977 resultados para Organic media


Relevância:

20.00% 20.00%

Publicador:

Resumo:

We report a new organic photovoltaics (OPV) design, a wrapped OPV, which can circumvent both challenges of short exciton diffusion length [1], and low charge carrier mobility [2] of organic semiconductors by orienting the OPV vertically, to capture; manage; guide and use all incident photons and therefore, generate higher current. Resonant light, on being transmitted into a wrapped OPV, makes multiple passes through the photoactive layer and is absorbed completely, thus achieving benefits of thick photoactive layer while maintaining its ultra-thin thickness requirement. The current density generated from a wrapped OPV is twice than that generated by a similar OPV with flat orientation.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

High efficiency organic photovoltaic cells discussed in literature are normally restricted to devices fabricated on glass substrates. This is a consequence of the extreme brittleness and inflexibility of the commonly used transparent conductive oxide electrode, indium tin oxide (ITO). This shortcoming of ITO along with other concerns such as increasing scarcity of indium, migration of indium to organic layer, etc. makes it imperative to move away from ITO. Here we demonstrate a highly flexible Ag electrode that possesses low sheet resistances even in ultra-thin layers. It retains its conductivity under severe bending stresses where ITO fails completely. A P3HT:PCBM blend organic solar cell fabricated on this highly flexible electrode gives an efficiency of 2.3%.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Bottom emitting organic light emitting diodes (OLEDs) can suffer from lower external quantum efficiencies (EQE) due to inefficient out-coupling of the generated light. Herein, it is demonstrated that the current efficiency and EQE of red, yellow, and blue fluorescent single layer polymer OLEDs is significantly enhanced when a MoOx(5 nm)/Ag(10 nm)/MoOx(40 nm) stack is used as the transparent anode in a top emitting OLED structure. A maximum current efficiency and EQE of 21.2 cd/A and 6.7%, respectively, was achieved for a yellow OLED, while a blue OLED achieved a maximum of 16.5 cd/A and 10.1%, respectively. The increase in light out-coupling from the top-emitting OLEDs led to increase in efficiency by a factor of up to 2.2 relative to the optimised bottom emitting devices, which is the best out-coupling reported using solution processed polymers in a simple architecture and a significant step forward for their use in large area lighting and displays.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

We initially look at the changing energy environment and how that can have a dramatic change on the potential of alternative energies, in particular those of organic photovoltaicvs (OPV) cells. In looking at OPV's we also address the aspects of where we are with the current art and why we may not be getting the best from our materials. In doing so, we propose the idea of changing how we build organic photovoltaics by addressing the best method to contain light within the devices. Our initial effort is in addressing how these microscale optical concentrators work in the form of optical fibers in terms of absorption. We have derived a mathematical method which takes account of the input angle of light to achieve optimum absorption. However, in doing so we also address the complex issue how the changing refractive indices in a multilayer device can alter how we input the light. We have found that by knowing the materials refractive index our model takes into account the incident plane, meridonal plane, cross sectional are and path length to ensure optical angular input. Secondly, we also address the practicalities of making such vertical structures the greater issue of changing light intensity incident on a solar cell and how that aspects alters how we view the performance of organic solar cells.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Optical transmittance and conductivity for thin metallic films, such as Au, are two inversely related and extremely important parameters for its application in organic photovoltaics as the front electrode. We report our findings on how these parameters have been optimized to attain maximum possible efficiencies by fabricating organic solar cells with thin Au film anodes of differing optical transmittances and consequently due to scaling at the nanolevel, varying electrical conductivities. There was an extraordinary improvement in the overall solar cell efficiency (to the order of 49%) when the Au thin film transmittance was increased from 38% to 54%. Surface morphologies of these thin films also have an effect on the critical parameters including, Voc, Jsc and FF.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Flexible multilayer electrodes that combine high transparency, high conductivity, and efficient charge extraction have been deposited, characterised and used as the anode in organic solar cells. The anode consists of an AZO/Ag/AZO stack plus a very thin oxide interlayer whose ionization potential is fine-tuned by manipulating its gap state density to optimise charge transfer with the bulk heterojunction active layer consisting of poly(n-3- hexylthiophene-2,5-diyl) and phenyl-C61-butyric acid methyl ester (P3HT:BC61BM). The deposition method for the stack was compatible with the low temperatures required for polymer substrates. Optimisation of the electrode stack was achieved by modelling the optical and electrical properties of the device and a power conversion efficiency of 2.9% under AM1.5 illumination compared to 3.0% with an ITO-only anode and 3.5% for an ITO:PEDOT electrode. Dark I-V reverse bias characteristics indicate very low densities of occupied buffer states close to the HOMO level of the hole conductor, despite observed ionization potential being high enough. Their elimination should raise efficiency to that with ITO:PEDOT.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Indium Tin Oxide (ITO) is the most commonly used anode as a transparent electrode and more recently as an anode for organic photovoltaics (OPVs). However, there are significant drawbacks in using ITO which include high material costs, mechanical instability including brittleness and poor electrical properties which limit its use in low-cost flexible devices. We present initial results of poly(3-hexylthiophene): phenyl-C61-butyric acid methyl ester OPVs showing that an efficiency of 1.9% (short-circuit current 7.01 mA/cm2, open-circuit voltage 0.55 V, fill factor 0.49) can be attained using an ultra thin film of gold coated glass as the device anode. The initial I-V characteristics demonstrate that using high work function metals when the thin film is kept ultra thin can be used as a replacement to ITO due to their greater stability and better morphological control.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

