997 resultados para Credit method
Resumo:
Explicitly correlated coupled-cluster calculations of intermolecular interaction energies for the S22 benchmark set of Jurecka, Sponer, Cerny, and Hobza (Chem. Phys. Phys. Chem. 2006, 8, 1985) are presented. Results obtained with the recently proposed CCSD(T)-F12a method and augmented double-zeta basis sets are found to be in very close agreement with basis set extrapolated conventional CCSD(T) results. Furthermore, we propose a dispersion-weighted MP2 (DW-MP2) approximation that combines the good accuracy of MP2 for complexes with predominately electrostatic bonding and SCS-MP2 for dispersion-dominated ones. The MP2-F12 and SCS-MP2-F12 correlation energies are weighted by a switching function that depends on the relative HF and correlation contributions to the interaction energy. For the S22 set, this yields a mean absolute deviation of 0.2 kcal/mol from the CCSD(T)-F12a results. The method, which allows obtaining accurate results at low cost, is also tested for a number of dimers that are not in the training set.
Resumo:
The Attorney General’s Consumer Protection Division receives hundreds of calls and consumer complaints every year. Follow these tips to avoid unexpected expense and disappointments. This record is about: Nailing Down Home Repair Rip-Offs & Disputes
Resumo:
WO3 nanocrystalline powders were obtained from tungstic acid following a sol-gel process. Evolution of structural properties with annealing temperature was studied by X-ray diffraction and Raman spectroscopy. These structural properties were compared with those of WO3 nanopowders obtained by the most common process of pyrolysis of ammonium paratungstate, usually used in gas sensors applications. Sol-gel WO3 showed a high sensor response to NO2 and low response to CO and CH4. The response of these sensor devices was compared with that of WO3 obtained from pyrolysis, showing the latter a worse sensor response to NO2. Influence of operating temperature, humidity, and film thickness on NO2 detection was studied in order to improve the sensing conditions to this gas.
Resumo:
The study of the thermal behavior of complex packages as multichip modules (MCM¿s) is usually carried out by measuring the so-called thermal impedance response, that is: the transient temperature after a power step. From the analysis of this signal, the thermal frequency response can be estimated, and consequently, compact thermal models may be extracted. We present a method to obtain an estimate of the time constant distribution underlying the observed transient. The method is based on an iterative deconvolution that produces an approximation to the time constant spectrum while preserving a convenient convolution form. This method is applied to the obtained thermal response of a microstructure as analyzed by finite element method as well as to the measured thermal response of a transistor array integrated circuit (IC) in a SMD package.
Resumo:
This article designs what it calls a Credit-Risk Balance Sheet (the risk being that of default by customers), a tool which, in principle, can contribute to revealing, controlling and managing the bad debt risk arising from a company¿s commercial credit, whose amount can represent a significant proportion of both its current and total assets.To construct it, we start from the duality observed in any credit transaction of this nature, whose basic identity can be summed up as Credit = Risk. ¿Credit¿ is granted by a company to its customer, and can be ranked by quality (we suggest the credit scoring system) and ¿risk¿ can either be assumed (interiorised) by the company itself or transferred to third parties (exteriorised).What provides the approach that leads to us being able to talk with confidence of a real Credit-Risk Balance Sheet with its methodological robustness is that the dual vision of the credit transaction is not, as we demonstrate, merely a classificatory duality (a double risk-credit classification of reality) but rather a true causal relationship, that is, a risk-credit causal duality.Once said Credit-Risk Balance Sheet (which bears a certain structural similarity with the classic net asset balance sheet) has been built, and its methodological coherence demonstrated, its properties ¿static and dynamic¿ are studied.Analysis of the temporal evolution of the Credit-Risk Balance Sheet and of its applications will be the object of subsequent works.
Resumo:
This article has an immediate predecessor, upon which it is based and with which readers must necessarily be familiar: Towards a Theory of the Credit-Risk Balance Sheet (Vallverdú, Somoza and Moya, 2006). The Balance Sheet is conceptualised on the basis of the duality of a credit-based transaction; it deals with its theoretical foundations, providing evidence of a causal credit-risk duality, that is, a true causal relationship; its characteristics, properties and its static and dynamic characteristics are analyzed. This article, which provides a logical continuation to the previous one, studies the evolution of the structure of the Credit-Risk Balance Sheet as a consequence of a business¿s dynamics in the credit area. Given the Credit-Risk Balance Sheet of a company at any given time, it attempts to estimate, by means of sequential analysis, its structural evolution, showing its usefulness in the management and control of credit and risk. To do this, it bases itself, with the necessary adaptations, on the by-now classic works of Palomba and Cutolo. The establishment of the corresponding transformation matrices allows one to move from an initial balance sheet structure to a final, future one, to understand its credit-risk situation trends, as well as to make possible its monitoring and control, basic elements in providing support for risk management.
Resumo:
Gene correction at the site of the mutation in the chromosome is the absolute way to really cure a genetic disease. The oligonucleotide (ODN)-mediated gene repair technology uses an ODN perfectly complementary to the genomic sequence except for a mismatch at the base that is mutated. The endogenous repair machinery of the targeted cell then mediates substitution of the desired base in the gene, resulting in a completely normal sequence. Theoretically, it avoids potential gene silencing or random integration associated with common viral gene augmentation approaches and allows an intact regulation of expression of the therapeutic protein. The eye is a particularly attractive target for gene repair because of its unique features (small organ, easily accessible, low diffusion into systemic circulation). Moreover therapeutic effects on visual impairment could be obtained with modest levels of repair. This chapter describes in details the optimized method to target active ODNs to the nuclei of photoreceptors in neonatal mouse using (1) an electric current application at the eye surface (saline transpalpebral iontophoresis), (2) combined with an intravitreous injection of ODNs, as well as the experimental methods for (3) the dissection of adult neural retinas, (4) their immuno-labelling, and (5) flat-mounting for direct observation of photoreceptor survival, a relevant criteria of treatment outcomes for retinal degeneration.
Resumo:
[cat] La historiografia ha assenyalat que en el segle XIX el crèdit que els fabricants cotoners catalans oferien als seus clients era de caràcter informal i, per tant, impossible de ser transferit al sistema bancari. Això hauria tingut un efecte negatiu en la rendibilitat de les empreses cotoneres. A partir de l’anàlisi de diversos arxius empresarials, així com de fonts judicials i notarials, aquest treball confirma aquesta descripció dels fets però proposa una interpretació més optimista. Els fabricants feien de banquers dels seus clients perquè eren els millor situats per a exercir aquesta funció. Havien construït una bona estructura d’informació, gestionaven eficientment el risc creditici i obtenien beneficis d’aquesta activitat.
Resumo:
Summary
Resumo:
Over the last 10 years, diffusion-weighted imaging (DWI) has become an important tool to investigate white matter (WM) anomalies in schizophrenia. Despite technological improvement and the exponential use of this technique, discrepancies remain and little is known about optimal parameters to apply for diffusion weighting during image acquisition. Specifically, high b-value diffusion-weighted imaging known to be more sensitive to slow diffusion is not widely used, even though subtle myelin alterations as thought to happen in schizophrenia are likely to affect slow-diffusing protons. Schizophrenia patients and healthy controls were scanned with a high b-value (4000s/mm(2)) protocol. Apparent diffusion coefficient (ADC) measures turned out to be very sensitive in detecting differences between schizophrenia patients and healthy volunteers even in a relatively small sample. We speculate that this is related to the sensitivity of high b-value imaging to the slow-diffusing compartment believed to reflect mainly the intra-axonal and myelin bound water pool. We also compared these results to a low b-value imaging experiment performed on the same population in the same scanning session. Even though the acquisition protocols are not strictly comparable, we noticed important differences in sensitivities in the favor of high b-value imaging, warranting further exploration.
Resumo:
En este trabajo se presenta una aplicación empírica del modelo de Hull-White (2000) al mercado de renta fija español. Este modelo proporciona la expresión por el cálculo de los pagos hechos por el comprador de un credit default swap (CDS), bajo la hipótesis de que no existe riesgo de contrapartida. Se supone, además, que la curva cupón cero, la tasa de recuperación constante y el momento del suceso de crédito son independientes. Se utilizan bonos del Banco Santander Central Hispano para mesurar la probabilidad neutra al riesgo de quiebra y, bajo hipótesis de no arbitraje, se calculan las primas de un CDS, por un bono subyacente con la misma calificación crediticia que la entidad de referencia. Se observa que las primas se ajustan bien a los spreads crediticios del mercado, que se acostumbran a utilizar como alternativa a las mismas.
