Titanate nanotubes produced from microwave-assisted hydrothermal synthesis: Photocatalytic and structural properties

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

TANZANIA GRASS STRUCTURE GRAZED BY GOATS MANAGED WITH DIFFERENT RESIDUAL LEAF AREA INDEX UNDER INTERMITTENT STOCKING

The objective of this study was to evaluate the structure of Tanzania grassland grazed by goats managed with different residue leaf area index (RLAI) under intermittent stocking. The experiment was carried out from February to August, 2008. The treatments consisted of three different targets RLAI (0.8, 1.6 and 2.4) and 95% light interception (LI) criterion determined the rest period. Forage samples were collected at average height sampling points and weighed. Subsequently, a smaller sample was removed to separate the morphological components (leaf, stem and dead material) and to determine the structural and productive features. The canopy architecture was evaluated by the method of inclined point quadrat. The pre-grazing height in the paddocks were significantly different among treatments. RLAI influenced dry matter contents of green forage, leaf, stem and total, with the exception of dry matter of dead material, where the lowest values were observed for 0.8 RLAI. Thus, RLAI modifies canopy structure and is sensitive to canopy height changes throughout the year. Pasture regrowth is not compromised by residual leaf area indexes between 0.8 and 2.4, when climatic factors are not limiting.

Experimental and theoretical studies of photoluminescence in Zns obtained by microwave-assisted solvothermal method

A shift of the photoluminescence (PL) emission was observed in ZnS prepared by microwave assisted solvothermal method with the increase of the time in microwave. In this work we reported a study of the optical behavior linking with the structural disorder according to XRD and FEG-TEM results. The reduction of intrinsic defects in the lattice is responsible for the decrease of electronic levels in the band gap changing the PL profile. This effect was confirmed by electronic structure calculations.

Ce0.97Cu0.03O2 Nanocatalysts Synthesized via Microwave-assisted Hydrothermal Method: Characterization and CO-PROX Catalytic Efficiency

In the work presented here, Ce0.97Cu0.03O2 nanoparticles were synthesized by a microwave-assisted hydrothermal method under different synthesis temperatures. The obtained nanoparticles were tested as catalysts in preferential oxidation of CO to obtain CO-free H2 (PROX reaction). The samples were characterized by X-ray diffraction, transmission electron microscopy (TEM), electron paramagnetic resonance spectroscopy (EPR) and temperature-programmed reduction (TPR). X-ray diffraction measurements detected the presence of pure cubic CeO2 for all synthesized samples. TEM images of the Ce0.97Cu0.03O2 nanoparticles revealed that samples synthesized at 80°C are composed mainly of nanospheres with an average size of 20 nm. The formation of some nanorods with an average diameter of 8 nm and 40 nm in length, and the size reduction of the nanoparticles from 20 to approximately 15 nm is observed with increasing synthesis temperature. EPR spectra indicated that copper is found well dispersed in sample synthesized at 160°C, located predominant in surface sites of ceria. For samples synthesized at 80 and 120°C, the species are less dispersed than in the other one, resulting in the formation of Cu2+−Cu2+ dimmers at the surface of ceria. TPR profiles presented two reduction peaks, one below 400°C attributed to the reduction of different copper species and a second peak around 800°C attributed to the reduction of Ce4+→ Ce3+ species located in the volume of the nanoparticles. The peak related to the reduction of copper species shifts to lower temperatures with increasing synthesis temperature, i.e., the sample synthesized at 160°C is more easily reduced than the ones synthesized at 120 and 80°C. The nanoparticles showed active as catalysts for the CO-PROX reaction. The microwave-assisted method revealed efficient for the synthesis of Ce0.97Cu0.03O2 nanoparticles with copper species selective for the CO-PROX reaction, which reaches CO conversions up to 92% for the sample synthesized at 160°C.

