(Table 1) Sulfur isotopes and sulfur content at DSDP Leg 64 Holes

Hydrothermal pyrite samples from Holes 477, 477A, and 478 have sulfur isotope values ranging from about 10 to 11 per mil. Samples with negative sulfur isotope values generally have low sulfide sulfur contents and reflect mixed bacterial and hydrothermal sulfur sources. At higher sulfur contents, the hydrothermal component predominates, producing positive isotope values. Hydrothermal sulfide derives from reduction of seawater sulfate and may contain a significant basaltic component. Hydrothermal anhydrite is restricted to a narrow zone beneath a dolerite sill at Site 477 and, because of partial sulfate reduction in the circulating waters, has isotopic values (23.5-25 per mil), heavier than seawater.

Pore water isotopic ratios of CO2 and SO4, and sediment CH4 content of ODP Leg 164 sites

A unique set of geochemical pore-water data, characterizing the sulfate reduction and uppermost methanogenic zones, has been collected at the Blake Ridge (offshore southeastern North America) from Ocean Drilling Program (ODP) Leg 164 cores and piston cores. The d13C values of dissolved CO2 (sum CO2) are as 13C-depleted as -37.7 per mil PDB (Site 995) at the sulfate-methane interface, reflecting a substantial contribution of isotopically light carbon from methane. Although the geochemical system is complex and difficult to fully quantify, we use two methods to constrain and illustrate the intensity of anaerobic methane oxidation in Blake Ridge sediments. An estimate using a two-component mixing model suggests that ~24% of the carbon residing in the sum CO2 pool is derived from biogenic methane. Independent diagenetic modeling of a methane concentration profile (Site 995) indicates that peak methane oxidation rates approach 0.005 µmol/cm**3/yr, and that anaerobic methane oxidation is responsible for consuming ~35% of the total sulfate flux into the sediments. Thus, anaerobic methane oxidation is a significant biogeochemical sink for sulfate, and must affect interstitial sulfate concentrations and sulfate gradients. Such high proportions of sulfate depletion because of anaerobic methane oxidation are largely undocumented in continental rise sediments with overlying oxic bottom waters. We infer that the additional amount of sulfate depleted through anaerobic methane oxidation, fueled by methane flux from below, causes steeper sulfate gradients above methane-rich sediments. Similar pore water chemistries should occur at other methane-rich, continental-rise settings associated with gas hydrates.

Geochemistry and isotopes at DSDP Hole 79-546

At Site 546, below the Mazagan Escarpment at a water depth of 4 km, 36 m of salt rock was cored from the top of one of a field of salt domes. The core was studied by thin section and a variety of geochemical procedures. The salt rock contains 0.1 to 3% carnallite and lesser amounts of sylvite and polyhalite, which with the corresponding high level of bromide place it within the potash evaporite facies. The bromide profile is of a dominantly marine evaporite deposited in moderately shallow brine which, however, was not repeatedly desiccated. A mineralogical argument suggests that the brine surface was not below sea level. An average of about 5% elastics, with dispersed anhydrite, darken the salt rock to deep shades of red, brown, and gray green. Most of the included materials are in highly deformed boudins or dispersions in the salt rock that has also undergone cataclasis in a subsequent, probably tectonic, deformation. The salt rock is slightly deficient in anhydrite, and the usual separate beds and laminae of anhydrite are virtually absent. Stable isotope ratios of sulfur and oxygen in the sulfate are clearly derived from sea water of Permian to Scythian age, in contrast to the late Triassic or Early Jurassic age of evaporites onshore in Morocco and Portugal and the corresponding evaporites offshore Maritime Canada. In contrast to those evaporites off the axis of Atlantic rifting, the salt at Site 546 may have been deposited in a very early central rift fed by marine waters from Tethys through the Gibraltar or South Atlas fracture zones.

AMS 14C ages and isotopic compositions of samples from the Derugin Basin, Sea of Okhotsk

