Properties of tantalum oxynitride thin films produced by magnetron sputtering: the influence of processing parameters

The main purpose of this work is to present and to interpret the change of structure and physical properties of tantalum oxynitride (TaNxOy) thin films, produced by dc reactive magnetron sputtering, by varying the processing parameters. A set of TaNxOy films was prepared by varying the reactive gases flow rate, using a N2/O2 gas mixture with a concentration ratio of 17:3. The different films, obtained by this process, exhibited significant differences. The obtained composition and the interpretation of X-ray diffraction results, shows that, depending on the partial pressure of the reactive gases, the films are: essentially dark grey metallic, when the atomic ratio (N + O)/Ta < 0.1, evidencing a tetragonal β-Ta structure; grey-brownish, when 0.1 < (N + O)/Ta < 1, exhibiting a face-centred cubic (fcc) TaN-like structure; and transparent oxide-type, when (N + O)/Ta > 1, evidencing the existence of Ta2O5, but with an amorphous structure. These transparent films exhibit refractive indexes, in the visible region, always higher than 2.0. The wear resistance of the films is relatively good. The best behaviour was obtained for the films with (N + O)/Ta ≈ 0.5 and (N + O)/Ta ≈ 1.3.

Impacto económico, energético e ambiental da produção renovável na Ilha Terceira

Dissertação para obtenção do grau de Mestre em Engenharia Electrotécnica Ramo de Energia

HFCs e soluções alternativas viáveis

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Mecânica

Eletrólise da água para produção de gás de síntese

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Química e Biológica Ramo de Processos Químicos

Análise do sistema de tratamento de efluentes gasosos de uma central de valorização energética de resíduos sólidos urbanos

Trabalho Final de Mestrado para obtenção do grau de Mestre Em Engenharia Química e Biológica Ramo de processos Químicos

Dispersão de gases poluentes na área de Sines

Tese de doutoramento

Renewable energy in Islands: an integrated proposal for electricity generation and transports

The purpose of this article is to analyse and evaluate the economical, energetic and environmental impacts of the increasing penetration of renewable energies and electrical vehicles in isolated systems, such as Terceira Island in Azores and Madeira Island. Given the fact that the islands are extremely dependent on the importation of fossil fuels - not only for the production of energy, but also for the transportation’s sector – it’s intended to analyse how it is possible to reduce that dependency and determine the resultant reduction of pollutant gas emissions. Different settings have been analysed - with and without the penetration of EVs. The Terceira Island is an interesting case study, where EVs charging during off-peak hours could allow an increase in geothermal power, limited by the valley of power demand. The percentage of renewable energy in the electric power mix could reach the 74% in 2030 while at the same time, it is possible to reduce the emissions of pollutant gases in 45% and the purchase of fossil fuels in 44%. In Madeira, apart from wind, solar and small hydro power, there are not so many endogenous resources and the Island’s emission factor cannot be so reduced as in Terceira. Although, it is possible to reduce fossil fuels imports and emissions in 1.8% in 2030 when compared with a BAU scenario with a 14% of the LD fleet composed by EVs.

Renewable energy in Islands: an integrated proposal for electricity generation and transports

The purpose of this article is to analyse and evaluate the economical, energetic and environmental impacts of the increasing penetration of renewable energies and electrical vehicles in isolated systems, such as Terceira Island in Azores and Madeira Island. Given the fact that the islands are extremely dependent on the importation of fossil fuels - not only for the production of energy, but also for the transportation’s sector – it’s intended to analyse how it is possible to reduce that dependency and determine the resultant reduction of pollutant gas emissions. Different settings have been analysed - with and without the penetration of EVs. The Terceira Island is an interesting case study, where EVs charging during off-peak hours could allow an increase in geothermal power, limited by the valley of power demand. The percentage of renewable energy in the electric power mix could reach the 74% in 2030 while at the same time, it is possible to reduce the emissions of pollutant gases in 45% and the purchase of fossil fuels in 44%. In Madeira, apart from wind, solar and small hydro power, there are not so many endogenous resources and the Island’s emission factor cannot be so reduced as in Terceira. Although, it is possible to reduce fossil fuels imports and emissions in 1.8% in 2030 when compared with a BAU scenario with a 14% of the LD fleet composed by EVs.

