The BACOMA cod-end. History and recent developments in BACOMA cod-end regulations and a proposal for abetter specification of the BACOMA cod-end for Baltic Sea cod fishery

To improve the cod stocks in the Baltic Sea, a number of regulations have recently been established by the International Baltic Sea Fisheries Commission (IBSFC) and the European Commission. According to these, fishermen are obliged to use nets with escape windows (BACOMA nets) with a mesh size of the escape window of 120 mm until end of September 2003. These nets however, retain only fish much larger than the legal minimum landing size would al-low. Due to the present stock structure only few of such large fish are however existent. As a consequence fishermen use a legal alternative net. This is a conventional trawl with a cod-end of 130 mm diamond-shaped meshes (IBSFC-rules of 1st April 2002), to be increased to 140 mm on 1st September 2003, according to the mentioned IBSFC-rule. Due legal alterations of the net by the fishermen (e.g. use of extra stiff net material) these nets have acquired extremely low selective properties, i. e. they catch very small fish and produce great amounts of discards. Due to the increase of the minimum landing size from 35 to 38 cm for cod in the Baltic, the amount of discards has even increased since the beginning of 2003. Experiments have now been carried out with the BACOMAnet on German and Swedish commercial and research vessels since arguments were brought forward that the BACOMA net was not yet sufficiently tested on commercial vessels. The results of all experiments conducted so far, are compiled and evaluated here. As a result of the Swedish, Danish and German initiative and research the European Commission reacted upon this in June 2003 and rejected the increase of the diamond-meshed non-BACOMA net from 130 mm to 140mm in September 2003. To protect the cod stocks in the Baltic Sea more effectively the use of traditional diamond meshed cod-ends with-out escape window are prohibited in community waters without derogation, becoming effective 1st of September 2003. To enable more effective and simplified control of the bottom trawl fishery in the Baltic Sea the principle of a ”One-Net-Rule“ is enforced. This is going to be the BACOMA net, with the meshes of the escape window being 110 mm for the time being. The description of the BACOMA net as given in the IBSFC-rules no.10 (revision of the 28th session, Berlin 2002) concentrates on the cod-end and the escape window but only to a less extent on the design and mesh-composition of the remaining parts of the net, such as belly and funnel and many details. Thus, the present description is not complete and leaves, according to fishermen, ample opportunity for manipulation. An initiative has been started in Germany with joint effort from scientists and the fishery to better describe the entire net and to produce a proposal for a more comprehensive description, leaving less space for manipulation. A proposal in this direction is given here and shall be seen as a starting point for a discussion and development towards an internationally uniform net, which is agreed amongst the fishery, scientists and politicians. The Baltic Sea fishery is invited to comment on this proposal, and recommendations for further improvement and specifications are welcomed. Once the design is agreed by the Baltic Fishermen Association, it shall be proposed to the IBSFC and European Commission via the Baltic Fishermen Association.

Fisheries laws and regulations of Nigeria and room for further developments

The fisheries laws and regulations presently operative in Nigeria are on marine waters. These include: 1) The Sea Fisheries Decree (Act) of 1971; 2) The Sea Licencing Regulations of 1971; 3) The Sea Fisheries (Fishing) Regulations of 1972; and 4) The exclusive Economic Zone Decree of 1978. Attempts have also been made to produce the Inland waters Fisheries Regulation

Fisheries rules and regulations in 23 states of Nigeria: a note

In order to make a sound proposal to the Kainji Lake Fisheries Management and Conservation Unit regarding the amendment of the existing Fisheries Laws and Regulations, including the raise of fishing license fees, the Fisheries Departments of 21 Nigerian States were visited in August-September 2000. In that occasion the staff was interviewed, existing documents were revised, and the results were compared with those of Kebbi and Niger State

Competing Ecosystem services: an Assessment of Carbon and timber in the Tropical forests of Central America

4 p.

Competing Ecosystem Services: an Assessment of Carbon and Timber in the Tropical Forests of Central America

29 p.

Design of a timber Howe truss highway bridge

The span of the bridge was assumed as 100 feet. The type of bridge used is the timber Howe Truss. The height of truss was taken as 20 feet between center lines of top and bottom chords. The width was taken as 18 feet center to center of trusses. The truss was divided up into five panels 20 feet long.

