Pharmacological and Toxicological Studies of Essential Oil of Lavandula stoechas subsp. luisieri.

The present study was carried out to evaluate the chemical and pharmacological properties of essential oil (EO) of Lavandula stoechas L. subsp. luisieri that is a spontaneous shrub widespread in Alentejo (Portugal). Oxygenated monoterpenes, as 1,8-cineole, lavandulol and necrodane derivatives are the main components of essential oil. It revealed important antioxidant activity with high ability to inhibit the lipid peroxidation and showed an outstanding effect against a wide spectrum of microorganisms, such as Gram-positive and Gram-negative bacteria and pathogenic yeasts. The analgesic effect studied in rats was dose dependent, reaching a maximum of 67 % at 60 min. with the dose of 200 mg/kg and the anti-inflammatory activity with this dose caused an inhibition in carrageenan-induced rat paw oedema (83 %) that is higher than dexamethasone 1 mg/Kg (69 %). Besides, animals exhibited a normal behaviour after EO administration revealing low toxicity. Essential oil of L. luisieri from Alentejo that presents important pharmacological properties and low toxicity is a promised candidate to be used as food supplement or in pharmaceutical applications.

O/W Nanoemulsion After 15 Years of Preparation: A Suitable Vehicle for Pharmaceutical and Cosmetic Applications

The application of nanoemulsions is due to have good stability, uniform spreading and enhance active penetration upon skin. Nanometer emulsions can be obtained by low-energy emulsification method. The required hydrophilic and lipophilic balance indicates the better balance of emulsifier for optimum system emulsification. Emulsion stability is evidently controlled for the properties of the adsorbed layer formed in the surface of its globules, know as potential zeta. The aim of this work was to evaluate the oil/water nanoemulsion of formulation obtained after 15 years of preparation. The results suggested that the nanoemulsion have performed stability for many years.

Potentiometric and conductimetric studies of chemical equilibria for pyridoxine hydrochloride in aqueous solutions: simple experimental determination of pKa values and analytical applications to pharmaceutical analysis

The combination of two low-cost classical procedures based on titrimetric techniques is presented for the determination of pyridoxine hydrochloride in pharmaceuticals samples. Initially some experiments were carried out aiming to determine both pKa1 and pKa2 values, being those compared to values of literature and theoretical procedures. Commercial samples containing pyridoxine hydrochloride were electrochemically analysed by exploiting their acid-base and precipitation reactions. Potentiometric titrations accomplished the reaction between the ionizable hydrogens present in pyridoxine hydrochloride, being NaOH used as titrant; while the conductimetric method was based on the chemical precipitation between the chloride of pyridoxine hydrochloride molecule and Ag+ ions from de silver nitrate, changing the conductivity of the solution. Both methods were applied to the same commercial samples leading to concordant results when compared by statistical tests (95 and 98% confidence levels). Recoveries ranging from 99.0 to 108.1% were observed, showing no significant interference on the results.

Non-conventional applications of computerized tomography: Analysis of solid dosage forms produced by pharmaceutical industry

X-ray computed tomography (CT) refers to the cross-sectional imaging of an object measuring the transmitted radiation at different directions. In this work, we describe a non-conventional application of computerized tomography: visualization and improvements in the understanding of some internal structural features of solid dosage forms. A micro-CT X-ray scanner, with a minimum resolution of 30 μm was used to characterize some pharmaceutical tablets, granules, controlled-release osmotic tablet and liquid-filled soft-gelatin capsules. The analysis presented in this work are essentially qualitative, but quantitative parameters, such as porosity, density distribution, tablets dimensions, etc. could also be obtained using the related CT techniques. © 2010 American Institute of Physics.

Recent applications of analytical techniques for quantitative pharmaceutical analysis: A review

The intension of this paper was to review and discuss some of the current quantitative analytical procedures which are used for quality control of pharmaceutical products. The selected papers were organized according to the analytical technique employed. Several techniques like ultraviolet/visible spectrophotometry, fluorimetry, titrimetry, electroanalytical techniques, chromatographic methods (thin-layer chromatography, gas chromatography and high-performance liquid chromatography), capillary electrophoresis and vibrational spectroscopies are the main techniques that have been used for the quantitative analysis of pharmaceutical compounds. In conclusion, although simple techniques such as UV/VIS spectrophotometry and TLC are still extensively employed, HPLC is the most popular instrumental technique used for the analysis of pharmaceuticals. Besides, a review of recent works in the area of pharmaceutical analysis showed a trend in the application of techniques increasingly rapid such as ultra performance liquid chromatography and the use of sensitive and specific detectors as mass spectrometers.

