Pleopod Cuticular Morphology as an Index of Moult Stage in the Ornate Rock Lobster, Panulirus ornatus (Fabricius 1789)

Seven discrete stages and substages of moulting in the ornate rock lobster, Panulirus ornatus, have been distinguished by microscopic examination of the cuticle and setae of the pleopods . The diagnostic features and the duration of each of the stages are described. Freezing did not visually alter the tissue features used to identify each moult stage. Pleopod morphology can reliably indicate whether a lobster has moulted within the previous 24 h or is within 72 h of the next ecdysis.

A Touch of Red : Archaeological and Ethnographic Approaches to Interpreting Finnish Rock Paintings

Approximately 125 prehistoric rock paintings have been found in the modern territory of Finland. The paintings were done with red ochre and are almost without exception located on steep lakeshore cliffs associated with ancient water routes. Most of the sites are found in the central and eastern parts of the country, especially on the shores of Lakes Päijänne and Saimaa. Using shore displacement chronology, the art has been dated to ca. 5000 – 1500 BC. It was thus created mainly during the Stone Age and can be associated with the so-called ‘Comb Ware’ cultures of the Subneolithic period. The range of motifs is rather limited, consisting mainly of schematic depictions of stick-figure humans, elks, boats, handprints and geometric signs. Few paintings include any evidence of narrative scenes, making their interpretation a rather difficult task. In Finnish archaeological literature, the paintings have traditionally been associated with ’sympathetic’ hunting magic, or the belief that the ritual shooting of the painted animals would increase hunting luck. Some writers have also suggested totemistic and shamanistic readings of the art. This dissertation is a critical review of the interpretations offered of Finnish rock art and an exploration of the potentials of archaeological and ethnographic research in increasing our knowledge of its meaning. Methods used include ’formal’ approaches such as archaeological excavation, landscape analysis and the application of neuropsychological research to the study of rock art, as well as ethnographically ’informed’ approaches that make use of Saami and Baltic Finnish ethnohistorical sources in interpretation. In conclusion, it is argued that although North European hunter-gatherer rock art is often thought to lie beyond the reach of ‘informed’ knowledge, the exceptional continuity of prehistoric settlement in Finland validates the informed approach in the interpretation of Finnish rock paintings. The art can be confidently associated with shamanism of the kind still practiced by the Saami of Northern Fennoscandia in the historical period. Evidence of similar shamanistic practices, concepts and cosmology are also found in traditional Finnish-Karelian epic poetry. Previous readings of the art based on ‘hunting magic’ and totemism are rejected. Most of the paintings appear to depict experiences of falling into a trance, of shamanic metamorphosis and trance journeys, and of ‘spirit helper’ beings comparable to those employed by the Saami shaman (noaidi). As demonstrated by the results of an excavation at the rock painting of Valkeisaari, the painted cliffs themselves find a close parallel in the Saami cult of the 'sieidi', or sacred cliffs and boulders worshipped as expressing a supernatural power. Like the Saami, the prehistoric inhabitants of the Finnish Lake Region seem to have believed that certain cliffs were ’alive’ and inhabited by the spirit helpers of the shaman. The rock paintings can thus be associated with shamanic vision quests, and the making of ‘art’ with an effort to socialize the other members of the community, especially the ritual specialists, with trance visions. However, the paintings were not merely to be looked at. The red ochre handprints pressed on images of elks, as well as the fact that many paintings appear ’smeared’, indicate that they were also to be touched – perhaps in order to tap into the supernatural potency inherent in the cliff and in the paintings of spirit animals.

Predicting survival of western rock lobsters Panulirus cygnus using discriminant analysis of hemolymph parameters taken immediately following simulated handling treatments

