TESTING A SUBTYPE-SPECIFIC GP41 AMPLIFICATION METHOD FOR GENOTYPING INDIVIDUALS INFECTED BY HUMAN IMMUNODEFICIENCY VIRUS TYPE-1 IN THE BRAZILIAN POPULATION OF ITAJAÍ, SOUTH BRAZIL

The method used by YAGYU et al. for the subtype-specific polymerase chain reaction (PCR) amplification of the gp41 transmembrane region of the human immunodeficiency virus type-1 (HIV-1) env gene, was tested. HIV-1 proviral DNA from 100 infected individuals in Itajaí, South Brazil was used to analyze this method. Seventy individuals were determined according to this method as having PCR products at the expected size for subtypes B, C, D and F. Of these individuals, 26 (37.1%) were observed as having the expected amplification for subtype C, and 42 (60%) were observed as having the expected products for subtypes B and D. Of the subtype B and D amplicons, 16 (22.9%) were classified as subtype D, and 26 (37.1%) were classified as subtype B. Two individuals (2.9%) had amplicons that were observed after subtype F-specific amplification was performed. Sequencing and comparing the patient sequences to reference sequences confirmed the classification of sequences of subtypes C and B. However, sequences that were falsely determined as being D and F in the PCR assay were determined as being subtypes C and B, respectively, by sequence analysis. For those individuals from whom no amplified products were obtained, a low viral load that was indicated in their patient history may explain the difficulty in subtyping by PCR methods. This issue was demonstrated by the results of ANOVA when testing the effect of viral load on the success of PCR amplification. The alignment of the obtained sequences with HIV-1 reference sequences demonstrated that there is high intra-subtype diversity. This indicates that the subtype-specific primer binding sites were not conserved or representative of the subtypes that are observed in the Brazilian populations, and that they did not allow the correct classification of HIV-1 subtypes. Therefore, the proposed method by YAGYU et al. is not applicable for the classification of Brazilian HIV-1 subtypes.

Otimização de processos de logística in-house

A presente dissertação foi realizada no âmbito do Mestrado de Engenharia e Gestão Industrial da Escola Superior de Estudos Industriais e de Gestão, de Vila do Conde. O projeto desenvolvido tem como tema principal a Otimização de processos de Logística in-house baseado num projeto, em contexto empresarial da empresa cliente, Continental Mabor S.A., da Rangel Distribuição e Logística, S.A. Este projeto tem como objetivo a “aglomeração” de dois armazéns do cliente, devido à necessidade de ocupação do armazém de produto acabado interno, para aumento da área de produção. Inicialmente foi feita uma revisão de literatura sobre os temas mais relevantes de suporte para o projeto, nomeadamente na otimização e melhoria contínua. Seguidamente é apresentado o Grupo Rangel, bem como a Rangel Distribuição e Logística, S.A., onde se enquadra o projeto e para se perceber o enquadramento e objetivo. A metodologia usada, caso de estudo, permitiu a aplicação de conceitos e ferramentas usados na literatura neste contexto, como ferramentas de otimização e melhoria continua como as melhores práticas de Kaizen-Lean. Na fase de diagnóstico do atual sistema, foi realizado um mapeamento de fluxo de processos e uma descrição detalhada do layout dos dois armazéns: Armazém de Produto Acabado (APA) e Armazém de Produto Acabado Externo (APAE), bem como todos os recursos, quer técnicos quer humanos necessários. Verificamos ao longo deste projeto várias limitações, inclusive limitações impostas pelo cliente, tal como não aprovar um estudo para um novo layout do armazém. Foi aprovado apenas a replicação do já existente. Com isto, depararam-se constrangimentos na gestão deste projeto. Os custos aumentaram significativamente, embora estes não sejam apresentados por questões de confidencialidade, principalmente com a necessidade de aquisição de novos equipamentos retráteis, e mais baterias para os mesmos, devido às grandes distâncias que irão ser percorridas. Finalmente foi projetado o sistema futuro, de acordo com as necessidades reais do cliente tendo em consideração a otimização de recursos e uma gestão magra (Lean Management). Foi desenvolvida a implementação da metodologia “Kaizen diário”, a dar início em 2016 juntamente com o novo projeto APAE. Com esta projeção foram identificados problemas e implicações no projeto, bem como possíveis melhorias.

Linear amplification with multiple nonlinear devices

Dissertação para obtenção do Grau de Mestre em Engenharia Electrotécnica e Computadores

COMPARISON BETWEEN AUTOMATED SYSTEM AND PCR-BASED METHOD FOR IDENTIFICATION AND ANTIMICROBIAL SUSCEPTIBILITY PROFILE OF CLINICAL Enterococcus spp

