2-(4-Aminobenzenesulfonamido)-4,6-dimetylpyrimidin-1-ium 2-carboxy-4,6-dinitrophenolate

In the structure of the of the phenolate salt of the sulfa drug sulfamethazine with 3,5-dinitrosalicylic acid, C12H15N4O2S+ C7H3N2O7-, the dihedral angle between the pyrimidine and phenyl rings of the cation is 59.70(17)\%. Cation--anion hydrogen-bonding interactions involving pyrimidine N+-H...O(carboxyl) and amine N-H...O(carboxyl) pairs give a cyclic R2/2(8) motif while secondary N-H...O hydrogen bonds between the aniline group and both sulfone and nitro O-atom acceptors give a two-dimensional structure extending along (001).

Vibrational spectroscopic characterization of the phosphate mineral hureaulite – (Mn, Fe)5(PO4)2(HPO4)2·4(H2O)

This research was done on hureaulite samples from the Cigana claim, a lithium bearing pegmatite with triphylite and spodumene. The mine is located in Conselheiro Pena, east of Minas Gerais. Chemical analysis was carried out by Electron Microprobe analysis and indicated a manganese rich phase with partial substitution of iron. The calculated chemical formula of the studied sample is: (Mn3.23, Fe1.04, Ca0.19, Mg0.13)(PO4)2.7(HPO4)2.6(OH)4.78. The Raman spectrum of hureaulite is dominated by an intense sharp band at 959 cm−1 assigned to PO stretching vibrations of HPO42− units. The Raman band at 989 cm−1 is assigned to the PO43− stretching vibration. Raman bands at 1007, 1024, 1047, and 1083 cm−1 are attributed to both the HOP and PO antisymmetric stretching vibrations of HPO42− and PO43− units. A set of Raman bands at 531, 543, 564 and 582 cm−1 are assigned to the ν4 bending modes of the HPO42− and PO43− units. Raman bands observed at 414, and 455 cm−1 are attributed to the ν2 HPO42− and PO43− units. The intense A series of Raman and infrared bands in the OH stretching region are assigned to water stretching vibrations. Based upon the position of these bands hydrogen bond distances are calculated. Hydrogen bond distances are short indicating very strong hydrogen bonding in the hureaulite structure. A combination of Raman and infrared spectroscopy enabled aspects of the molecular structure of the mineral hureaulite to be understood.

Infrared and Raman spectroscopic characterization of the phosphate mineral leucophosphite - K(Fe3+)2(PO4)2(OH)·2(H2O)

The phosphate mineral leucophosphite K(Fe2)3þ(PO4)2(OH) · 2H2O has been characterized by SEM-EDS, Raman, and infrared spectro- scopic measurements. The mineral is predominantly a K and Fe phosphate with some minor substitution of Al in the Fe3þ site. Raman bands at 994 and 1058 cm-1 are assigned to the symmetric stretching modes of PO3- and HPO2- units. The Raman bands at 1104, 1135, and 1177 cm-1 are assigned to the PO3- and HPO2- antisymmetric stretching modes. Raman and infrared spectra in the 2600–3800 cm-1 region show a complex set of overlapping bands, which may be resolved into the component bands. The Raman bands observed at 3325, 3355, and 3456 cm-1 are attributed to water stretching vibrations, and in the infrared spectrum, bands at 3237, 3317, and 3453 cm-1 are assigned to water stretching bands.

The adoption of e-learning 2.0 in higher education by teachers and students : an investigation using mixed methods approach

This paper describes an approach to investigate the adoption of Web 2.0 in the classroom using a mixed methods study. By using a combination of qualitative or quantitative data collection and analysis techniques, we attempt to synergize the results and provide a more valid understanding of Web 2.0 adoption for learning by both teachers and students. This approach is expected to yield a better holistic view on the adoption issues associated with the e-learning 2.0 concept in current higher education as opposed to single method studies done previously. This paper also presents some early findings of e-learning 2.0 adoption using this research method

Slice, mine and dice : complexity-aware automated discovery of business process models

Automated process discovery techniques aim at extracting models from information system logs in order to shed light into the business processes supported by these systems. Existing techniques in this space are effective when applied to relatively small or regular logs, but otherwise generate large and spaghetti-like models. In previous work, trace clustering has been applied in an attempt to reduce the size and complexity of automatically discovered process models. The idea is to split the log into clusters and to discover one model per cluster. The result is a collection of process models -- each one representing a variant of the business process -- as opposed to an all-encompassing model. Still, models produced in this way may exhibit unacceptably high complexity. In this setting, this paper presents a two-way divide-and-conquer process discovery technique, wherein the discovered process models are split on the one hand by variants and on the other hand hierarchically by means of subprocess extraction. The proposed technique allows users to set a desired bound for the complexity of the produced models. Experiments on real-life logs show that the technique produces collections of models that are up to 64% smaller than those extracted under the same complexity bounds by applying existing trace clustering techniques.