Applications of RFID in the pharmaceutical supply chain

L’obiettivo di questa tesi è principalmente quello di mostrare le possibili applicazioni della tecnologia RFID (Radio Frequency Identification) all’interno della supply chain farmaceutica, cercando di comprendere il campo di applicazione di questa tecnologia in un’industria così altamente regolata e complessa come quella farmaceutica. La tesi è organizzata in tre sezioni; nel primo capitolo si trattano i principi alla base della tecnologia RFID e l’attuale stato dell’arte nella standardizzazione della banda di frequenza utilizzata e nell’hardware. In questa sezione sono poi mostrate le principali applicazioni e nella parte finale i problemi affrontati da un’azienda nell’applicare l’RFID al proprio business. Il secondo capitolo descrive le parti coinvolte nell’industria farmaceutica, dal produttore al consumatore finale, poi esamina le caratteristiche essenziali della supply chain farmaceutica e gli aspetti chiave e le criticità da affrontare in questo campo per essere efficiente e per consegnare il prodotto al cliente in maniera sicura e consistente. Infine nell’ultima sezione i due argomenti centrali sono fusi assieme, cercando di esaminare come la tecnologia RFID sia in grado di risolvere i problemi affrontati da tale industria. Il lavoro non vuole mostrare la tecnologia RFID come una panacea di tutte le problematiche presentate in questa industria, ma vuole cercare di colmare il gap presente in letteratura riguardo le possibili applicazioni di questa tecnologia nell’industria specificata.

Applications of thermal processing in pharmaceutical drug product development

Dissertação para obtenção do grau de Mestre no Instituto Superior de Ciências da Saúde Egas Moniz

Pharmaceutical inhalation aerosols: their delivery and therapeutic applications

DUE TO COPYRIGHT RESTRICTIONS ONLY AVAILABLE FOR CONSULTATION AT ASTON UNIVERSITY LIBRARY AND INFORMATION SERVICES WITH PRIOR ARRANGEMENT

Development of advanced capillary electrophoresis techniques with UV and mass spectrometry detection for forensic, pharmaceutical and environmental applications

Capillary electrophoresis (CE) is a modern analytical technique, which is electrokinetic separation generated by high voltage and taken place inside the small capillaries. In this dissertation, several advanced capillary electrophoresis methods are presented using different approaches of CE and UV and mass spectrometry are utilized as the detection methods. ^ Capillary electrochromatography (CEC), as one of the CE modes, is a recent developed technique which is a hybrid of capillary electrophoresis and high performance liquid chromatography (HPLC). Capillary electrochromatography exhibits advantages of both techniques. In Chapter 2, monolithic capillary column are fabricated using in situ photoinitiation polymerization method. The column was then applied for the separation of six antidepressant compounds. ^ Meanwhile, a simple chiral separation method is developed and presented in Chapter 3. Beta cycodextrin was utilized to achieve the goal of chiral separation. Not only twelve cathinone analytes were separated, but also isomers of several analytes were enantiomerically separated. To better understand the molecular information on the analytes, the TOF-MS system was coupled with the CE. A sheath liquid and a partial filling technique (PFT) were employed to reduce the contamination of MS ionization source. Accurate molecular information was obtained. ^ It is necessary to propose, develop, and optimize new techniques that are suitable for trace-level analysis of samples in forensic, pharmaceutical, and environmental applications. Capillary electrophoresis (CE) was selected for this task, as it requires lower amounts of samples, it simplifies sample preparation, and it has the flexibility to perform separations of neutral and charged molecules as well as enantiomers. ^ Overall, the study demonstrates the versatility of capillary electrophoresis methods in forensic, pharmaceutical, and environmental applications.^

Development of Advanced Capillary Electrophoresis Techniques with UV and Mass Spectrometry Detection for Forensic, Pharmaceutical and Environmental Applications

Capillary electrophoresis (CE) is a modern analytical technique, which is electrokinetic separation generated by high voltage and taken place inside the small capillaries. In this dissertation, several advanced capillary electrophoresis methods are presented using different approaches of CE and UV and mass spectrometry are utilized as the detection methods. Capillary electrochromatography (CEC), as one of the CE modes, is a recent developed technique which is a hybrid of capillary electrophoresis and high performance liquid chromatography (HPLC). Capillary electrochromatography exhibits advantages of both techniques. In Chapter 2, monolithic capillary column are fabricated using in situ photoinitiation polymerization method. The column was then applied for the separation of six antidepressant compounds. Meanwhile, a simple chiral separation method is developed and presented in Chapter 3. Beta cycodextrin was utilized to achieve the goal of chiral separation. Not only twelve cathinone analytes were separated, but also isomers of several analytes were enantiomerically separated. To better understand the molecular information on the analytes, the TOF-MS system was coupled with the CE. A sheath liquid and a partial filling technique (PFT) were employed to reduce the contamination of MS ionization source. Accurate molecular information was obtained. It is necessary to propose, develop, and optimize new techniques that are suitable for trace-level analysis of samples in forensic, pharmaceutical, and environmental applications. Capillary electrophoresis (CE) was selected for this task, as it requires lower amounts of samples, it simplifies sample preparation, and it has the flexibility to perform separations of neutral and charged molecules as well as enantiomers. Overall, the study demonstrates the versatility of capillary electrophoresis methods in forensic, pharmaceutical, and environmental applications.

Assessment of the Mutagenic Activity of Extracts of Brazilian Propolis in Topical Pharmaceutical Formulations on Mammalian Cells In Vitro and In Vivo

Propolis possesses various biological activities such as antibacterial, antifungal, anti-inflammatory, anesthetic and antioxidant properties. A topically applied product based on Brazilian green propolis was developed for the treatment of burns. For such substance to be used more safely in future clinical applications, the present study evaluated the mutagenic potential of topical formulations supplemented with green propolis extract (1.2, 2.4 and 3.6%) based on the analysis of chromosomal aberrations and of micronuclei. In the in vitro studies, 3-h pulse (G(1) phase of the cell cycle) and continuous (20 h) treatments were performed. In the in vivo assessment, the animals were injured on the back and then submitted to acute (24 h), subacute (7 days) and subchronic (30 days) treatments consisting of daily dermal applications of gels containing different concentrations of propolis. Similar frequencies of chromosomal aberrations were observed for cultures submitted to 3-h pulse and continuous treatment with gels containing different propolis concentrations and cultures not submitted to any treatment. However, in the continuous treatment cultures treated with the 3.6% propolis gel presented significantly lower mitotic indices than the negative control. No statistically significant differences in the frequencies of micronuclei were observed between animals treated with gels containing different concentrations of propolis and the negative control for the three treatment times. Under the present conditions, topical formulations containing different concentrations of green propolis used for the treatment of burns showed no mutagenic effect in either test system, but 3.6% propolis gel was found to be cytotoxic in the in vitro test.

Feedback regarding students initial pharmaceutical internship from the University of Medicine and Pharmacy, Cluj-Napoca

Introduction/Aims: The purpose of the study is to evaluate the perception of the organization, the development and the evaluation of the initial stage in the internship of students, in order to improve these activities and to establish the adequate objectives in accordance with the changes concerning the concept of modern pharmacy. Materials and methods: An online survey was made using Google Docs ® -Create Form extension. All results were accumulated and computed using Microsoft Excel ®. The questionnaire consisted of 11 questions, structured on several levels: the objectives and how they can be achieved, internship organization, the internship training (effective participation in specific activities and integration in the pharmaceutical activity), the assessment, the profile of tutor / pharmacy. The questionnaire was completed by students from the Faculty of Pharmacy, University of Medicine and Pharmacy "Iuliu Haţieganu" Cluj Napoca, Romania. Results and discussions. The study was conducted on 308 students (60% of all students from the study years II-IV. 90% of the respondents had actually participated in the internship, whilst 10% only formally participated in this activity. The main responsibilities of the students were: storage and reception of pharmaceutical products (94%, respectively 79%) and working with the receipts (57%). Most of the students appreciate that they were integrated into the work in the pharmacy, this being due largely pharmacist tutor, who expressed interest and ability in mentoring activities. They appreciated that the role of tutor requires 3-5 years of professional experience. In terms of the internship objectives, these should aim at applying the knowledge gained until the graduation year, but also familiarization with activities which might turn into applications for the coming years. 43% of students believe that only 25% of the theoretical knowledge was useful during the internship. 90 % of the total questioned considered useful to develop a practice guideline adapted to the year of study. Conclusions. The professional training of the future pharmacist’s students depends largely on experience gained by students during the internship activity. Feed-back from the students’ shows that they are aware of the usefulness of the internship, but believe the objectives must be updated and a better correlation between work in pharmacy and theoretical knowledge has to be made. A first step is to develop a practical guide adapted to each year of study. The involvement of the tutor pharmacist is also essential to the success of this activity

Downstream processing development of enveloped viruses for clinical applications: innovative tools for rational process optimization

Dissertation presented to obtain a Ph.D. degree in Engineering and Technology Sciences, Biotechnology at the Instituto de Tecnologia Química e Biológica, Universidade Nova de Lisboa