Anisotropic behaviour in the magnetic field dependence of the low temperature electrical resistance of calcium-doped lanthanum manganate thin films grown by RF magnetron sputtering

We report about the magnetoresistive properties of calcium-doped lanthanum manganate thin films grown by RF magnetron sputtering on single crystalline LaAlO3 and MgO substrates. Two orientations of the magnetic field with respect to the electrical current have been studied: (i) magnetic field in the plane of the film and parallel to the electrical current, and (ii) magnetic field perpendicular to the plane of the film. The film grown on LaAlO 3 is characterised by an unusual magnetoresistive behaviour when the magnetic field is applied perpendicular to the film plane: the appearance of two bumps in the field dependence of the resistance is shown to be related to the occurrence of anisotropic magnetoresistive effects in manganate films. © 2004 Elsevier B.V. All rights reserved.

Non-ohmic contact resistance and field-effect mobility in nanocrystalline silicon thin film transistors

Contact resistance has a significant impact on the electrical characteristics of thin film transistors. It limits their maximum on-current and affects their subsequent behavior with bias. This distorts the extracted device parameters, in particular, the field-effect mobility. This letter presents a method capable of accounting for both the non-ohmic (nonlinear) and ohmic (linear) contact resistance effects solely based upon terminal I-V measurements. Applying our analysis to a nanocrystalline silicon thin film transistor, we demonstrate that contact resistance effects can lead to a twofold underestimation of the field-effect mobility. © 2008 American Institute of Physics.

Investigating vibration dyanmics of cross-coupled MEMS resonators for reduced motional resistance

This paper investigates the vibration dynamics of a closed-chain, cross-coupled architecture of MEMS resonators. The system presented here is electrostatically transduced and operates at 1.04 MHz. Curve veering of the eigenvalue loci is used to experimentally quantify the coupling spring constants. Numerical simulations of the motional resistance variation against induced perturbation are used to assess the robustness of the cross-coupled system as opposed to equivalent traditional open-ended linear one-dimensional coupling scheme. Results show improvements of as much as 32% in the motional resistance between the cross-coupled system and its one-dimensional counterpart. © 2013 IEEE.

Mix design, mechanical properties and impact resistance of UHPFRCCs

The research work focused on the determination of guidelines for the production of an UHPFRCC, and the experimental investigation of the quality and the behaviour of this material in a highly demanding application, such as the impact resistance of structures. Specifically, the aim of this study is to present the results of an extended work on the development of an UHPFRCC and the experimental determination of the mechanical properties of the produced material. Furthermore, the paper will present preliminary experimental results on the impact resistance of Reinforced Concrete and UHPFRCC slab specimens. © 2012 Taylor & Francis Group.

Enhanced grass carp reovirus resistance of Mx-transgenic rare minnow (Gobiocypris rarus)

In the interferon-induced antiviral mechanisms, the Mx pathway is one of the most powerful. Mx proteins have direct antiviral activity and inhibit a wide range of viruses by blocking an early stage of the viral genome replication cycle. However, antiviral activity of piscine Mx remains unclear in vivo. In the present study, an Mx-like gene was cloned, characterized and gene-transferred in rare minnow Gobiocypris rarus, and its antiviral activity was confirmed in vivo. The full length of the rare minnow Mx-like cDNA is 2241 bp in length and encodes a polypeptide of 625 amino acids with an estimated molecular mass of 70.928 kDa and a predicted isoelectric point of 7.33. Analysis of the deduced amino acid sequence indicated that the mature peptide contains an amino-terminal tripartite GTP-binding motif, a dynamin family signature sequence, a GTPase effector domain and two carboxy-terminal leucine zipper motifs, and is the most similar to the crucian carp (Carassius auratus) Mx3 sequence with an identity of 89%. Both P0 and F1 generations of Mx-transgenic rare minnow demonstrated very significantly high survival rate to GCRV infection (P < 0.01). The mRNA expression of Mx gene was consistent with survival rate in F1 generation. The virus yield was also concurrent with survival time using electron microscope technology. Rare minnow has Mx gene(s) of its own but introducing more Mx gene improves their resistance to GCRV. Mx-transgenic rare minnow might contribute to control the GCRV diseases. (C) 2008 Published by Elsevier Ltd.

