPT) converters at module level in series association, commercially known as “power optimizers”, allows the individual adaptation of each panel to the load, solving part of the problems related to partial shadows and different tilt and/or orientation angles of the photovoltaic (PV) modules. This is particularly relevant in building integrated PV systems. This paper presents useful behavioural analytical studies of cascade MPPT converters and evaluation test results of a prototype developed under a Spanish national research project. On the one hand, this work focuses on the development of new useful expressions which can be used to identify the behaviour of individual MPPT converters applied to each module and connected in series, in a typical grid-connected PV system. On the other hand, a novel characterization method of MPPT converters is developed, and experimental results of the prototype are obtained: when individual partial shading is applied, and they are connected in a typical grid connected PV array

Atomic physics modeling and applications for ICF plasmas

The Atomic Physics Group at the Institute of Nuclear Fusion (DENIM) in Spain has accumulated experience over the years in developing a collection of computational models and tools for determining some relevant microscopic properties of, mainly, ICF and laser-produced plasmas in a variety of conditions. In this work several applications of those models in determining some relevant microscopic properties are presented.