Improvement of electrical conductivity in Pb0.96-yMn0.04SnyTe alloys for high temperature thermoelectric applications

Lead-tin-telluride is a well-known thermoelectric material in the temperature range 350-750 K. Here, this alloy doped with manganese (Pb0.96-yMn0.04SnyTe) was prepared for different amounts of tin. X-ray diffraction showed a decrease of the lattice constant with increasing tin content, which indicated solid solution formation. Microstructural analysis showed a wide distribution of grain sizes from <1 mu m to 10 mm and the presence of a SnTe rich phase. All the transport properties were measured in the range of 300-720 K. The Seebeck coefficient showed that all the samples were p-type indicating holes as dominant carriers in the measurement range. The magnitude increased systematically on reduction of the Sn content due to possible decreasing hole concentration. Electrical conductivity showed the degenerate nature of the samples. Large values of the electrical conductivity could have possibly resulted from a large hole concentration due to a high Sn content and secondly, due to increased mobility by sp-d orbital interaction between the Pb1-ySnyTe sublattice and the Mn2+ ions. High thermal conductivity was observed due to higher electronic contribution, which decreased systematically with decreasing Sn content. The highest zT = 0.82 at 720 K was obtained for the alloy with the lowest Sn content (y = 0.56) due to the optimum doping level.

Improvement of superconducting properties in Fe1+xSe0.5Te0.5 superconductor by Cr-substitution

Enhancement of superconducting transition temperature (T-c) of parent superconductor, Fe1+xSe, of `Fe-11' family by Cr-substitution for excess Fe has been motivated us to investigate the effect of Cr-substitution in optimal superconductor or Fe1+xSe0.5Te0.5 at Fe site. Here, we report structural, magnetic, electrical transport, thermal transport and heat capacity properties or Cr-substitute compounds. x-ray diffraction measurement confirms the substitution of Cr-atoms in host lattice. Magnetic and electrical transport measurements are used to explore the superconducting properties where Cr-substituted compounds show improvement in superconducting diamagnetic fraction with same T-c as undoped one Heat capacity measurement confirms the bulk superconducting properties of compounds. Thermopower measurement characterizes the type of charge carriers in normal state. (C) 2015 Elsevier Ltd. All rights reserved.

A Design for Performance Improvement of Clock Synchronization in WSNs using a TDMA-based MAC Protocol

Clock synchronization in a wireless sensor network (WSN) is quite essential as it provides a consistent and a coherent time frame for all the nodes across the network. Typically, clock synchronization is achieved by message passing using a contention-based scheme for media access, like carrier sense multiple access (CSMA). The nodes try to synchronize with each other, by sending synchronization request messages. If many nodes try to send messages simultaneously, contention-based schemes cannot efficiently avoid collisions. In such a situation, there are chances of collisions, and hence, message losses, which, in turn, affects the convergence of the synchronization algorithms. However, the number of collisions can be reduced with a frame based approach like time division multiple access (TDMA) for message passing. In this paper, we propose a design to utilize TDMA-based media access and control (MAC) protocol for the performance improvement of clock synchronization protocols. The basic idea is to use TDMA-based transmissions when the degree of synchronization improves among the sensor nodes during the execution of the clock synchronization algorithm. The design significantly reduces the collisions among the synchronization protocol messages. We have simulated the proposed protocol in Castalia network simulator. The simulation results show that the proposed protocol significantly reduces the time required for synchronization and also improves the accuracy of the synchronization algorithm.

Improvement of Aircraft Rolling Power by Use of Piezoelectric Actuators

Piezoelectric actuators are distributed on both side of a rectangular wing model,and the possibility of improvement of aircraft rolling power is investigated. The difference between the model with aileron deflection and the model without aileron (fictitious control surface, FCS) is studied. The analytical results show that these two cases are substantial different. In aileron deflection case, the aeroelastic effect is disadvantageous, so the structural stiffness should be high until the electrical voltage is not necessary. But in the case of FCS,the aeroelastic effect is advantageous and it means that lower structural stiffness can lead to lower voltage. Compared with aileron project, the FCS project can save structure weight.