It was designed according to the "General Specifications for Steel Highway Bridges" by Ketchum. For the live load for the floor and its supports, a load of 80 pounds per square foot of total floor surface or a 15 ton traction engine with axles 10 feet centers and 6 feet gage, two thirds of load to be carried by rear axles.

For the truss a load of 75 pounds per square foot of floor surface.

For the wind load the bottom lateral bracing is to be designed to resist a lateral wind load of 300 pounds per foot of span; 150 pounds of this to be treated as a moving load.

The top lateral bracing is to be designed to resist a lateral wind force of 150 pounds per foot of span.

The timber to be used in the bridge is to be Douglas fir.

The unit stresses used for timber are those of the American Railway Engineering Association.

Newport's mooring regulations: legal and policy analysis

The legal and policy issues facing Newport as it revises and implements its ordinances are numerous. Most of the issues have not been squarely resolved for Rhode Island. While Newport may take guidance from other states, it will be Rhode Island's task going forward to define the reach of its PTD as applied to some novel issues raised by mooring administration. The benefit of the flexibility of the PTD is allowing smaller units of government like Newport to define their regulatory goals based on a locally-tailored balancing test of competing interests facing scarce ocean resources. This report was designed to facilitate decision-maker discussion of how to strike that delicate balance.

History of Molluscan Fishery Regulations and the Shellfish Officer Service in Massachusetts

Oysters, Crassostrea virginica, and softshell clams, Mya arenaria, along the Massachusetts coast were harvested by European colonists beginning in the 1600’s. By the 1700’s, official Commonwealth rules were established to regulate their harvests. In the final quarter of the 1800’s, commercial fishermen began harvesting northern quahogs, Mercenaria mercenaria, and northern bay scallops, Argopecten irradians irradians, and regulations established by the Massachusetts Legislature were applied to their harvests also. Constables (also termed wardens), whose salaries were paid by the local towns, enforced the regulations, which centered on restricting harvests to certain seasons, preventing seed from being taken, and personal daily limits on harvests. In 1933, the Massachusetts Legislature turned over shellfisheries management to individual towns. Local constables (wardens) enforced the rules. In the 1970’s, the Massachusetts Shellfish Officers Association was formed, and was officially incorporated in 2000, to help the constables deal with increasing environmental problems in estuaries where fishermen harvest mollusks. The constables’ stewardship of the molluscan resources and the estuarine environments and promotion of the fisheries has become increasingly complex.

Simulated Economic Impact of TED Regulations on Selected Vessels in the Texas Shrimp Fishery

Shrimp fishermen trawling in the Gulf of Mexico and south Atlantic inadvertently capture and kill sea turtles which are classified as endangered species. Recent legislation requires the use of a Turtle Excluder Device(TED) which, when in place in the shrimp trawl, reduces sea turtle mortality. The impact of the TED on shrimp production is not known. This intermediate analysis of the TED regulations using an annual firm level simulation model indicated that the average Texas shrimp vessel had a low probability of being an economic success before regulations were enacted. An assumption that the TED regulations resulted in decreased production aggravated this condition and the change in Ending Net Worth and Net Present Value of Ending Net Worth before and after a TED was placed in the net was significant at the 5 percent level. However, the difference in the Internal Rate of Return for the TED and non-TED simulations was not significant unless the TED caused a substantial change in catch. This analysis did not allow for interactions between the fishermen in the shrimp industry, an assumption which could significantly alter the impact of TED use on the catch and earnings of the individual shrimp vessel.

Habitats regulations for stage 3 assessments radioactive substance authorisations

This is the Habitats regulations for stage 3 assessments: radioactive substances authorisations report from the Environment Agency, published on October 2003. The report focuses on the stage 3 assessments of radioactive substances authorisations in UK (to take place over the next five years, starting in 2003), which may have a potential impact on European designated Natura 2000 sites such Special Protection Areas (SPA), Special Areas of Conservation (SAC); and thus require further detailed assessment. This Environment Agency R&D project was commissioned to ERC, University o f Liverpool, in conjunction with Westlakes Scientific Consulting and the Centre for Ecology and Hydrology, as part o f the agency's preparation for the Stage 3 Assessments o f radioactive substances authorisations. The aim was to prepare site information sheets containing all data relevant for individual Natura 2000 sites needing Stage 3 Assessment and to stylise and represent species that require protection under the Habitats Regulations by the reference organism geometries listed in R&D Publication 128 (Copplestone et al., 2001).