Long-range and short-range structures of cube-like shape SrTiO3 powders: microwave-assisted hydrothermal synthesis and photocatalytic activity

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

SnO2 dense ceramic microwave sintered with low resistivity

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Microwave-assisted hydrothermal synthesis of NiO-Ce1-XEuxO2-δ powders for fuel cell catalytic anodes

CeO2-based materials doped with rare earth (TR +3) can be used as alternative to traditional NiO-YSZ anodes in solid oxide fuel cells as they have higher ionic conductivity and lower ohmic losses compared to YSZ. Moreover, they allow fuel cell operation at lower temperatures (500-800°C). In the anode composition, the concentration of NiO acting as catalyst in YSZ provides high electrical conductivity and high electrochemical activity of reactions, promoting internal reform in the cell. In this work, NiO - Ce1-xEuxO2-δ compounds (x = 0.1, 0.2 and 0.3) have been synthesized by microwave-assisted hydrothermal method. The materials were characterized by TG, XRD, TPR and SEM-FEG techniques. The refinement of data obtained by X-ray diffraction showed the presence of ceria doped with europium crystallized in a cubic phase with fluorite structure, in addition to the presence of NiO. The microwave-assisted hydrothermal method showed significant reduction in the average particle size and good mass control of phase compositions compared to other chemical synthesis techniques.

Synthesis and characterization of NaNbO3 mesostructure by a microwave-assisted hydrothermal method

In the present work, we report the synthesis and characterization of NaNbO3 particles obtained by microwave-assisted hydrothermal method from Nb2O5 and NaOH. The synthesis was made at different periods at 180 °C and 300W. The crystallization of NaNbO3 structures produced Na2Nb2O6.H2O in the intermediate phase with fiber-like morphology, and this is associated with the synthesis time. Pure orthorhombic NaNbO3 with cube-like morphology originates after synthesizing for 240 minutes. To verify the remnant polarization of particles, films were obtained by electrophoresis process and sintered at 800°C for 10 minutes in a microwave furnace. The films characterization indicated that films of niobate with fiber-like morphology present remaining polarization, and the morphology of cubes did not show remaining polarization. Considering these results, it can be concluded that the morphology implemented ferroelectric property of NaNbO3.

Ethyl biodiesel: Microwave irradiation aiding ethanolysis of waste cooking oil.

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Microwave interferometric technique for characterizing few mode fibers

We propose and experimentally demonstrate a simple and accurate technique for measuring differential mode group delay (DMGD) in few mode fibers (FMF). A frequency-swept microwave signal is modulated on a filtered optical incoherent source. The microwave signals carried on different fiber modes experience different time delays and interfere with each other in the photodetector. Optical interference between propagating fiber modes is avoided by the use of an incoherent optical source. A mathematical model is established to analyze the interference pattern and extract the DMGD values. A 456-m two-mode fiber and a 981-m FMF, which supports four LP modes, are measured. The measurement covers the whole C-band and the results coincide well with those obtained by the time-of-flight method and the numerical simulations. A precision of ±0.002 ps/m is achieved.

Cell membrane integrity of candida albicans after different protocols of microwave irradiation

To evaluate the ability of low time microwaveexposureto inactivate and damage cell membrane integrity of C. albicans. Materials and Methods: Two 200ml C. albicans suspensions were obtained. Sterile dentures were placed in a beaker containing Experimental (ES) or Control suspensions (CS). ES was microwaved at 650 W for 1, 2, 3, 4 or 5 min. Suspensions were optically counted using Methylene blue dye as indicative of membrane-damaged cells; spread on Agar Sabouraud dextrose (ASD) for viability assay; or spectrophotometrically measured at 550nm. Cell-free solutions were submitted to content analyses of protein (Bradford and Pyrogallol red methods); Ca++ (Cresolphthalein Complexone method); DNA (spectrophotometer measurements at 260nm) and K+ (selective electrode technique). Data were analyzed by Student-t test and linear regression (α=0.05). In addition, flowcytometry analysis of Candida cells in suspensionwas performed using propidium iodide. Results: All ES cells demonstrated cell membrane damage at 3, 4 and 5 min,viable cells were nonexistent at 3, 4 and 5 min ES ASD plates and optical density of ES and CS was not significantly differentfor all exposition times. ES cells released highcontents of protein, K+ , Ca++ and DNA after 2 min exposition when compared to that of the CSs. Similar results were observed with flow cytometry analysiswith regard to the periodsof microwave exposure. Conclusions: Microwave irradiation inactivated C. albicansafter 3min and damaged cell membrane integrity after 2 min exposition.