Instances of morbidity amongst rock lobsters (Panulirus cygnus) arriving at factories in Western Australia (WA) have been attributed to stress during post-harvest handling. This study used discriminant analysis to determine whether physiological correlates of stress following a period of simulated post-harvest handling had any validity as predictors of future rejection or morbidity of western rock lobsters. Groups of 230 western rock lobsters were stored for 6 h in five environments (submerged/flowing sea water, submerged/re-circulating sea water, humid air, flowing sea water spray, and re-circulated sea water spray). The experiment was conducted in late spring (ambient sea water 22°C), and repeated again in early autumn (ambient sea water 26°C). After 6 h treatment, each lobster was graded for acceptability for live export, numbered, and its hemolymph was sampled. The samples were analysed for a number of physiological and health status parameters. The lobsters were then stored for a week in tanks in the live lobster factory to record mortality. The mortality of lobsters in the factory was associated with earlier deviations in hemolymph parameters as they emerged from the storage treatments. Discriminant analysis (DA) of the hemolymph assays enabled the fate of 80-90% of the lobsters to be correctly categorised within each experiment. However, functions derived from one experiment were less accurate at predicting mortality when applied to the other experiments. One of the reasons for this was the higher mortality and the more severe patho-physiological changes observed in lobsters stored in humid air or sprays at the higher temperature. The analysis identified lactate accumulation during emersion and associated physiological and hemocyte-related effects as a major correlate of mortality. Reducing these deviations, for example by submerged transport, is expected to ensure high levels of survival. None of the indicators tested predicted mortality with total accuracy. The simplest and most accurate means of comparing emersed treatments was to count the mortality afterwards.

Effect of simulated rock dumping on geotextile

The use of geotextiles in coastal structures such as revetments and bund walls has become a common practice. The performance of these structures during their lifetime depends on the durability of geotextile used. During construction of these coastal structures, geotextiles are subjected to a drop load with high impact stress and that can damage the geotextile. In the current design practice, index tests are insufficient in predicting the performance of the geotextile. This puts the stability and performance of the coastal structures at risk. The current geotextile design guidelines are based on index tests and there is no standard procedure to account for the potential loss in the geotextile’s mechanical properties during installation (construction).This study aims to develop a standard procedure to estimate the properties of geotextile after its installation and using these properties for designing the performance of these structures. This paper describes the laboratory method of simulating large scale rock dumping on non-woven geotextiles and how to quantify the retained strength of damaged geotextiles. Results show that the reduction in retained strength of geotextile could extent up to 26% during installation.

Additional records of the rock shrimp, Sicyonia australiensis Hanamura & Wadley, 1998 (Decapoda, Sicyoniidae) from eastern Australia, western central Pacific

This paper reports on the collection of S. australiensis from the continental shelf off southern Queensland, easter Australia, in the western Central Pacific, documenting for the first time the occurrence of the species outside of eastern Bass Strait.

Influence of inclination angle of plate on friction, stick-slip and transfer layer-A study of magnesium pin sliding against steel plate

In this study, sliding experiments were conducted using pure magnesium pins against steel plates using an inclined pin-on-plate sliding tester. The inclination angle of the plate was varied in the tests and for each inclination angle, the pins were slid both perpendicular and parallel to the unidirectional grinding marks direction under both dry and lubricated conditions. SEM was used to study morphology of the transfer layer formed on the plates. Surface roughness of plates was measured using an optical profilometer. Results showed that the friction, amplitude of stick-slip motion and transfer layer formation significantly depend on both inclination angle and grinding marks direction of the plates. These variations could be attributed to the changes in the level of plowing friction taking place at the asperity level during sliding.

Studies on friction and formation of transfer layer when Al-4Mg alloy pins slid at various numbers of cycles on steel plates of different surface texture

In the present investigation, various kinds of textures, namely, unidirectional, 8-ground, and random were attained on the die surfaces. Roughness of the textures was varied using different grits of emery papers or polishing powders. Then pins made of Al-4Mg alloys were slid against steel plates at various numbers of cycles, namely 1, 2, 6, 10 and 20 under both dry and lubricated conditions using an inclined pin-on-plate sliding tester. The morphologies of the worn surfaces of the pins and the formation of transfer layer on the counter surfaces were observed using a scanning electron microscope. Surface roughness parameters of the plate were measured using an optical profilometer. It was observed that the coefficient of friction and formation of transfer layer during the first few cycles depend on the die surface textures under both dry and lubricated conditions. It was also observed that under lubricated condition, the coefficient of friction decreases with number of cycles for all kinds of textures. However, under dry condition, it ecreases for unidirectional and 8-ground surfaces while for random surfaces it increases with number of cycles

Statistically steady turbulence in thin films: direct numerical simulations with Ekman friction

We present a detailed direct numerical simulation (DNS) of the two-dimensional Navier-Stokes equation with the incompressibility constraint and air-drag-induced Ekman friction; our DNS has been designed to investigate the combined effects of walls and such a friction on turbulence in forced thin films. We concentrate on the forward-cascade regime and show how to extract the isotropic parts of velocity and vorticity structure functions and hence the ratios of multiscaling exponents. We find that velocity structure functions display simple scaling, whereas their vorticity counterparts show multiscaling, and the probability distribution function of the Weiss parameter 3, which distinguishes between regions with centers and saddles, is in quantitative agreement with experiments.

