Uranium removal from contaminated groundwater by synthetic resins

Synthetic resins are shown to be effective in removing uranium from contaminated groundwater. Batch and field column tests showed that strong-base anion-exchange resins were more effective in removing uranium from both near-neutral-pH (6.5)- and high-pH (8)-low-nitrate-containing groundwaters, than metal-chelating resins, which removed more uranium from acidic-pH (5)-high-nitrate-containing groundwater from the Oak Ridge Reservation (ORR) Y-12 S-3 Ponds area in Tennessee, USA. Dowex 1-X8 and Purolite A-520E anion-exchange resins removed more uranium from high-pH (8)-low-nitrate-containing synthetic groundwater in batch tests than metal-chelating resins. The Dowex™ 21K anion-exchange resin achieved a cumulative loading capacity of 49.8 mg g^-1 before breakthrough in a field column test using near-neutral-pH (6.5)-low-nitrate-containing groundwater. However, in an acidic-pH (5)-high-nitrate-containing groundwater, metal-chelating resins Diphonix and Chelex-100 removed more uranium than anion-exchange resins. In 15 mL of acidic-pH (5)-high-nitrate-containing groundwater spiked with 20 mg L^-1 uranium, the uranium concentrations ranged from 0.95 mg L^-1 at 1-h equilibrium to 0.08 mg L^-1 at 24-h equilibrium for Diphonix and 0.17 mg L^-1 at 1-h equilibrium to 0.03 mg L^-1 at 24-h equilibrium for Chelex-100. Chelex-100 removed more uranium in the first 10 min in the 100 mL of acidic-(pH 5)-high-nitrate-containing groundwater (~5 mg L^-1 uranium); however, after 10 min, Diphonix equaled or out-performed Chelex-100. This study presents an improved understanding of the selectivity and sorption kenetics of a range of ion-exchange resins that remove uranium from both low- and high-nitrate-containing groundwaters with varying pHs..

Speciation of Uranium in Sediments before and after In situ Biostimulation

The success of sequestration-based remediation strategies will depend on detailed information, including the predominant U species present as sources before biostimulation and the products produced during and after in situ biostimulation. We used X-ray absorption spectroscopy to determine the valence state and chemical speciation of U in sediment samples collected at a variety of depths through the contaminant plume at the Field Research Center at Oak Ridge, TN, before and after approximately 400 days of in situ biostimulation, as well as in duplicate bioreduced sediments after 363 days of resting conditions. The results indicate that U(VI) in subsurface sediments was partially reduced to 10–40% U(IV) during biostimulation. After biostimulation, U was no longer bound to carbon ligands and was adsorbed to Fe/Mn minerals. Reduction of U(VI) to U(IV) continued in sediment samples stored under anaerobic condition at <4 °C for 12 months, with the fraction of U(IV) in sediments more than doubling and U concentrations in the aqueous phase decreasing from 0.5-0.74 to <0.1 µM. A shift of uranyl species from uranyl bound to phosphorus ligands to uranyl bound to carbon ligands and the formation of nanoparticulate uraninite occurred in the sediment samples during storage.

Deposition of Uranium Precipitates in Dolomitic Gravel Fill

Uranium-containing precipitates have been observed in a dolomitic gravel fill near the Department of Energy (DOE) S-3 Ponds former waste disposal site as a result of exposure to acidic (pH 3.4) groundwater contaminated with U (33 mg L-1), Al3+ (900 mg L-1), and NO3- (14?000 mg L-1). The U containing precipitates fluoresce a bright green under ultraviolet (UV) short-wave light which identify U-rich coatings on the gravel. Scanning electron microscopy (SEM) microprobe analysis show U concentration ranges from 1.6-19.8% (average of 7%) within the coatings with higher concentrations at the interface of the dolomite fragments. X-ray absorption near edge structure spectroscopy (XANES) indicate that the U is hexavalent and extended X-ray absorption fine structure spectroscopy (EXAFS) shows that the uranyl is coordinated by carbonate. The exact nature of the uranyl carbonates are difficult to determine, but some are best described by a split K+-like shell similar to grimselite [K4Na(UO2)(CO3)3·H2O] and other regions are better described by a single Ca2+-like shell similar to liebigite [Ca2(UO2)(CO3)3·11(H2O)] or andersonite [Na2CaUO2(CO3)3 · 6H2O]. The U precipitates are found in the form of white to light yellow cracked-formations as coatings on the dolomite gravel and as detached individual precipitates, and are associated with amorphous basalumnite [Al4(SO4)(OH)10·4H2O].

syn-Benzene dioxides: chemoenzymatic synthesis from 2,3-cis-dihydrodiol derivatives of monosubstituted benzenes and their application in the synthesis of regioisomeric 1,2- and 3,4-cis-dihydrodiols and 1,4-dioxocins

cis-2,3-Dihydrodiol metabolites of monosubstituted halobenzenes and toluene have been used as synthetic precursors of the corresponding 3,4-cis-dihydrodiols. Enantiopure syn-benzene dioxide intermediates were reduced to the 3,4-cis-dihydrodiols and thermally racemised via the corresponding 1,4-dioxocins. The syn-benzene dioxide-1,4-dioxocin valence tautomeric equilibrium ratio was found to be dependent on the substituent position. The methodology has also been applied to the synthesis of both enantiomers of the 1,2-(ipso)- and 3,4-cis-dihydrodiols of toluene. This chemoenzymatic approach thus makes available, for the first time, all three possible cis-dihydrodiol regioisomers of a monosubstituted benzene.

Chemoenzymatic synthesis of the trans-dihydrodiol isomers of monosubstituted benzenes via anti-benzene dioxides

Enantiopure cis-2,3-dihydrodiols, available from dioxygenase-catalysed cis-dihydroxylation of monosubstituted benzene substrates, have been used as synthetic precursors of the corresponding trans-3,4-dihydrodiols. The six-step chemoenzymatic route from cis-dihydrodiol precursors, involving acetonide, tetraol, dibromodiacetate and diepoxide intermediates, and substitution of vinyl bromide and iodide atoms, has been used in the synthesis of ten trans-dihydrododiol derivatives of substituted benzenes. The general applicability of the method has been demonstrated by its use in the synthesis of both enantiomers of the trans-1,2- and 3,4-dihydrodiol derivatives of toluene.