Grain sizes and mineral composition of the basement of ODP Site 206-1256

Hole 1256C was cored 88.5 m into basement, and Hole 1256D, the deep reentry hole, was cored 502 m into basement during Ocean Drilling Program Leg 206. Hole 1256D is located ~30 m south of Hole 1256C (Wilson, Teagle, Acton, et al., 2003, doi:10.2973/odp.proc.ir.206.2003). A thick massive flow drilled in both holes, Units 1256C-18 and 1256D-1, consists of a single cooling unit of cryptocrystalline to fine-grained basalt, interpreted as a ponded lava, 32 m and at least 74.2 m thick, respectively. This ponded flow gives us a unique opportunity to examine textural variations from the glassy, folded crust of the lava pond recovered from the top of Unit 1256C-18 through the coarse-grained, thick massive lava body to the unusually recrystallized and deformed base cored in Unit 1256C-18. Some detailed descriptions of the textures and grain size variations through the lava pond (Units 1256C-18 and 1256D-1), with special reference to the recrystallization of the base of Unit 1256C-18, are presented here.

Magnetic susceptibility of bottom sediments from the Middle and South Caspian Sea

Dependence of magnetic susceptibility of bottom sediments from the Caspian Sea on composition of magnetoactive minerals contained in the heavy subfraction of fine-grained sand (0.125-0.100 mm grain size fraction) was established. Changes in the curve shape and magnetic susceptibility values reflect a pulsating pattern of input of different (in magnetic properties) magmatic and metamorphic clastic minerals into sediments, as well as different intensities of formation of authigenic magnetoactive iron sulfides under conditions of multiple alternation of transgressive and regressive phases in marine basins. Values of magnetic susceptibility and shapes of magnetic susceptibility curves for studied sedimentary sequences show that sediments in the South and Middle Caspian Basins are characterized by different specific features.

Ages, lithologie descriptions and mineral analyses from different DSDP holes in the Indian Ocean

The present work is based on mineralogical studies of sand and silt layers from a number of Deep Sea Drilling Project sites in the Indian Ocean belonging to different physiographic provinces of different ages. The minerals can be grouped into two major associations: a hornblende-opaque association with varying amounts of pyroxene, garnet, epidote, zircon, etc. and a biotite-chlorite-muscovite assemblage. The dominance of unstable minerals indicates a first generation, though evidence of reworking is reflected in the zircon and tourmaline grains at some sites. A large variety of minerals at some sites indicates a complex source. The mineral composition is nearly homogeneous at different sites for the entire length of the core, indicating that they have been derived from the same source during the deposition of that interval. However, the provenance changed by tectonic activity, the effect of which has been reflected in the mineralogy of some sites. An attempt was made to describe the mineralogic characteristics and their tectonic interpretations in the Pliocene and Miocene periods in the Ganges and Indus fan sites and also in the Wharton and Mozambique basin sites. Similar attempts could not be made for other ages in other physiographic provinces as the numbers of samples were too few. Within the limited scope, some idea about the mineralogical character of different basins and different physiographic provinces can be obtained from the present study. Mineralogical evidence also suggests very long transport of sediments in the deep sea. Regional variation of mineralogy has resulted due to source, sea-floor configuration, selective removal, reworking by different agencies and the processes operating in the ocean. There is no relation between a particular age and a set mineral assemblage for the Cenozoic sediments of the Indian Ocean.

Concentrations of Fe, Mn, Cu, Zn, Co, Ni, Pb, Cd, B, and SiO2 in interstitial waters from bottom sediments of the Atlantis II and Discovery Deeps, Red Sea rift zone

Chemical analyzes show that interstitial waters from ore-bearing bottom sediments of the Atlantis II and Discovery Deeps are enriched in Fe, Mn, Cu, Ni, Co, Zn, Pb, and Cd compared to sea water. Enrichment factors of these trace elements in the interstitial waters of the Atlantis II Deep relative to the sea water vary within the following ranges: for Fe from 100 to 7000, for Mn from 19047 to 32738, for Zn from 500 to 1600, for Pb from 78333 to 190000, for Cu from 107 to 654. Comparison of average weighted concentrations of Fe, Mn, Zn, Pb, Cu, Ni in the bottom sediments and the interstitial waters of the Atlantis II Deep indicates common regularities and good relationship in distribution of these elements along sediment cores. Differences in concentrations and distribution of the studied trace elements in the interstitial waters of the Atlantis II and Discovery Deeps result from different chemical compositions of hydrothermal fluids entering these deeps.

Effective stress, porosity, p-wave velocity and mineral composition of ODP Hole 174A-1073A sediments

Porosity, permeability, and compressional (P-wave) velocity were measured as a function of stress on sediments from Ocean Drilling Program Site 1073, U.S. Mid-Atlantic continental slope. Thin sections, scanning electron microscopy, and X-ray diffraction analyses provided mineralogical characteristics of the samples. Uniaxial strain boundary conditions were imposed on the samples during consolidation tests with the maximum effective axial stress reaching 13 MPa. The maximum effective radial stress necessary to maintain uniaxial strain was 7.6 MPa. Over an effective axial stress interval of 0 to 5.2 MPa, Sample 174A-1073A-26X-2, 82-89 cm (226.65 meters below seafloor [mbsf]), exhibited the largest decrease in porosity (51% to 41%), whereas Sample 71X-1, 2-8 cm (644.70 mbsf), exhibited the smallest decrease in porosity (48% to 45%). All samples showed negligible porosity increases during unloading. The permeability (on the order of 1 x 10-17 m**2) of Sample 174A-1073A-71X-1, 2-8 cm, was twice that measured on Sample 8H-1, 23-26 cm (63.75 mbsf), even though the former was considerably deeper and older. The differences in porosity-stress behavior and permeability between shallow and deep samples is related to lithologic, mineralogic, and diagenetic differences between the sediments above and below the Pliocene-Pleistocene to Miocene unconformity. P-wave velocity for Samples 174A-1073A-41X-5, 97-103 cm (372.35 mbsf), and 71X-1, 2-8 cm, increased with decreasing porosity, but did not change significantly during unloading.

Phosphorus in bottom sediments and micronodules from Core VITYAZ7414, Central Indian Ocean

Study of phosphorus distribution in grain size fractions of eupelagic clays showed high (up to 3%) content of P in Fe-Mn micronodules that can contain up to 20-30% of total P. Mineral P associated with Fe in ocean sediments is an analog of manganese in ocean sedimentogenesis. Sharp decrease of P contents in ocean Fe-Mn nodules compared to ones from seas results from decrease of Fe contents and partial neutralization of Fe activity by Mn.

Composition of native Cu, Cu isotope and mineral analysis from different samples of ODP and DSDP

Ocean drilling has revealed that, although a minor mineral phase, native Cu ubiquitously occurs in the oceanic crust. Cu isotope systematics for native Cu from a set of occurrences from volcanic basement and sediment cover of the oceanic crust drilled at several sites in the Pacific, Atlantic and Indian oceans constrains the sources of Cu and processes that produced Cu**0. We propose that both hydrothermally-released Cu and seawater were the sources of Cu at these sites. Phase stability diagrams suggest that Cu**0 precipitation is favored only under strictly anoxic, but not sulfidic conditions at circum-neutral pH even at low temperature. In the basaltic basement, dissolution of primary igneous and potentially hydrothermal Cu-sulfides leads to Cu**0 precipitation along veins. The restricted Cu-isotope variations (delta 65Cu = 0.02-0.19 per mil) similar to host volcanic rocks suggest that Cu**0 precipitation occurred under conditions where Cu+-species were dominant, precluding Cu redox fractionation. In contrast, the Cu-isotope variations observed in the Cu**0 from sedimentary layers yield larger Cu-isotope fractionation (delta 65Cu = 0.41-0.95 per mil) suggesting that Cu**0 precipitation involved redox processes during the diagenesis, with potentially seawater as the primary Cu source. We interpret that native Cu precipitation in the basaltic basement is a result of low temperature (20°-65 °C) hydrothermal processes under anoxic, but not H2S-rich conditions. Consistent with positive delta 65Cu signatures, the sediment cover receives major Cu contribution from hydrogenous (i.e., seawater) sources, although hydrothermal contribution from plume fallout cannot be entirely discarded. In this case, disseminated hydrogenous and/or hydrothermal Cu might be diagenetically remobilized and reprecipitated as Cu**0 in reducing microenvironment.