Social media and Web 2.0 : teacher-librarians, risk and inequity

This paper reports research into teacher-­‐librarians’ perceptions of using social media and Web 2.0 in teaching and learning. A pilot study was conducted with teacher-­‐librarians in five government schools and five private schools in southeast Queensland. The findings revealed that there was a strong digital divide between government schools and private schools, with government schools suffering severe restrictions on the use of social media and Web 2.0, leading to an unsophisticated use of these technologies. It is argued that internet ‘over-­‐ blocking’ may lead to government school students not being empowered to manage risks in an open internet environment. Furthermore, their use of information for academic and recreational learning may be compromised. This has implications particularly for low socioeconomic students, leading to further inequity in the process and outcomes of Australian education.

Complexity of increasing the secure connectivity in wireless ad hoc networks

We consider the problem of maximizing the secure connectivity in wireless ad hoc networks, and analyze complexity of the post-deployment key establishment process constrained by physical layer properties such as connectivity, energy consumption and interference. Two approaches, based on graph augmentation problems with nonlinear edge costs, are formulated. The first one is based on establishing a secret key using only the links that are already secured by shared keys. This problem is in NP-hard and does not accept polynomial time approximation scheme PTAS since minimum cutsets to be augmented do not admit constant costs. The second one extends the first problem by increasing the power level between a pair of nodes that has a secret key to enable them physically connect. This problem can be formulated as the optimal key establishment problem with interference constraints with bi-objectives: (i) maximizing the concurrent key establishment flow, (ii) minimizing the cost. We prove that both problems are NP-hard and MAX-SNP with a reduction to MAX3SAT problem.

Damage assessment in reinforced concrete flexural members using modal strain energy based method

Damage assessment (damage detection, localization and quantification) in structures and appropriate retrofitting will enable the safe and efficient function of the structures. In this context, many Vibration Based Damage Identification Techniques (VBDIT) have emerged with potential for accurate damage assessment. VBDITs have achieved significant research interest in recent years, mainly due to their non-destructive nature and ability to assess inaccessible and invisible damage locations. Damage Index (DI) methods are also vibration based, but they are not based on the structural model. DI methods are fast and inexpensive compared to the model-based methods and have the ability to automate the damage detection process. DI method analyses the change in vibration response of the structure between two states so that the damage can be identified. Extensive research has been carried out to apply the DI method to assess damage in steel structures. Comparatively, there has been very little research interest in the use of DI methods to assess damage in Reinforced Concrete (RC) structures due to the complexity of simulating the predominant damage type, the flexural crack. Flexural cracks in RC beams distribute non- linearly and propagate along all directions. Secondary cracks extend more rapidly along the longitudinal and transverse directions of a RC structure than propagation of existing cracks in the depth direction due to stress distribution caused by the tensile reinforcement. Simplified damage simulation techniques (such as reductions in the modulus or section depth or use of rotational spring elements) that have been extensively used with research on steel structures, cannot be applied to simulate flexural cracks in RC elements. This highlights a big gap in knowledge and as a consequence VBDITs have not been successfully applied to damage assessment in RC structures. This research will address the above gap in knowledge and will develop and apply a modal strain energy based DI method to assess damage in RC flexural members. Firstly, this research evaluated different damage simulation techniques and recommended an appropriate technique to simulate the post cracking behaviour of RC structures. The ABAQUS finite element package was used throughout the study with properly validated material models. The damaged plasticity model was recommended as the method which can correctly simulate the post cracking behaviour of RC structures and was used in the rest of this study. Four different forms of Modal Strain Energy based Damage Indices (MSEDIs) were proposed to improve the damage assessment capability by minimising the numbers and intensities of false alarms. The developed MSEDIs were then used to automate the damage detection process by incorporating programmable algorithms. The developed algorithms have the ability to identify common issues associated with the vibration properties such as mode shifting and phase change. To minimise the effect of noise on the DI calculation process, this research proposed a sequential order of curve fitting technique. Finally, a statistical based damage assessment scheme was proposed to enhance the reliability of the damage assessment results. The proposed techniques were applied to locate damage in RC beams and slabs on girder bridge model to demonstrate their accuracy and efficiency. The outcomes of this research will make a significant contribution to the technical knowledge of VBDIT and will enhance the accuracy of damage assessment in RC structures. The application of the research findings to RC flexural members will enable their safe and efficient performance.

