Effect of cooking on non-starch polysaccharides of hard-to-cook beans

Experiments carried out to study changes induced by hard-to-cook (HTC) phenomenon in the non-starch polysaccharides of beans stored at 30 degrees C and 75% RH for 8 months showed that the development of HTC did not affect the amounts of soluble and insoluble fibre in cooked seeds but changed their carbohydrates physical properties. Aged beans non-starch polysaccharides presented lower water-solubility and underwent lower degradation of galacturonans and arabinose-rich polysaccharides when submitted to cooking. The decrease in non-starch polysaccharides water-solubility produced a shift in the polymers fractionation profile which resulted in an increase of weak and middle-alkali soluble polymers bulk as well as in their arabinose and uronic acid contents. Uronic acid contents were higher in polymers released by 1 M NaOH and in the cellulose-rich residues while the arabinose contents were higher in the mild-alkali soluble polymers of aged seeds. Methylation analysis showed no evident alterations in the xyloglucans and arabinans branching degree with beans ageing. However, both, the molecular mass of water-soluble pectins and CDTA-soluble pectins, increased. Even though changes in the non-starch polysaccharide solubility were not related to the decrease in the arabinan and xyloglucan degree of branching they may be related to the formation of new chemical interactions other than hydrogen bond. There was a correlation between acidic and neutral polysaccharides insolubilisation in beans ageing and probably in beans hardening. After processing, aged seeds present higher amounts of insoluble fibre when compared to normal beans. (C) 2008 Elsevier Ltd. All rights reserved.

Effect of the compact Ti layer on the efficiency of dye-sensitized solar cells assembled using stainless steel sheets

Titanium films have been deposited on stainless steel metal sheets using dc magnetron sputtering technique at different substrate temperatures. The structure of the titanium films strongly depend on the substrate temperature. The titanium film deposited at the substrate temperature lower than 300 ◦C has a loose flat sheet grains structure and the titanium film prepared at the substrate temperature higher than 500 ◦C has a dense nubby grains structure. The DSSC assembled using stainless steel sheet coated with titanium film deposited at high substrate temperature has a low charge transfer resistance in the TiO2/Ti interface and results in a high conversion efficiency. The DSSC assembled using stainless steel sheet coated with titanium film deposited at temperature higher than 500 ◦C has higher conversion efficiency than that assembled using titanium metal sheet as the substrate. The maximum conversion efficiency, 2.26% is obtained for DSSC assembled using stainless steel sheet coated with titanium film deposited at 700 ◦C substrate temperature, which is about 70% of the conversion efficiency of the FTO reference cell used in this study.

Non-uniform microstrip antenna array for RX DSRC communications

The urgent need to mitigate traffic problems such as accidents, road hazards, pollution and traffic jam have strongly driven the development of vehicular communications. DSRC (Dedicated Short Range Communications) is the technology of choice in vehicular communications, enabling real time information exchange among vehicles V2V (Vehicle-to-Vehicle) and between vehicles and infrastructure V2I (Vehicle-Infrastructure). This paper presents a receiving antenna for a single lane DSRC control unit. The antenna is a non-uniform array with five microstrip patches. The obtained beam width, bandwidth and circular polarization quality, among other characteristics, are compatible with the DSRC standards, making this antenna suitable for this application. © 2014 IEEE.

Design of biped robot walking based on non-linear periodical oscillations

Magdeburg, Univ., Fak. für Elektrotechnik und Informationstechnik, Diss., 2012

On non-marine shells from Northeastern Brazil and Peru.

v.37:no.10(1955)

Predators promote defence of rhizosphere bacterial populations by selective feeding on non-toxic cheaters.

Soil pseudomonads increase their competitiveness by producing toxic secondary metabolites, which inhibit competitors and repel predators. Toxin production is regulated by cell-cell signalling and efficiently protects the bacterial population. However, cell communication is unstable, and natural populations often contain signal blind mutants displaying an altered phenotype defective in exoproduct synthesis. Such mutants are weak competitors, and we hypothesized that their fitness depends on natural communities on the exoproducts of wild-type bacteria, especially defence toxins. We established mixed populations of wild-type and signal blind, non-toxic gacS-deficient mutants of Pseudomonas fluorescens CHA0 in batch and rhizosphere systems. Bacteria were grazed by representatives of the most important bacterial predators in soil, nematodes (Caenorhabditis elegans) and protozoa (Acanthamoeba castellanii). The gacS mutants showed a negative frequency-dependent fitness and could reach up to one-third of the population, suggesting that they rely on the exoproducts of the wild-type bacteria. Both predators preferentially consumed the mutant strain, but populations with a low mutant load were resistant to predation, allowing the mutant to remain competitive at low relative density. The results suggest that signal blind Pseudomonas increase their fitness by exploiting the toxins produced by wild-type bacteria, and that predation promotes the production of bacterial defence compounds by selectively eliminating non-toxic mutants. Therefore, predators not only regulate population dynamics of soil bacteria but also structure the genetic and phenotypic constitution of bacterial communities.

Triatoma infestans is more efficient than Panstrongylus megistus in obtaining blood meals on non Anaesthetized mice

We compared the influence of the bug density in the capacity of Triatoma infestans and Panstrongylus megistus in obtaining blood meal in non anaesthetized mice. The regression anlysis for increase in body weight (mg) versus density (no. of bugs/mouse) showed that in experiments with anaesthetized mice (AM), no correlation was observed. In experiments with non anaesthetized mice (NAM) the weight increase was inversely proportional to density. The regression slope for blood meal size on density was less steep for T. infestans than for P. megistus (-1.9 and -3.0, respectively). The average weight increase of P. megistus nymphus in experiments with AM was higher than for T. infestans nymphs; however, in experiments with NAM such results were inverted. Mortality of P. megistus was significantly higher than of T. infestans with NAM. However, in experiments with AM very low mortality was observed. Considering the mortality and the slope of regression line on NAM, T. infestans is more efficient than P. megistus in obtaining blood meal in similar densities, possibly because it caused less irritation of the mice. The better exploitation of blood source of T. infestans when compared with P. megistus in similar densities, favours the maintenance of a better nutritional status in higher densities. This could explain epidemiological findings in which T. infestans not only succeeds in establishing larger colonies but also dislodges P. megistus in human dwellings when it is introduced in areas where the latter species prevails.

The Office International des Epizooties ad hoc Group on Non Tsetse Animal Trypanosomoses: Its Origin, Scope and Perspectives

A summary of the goals and activities of the ad hoc group on Non Tsetse Transmitted Animal Trypanosomosis belonging to the Office International des Epizooties is presented.

Use of quantum dots in aqueous solution to detect blood fingermarks on non-porous surfaces.

A new and original reagent based on the use of highly fluorescent cadmium telluride (CdTe) quantum dots (QDs) in aqueous solution is proposed to detect weak fingermarks in blood on non-porous surfaces. To assess the efficiency of this approach, comparisons were performed with one of the most efficient blood reagents on non-porous surfaces, Acid Yellow 7 (AY7). To this end, four non-porous surfaces were studied, i.e. glass, transparent polypropylene, black polyethylene, and aluminium foil. To evaluate the sensitivity of both reagents, sets of depleted fingermarks were prepared, using the same finger, initially soaked with blood, which was then successively applied on the same surface without recharging it with blood or latent secretions. The successive marks were then cut in halves and the halves treated separately with each reagent. The results showed that QDs were equally efficient to AY7 on glass, polyethylene and polypropylene surfaces, and were superior to AY7 on aluminium. The use of QDs in new, sensitive and highly efficient latent and blood mark detection techniques appears highly promising. Health and safety issues related to the use of cadmium are also discussed. It is suggested that applying QDs in aqueous solution (and not as a dry dusting powder) considerably lowers the toxicity risks.

8-month non-use of a language. A case tudy. A longitudinal study of the effects on non use of one of the languages (Spanish) of a German L1 multilingual

Under the Dynamic Model of Multilingualism multilinguals are especially vulnerable to language attrition. It was the aim of the present study to verify if this was the case and to observe whether the different linguistic skills (receptive vs. descriptive) and the different linguistic levels (syntactic, lexical, morphological, etc.) would be affected equally.Data were gathered longitudinally by means of a language test for the subject’s reading, writing, listening and speaking skills as well as her knowledge of grammar and vocabulary. Although the overall accuracy remained intact and no proof for attrition in the receptive skills was found, the productive skills - mainly fluency - were shown to have suffered from language attrition. This was demonstrated by an increase in the number of pauses, hesitations, repetitions and self-corrections among others and decrease in the percentage of error-free clauses and decrease in the clause length, in oral and written fluency respectively.