Enterococci are increasingly responsible for nosocomial infections worldwide. This study was undertaken to compare the identification and susceptibility profile using an automated MicrosScan system, PCR-based assay and disk diffusion assay of Enterococcus spp. We evaluated 30 clinical isolates of Enterococcus spp. Isolates were identified by MicrosScan system and PCR-based assay. The detection of antibiotic resistance genes (vancomycin, gentamicin, tetracycline and erythromycin) was also determined by PCR. Antimicrobial susceptibilities to vancomycin (30 µg), gentamicin (120 µg), tetracycline (30 µg) and erythromycin (15 µg) were tested by the automated system and disk diffusion method, and were interpreted according to the criteria recommended in CLSI guidelines. Concerning Enterococcus identification the general agreement between data obtained by the PCR method and by the automatic system was 90.0% (27/30). For all isolates of E. faecium and E. faecalis we observed 100% agreement. Resistance frequencies were higher in E. faecium than E. faecalis. The resistance rates obtained were higher for erythromycin (86.7%), vancomycin (80.0%), tetracycline (43.35) and gentamicin (33.3%). The correlation between disk diffusion and automation revealed an agreement for the majority of the antibiotics with category agreement rates of > 80%. The PCR-based assay, the van(A) gene was detected in 100% of vancomycin resistant enterococci. This assay is simple to conduct and reliable in the identification of clinically relevant enterococci. The data obtained reinforced the need for an improvement of the automated system to identify some enterococci.

Evaluation of a volunteered geographical information trust measure in the case of OpenStreetMap

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Analysing and visualising areal crime data. A case study of residential burglary in San Francisco, USA

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

HIGH SENSITIVE PCR METHOD FOR DETECTION OF PATHOGENIC Leptospira spp. IN PARAFFIN-EMBEDDED TISSUES

This study describes the development and application of a new PCR assay for the specific detection of pathogenic leptospires and its comparison with a previously reported PCR protocol. New primers were designed for PCR optimization and evaluation in artificially-infected paraffin-embedded tissues. PCR was then applied to post-mortem, paraffin-embedded samples, followed by amplicon sequencing. The PCR was more efficient than the reported protocol, allowing the amplification of expected DNA fragment from the artificially infected samples and from 44% of the post-mortem samples. The sequences of PCR amplicons from different patients showed >99% homology with pathogenic leptospires DNA sequences. The applicability of a highly sensitive and specific tool to screen histological specimens for the detection of pathogenic Leptospira spp. would facilitate a better assessment of the prevalence and epidemiology of leptospirosis, which constitutes a health problem in many countries.

Ponseti Method: Does Age at the Beginning of Treatment Make a Difference?

The Ponseti method is reportedly effective for treating clubfoot in children up to 9 years of age. However, whether age at the beginning of treatment influences the rate of successful correction and the rate of relapse is unknown. We therefore retrospectively reviewed 68 consecutive children with 102 idiopathic clubfeet treated by the Ponseti technique in four Portuguese hospitals. We followed patients a minimum of 30 months (mean, 41.4 months; range, 30–61 months). The patients were divided into two groups according to their age at the beginning of treatment; Group I was younger than 6 months and Group II was older than 6 months. All feet(100%) were initially corrected and no feet required extensive surgery regardless of age at the beginning of treatment. There were no differences between Groups I and II in the number of casts, tenotomies, success in terms of rate of initial correction, rate of recurrence, and rate of tibialis anterior transference. The rate of the Ponseti method in avoiding extensive surgery was 100% in Groups I and II; relapses occurred in 8% of the feet in younger and older children. Level of Evidence: Level II, prognostic study. See the Guidelines for Authors for a complete description of levels of evidence.

Participatory mapping in the design process of a spatial data infrastructure SDI: a case study in the Biosphere Reserve Rio Platano (Honduras)

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Public Participation geographic information systems in developing countries: lessons from Uganda on the impacts of interactive screens PPGIS and community perceptions of space

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Virtual Campus for the University of Jaume I, Castelló, Spain: 3D Modelling of the Campus Buildings using CityEngine

Dissertation submitted in partial fulfillment of the requirements for the Degree of Master of Science in Geospatial Technologies.

Preparation of gas-filled porous microparticles (GPPs) and microbubbles (MBs) by PGSS method

Dissertation to obtain the Master Degree in Biotechnology

The sum-of-the-parts method: An international application

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics

A Homemade Snare: An Alternative Method for Mechanical Removal of Dirofilaria Immitis in Dogs

Canine dirofilariosis is a life-threatening parasitic disease that is increasingly reported worldwide. Once diagnosed the main treatment goals are to improve the animal's clinical condition and to eliminate all life stages of the parasite with minimal posttreatment side effects. This can be achieved through mechanical, surgical, or chemotherapeutical approaches. Currently, manual extraction is the preferred method to remove adult heartworms due to its diminished invasiveness, reduced damage to the vascular endothelium, and shortened anaesthesia duration. However, it remains an expensive technique that can be highly traumatic. To address this issue, a nontraumatic homemade catheter-guided snare was developed for heartworm removal by adapting and folding a 0.014-inch coronary wire (BMW, Abbott Vascular). Transvenous heartworm extraction was performed on a dog severely infected with adult heartworms by inserting the modified snare into a 6-F Judkins right coronary guiding catheter BMW (Cordis) and advancing it into the right ventricle under fluoroscopic guidance. Fifteen adult specimens of Dirofilaria immitis were successfully extracted from the pulmonary artery and right ventricle without complications. To assure the death of both larvae and adults, postoperative treatment was successfully managed using ivermectin, doxycycline, and melarsomine, with no recurrence after surgery.

What is the best accounting method for financial assets?

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics