Data based Calibration System for Radar used by Vehicle Activated Signs

The accurate measurement of a vehicle’s velocity is an essential feature in adaptive vehicle activated sign systems. Since the velocities of the vehicles are acquired from a continuous wave Doppler radar, the data collection becomes challenging. Data accuracy is sensitive to the calibration of the radar on the road. However, clear methodologies for in-field calibration have not been carefully established. The signs are often installed by subjective judgment which results in measurement errors. This paper develops a calibration method based on mining the data collected and matching individual vehicles travelling between two radars. The data was cleaned and prepared in two ways: cleaning and reconstructing. The results showed that the proposed correction factor derived from the cleaned data corresponded well with the experimental factor done on site. In addition, this proposed factor showed superior performance to the one derived from the reconstructed data.

Triggering Solar-Powered Vehicle Activated Signs using Self Organising Maps with K-means

Solar-powered vehicle activated signs (VAS) are speed warning signs powered by batteries that are recharged by solar panels. These signs are more desirable than other active warning signs due to the low cost of installation and the minimal maintenance requirements. However, one problem that can affect a solar-powered VAS is the limited power capacity available to keep the sign operational. In order to be able to operate the sign more efficiently, it is proposed that the sign be appropriately triggered by taking into account the prevalent conditions. Triggering the sign depends on many factors such as the prevailing speed limit, road geometry, traffic behaviour, the weather and the number of hours of daylight. The main goal of this paper is therefore to develop an intelligent algorithm that would help optimize the trigger point to achieve the best compromise between speed reduction and power consumption. Data have been systematically collected whereby vehicle speed data were gathered whilst varying the value of the trigger speed threshold. A two stage algorithm is then utilized to extract the trigger speed value. Initially the algorithm employs a Self-Organising Map (SOM), to effectively visualize and explore the properties of the data that is then clustered in the second stage using K-means clustering method. Preliminary results achieved in the study indicate that using a SOM in conjunction with K-means method is found to perform well as opposed to direct clustering of the data by K-means alone. Using a SOM in the current case helped the algorithm determine the number of clusters in the data set, which is a frequent problem in data clustering.

Hidrogeoquímica do sistema aqüífero granular cenozóico do município de Porto Alegre, RS

As águas subterrâneas são significantemente afetadas pelo ambiente deposicional no Sistema Aqüífero Granular Cenozóico. Os sedimentos terciários e quaternários da Planície Costeira do Rio Grande do Sul que ocorrem em Porto Alegre foram depositados em Sistemas de Laguna/Barreira que geraram depósitos de leques aluviais, fluviais, lacustres e deltáicos. O Sistema Aqüífero Granular Cenozóico na área estudada sofreu influência de transgressões e regressões marinhas iniciadas há 400 mil anos. No presente estudo foram analisadas 39 amostras de água subterrânea na região de Porto Alegre, que se destacam por possuir alto conteúdo de íons, em particular: cloreto (13 a 1680 mg/L), sulfato (4 a 500 mg/L), cálcio (0,9 a 125 mg/L), magnésio (0,7 a 154 mg/L) e sódio (17 a 740 mg/L), permitindo classificá-las como cloretada-cálcico-sódicas com elevados teores de sulfato. Os resultados físico-químicos foram tratados estatisticamente (análise fatorial e análise discriminante), o que permitiu identificar 4 grupos de águas, a partir dos parâmetros de maior correlação, que compreendem cloreto, potássio, cálcio, magnésio, sulfato, sódio, dureza e condutividade elétrica. A dissolução de sais de ambiente marinho ou mixohalino associada com condições hidrodinâmicas de fluxos de baixa velocidade e elevado tempo de residência, são fatores decisivos para a existência dos vários tipos hidroquímicos. O modelamento geoquímico indicou subsaturação em fluorita, halita e gipsita, enquanto calcita e dolomita tendem a saturação. Por outro lado, os cálculos indicam supersaturação em fluorapatita, gibsita, caolinita e goetita.