The provision on non-audit services by auditors: Let the market evolve and decide

The provision of non-audit services by auditors to their auditclients reduces total costs, increases technical competence and motivates more intense competition. Furthermore, theseservices do not necessarily damage auditor independence nor the quality of non-audit services. This assessment leads to recommending that legislative policy should aim at facilitating the development and use of the safeguardsprovided by the free action of market forces. Regulation should thus aim to enable the parties-audit firms, self-regulatory bodies and audit clients-to discover through competitive market interaction both the most efficient mix of services and the corresponding quality safeguards, adjusting for the costs and benefits of each possibility. Particular emphasis is placed on the role played by fee income diversification and the enhancement, through disclosurerules, of market incentives to diversify.

Cadmium-free quantum dots in aqueous solution: potential for fingermark detection, synthesis and an application to the detection of fingermarks in blood on non-porous surfaces

The use of quantum dots (QDs) in the area of fingermark detection is currently receiving a lot of attention in the forensic literature. Most of the research efforts have been devoted to cadmium telluride (CdTe) quantum dots often applied as powders to the surfaces of interests. Both the use of cadmium and the nano size of these particles raise important issues in terms of health and safety. This paper proposes to replace CdTe QDs by zinc sulphide QDs doped with copper (ZnS:Cu) to address these issues. Zinc sulphide-copper doped QDs were successfully synthesized, characterized in terms of size and optical properties and optimized to be applied for the detection of impressions left in blood, where CdTe QDs proved to be efficient. Effectiveness of detection was assessed in comparison with CdTe QDs and Acid Yellow 7 (AY7, an effective blood reagent), using two series of depletive blood fingermarks from four donors prepared on four non-porous substrates, i.e. glass, transparent polypropylene, black polyethylene and aluminium foil. The marks were cut in half and processed separately with both reagents, leading to two comparison series (ZnS:Cu vs. CdTe, and ZnS:Cu vs. AY7). ZnS:Cu proved to be better than AY7 and at least as efficient as CdTe on most substrates. Consequently, copper-doped ZnS QDs constitute a valid substitute for cadmium-based QDs to detect blood marks on non-porous substrates and offer a safer alternative for routine use.

Country actions to meet UN commitments on non-communicable diseases: a stepwise approach.

Strong leadership from heads of state is needed to meet national commitments to the UN political declaration on non-communicable diseases (NCDs) and to achieve the goal of a 25% reduction in premature NCD mortality by 2025 (the 25 by 25 goal). A simple, phased, national response to the political declaration is suggested, with three key steps: planning, implementation, and accountability. Planning entails mobilisation of a multisectoral response to develop and support the national action plan, and to build human, financial, and regulatory capacity for change. Implementation of a few priority and feasible cost-effective interventions for the prevention and treatment of NCDs will achieve the 25 by 25 goal and will need only few additional financial resources. Accountability incorporates three dimensions: monitoring of progress, reviewing of progress, and appropriate responses to accelerate progress. A national NCD commission or equivalent, which is independent of government, is needed to ensure that all relevant stakeholders are held accountable for the UN commitments to NCDs.

What to consider for applying backfilling on non-dedicated environments

The resource utilization level in open laboratories of several universities has been shown to be very low. Our aim is to take advantage of those idle resources for parallel computation without disturbing the local load. In order to provide a system that lets us execute parallel applications in such a non-dedicated cluster, we use an integral scheduling system that considers both Space and Time sharing concerns. For dealing with the Time Sharing (TS) aspect, we use a technique based on the communication-driven coscheduling principle. This kind of TS system has some implications on the Space Sharing (SS) system, that force us to modify the way job scheduling is traditionally done. In this paper, we analyze the relation between the TS and the SS systems in a non-dedicated cluster. As a consequence of this analysis, we propose a new technique, termed 3DBackfilling. This proposal implements the well known SS technique of backfilling, but applied to an environment with a MultiProgramming Level (MPL) of the parallel applications that is greater than one. Besides, 3DBackfilling considers the requirements of the local workload running on each node. Our proposal was evaluated in a PVM/MPI Linux cluster, and it was compared with several more traditional SS policies applied to non-dedicated environments.