ENCOURAGE architecture: support for heterogeneous smart grids

Our society relies on energy for most of its activities. One application domain inciding heavily on the energy budget regards the energy consumption in residential and non-residential buildings. The ever increasing needs for energy, resulting from the industrialization of developing countries and from the limited scalability of the traditional technologies for energy production, raises both problems and opportunities. The problems are related to the devastating effects of the greenhouse gases produced by the burning of oil and gas for energy production, and from the dependence of whole countries on companies providing gas and oil. The opportunities are mostly technological, since novel markets are opening for both energy production via renewable sources, and for innovations that can rationalize energy usage. An enticing research effort can be the mixing of these two aspects, by leveraging on ICT technologies to rationalize energy production, acquisition, and consumption. The ENCOURAGE project aims to develop embedded intelligence and integration technologies that will directly optimize energy use in buildings and enable active participation in the future smart grid environment.The primary application domains targeted by the ENCOURAGE project are non-residential buildings (e.g.: campuses) and residential buildings (e.g.: neighborhoods). The goal of the project is to achieve 20% of energy savings through the improved interoperability between various types of energy generation, consumption and storage devices; interbuilding energy exchange; and systematic performance monitoring.

The effect of metal transfer modes and shielding gas composition on the emission of ultraafine particles in MAG steel welding

The present study aims to characterize ultrafine particles emitted during gas metal arc welding of mild steel and stainless steel, using different shielding gas mixtures, and to evaluate the effect of metal transfer modes, controlled by both processing parameters and shielding gas composition, on the quantity and morphology of the ultrafine particles. It was found that the amount of emitted ultrafine particles (measured by particle number and alveolar deposited surface area) are clearly dependent from the main welding parameters, namely the current intensity and the heat input of the Welding process. The emission of airborne ultrafine particles increases with the current intensity as fume formation rate does. When comparing the shielding gas mixtures, higher emissions were observed for more oxidizing mixtures, that is, with higher CO2 content, which means that these mixtures originate higher concentrations of ultrafine particles (as measured by number of particles. by cubic centimeter of air) and higher values of alveolar deposited surface area of particles, thus resulting in a more hazardous condition regarding welders exposure.

Characterization of the volatile fraction emitted by phloems of four pinus species by solid-phase microextraction and gas chromatography–mass spectrometry

Pine forests constitute some of the most important renewable resources supplying timber, paper and chemical industries, among other functions. Characterization of the volatiles emitted by different Pinus species has proven to be an important tool to decode the process of host tree selection by herbivore insects, some of which cause serious economic damage to pines. Variations in the relative composition of the bouquet of semiochemicals are responsible for the outcome of different biological processes, such as mate finding, egg-laying site recognition and host selection. The volatiles present in phloem samples of four pine species, P. halepensis, P. sylvestris, P. pinaster and P. pinea, were identified and characterized with the aim of finding possible host-plant attractants for native pests, such as the bark beetle Tomicus piniperda. The volatile compounds emitted by phloem samples of pines were extracted by headspace solid-phase micro extraction, using a 2 cm 50/30 mm divinylbenzene/carboxen/polydimethylsiloxane table flex solid-phase microextraction fiber and its contents analyzed by high-resolution gas chromatography, using flame ionization and a non polar and chiral column phases. The components of the volatile fraction emitted by the phloem samples were identified by mass spectrometry using time-of-flight and quadrupole mass analyzers. The estimated relative composition was used to perform a discriminant analysis among pine species, by means of cluster and principal component analysis. It can be concluded that it is possible to discriminate pine species based on the monoterpenes emissions of phloem samples.

Produção de biodiesel mediante ecovalorização de óleos alimentares: otimização de estratégias de produção e de controlo de qualidade

