The seismic SPT to determine the maximum shear modulus

This paper presents the first results of a system to carry out seismic SPT, which associates the up-hole seismic technique to the currently used SPT test. This hybrid test allows determining the maximum shear modulus (G 0) together with the SPT test. G 0 is the most important dynamic soil parameter and it is calculated based on the shear wave velocity (V S) measurements. The equipment and the method of analysis will be briefly described. The V s values measured using the S-SPT in one experimental research site located inland of Sao Paulo State-Brazil are presented and compared with down-hole and Seismic CPT test data. These preliminary results indicate that the S-SPT was satisfactory and can be used for dynamic site characterization.

Session report: Non-textbook type geomaterials

An abstract of all the papers presented in the Conference Section where the geotechnical material is considered non-conventional to classical Soil Mechanics is presented. Thirteen papers submitted to this Conference were considered as a non-textbook type geomaterial. The papers were grouped in four groups: tropical soils, tailings, cementation and heterogeneous soils. The objective is to present a report with the major contributions of the each paper to encourage the reader to read the original papers. © 2013 Taylor & Francis Group.

The use of CPT to evaluate the effect of helical pile installation in tropical soils

The uplift capacity of helical piles depends on the shear resistance of the soil above the helical plates. During helical pile installation, the soil traversed by the plates are sheared and displaced laterally, and consequently the soil structure is disturbed. Considering this fact, the aim of this paper is presenting the effect of helical piles installation in the soil mass by means of CPT tests carried out close to the soil cylinder above the pile helices. The CPT tests were performed at the CRHEA site from the Sao Carlos School of Engineering, Sao Carlos city, inland of Sao Paulo State, Brazil. In addition, an interpretation of CPT tests data for stratigrafic logging are presented and compared to Standard Penetration Tests (SPT) carried out at this site. This study showed that the CPT sleeve friction fs data were affected by the installation of helical pile in this particular tropical soil site. © 2013 Taylor & Francis Group.

Anterior pericranial flap for frontal sinus duct obliteration: Is it a valuable resource?

Inappropriate treatments of frontal sinus fractures may lead to serious complications, such as mucopyocele, meningitis, and brain abscess. Assessment of nasofrontal duct injury is crucial, and nasofrontal duct injury requires sinus obliteration, which is often accomplished by autogenous grafts such as fat, muscle, or bone. These avascular grafts have an increased risk of resorption and infection and donor site morbidity. For these reasons, pericranial flap, which is vascular, should be used for frontal sinus obliteration. The pericranial flap presented with less morbidity procedure and has decreased infection rates, which justifies its use in frontal sinus obliteration. This study aimed to report a case of a comminuted frontal sinus fracture with a brief literature review, regarding the use of pericranial flap. The authors report a case of a 23-year-old male subject with a severely comminuted fracture of the anterior and posterior walls of the frontal sinus. The patient was successfully treated by cranialization with frontal sinus duct obliteration, using anterior pericranial flap. The patient was followed up for 16 months with no postoperative complication, such as infection. Pericranial flap is a good resource for frontal sinus duct obliteration because it is a durable and well-vascularized flap, which determines low rates of postoperative complications. Copyright © 2013 by Mutaz B. Habal, MD.

Engaging environments: Tacit knowledge sharing on the shop floor

Purpose: The purpose of this paper is to identify factors that facilitate tacit knowledge sharing in unstructured work environments, such as those found in automated production lines. Design/methodology/approach: The study is based on a qualitative approach, and it draws data from a four-month field study at a blown-molded glass factory. Data collection techniques included interviews, informal conversations and on-site observations, and data were interpreted using content analysis. Findings: The results indicated that sharing of tacit knowledge is facilitated by an engaging environment. An engaging environment is supported by shared language and knowledge, which are developed through intense communication and a strong sense of collegiality and a social climate that is dominated by openness and trust. Other factors that contribute to the creation of an engaging environment include managerial efforts to provide appropriate work conditions and to communicate company goals, and HRM practices such as the provision of formal training, on-the-job training and incentives. Practical implications: This paper clarifies the scope of managerial actions that impact knowledge creation and sharing among blue-collar workers. Originality/value: Despite the acknowledgement of the importance of blue-collar workers' knowledge, both the knowledge management and operations management literatures have devoted limited attention to it. Studies related to knowledge management in unstructured working environments are also not abundant. © Emerald Group Publishing Limited.