Efficient line launch for bandwidth improvement of 10 Gbit/s multimode fibre links using elliptical Gaussian beam

A novel elliptical Gaussian beam line launch is shown to allow improved system capacity for high speed multimode fibre links. This launch maintains higher bandwidth than dual launch even with misalignment of ±6 μm despite not requiring testing at installation. ©2010 IEEE.

Evaluation of Several Commercial Algicides for Control of Odor-producing Cyanobacteria

The production of certain odorous metabolites is an undesirable attribute of cyanobacteria (blue-green algae) growth in aquaculture ponds [e.g., channel catfish(Ictalurus punctatus)] and in drinking water reservoirs. The most common odorous compounds encountered in catfish aquaculture are geosmin (trans-1,10-dimethyltrans-9-decalol) and 2-methylisoborneol(exo-1,2,7,7-tetramethylbicyclo[2.2.1]heptan-2-ol). These compounds are also frequently encountered worldwide in reservoirs and aqueducts used for municipal drinking water systems(Schrader et al. 2002). In this study, several algicides were evaluated using a rapid bioassay to determine their effectiveness in controlling the MIB-producing cyanobacterium Oscillatoria perornata from a west Mississippi catfish pond and the MIBproducing Pseudanabaena sp. (strain LW397) from Lake Whitehurst, Virginia, used as a city water supply reservoir. The cyanobacterium Oscillatoria agardhii , not a MIB-producer, and the green alga Selenastrum capricornutum , found in catfish ponds in the southeastern United States, were included in the bioassay to help determine potential broad-spectrum toxicity of the commercial products. (PDF has 3 pages.)

Improvement of sensitivity and refractive-index changes in LiNbO3 : Ce : Cu crystals with UV light

A nonvolatile recording scheme is proposed using LiNbO3:Ce:Cu crystals and modulated UV light to record gratings simultaneously in two centres and using red light to bleach the grating in the shallow centre to realize persistent photorefractive holographic storage. Compared with the normal UV-sensitized nonvolatile holographic system, the amplitude of refractive-index changes is greatly increased and the recording sensitivity is significantly enhanced by recording with UV light in the LiNbO3:Ce:Cu crystals. Based on jointly solving the two-centre material equations and the coupled-wave equations, temporal evolutions of the photorefractive grating and the diffraction effciency are effectively described and numerically analysed. Roles of doping levels and recording-beam intensity are discussed in detail. Theoretical results confirm and predict experimental results.

Cultural methods of detection for microorganisms: recent advances and successes

Most microbiological methods require culture to allow organisms to recover or to selectively increase, and target organisms are identified by growth on specific agar media. Many cultural methods take several days to complete and even then the results require confirmation. Alternative techniques include the use of chromogenic and fluorogenic substances to identify bacteria as they are growing, selective capture using antibodies after short periods of growth, molecular techniques, and direct staining with or without flow cytometry for enumeration and identification. Future microbiologists may not use culture but depend on the use of specific probes and sophisticated detection systems.

Initiatives for the improvement of continuous management training

[EN] Purpose. This work aims to present, from the company viewpoint, a structured account of management proposals and practices directed toward improving the intensity and effectiveness of continuous management training (CMT). Design/methodology/approach. The article takes as its main theoretical referents the Theory of Human Capital, the Resource-Based Vision and the contributions made via the new institutional economy with regard to the problems of information asymmetry between companies, employees and training providers and completes the proposals that derive from this theoretical approach. To do this, experience-based contributions are collected from a selection of company training and HR managers from twelve Basque companies characterised by their strong investment in management training. The methodology used was qualitative and obtained by different qualitative techniques: Focus Groups, Nominal Groups and the Delphi Method, which make up the so-called Hybrid Delphi. Findings and implications. The proposals are aimed at the main agents in training activity: training providers, associations and public agents engaged in management training and, particularly, companies themselves. The initiatives seek above all to increase training market transparency, to improve mutual commitments between companies and managers, and to link training and development with culture and strategic management, so that firms make optimal investment in management training. Originality/value. The methodology used is original, and the contributions are consistent with the theory, have a proven practical utility, and are presented in a hierarchy, which facilitates decision making.