Dialysis complications in acute kidney injury patients treated with prolonged intermittent renal replacement therapy sessions lasting 10 versus 6 hours: results of a randomized clinical trial

Prolonged intermittent renal replacement therapy (PIRRT) has emerged as an alternative to continuous renal replacement therapy in the management of acute kidney injury (AKI) patients. This trial aimed to compare the dialysis complications occurring during different durations of PIRRT sessions in critically ill AKI patients. We included patients older than 18 years with AKI associated with sepsis admitted to the intensive care unit and using noradrenaline doses ranging from 0.3 to 0.7 mu g/kg/min. Patients were divided into two groups randomly: in G1, 6-h sessions were performed, and in G2, 10-h sessions were performed. Seventy-five patients were treated with 195 PIRRT sessions for 18 consecutive months. The prevalence of hypotension, filter clotting, hypokalemia, and hypophosphatemia was 82.6, 25.3, 20, and 10.6%, respectively. G1 was composed of 38 patients treated with 100 sessions, whereas G2 consisted of 37 patients treated with 95 sessions. G1 and G2 were similar in male predominance (65.7 vs. 75.6%, P=0.34), age (63.6 +/- 14 vs. 59.9 +/- 15.5 years, P=0.28) and Sequential Organ Failure Assessment score (SOFA; 13.1 +/- 2.4 vs. 14.2 +/- 3.0, P=0.2). There was no significant difference between the two groups in hypotension (81.5 vs. 83.7%, P=0.8), filter clotting (23.6 vs. 27%, P=0.73), hypokalemia (13.1 vs. 8.1%, P=0.71), and hypophosphatemia (18.4 vs. 21.6%, P=0.72). However, the group treated with sessions of 10h were refractory to clinical measures for hypotension, and dialysis sessions were interrupted more often (9.5 vs. 30.1%, P=0.03). Metabolic control and fluid balance were similar between G1 and G2 (blood urea nitrogen [BUN]: 81 +/- 30 vs. 73 +/- 33mg/dL, P=1.0; delivered Kt/V: 1.09 +/- 0.24 vs. 1.26 +/- 0.26, P=0.09; actual ultrafiltration: 1731 +/- 818 vs. 2332 +/- 947mL, P=0.13) and fluid balance (-731 +/- 125 vs. -652 +/- 141mL, respectively) . In conclusion, intradialysis hypotension was common in AKI patients treated with PIRRT. There was no difference in the prevalence of dialysis complications in patients undergoing different durations of PIRRT.

Evaluation of microwave-assisted pretreatment of lignocellulosic biomass immersed in alkaline glycerol for fermentable sugars production

A pretreatment with microwave irradiation was applied to enhance enzyme hydrolysis of corn straw and rice husk immersed in water, aqueous glycerol or alkaline glycerol. Native and pretreated solids underwent enzyme hydrolysis using the extract obtained from the fermentation of Myceliophthora heterothallica, comparing its efficiency with that of the commercial cellulose cocktail Celluclast (R). The highest saccharification yields, for both corn straw and rice husk, were attained when biomass was pretreated in alkaline glycerol, method that has not been previously reported in literature. Moreover, FTIR, TG and SEM analysis revealed a more significant modification in the structure of corn straw subjected to this pretreatment.Highest global yields were attained with the crude enzyme extract, which might be the result of its content in a great variety of hydrolytic enzymes, as revealed zymogram analysis. Moreover, its hydrolysis efficiency can be improved by its supplementation with commercial beta-glucosidase.