An area of massive barite precipitations was studied at a tectonic horst in 1500 m water depth in the Derugin Basin, Sea of Okhotsk. Seafloor observations and dredge samples showed irregular, block- to column-shaped barite build-ups up to 10 m high which were scattered over the seafloor along an observation track 3.5 km long. High methane concentrations in the water column show that methane expulsion and probably carbonate precipitation is a recently active process. Small fields of chemoautotrophic clams (Calyptogena sp., Acharax sp.) at the seafloor provide additional evidence for active fluid venting. The white to yellow barites show a very porous and often layered internal fabric, and are typically covered by dark-brown Mn-rich sediment; electron microprobe spectroscopy measurements of barite sub-samples show a Ba substitution of up to 10.5 mol% of Sr. Rare idiomorphic pyrite crystals (~1%) in the barite fabric imply the presence of H2S. This was confirmed by clusters of living chemoautotrophic tube worms (1 mm in diameter) found in pores and channels within the barite. Microscopic examination showed that micritic aragonite and Mg-calcite aggregates or crusts are common authigenic precipitations within the barite fabric. Equivalent micritic carbonates and barite carbonate cemented worm tubes were recovered from sediment cores taken in the vicinity of the barite build-up area. Negative d13C values of these carbonates (>-43.5 per mill PDB) indicate methane as major carbon source; d18O values between 4.04 and 5.88 per mill PDB correspond to formation temperatures, which are certainly below 5°C. One core also contained shells of Calyptogena sp. at different core depths with 14C-ages ranging from 20 680 to >49 080 yr. Pore water analyses revealed that fluids also contain high amounts of Ba; they also show decreasing SO4**2- concentrations and a parallel increase of H2S with depth. Additionally, S and O isotope data of barite sulfate (d34S: 21.0-38.6 per mill CDT; d18O: 9.0-17.6 per mill SMOW) strongly point to biological sulfate reduction processes. The isotope ranges of both S and O can be exclusively explained as the result of a mixture of residual sulfate after a biological sulfate reduction and isotopic fractionation with 'normal' seawater sulfate. While massive barite deposits are commonly assumed to be of hydrothermal origin, the assemblage of cheomautotrophic clams, methane-derived carbonates, and non-thermally equilibrated barite sulfate strongly implies that these barites have formed at ambient bottom water temperatures and form the features of a Giant Cold Seep setting that has been active for at least 49 000 yr.

Isotopic analyses of DSDP Hole 45-395A samples from veins containing gypsum (Table 1)

Gypsum and halite crystals, together with saponite and phillipsite, were found in a vein in a basalt sill 625 m below the sea floor at DSDP Site 395A, located 190 km west of the crest of the Mid-Atlantic Ridge. The delta34S value of the gypsum (+19.4?) indicates a seawater source for the sulfate. The delta18O values of the saponite (+19.9?) and phillipsite (+18.1?) indicate either formation from normal seawater at about 55°C or formation from delta18O-depleted seawater at a lower temperature. The gypsum (which could be secondary after anhydrite) was formed by reaction between Ca[2+] released from basalt and SO4[2-] in circulating seawater. The halite could have formed when water was consumed by hydration of basalt under conditions of extremely restricted circulation. A more probable mechanism is that the gypsum was originally precipitated as anhydrite at temperatures above 60°C. As the temperature dropped the anhydrite converted to gypsum. The conversion would consume water, which could cause halite precipitation, and would cause an increase in the volume of solids, which would plug the vein and prevent subsequent dissolution of the halite.

Chemical and isotopic compositions of sediments and some minerals from the Derugin Basin, Sea of Okhotsk

The paper reports specific mineralogical and geochemical characteristics of deposits from local depressions of the Derugin Basin. They were formed in an environment with periodic changes from oxic to anoxic conditions and show evidence for presence of hydrogen sulfide in bottom waters. Deposits of this type can be considered as a modern model for ancient ore-bearing black shale associations. Compared with typical metalliferous black shale sequences, which are characterized by high contents of organic matter, the sediments described here are depleted in elements of the organophilic association (Mo, Ni, Cu, Zn, V, and U), but have higher Mn contents.