Caracterização de Fe granular em matriz de Al/sub 2/O/sub 3/

Neste trabalho é apresentada a caracterização de amostras de filmes finos granulares de Fe- Al2O3, obtidas por evaporação em ultra alto vácuo. Duas amostras com composições diferentes foram obtidas. A espectroscopia de Espalhamento de Rutherford (Rutherford Backscattering Spectroscopy - RBS) foi utilizada para determinar a fração volumétrica de metal e a espessura das amostras, cujos valores obtidos foram 43% e 34% respectivamente. A morfologia das amostras foi investigada por difração de raios-x a qual mostrou a existência de grãos de ferro com 30Å de diâmetro e orientação cristalina preferencial (110) embebidos em uma matriz amorfa de Al2O3. As medidas de magnetização também mostraram que as duas amostras apresentavam uma distribuição de tamanhos de grão de ferro com valor médio de 24Å, estando de acordo com os resultados obtidos por difração de raios-x. A magneto-resistência observada em temperatura ambiente pode ser explicada pelo tunelamento dependente de spin dos elétrons de condução entre os grãos de ferro. Os resultados das medidas de RxT e IxV mostraram que o principal mecanismo de transporte foi o tunelamento termicamente ativado, o que está de acordo com a teoria apresentada por Abeles.

The Effect of Residence Time on the Tensile Properties of Superelastic and Thermal Activated Ni-Ti Orthodontic Wires

Since the 1980s, different devices based on superelastic alloys have been developed to fulfill orthodontic applications. Particularly in the last decades several researches have been carried out to evaluate the mechanical behavior of Ni-Ti alloys, including their tensile, torsion and fatigue properties. However, studies regarding the dependence of elastic properties on residence time of Ni-Ti wires in the oral cavity are scarce. Such approach is essential since metallic alloys are submitted to mechanical stresses during orthodontic treatment as well as pH and temperature fluctuations. The goal of the present contribution is to provide elastic stress-strain results to guide the orthodontic choice between martensitic thermal activated and austenitic superelastic Ni-Ti alloys. From the point of view of an orthodontist, the selection of appropriate materials and the correct maintenance of the orthodontic apparatus are essential needs during clinical treatment. The present work evaluated the elastic behavior of Ni-Ti alloy wires with diameters varying from 0.014 to 0.020 inches, submitted to hysteresis tensile tests with 8% strain. Tensile tests were performed after periods of use of 1, 2 and 3 months in the oral cavity of patients submitted to orthodontic treatment. The results from the hysteresis tests allowed to exam the strain range covered by isostress lines upon loading and unloading, as well as the residual strain after unloading for both superelastic and thermal activated Ni-Ti wires. Superelastic Ni-Ti wires exhibited higher load isostress values compared to thermal activated wires. It was found that such differences in the load isostress values can increase with increasing residence time.

Karyoplast exchange between strontium- and 6-DMAP-parthenogenetically activated zygotes of cattle

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of therapeutic plasma concentrations of non-steroidal anti-inflammatory drugs on the production of reactive oxygen species by activated rat neutrophils

The release of reactive oxygen specie (ROS) by activated neutrophil is involved in both the antimicrobial and deleterious effects in chronic inflammation. The objective of the present investigation was to determine the effect of therapeutic plasma concentrations of non-steroidal anti-inflammatory drugs (NSAIDs) on the production of ROS by stimulated rat neutrophils. Diclofenac (3.6 µM), indomethacin (12 µM), naproxen (160 µM), piroxicam (13 µM), and tenoxicam (30 µM) were incubated at 37ºC in PBS (10 mM), pH 7.4, for 30 min with rat neutrophils (1 x 10(6) cells/ml) stimulated by phorbol-12-myristate-13-acetate (100 nM). The ROS production was measured by luminol and lucigenin-dependent chemiluminescence. Except for naproxen, NSAIDs reduced ROS production: 58 ± 2% diclofenac, 90 ± 2% indomethacin, 33 ± 3% piroxicam, and 45 ± 6% tenoxicam (N = 6). For the lucigenin assay, naproxen, piroxicam and tenoxicam were ineffective. For indomethacin the inhibition was 52 ± 5% and diclofenac showed amplification in the light emission of 181 ± 60% (N = 6). Using the myeloperoxidase (MPO)/H2O2/luminol system, the effects of NSAIDs on MPO activity were also screened. We found that NSAIDs inhibited both the peroxidation and chlorinating activity of MPO as follows: diclofenac (36 ± 10, 45 ± 3%), indomethacin (97 ± 2, 100 ± 1%), naproxen (56 ± 8, 76 ± 3%), piroxicam (77 ± 5, 99 ± 1%), and tenoxicam (90 ± 2, 100 ± 1%), respectively (N = 3). These results show that therapeutic levels of NSAIDs are able to suppress the oxygen-dependent antimicrobial or oxidative functions of neutrophils by inhibiting the generation of hypochlorous acid.