A Summative Evaluation of the Stronger Smarter Learning Communities Project : Vol 1 and Vol 2

This is a summative evaluation of the Stronger Smarter Learning Communities (SSLC) project that examines whether and how the SSLC project had an impact on Australian state schools which adopted its models and approaches. Drawing from qualitative and quantitative data sets, it also presents the largest scale and most comprehensive analysis of Indigenous education practices and outcomes to date. It includes empirical findings on: success in changing school ethos and community engagement; challenges in progress at closure of the 'gap' in conventionally measured achievement and performance; schools' and principals' choices in curriculum and instruction; profiles of teachers' and principals' training and views on teacher education; and a strong emphasis on community and school Indigenoous voices and views on Indigenous education.

Connecting across continents : collaborative learning in a Web 2.0 world

Purpose – The article aims to review a university course, offered to students in both Australia and Germany, to encourage them to learn about designing, implementing, marketing and evaluating information programs and services in order to build active and engaged communities. The concepts and processes of Web 2.0 technologies come together in the learning activities, with students establishing their own personal learning networks (PLNs). Design/methodology/approach – The case study examines the principles of learning and teaching that underpin the course and presents the students' own experiences of the challenges they faced as they explored the interactive, participative and collaborative dimensions of the web. Findings – The online format of the course and the philosophy of learning through play provided students with a safe and supportive environment for them to move outside of their comfort zones, to be creative, to experiment and to develop their professional personas. Reflection on learning was a key component that stressed the value of reflective practice in assisting library and information science (LIS) professionals to adapt confidently to the rapidly changing work environment. Originality/value – This study provides insights into the opportunities for LIS courses to work across geographical boundaries, to allow students to critically appraise library practice in different contexts and to become active participants in wider professional networks.

Introduction to the special issue

Creative productivity emerges from human interactions (Hartley, 2009, p. 214). In an era when life is lived in rather than with media (Deuze, this issue), this productivity is widely distributed among ephemeral social networks mediated through the internet. Understanding the underlying dynamics of these networks of human interaction is an exciting and challenging task that requires us to come up with new ways of thinking and theorizing. For example, inducting theory from case studies that are designed to show the exceptional dynamics present within single settings can be augmented today by largescale data generation and collections that provide new analytic opportunities to research the diversity and complexity of human interaction. Large-scale data generation and collection is occurring across a wide range of individuals and organisations. This offers a massive field of analysis which internet companies and research labs in particular are keen on exploring. Lazer et al (2009: 721) argue that such analytic potential is transformational for many if not most research fields but that the use of such valuable data must neither remain confined to private companies and government agencies nor to a privileged set of academic researchers whose studies cannot be replicated nor critiqued. In fact, the analytic capacity to have data of such unprecedented scope and scale available not only requires us to analyse what is and could be done with it and by whom (1) but also what it is doing to us, our cultures and societies (2). Part (1) of such analysis is interested in dependencies and their implications. Part (2) of the enquiry embeds part (1) in a larger context that analyses the long-term, complex dynamics of networked human interaction. From the latter perspective we can treat specific phenomena and the methods used to analyse them as moments of evolution.

SECIS-binding protein 2 promotes cell survival by protecting against oxidative stress

Reactive oxygen species (ROS) are a primary cause of cellular damage that leads to cell death. In cells, protection from ROS-induced damage and maintenance of the redox balance is mediated to a large extent by selenoproteins, a distinct family of proteins that contain selenium in form of selenocysteine (Sec) within their active site. Incorporation of Sec requires the Sec-insertion sequence element (SECIS) in the 3'-untranslated region of selenoproteins mRNAs and the SECIS-binding protein 2 (SBP2). Previous studies have shown that SBP2 is required for the Sec-incorporation mechanism; however, additional roles of SBP2 in the cell have remained undefined. We herein show that depletion of SBP2 by using antisense oligonucleotides (ASOs) causes oxidative stress and induction of caspase- and cytochrome c-dependent apoptosis. Cells depleted of SBP2 have increased levels of ROS, which lead to cellular stress manifested as 8-oxo-7,8-dihydroguanine (8-oxo-dG) DNA lesions, stress granules, and lipid peroxidation. Small-molecule antioxidants N-acetylcysteine, glutathione, and α-tocopherol only marginally reduced ROS and were unable to rescue cells fully from apoptosis, indicating that apoptosis might be directly mediated by selenoproteins. Our results demonstrate that SBP2 is required for protection against ROS-induced cellular damage and cell survival. Antioxid. Redox Signal. 12, 797–808.