Numerical study of the impact of process variations on the motional resistance of weakly coupled MEMS resonators

This paper presents a numerical study of the impact of process-induced variations on the achievable motional resistance Rx of one-dimensional, cyclic and cross-coupled architectures of electrostatically transduced MEMS resonators operating in the 250 kHz range. Monte Carlo numerical simulations which accounted for up to 0.75% variation in critical resonator feature sizes were initiated on 1, 2, 3, 4, 5 and 9 coupled MEMS resonators for three distinct coupling architectures. Improvements of 100X in the spread of Rx and 2.7X in mean achievable Rx are reported for the case of 9 resonators when implemented in the cross-coupled topology, as opposed to the traditional one-dimensional chain. © 2013 IEEE.

Changes in biomechanical properties of the coronary artery wall contribute to maintained contractile responses to endothelin-1 in atherosclerosis.

AIMS: Our aim was to determine whether alterations in biomechanical properties of human diseased compared to normal coronary artery contribute to changes in artery responsiveness to endothelin-1 in atherosclerosis. MAIN METHODS: Concentration-response curves were constructed to endothelin-1 in normal and diseased coronary artery. The passive mechanical properties of arteries were determined using tensile ring tests from which finite element models of passive mechanical properties of both groups were created. Finite element modelling of artery endothelin-1 responses was then performed. KEY FINDINGS: Maximum responses to endothelin-1 were significantly attenuated in diseased (27±3 mN, n=55) compared to normal (38±2 mN, n=68) artery, although this remained over 70% of control. There was no difference in potency (pD2 control=8.03±0.06; pD2 diseased=7.98±0.06). Finite element modelling of tensile ring tests resulted in hyperelastic shear modulus μ=2004±410 Pa and hardening exponent α=22.8±2.2 for normal wall and μ=2464±1075 Pa and α=38.3±6.7 for plaque tissue and distensibility of diseased vessels was decreased. Finite element modelling of active properties of both groups resulted in higher muscle contractile strain (represented by thermal reactivity) of the atherosclerotic artery model than the normal artery model. The models suggest that a change in muscle response to endothelin-1 occurs in atherosclerotic artery to increase its distensibility towards that seen in normal artery. SIGNIFICANCE: Our data suggest that an adaptation occurs in medial smooth muscle of atherosclerotic coronary artery to maintain distensibility of the vessel wall in the presence of endothelin-1. This may contribute to the vasospastic effect of locally increased endothelin-1 production that is reported in this condition.

The effect of carbon nanotube orientation on erosive wear resistance of CNT-epoxy based composites

Aligned carbon nanotube (CNT) polymer composites are envisioned as the next-generation composite materials for a wide range of applications. In this work, we investigate the erosive wear behavior of epoxy matrix composites reinforced with both randomly dispersed and aligned carbon nanotube (CNT) arrays. The aligned CNT composites are prepared in two different configurations, where the sidewalls and ends of nanotubes are exposed to the composite surface. Results have shown that the composite with vertically aligned CNT-arrays exhibits superior erosive wear resistance compared to any of the other types of composites, and the erosion rate reaches a similar performance level to that of carbon steel at 20° impingement angle. The erosive wear mechanism of this type of composite, at various impingement angles, is studied by Scanning Electron Microscopy (SEM). We report that the erosive wear performance shows strong dependence on the alignment geometries of CNTs within the epoxy matrix under identical nanotube loading fractions. Correlations between the eroded surface roughness and the erosion rates of the CNT composites are studied by surface profilometry. This work demonstrates methods to fabricate CNT based polymer composites with high loading fractions of the filler, alignment control of nanotubes and optimized erosive wear properties. © 2014 Elsevier Ltd. All rights reserved.