We have prepared p-n junction organic photovoltaic cells using an all solution processing method with poly(3-hexylthiophene) (P3HT) as the donor and phenyl-C 61-butyric acid methyl ester (PCBM) as the acceptor. Interdigitated donor/acceptor interface morphology was observed in the device processed with the lowest boiling point solvent for PCBM used in this study. The influences of different solvents on donor/acceptor morphology and respective device performance were investigated simultaneously. The best device obtained had characteristically rough interface morphology with a peak to valley value ∼15 nm. The device displayed a power conversion efficiency of 1.78%, an open circuit voltage (V oc) 0.44 V, a short circuit current density (J sc) 9.4 mA/cm 2 and a fill factor 43%.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

An innovative design strategy for light emitting field effect transistors (LEFETs) to harvest higher luminance and switching is presented. The strategy uses a non-planar electrode geometry in tri-layer LEFETs for simultaneous enhancement of the key parameters of quantum efficiency, brightness, switching, and mobility across the RGB color gamut.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The interaction at the interface between a metal electrode and photoactive polymer is crucial for overall performance and stability of organic photovoltaics (OPVs). In this article, we report a comparative study of the stability of thin film Ag and indium tin oxide (ITO) as electrodes when used in conjunction with an interfacial PEDOT:PSS layer for P3HT:PCBM blend OPV devices. XPS measurements were taken for Ag and ITO/PEDOT:PSS layered samples with different exposure times to ambient conditions (∼25 °C, ∼50% relative humidity) to investigate the migration of Ag and In into the PEDOT:PSS layer. The change in efficiency of OPVs with a longer exposure time and degree of migration is explained by the analysis of XPS results. We propose the mechanism behind the interactions occurring at the interfaces. The efficiency of the ITO electrode OPVs continuously decreased to below 10% of the initial efficiency. However, the Ag devices displayed a slower degradation and maintained 50% of the initial efficiency for the same period of time.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This constructivist grounded theory study investigated the nature of new mothers' information experience in social media. The findings provide a holistic view of the phenomenon and the resultant substantive grounded theory describes new mothers' information experience in social media as a complex, multi-layered, and highly contextualised phenomenon. It encapsulates multiple individual experiences of information, and is broader and deeper than the individual experiences it is comprised of. The theory incorporates the characteristics, dimensions and categories of experience to provide a holistic view of new mothers' information experience in social media.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