Resumo:
Purpose: SIOPEN scoring of 123I mIBG imaging has been shown to predict response to induction chemotherapy and outcome at diagnosis in children with HRN.Method: Patterns of skeletal 123I mIBG uptake were assigned numerical scores (Mscore) ranging from 0 (no metastasis) to 72 (diffuse metastases) within 12 body areas as described previously. 271 anonymised, paired image data sets acquired at diagnosis and on completion of Rapid COJEC induction chemotherapy were reviewed, constituting a representative sample of 1602 children treated prospectively within the HR-NBL1/SIOPEN trial. Pre-and post-treatment Mscores were compared with bone marrow cytology (BM) and 3 year event free survival (EFS).Results: Results 224/271 patients showed skeletal MIBG-uptake at diagnosis and were evaluable forMIBG-response. Complete response (CR) on MIBG to Rapid COJEC induction was achieved by 66%, 34% and 15% of patients who had pre-treatment Mscores of <18 (n¼65, 29%), 18-44 (n¼95,42%) and Y ´ 45 (n¼64, 28.5%) respectively (chi squared test p<.0001). Mscore at diagnosis and on completion of Rapid COJEC correlated strongly with BM involvement (p<0.0001). The correlation of pre score with post scores and response was highly significant (p<0.001). Most importantly, the 3 year EFS in 47 children with Mscore 0 at diagnosis was 0.68 (A ` 0.07), by comparison with 0.42 (A` 0.06), 0.35 (A` 0.05) and 0.25 (A` 0.06) for patients in pre-treatment score groups <18, 18-44 and Y ´ 45, respectively (p<0.001). AnMscore threshold ofY ´ 45 at diagnosis was associated with significantly worse outcome by comparison with all other Mscore groups (p¼0.029). The 3 year EFS of 0.53 (A` 0.07) of patients in metastatic CR (mIBG and BM) after Rapid Cojec (33%) is clearly superior to patients not achieving metastatic CR (0.24 (A ` 0.04), p¼0.005).Conclusion: SIOPEN scoring of 123I mIBG imaging has been shown to predict response to induction chemotherapy and outcome at diagnosis in children with HRN.
Resumo:
With the trend in molecular epidemiology towards both genome-wide association studies and complex modelling, the need for large sample sizes to detect small effects and to allow for the estimation of many parameters within a model continues to increase. Unfortunately, most methods of association analysis have been restricted to either a family-based or a case-control design, resulting in the lack of synthesis of data from multiple studies. Transmission disequilibrium-type methods for detecting linkage disequilibrium from family data were developed as an effective way of preventing the detection of association due to population stratification. Because these methods condition on parental genotype, however, they have precluded the joint analysis of family and case-control data, although methods for case-control data may not protect against population stratification and do not allow for familial correlations. We present here an extension of a family-based association analysis method for continuous traits that will simultaneously test for, and if necessary control for, population stratification. We further extend this method to analyse binary traits (and therefore family and case-control data together) and accurately to estimate genetic effects in the population, even when using an ascertained family sample. Finally, we present the power of this binary extension for both family-only and joint family and case-control data, and demonstrate the accuracy of the association parameter and variance components in an ascertained family sample.
Resumo:
Nationwide, about five cents of each highway construction dollar is spent on culverts. In Iowa, average annual construction costs on the interstate, primary, and federal-aid secondary systems are about $120,000,000. Assuming the national figure applies to Iowa, about $6,000,000 are spent on culvert construction annually. For each one percent reduction in overall culvert costs, annual construction costs would be reduced by $60,000. One area of potential cost reduction lies in the sizing of the culvert. Determining the flow area and hydraulic capacity is accomplished in the initial design of the culvert. The normal design sequence is accomplished in two parts. The hydrologic portion consists of the determination of a design discharge in cubic feet per second using one of several available methods. This discharge is then used directly in the hydraulic portion of the design to determine the proper type, size, and shape of culvert to be used, based on various site and design restrictions. More refined hydrologic analyses, including rainfall-runoff analysis, flood hydrograph development, and streamflow routing techniques, are not pursued in the existing design procedure used by most county and state highway engineers.