Os biocombustíveis são combustíveis com origem em matérias-primas naturais e renováveis, como óleos vegetais, gorduras animais, óleos e gorduras residuais entre outros, utilizados como substitutos de combustíveis minerais, como o gasóleo ou gasolina. Esta alternativa aos combustíveis de origem fóssil, tem-se vindo a revelar cada vez mais atrativa, sobretudo devido aos seus benefícios ambientais, destacando-se entre ele s o facto de serem biodegradáveis, não tóxicos e emitirem menos gases aquando da sua combustão, não contribuindo deste modo para o aumento do efeito de estufa na atmosfera. Na execução do presente trabalho, assume-se como finalidade o desenvolvimento de procedimentos laboratoriais sistemático de modo, com o intuito de elaborar um controlo de qualidade para a produção do biodiesel que permita a implementação de novas medidas processuais melhorando a produção de biodiesel. Este trabalho é resultado do estágio no Ecoparque Braval Valorização e Tratamento de Resíduos Sólidos, S.A. Com a avaliação sistemática e contínua, tanto da matéria-prima usada na produção do biodiesel, como do produto final em si, através de procedimentos laboratoriais específicos para o efeito, visa-se que em distintas fases do processo de produção do biodiesel seja compreendido o que ocorre de forma efetiva, e assim se assumam medidas preventivas e corretivas com o intuito de melhorar a qualidade do produto final. Na elaboração deste trabalho foram também reunidos esforços no sentido de controlar as especificações do óleo à entrada das instalações e iniciar o controlo de qualidade do produto final através de análises comparativas elaboradas no laboratório da Unidade de Produção de Biodiesel do Ecoparque Brava! - Valorização e Tratamento de Resíduos Sólidos, S.A. Outra abordagem do trabalho em questão, incide no estudo do efeito da variação das condições operatórias, nomeadamente a razão molar metanol/óleo , quantidade de catalizador na produção de biodiesel, nomeadamente, na quantidade de glicerina obtida como subproduto da reação e na facilidade de separação de fases. Neste sentido, o trabalho proposto pretende controlar a qualidade da matéria-prima usada, a qualidade do produto final e apresentar os aspetos-chave que deve m ser considerados para urna melhor gestão do s recursos de produção do biocombustível.

Board-level prototype validation: a built-in controller and extended BST architecture

Prototype validation is a major concern in modern electronic product design and development. Simulation, structural test, functional and timing debug are all forming parts of the validation process, although very often addressed as dissociated tasks. In this paper we describe an integrated approach to board-level prototype validation, based on a set of mandatory/optional BST instructions and a built-in controller for debug and test, that addresses the late mentioned tasks as inherent parts of a whole process

Gás sulfídrico nas redes de águas residuais

Os colaboradores que realizam a sua atividade profissional, no setor das águas residuais, reconhecem que a sua atividade é perigosa. Esse conhecimento, foi adquirido pela experiência obtida ao longo dos anos, pelas várias formações e pelas notícias de acidentes, muitas vezes mortais, que têm acontecido na atividade. Muita das vezes, os colaboradores têm dificuldade em aceitar o risco, porque na realidade não existe um histórico conhecido do que se passa no interior das redes de drenagem de águas residuais e consideram que o risco é apenas teórico. Os portugueses são um Povo muito ligado à Cultura Popular,e são os ditados populares que melhor sintetiza as ideias expressas pelos trabalhador português “Ver para Crer, Como São Tomé” (SOUSA, Marcelo Rebelo de, Os Evangelhos de 2001, Lisboa, Bertrand Editora, 2001]. O objetivo principal com este trabalho, foi evidenciar que existem gases no interior das caixas de visita, mas principalmente, demostrar que seu aparecimento e respetiva concentração, é variável e que ocorre sem aviso prévio! Tornando assim, os trabalhos no interior das caixas de visita e das redes de drenagem de águas residuais domesticas, locais perigosos para quem opera no seu interior, sem a correta utilização dos equipamentos de proteção individual, (Epis e Epc). Sendo necessário, reforçar, a constante informação e formação para a utilização dos equipamentos de proteção individual e coletiva. Com o presente estágio, pretendeu-se iniciar um registo histórico de medições nas redes de drenagem de águas residuais domésticas. Com o resultado das medições que serão obtidas, pretende-se uma “Radiografia Fotográfica” ao interior das caixas de visitas das redes de drenagem de águas residuais. Com os resultados deste estudo, pretende-se contribuir de forma clara e objetiva, para os perigos iminentes que existem efetivamente, no interior das redes de saneamento, com a presença de altas concentrações de gás sulfídrico, nocivo para a vida humana!

Produção de biodiesel etílico por via enzimática a partir de óleo de milho transgénico

Mestrado em Engenharia Química