In his 1987 book, The Media Lab: Inventing the Future at MIT, Stewart Brand provides an insight into the visions of the future of the media in the 1970s and 1980s. 1 He notes that Nicolas Negroponte made a compelling case for the foundation of a media laboratory at MIT with diagrams detailing the convergence of three sectors of the media—the broadcast and motion picture industry; the print and publishing industry; and the computer industry. Stewart Brand commented: ‘If Negroponte was right and communications technologies really are converging, you would look for signs that technological homogenisation was dissolving old boundaries out of existence, and you would expect an explosion of new media where those boundaries used to be’. Two decades later, technology developers, media analysts and lawyers have become excited about the latest phase of media convergence. In 2006, the faddish Time Magazine heralded the arrival of various Web 2.0 social networking services: You can learn more about how Americans live just by looking at the backgrounds of YouTube videos—those rumpled bedrooms and toy‐strewn basement rec rooms—than you could from 1,000 hours of network television. And we didn’t just watch, we also worked. Like crazy. We made Facebook profiles and Second Life avatars and reviewed books at Amazon and recorded podcasts. We blogged about our candidates losing and wrote songs about getting dumped. We camcordered bombing runs and built open‐source software. America loves its solitary geniuses—its Einsteins, its Edisons, its Jobses—but those lonely dreamers may have to learn to play with others. Car companies are running open design contests. Reuters is carrying blog postings alongside its regular news feed. Microsoft is working overtime to fend off user‐created Linux. We’re looking at an explosion of productivity and innovation, and it’s just getting started, as millions of minds that would otherwise have drowned in obscurity get backhauled into the global intellectual economy. The magazine announced that Time’s Person of the Year was ‘You’, the everyman and everywoman consumer ‘for seizing the reins of the global media, for founding and framing the new digital democracy, for working for nothing and beating the pros at their own game’. This review essay considers three recent books, which have explored the legal dimensions of new media. In contrast to the unbridled exuberance of Time Magazine, this series of legal works displays an anxious trepidation about the legal ramifications associated with the rise of social networking services. In his tour de force, The Future of Reputation: Gossip, Rumor, and Privacy on the Internet, Daniel Solove considers the implications of social networking services, such as Facebook and YouTube, for the legal protection of reputation under privacy law and defamation law. Andrew Kenyon’s edited collection, TV Futures: Digital Television Policy in Australia, explores the intersection between media law and copyright law in the regulation of digital television and Internet videos. In The Future of the Internet and How to Stop It, Jonathan Zittrain explores the impact of ‘generative’ technologies and ‘tethered applications’—considering everything from the Apple Mac and the iPhone to the One Laptop per Child programme.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Driven by a desire to redevelop derelict land, attract inward investments, and better exploit the commercial potential of local talent, public authorities in Glasgow are partnering with private developers to transform an abandoned industrial dockland into a riverside business cluster for the creative industries. It’s a strategy increasingly common in a number of other peripheral regions and it highlights the new role “creativity” plays in urban rejuvenation, social renewal, and economic development. At its core, the strategy also betrays a troubling policy shift away from certain democratic conceptions of culture to ones that are more attuned to economic considerations shaped by global influences.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

In November 2010, tension between Internet infrastructure companies boiled over in a dispute between content distribution network (CDN) Level 3 and Internet service provider (ISP) Comcast. Level 3, a distribution partner of Netflix, accused Comcast of violating the principles of net neutrality when the ISP increased distribution fees for carrying high bandwidth services. Comcast justified its actions by stating that the price increase was standard practice and argued Level 3 was trying to avoid paying its fair share. The dispute exemplifies the growing concern over the rising costs of streaming media services. The companies facing these inflated infrastructure costs are CDNs (Level 3, Equinix, Limelight, Akamai, and Voxel), companies that host streaming media content on server farms and distribute the content to a variety of carriers, and ISPs (Comcast, Time Warner, Cox, and AT&T), the cable and phone companies that provide “last mile” service to paying customers. Both CDNs and ISPs are lobbying government regulators to keep their costs at a minimum. The outcome of these disputes will influence the cost, quality, and legal status of streaming media.