Petrology and isotope characteristics of basalts from ODP Hole 111-504B

Petrography and isotope geochemical characteristics of H, O, S, Sr, and Nd have been described for basalts recovered from Hole 504B during Leg 111 of the Ocean Drilling Program. The petrographic and chemical features of the recovered basalts are similar to those obtained previously (DSDP Legs 69, 70, and 83); they can be divided into phyric (plagioclase-rich) and aphyric (Plagioclase- and clinopyroxene-rich) basalts and show low abundances of TiO2, Na2O, K2O, and Sr. This indicates that the basalts belong to Group D, comprising the majority of the upper section of the Hole 504B. The diopside-rich nature of the clinopyroxene phenocrysts and Ca-rich nature of the Plagioclase phenocrysts are also consistent with the preceding statement. The Sr and Nd isotope systematics (average 87Sr/86Sr = 0.70267 ± 0.00007 and average 143Nd/144Nd = 0.513157 ± 0.000041) indicate that the magma sources are isotopically heterogeneous, although the analyzed samples represent only the lowermost 200-m section of Hole 504B. The rocks were subjected to moderate hydrothermal alteration throughout the section recovered during Leg 111. Alteration is limited to interstices, microfractures, and grain boundaries of the primary minerals, forming chlorite, actinolite, talc, smectite, quartz, sphene, and pyrite. In harmony with the moderate alteration, the following alteration-sensitive parameters show rather limited ranges of variation: H2O = 1.1 ±0.2 wt%, dD = - 38 per mil ± 4 per mil, d180 = 5.4 per mil ± 0.3 per mil, total S = 562 ± 181 ppm, and d34S = 0.8 per mil ± 0.3 per mil. Based on these data, it was estimated that the hydrothermal fluids had dD and d180 values only slightly higher than those of seawater, the water/rock ratios were as low as 0.02-0.2, and the temperature of alteration was 300°-400°C. Sulfur exists predominantly as pyrite and in minor quantities as chalcopyrite. No primary monosulfide was detected. This and the d34S values of pyrite (d34S = 0.8 per mil) suggest that primary pyrrhotite was almost completely oxidized to pyrite by reaction with hydrothermal fluids containing very little sulfate.

Sulphur geochemistry of interstitial waters and squeeze cake samples of ODP Leg 181 sites

Seventy-nine interstitial water samples from six sites (Ocean Drilling Program Sites 1119-1124) from the southwestern Pacific Ocean have been analyzed for stable isotopes of dissolved sulfate (34S), along with major and minor ions. Sulfate from the interstitial fluids (34S values between +20.7 and +57.5 vs. the Vienna-Canyon Diablo troilite standard) was enriched in 34S with respect to modern seawater (34S +20.6), indicating that differing amounts of microbial sulfate reduction took place at all investigated sites. Microbial sulfate reduction was found at all sites, the intensity depending on the availability of organic matter, which is controlled by paleosedimentation conditions (e.g., sedimentation rate and presence of turbidites). In addition, total reduced inorganic sulfur (essentially pyrite) as a product of microbial sulfate reduction was quantified in selected sediments from Site 1119.

Sulfur concentrations and isotope ratios in sediments from Kiel Bay, western Baltic Sea

The isotope-ratios of sulfur-components in several sedimentologically different cores of recent marine sediments from Kiel Bay (Baltic Sea) were investigated. In addition, quantitative determinations were made on total sulfur, sulfate, sulfide, chloride, organic carbon, iron and watercontent in the sediment or in the pore-water solution. The investigations gave the following results: 1. The sulfur in the sediment (about 0.3 -2 % of the dry sample) was for the most part introduced into the sediment after sedimentation. This confirms the results of Kaplan et al. (1963, doi:10.1016/0016-7037(63)90074-7). The yield of Sulfur from organic material is very small (in our samples about 5-10% of the total sulfur in the sediment). 2. The sulfur bound in the sediment is taken from the sulfate of the interstitial water. During normal sedimentation, the exchange of sulfate by diffusion significant for changes in the sulfur-content goes down to a sediment depth of 4-6 cm. In this way the sulfate consumed by reduction and formation of sulfide or pyrite is mostly replaced. The uppermost layer of the sediment is an partly open system for the sulfur. The diagenesis of the sulfur is allochemical. 3. The isotope-values of the sediment-sulfur are largely influenced by the sulfur coming into the sediment by diffusion and being bound by bacteriological reduction. Due to the prevailing reduction of 32S and reverse-diffusion of sulfate into the open sea-water, an 32S enrichment takes place in the uppermost layer of the sediment. delta34S-values in the sediment range between -15 and -35 ? while seawater-sulfate has +20 ?. No relationship could be established between sedimentological or chemical changes and isotope-ratios. In the cores, successive sandy and clayly layers showed no change in the delta-values. The sedimentation rate, however, seems to influence isotope-ratios. In one core with low sedimentationrates the delta34S-values varied between -29 and -33 ?, while cores with higher sedimentationrates showed values between -17 and -24 ?. 4. As sediment depth increases, the pore-water sulfate shows decreasing concentrations (in a depth of 30-40 cm we found between 20 and 70 % of the seawater-values), and increasing delta 34S-values (in one case reaching more than +60 ?). The concentration of sulfide in the pore-water increases with sediment-depth (reaching 80 mg S/l in one case). The (delta34S-values of the pore-water-sulfide in all cores show increases paralleling the sulfate sulfur, with a nearly constant delta-distance of 50-60 ? in all cores. This seems to confirm the genetic relationship between the two components.