Oxidation of melatonin and its catabolites, N-1-acetyl-N (2)-formyl-5-methoxykynuramine and N-1-acetyl-5-methoxykynuramine, by activated leukocytes

N-1-acetyl-N-2-formyl-5-methoxykynuramine (AFMK) and N-1-acetyl-5-methoxykynuramine (AMK), two melatonin catabolites, have been described as potent antioxidants. We aimed to follow the kinetics of AFMK and AMK formation when melatonin is oxidized by phorbol myristate acetate (PMA) and lipopolysaccharide (LPS)-activated leukocytes. An HPLC-based method was used for AFMK and AMK determination in neutrophil and peripheral blood mononuclear cell cultures supernatants. Samples were separated isocratically on a C18 reverse-phase column using acetonitrile/H2O (25:75) as the mobile phase. AFMK was detected by fluorescence (excitation 340 nm and emission 460 nm) and AMK by UV-VIS absorbance (254 nm). Activation of neutrophils and mononuclear cells with PMA produces larger amounts of AFMK than activation with LPS, probably due to the lower levels of reactive oxygen species formation and myeloperoxidase (MPO) degranulation that occurs when cells are stimulated with LPS. The concentration of AMK found in the supernatant was about 5-10% (from 18-hr cultures) compared with AFMK. This result may reflect its reactivity. Indeed AMK, but not AFMK, is easily oxidized by activated neutrophils in a MPO and hydrogen peroxide-dependent reaction. In conclusion, we defined a simple procedure for the determination of AFMK and AMK in biological samples and demonstrated the capacity of leukocytes to oxidize melatonin and AMK.

Effectiveness of Photogem (R) activated by LED on the decontamination of artificial carious bovine dentin

The aim of this study was the evaluation of the effectiveness of photodynamic therapy on the decontamination of artificially induced carious bovine dentin, using Photoge(R) as the photosensitizer agent and an LED device as a light source. Dentin samples obtained from bovine incisors were immersed in sterile broth supplemented by Lactobacillus acidophillus 10(8) colony formation units (CFU) and Streptococcus mutans 10 8 CFU. Different concentrations of photosensitizer, PA = 1 mg/ml, PB = 2 mg/ml, and PC = 3 mg/ml, and two fluences, D = 24 J/cm(2) and D = 48 J/cm(2), were investigated. After CFU counting per milligram of carious dentin and statistical analysis, we observed that the photodynamic therapy (PDT) parameters used were effective for bacterial reduction in the in vitro model under study. The best result was achieved with the application of Photoge(R) at 2 mg/ml and photoactivated under 24 J/cm(2) showing a survival factor of 0.14. At higher photosensitizer concentrations, a higher dark toxicity was observed. We propose a simple mathematical expression for the determination of PDT parameters of photosensitizer concentration and light fluence for different survival factor values. Since LED devices are simpler and cheaper compared to laser systems, it would be interesting to verify their efficacy as a light source in photodynamic therapy for the decontamination of carious dentin.

Thermally activated exchange narrowing of the Gd3+ ESR fine structure in a single crystal of Ce1-xGdxFe4P12 (x approximate to 0.001) skutterudite

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Protocatechuic Acid Alkyl Esters: Hydrophobicity As a Determinant Factor for Inhibition of NADPH Oxidase

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Utilización de columnas verticales de filtración de manta y arena como pre-tratamiento de un sistema de filtración lenta

Slow sand filtration is an efficient water treatment technique used for treating surface water with relatively low levels of contamination. Despite the slow sand filtration at pathogen, algae and cyanobacteria removal efficiency, it has some restrictions in relation to the required area for slow filters, and the cleaning activities for the filters and the stone pre-filters when used in the treatment. This research evaluated during 120 days the use of non woven & sand pre-filtration columns as part of a slow filtration process for the apparent color, turbidity, algae, cyanobacteria, phytoflagellates and diatomaceous. The columns shown an efficient removal of the monitored parameters and demonstrated as a vantage their faster and easier cleaning process and less awkward than the required to the stone pre-filters. The turbidity removal efficiency increased progressively during the experiment, especially after the first 35 days of the start; the apparent color removal by the pre-filtration columns was of 85%, and working together with the polishing of activated carbon columns was up to 95; the diatomaceous, phytoflagellates, algae and cyanobacteria removal by the columns achieve a weekly average of 95%, its recommended to use filtration rates lower to 1,5m(3)/m(2)/d.