Interclonal Variations in the Molecular Karyotype of Trypanosoma cruzi: Chromosome Rearrangements in a Single Cell-Derived Clone of the G Strain

Trypanosoma cruzi comprises a pool of populations which are genetically diverse in terms of DNA content, growth and infectivity. Inter- and intra-strain karyotype heterogeneities have been reported, suggesting that chromosomal rearrangements occurred during the evolution of this parasite. Clone D11 is a single-cell-derived clone of the T. cruzi G strain selected by the minimal dilution method and by infecting Vero cells with metacyclic trypomastigotes. Here we report that the karyotype of clone D11 differs from that of the G strain in both number and size of chromosomal bands. Large chromosomal rearrangement was observed in the chromosomes carrying the tubulin loci. However, most of the chromosome length polymorphisms were of small amplitude, and the absence of one band in clone D11 in relation to its reference position in the G strain could be correlated to the presence of a novel band migrating above or below this position. Despite the presence of chromosomal polymorphism, large syntenic groups were conserved between the isolates. The appearance of new chromosomal bands in clone D11 could be explained by chromosome fusion followed by a chromosome break or interchromosomal exchange of large DNA segments. Our results also suggest that telomeric regions are involved in this process. The variant represented by clone D11 could have been induced by the stress of the cloning procedure or could, as has been suggested for Leishmania infantum, have emerged from a multiclonal, mosaic parasite population submitted to frequent DNA amplification/deletion events, leading to a 'mosaic' structure with different individuals having differently sized versions of the same chromosomes. If this is the case, the variant represented by clone D11 would be better adapted to survive the stress induced by cloning, which includes intracellular development in the mammalian cell. Karyotype polymorphism could be part of the T. cruzi arsenal for responding to environmental pressure. © 2013 Lima et al.

The reliability of counting actinic keratosis

Many epidemiological studies and clinical trials have been performed concerning actinic keratoses. The most eligible endpoint in the majority of articles is counting of actinic keratoses before and after treatments, nevertheless some authors support that this is not a reliable form of evaluation. The aim of this study was to evaluate the actinic keratoses counting by various raters and suggest approaches to increase the reliability. Cross-sectional study: forty-three patients were evaluated by four raters (inter- and intra-rater assessment) on the face and forearms. The mean actinic keratoses counts on the face and forearms were 7.7 and 9.1. The overall agreement among the raters for the facial and forearm actinic keratoses was 0.74 and 0.77. The intra-rater assessment showed high rates of agreement for the face (ICC = 0.93) and forearms (ICC = 0.83). Higher agreement occurred when counting up to five lesions. Four raters led to increased measurement variability and loss of reliability. Higher rates of agreement may be achieved with small number of lesions, limitation and/or segmentation of body areas to reduce their number, in AK prevention designs, are strategies that may lead to a greater reliability of these measurements. © 2013 Springer-Verlag Berlin Heidelberg.

Variações regionais e efeitos da castração nos lobos dorsal e ventral da próstata do gerbilo da Mongólia (Meriones unguiculatus)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Biologia comportamental de Synoeca surinama: enxameio e interações socias (Vespidae, Polistinae: Epiponini)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise citogenética clássica, molecular e ultraestrutural em escorpiões da família Buthidae: um enfoque evolutivo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Preparação e caracterização de filmes finos do tipo 'Pb IND. 1-x-yCa IND. xSr IND.yTiO IND. 3'

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Propriedades de transporte eletrônico em filmes finos policristalinos de diboreto de magnésio (MGB IND.2') analisados pelo modelo de Bloch-Grüneisen

Pós-graduação em Ciência e Tecnologia de Materiais - FC

Determinação do teste padrão para o diagnóstico de cães com doença de von willebrand

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação, sistema de ciclos e regime de progressão continuada: progressão das aprendizagens do aluno ou progressão de fluxo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo de ilhas de calor no município de Piratininga/SP, por meio de dados orbitais do landsat 5 sensor tm

Pós-graduação em Agronomia (Energia na Agricultura) - FCA