Insecticide resistance in Chinese populations of the Culex pipiens complex through esterase overproduction

In most parts of China, mosquitoes have been subjected to organophosphate (OP) insecticide treatments since the mid-1960s, and resistance gene monitoring in the Culex pipiens complex (Diptera: Culicidae) started in only a few locations from the end of the 1980s. Many resistant alleles at the Ester locus have been found in field populations, including those commonly found around the world (Ester(B1) and Ester(2)), and those endemic to China (Ester(B6), Ester(B7), Ester(8), and Ester(9)). This situation is atypical, and may represent a complex situation for the evolution of insecticide resistance genes in China. To increase our understanding of the Chinese situation and our ability to manage resistance in the C. pipiens complex, a large study was performed. Twenty field populations were sampled from Beijing to Guangzhou. Bioassays with five insecticides (dichlorvos, parathion, chlorpyrifos, 2-sec-butylphenyl methyl carbamate, and propoxur) disclosed resistance levels variable according to the geographic origin, and up to 85-fold for dichlorvos. Six overproduced esterases were identified, including two that have not been previously described. Most of them were found in all samples, although at variable frequencies, suggesting variable selection or a transient situation, e.g., each one was recently restricted to a particular geographic area. The results are discussed in the context of recent alterations to insecticide campaigns, and of the evolution of resistance genes in Chinese C. pipiens populations.

Molecular identification and expression analysis of natural resistance associated macrophage protein (Nramp) cDNA from Japanese flounder (Paralichthys olivaceus)

Natural resistance associated macrophage protein (Nramp) controls partially innate resistance to intracellular parasites. Its function is to enhance the ability of macrophages to kill pathogens. However, little is known about the structure and function of Nramp in lower vertebrates such as teleosts. We have recently isolated a cDNA encoding Nramp from Japanese flounder (Paratichthys olivaceus). The full-length cDNA of the Nramp is 3066 bp in length, including 224 bp 5' terminal UTR, 1662 bp encoding region and 1180 bp 3' terminal UTR. The 1662-nt open reading frame was found to code for a protein with 554 amino acid residues. Comparison of amino acid sequence indicated that Japanese flounder Nramp consists of 12 transmembrane (TM) domains. A consensus transport motif (CTM) containing 20 residues was observed between transmembrane domains 8 and 9. The deduced amino acid sequence of Japanese flounder had 77.30%, 82.71%, 82.67%, 79.64%, 80.72%, 90.97%, 91.16%, 60.14%, 71.48%, 61.69%, 72.37% identity with that of rainbow trout Nramp alpha and beta, channel catfish Nramp, fathead minnow Nramp, common carp Nramp, striped sea bass Nramp, red sea bream Nramp, mouse Nramp 1 and 2, human Nramp 1 and 2, respectively. RT-PCR indicated that Nramp transcripts were highly abundant in spleen, head kidney, abundant in intestine, liver and gill, and less abundant in heart. The level of Nramp mRNA in embryos gradually increases during embryogenesis from 4 h (8 cell stage) to 80 h (hatched stage) after fertilization. (c) 2005 Elsevier Ltd. All rights reserved.

Enhanced resistance to Aeromonas hydrophila infection and enhanced phagocytic activities in human lactoferrin-transgenic grass carp (Ctenopharyngodon idellus)

Human lactoferrin (hLF) is an iron-binding protein with antimicrobial and immunomodulatory activities. hLF cDNA was transferred into grass carp via electroporated sperm. The production of transgenic fish was as high as 55% tinder the best parameters. 2(11) pulses and 20-min incubation. The expression of the transgene was demonstrated by the detection of hLF mRNA by RT-PCR. We also investigated the response of G(0) transgenic grass carp to Aeromonas hydrophila infection. Serum lysozyme activities (P>0.05) and phagocytic activities of kidney cells (P<0.05) were measured in transgenic individuals. The transgenic fish not only cleared A. hydrophila significantly faster than the control carp (P<0.05), but also showed enhanced phagocytic activities. The result shows that hLF has immunomodulatory activities in hLF-transgenic grass carp. The transgenic grass carp exhibited enhanced immunity to A. hydrophila infection. These results reveal that the mechanisms of disease resistance are different between hLF-transgenic plants and hLF-transgenic grass carp. (C) 2004 Elsevier B.V. All rights reserved.