Portrait of George Louis Wolff (Gerd Ludwig Wolff) holding a mouse in his genetics laboratory; Little Rock, Arkansas.

Digital Image

Portrait of George Louis Wolff (Gerd Ludwig Wolff) holding a mouse in his genetics laboratory; Little Rock, Arkansas.

Digital Image

Study of Friction and Transfer Layer Formation in Copper-Steel Tribo-System: Role of Surface Texture and Roughness Parameters

In the present investigation, experiments were conducted on a tribological couple-copper pin against steel plate-using an inclined pin-on-plate sliding tester to understand the role of surface texture and roughness parameters of the plate on the coefficient friction and transfer layer formation. Two surface characteristics of the steel plates-roughness and texture-were varied in the tests. It was observed that the transfer layer formation and the coefficient of friction along with its two components, namely, the adhesion and plowing, are controlled by the surface texture of the plate. The plowing component of friction was highest for the surface texture that promotes plane strain conditions while it was lowest for the texture that favors plane stress conditions at the interface. Dimensionless quantifiable roughness parameters were formulated to describe the degree of plowing and hence the plane strain/stress type deformations taking place at the asperity level.

Telomere dynamics in the Sydney rock oyster (Saccostrea glomerata): an investigation into the effects of age, tissue type, location and time of sampling.

Telomere length has been purported as a biomarker for age and could offer a non-lethal method for determining the age of wild-caught individuals. Molluscs, including oysters and abalone, are the basis of important fisheries globally and have been problematic to accurately age. To determine whether telomere length could provide an alternative means of ageing molluscs, we evaluated the relationship between telomere length and age using the commercially important Sydney rock oyster (Saccostrea glomerata). Telomere lengths were estimated from tissues of known age individuals from different age classes, locations and at different sampling times. Telomere length tended to decrease with age only in young oysters less than 18 months old, but no decrease was observed in older oysters aged 2-4 years. Regional and temporal differences in telomere attrition rates were also observed. The relationship between telomere length and age was weak, however, with individuals of identical age varying significantly in their telomere length making it an imprecise age biomarker in oysters.

Portrait of George Louis Wolff (Gerd Ludwig Wolff) holding a mouse in his genetics laboratory; Little Rock, Arkansas.

Digital Image

Damage and physiological stress to juvenile eastern rock lobster (Sagmariasus verreauxi) discarded after trapping and hand collection

Large numbers of Sagmariasus verreauxi are trapped and hand collected in Australia, but discarded due to size and quota restrictions, and under the unevaluated assumption of few impacts. To test the validity of enforced discarding, trapped and hand-collected S. verreauxi (49-143. mm carapace length - CL) were examined for external damage, placed into cages, transferred to aquaria and monitored (with controls) over three months. Haemolymph was non-repetitively sampled immediately and at one, three, and seven days to quantify stress. Most trapped (64%) and hand-collected (79%) specimens were undersized (<104. mm CL), with the latter method yielding broader ranges of sizes and moult stages. Within-trap Octopus tetricus predation caused the only mortalities (3.3%). Hand collection resulted in much greater antennae and pereopod loss than trapping (53 vs. 4%) but, compared to controls, both methods evoked benign physiological responses that resolved within a week. While most wounded S. verreauxi regenerated all or some missing appendages post-moult, their mean CLs were less than those from intact conspecifics. Simple strategies, including larger mesh sizes, and/or installing modifications to reduce bycatch in traps, careful hand collection, and appropriate release techniques might minimise impacts (including predation) to unwanted S. verreauxi, and help to control stock exploitation. © 2012 Elsevier B.V.