Geochemistry of ODP Leg 135 vitrophyric rhyolite samples

In-situ proton-microprobe analyses are presented for glasses, plagioclases, pyroxenes, olivines, and spinels in eleven samples from Sites 834-836, 839, and 841 (vitrophyric rhyolite), plus a Tongan dacite. Elements analyzed are Mn, Ni, Cu, Zn, Ga, Rb, Sr, Y, Zr, Pb, and Sn (in spinels only). The data are used to calculate two sets of partition coefficients, one set based on the ratio of element in mineral/element in coexisting glass. The second set of coefficients, thought to be more robust, is corrected by application of the Rayleigh fractionation equations, which requires additional use of modal data. Data are presented for phenocryst core-rim phases and microphenocryst-groundmass phases from a few samples. Comparison with published coefficients reveals an overall consistency with those presented here, but with some notable anomalies. Examples are relatively high Zr values for pyroxenes and abnormally low Mn values in olivines and clinopyroxenes from Site 839 lavas. Some anomalies may reflect kinetic effects, but interpretation of the coefficients is complicated, especially in olivines from Sites 836 and 839, by possible crystal-liquid disequilibrium resulting from mixing processes.

Anelastic strain recovery and elastic properties of ODP Leg 123 oceanic basalt samples

A knowledge of rock stress is fundamental for improving our understanding of oceanic crustal mechanisms and lithospheric dynamic processes. However, direct measurements of stress in the deep oceans, and in particular stress magnitudes, have proved to be technically difficult. Anelastic strain recovery measurements were conducted on 15 basalt core samples from Sites 765 and 766 during Leg 123. Three sets of experiments were performed: anelastic strain recovery monitoring, dynamic elastic property measurements, and thermal azimuthal anisotropy observations. In addition, a range of other tests and observations were recorded to characterize each of the samples. One common feature of the experimental results and observations is that apparently no consistent orientation trend exists, either between the different measurements on each core sample or between the same sets of measurements on the various core samples. However, some evidence of correspondence between velocity anisotropy and anelastic strain recovery exists, but this is not consistent for all the core samples investigated. Thermal azimuthal anisotropy observations, although showing no conclusive correlations with the other results, were of significant interest in that they clearly exhibited anisotropic behavior. The apparent reproducibility of this behavior may point toward the possibility of rocks that retain a "memory" of their stress history, which could be exploited to derive stress orientations from archived core. Anelastic strain recovery is a relatively new technique. Because use of the method has extended to a wider range of rock types, the literature has begun to include examples of rocks that contracted with time. Strong circumstantial evidence exists to suggest that core-sample contractions result from the slow diffusion of pore fluids from a preexisting microcrack structure that permits the rock to deflate at a greater rate than the expansion caused by anelastic strain recovery. Both expansions and contractions of the Leg 123 cores were observed. The basalt cores have clearly been intersected by an abundance of preexisting fractures, some of which pass right through the samples, but many are intercepted or terminate within the rock matrix. Thus, the behavior of the core samples will be influenced not only by the properties of the rock matrix between the fractures, but also by how these macro- and micro-scale fractures mutually interact. The strain-recovery curves recorded during Leg 123 for each of the 15 basalt core samples may reflect the result of two competing time dependent processes: anelastic strain recovery and pore pressure recovery. Were these the only two processes to influence the gauge responses, then one might expect that given the additional information required, established theoretical models might be used to determine consistent stress orientations and reliable stress magnitudes. However, superimposed upon these competing processes is their respective interaction with the preexisting fractures that intersect each core. Evidence from our experiments and observations suggests that these fractures have a dominating influence on the characteristics of the recovery curves and that their effects are complex.

Fission track analyses of ODP Hole 129-800A samples

Four models of fission track annealing in apatite are compared with measured fission track lengths in samples from Site 800 in the East Mariana Basin, Ocean Drilling Program Leg 129, given an independently determined temperature history. The temperature history of Site 800 was calculated using a one-dimensional, compactive, conductive heat flow model assuming two end-member thermal cases: one for cooling of Jurassic ocean crust that has experienced no subsequent heating, and one for cooling of Cretaceous ocean crust. Because the samples analyzed were only shallowly buried and because the tectonic history of the area since sample deposition is simple, resolution of the temperature history is high. The maximum temperature experienced by the sampled bed is between 16°-21°C and occurs at 96 Ma; temperatures since the Cretaceous have dropped in spite of continued pelagic sediment deposition because heat flow has continued to decay exponentially and bottom-water temperatures have dropped. Fission tracks observed within apatite grains from the sampled bed are 14.6 +/- 0.1 µm (1 sigma) long. Given the proposed temperature history of the samples, one unpublished and three published models of fission track annealing predict mean track lengths from 14.8 to 15.9 µm. These models require temperatures as much as 40°C higher than the calculated paleotemperature maximum of the sampled bed to produce the same degree of track annealing. Measured and predicted values are different because annealing models are based on extrapolation of high temperature laboratory data to geologic times. The model that makes the closest prediction is based on the greatest number of experiments performed at low temperature and on an apatite having composition closest to that of the core samples.

Grain entrainment and transport rates of magnetic minerals of coastal sediment samples from the Bay of Plenty, New Zealand

Heavy (magnetic & non-magnetic) minerals are found concentrated by natural processes in many fluvial, estuarine, coastal and shelf environments with a potential to form economic placer deposits. Understanding the processes of heavy mineral transport and enrichment is prerequisite to interpret sediment magnetic properties in terms of hydro- and sediment dynamics. In this study, we combine rock magnetic and sedimentological laboratory measurements with numerical 3D discrete element models to investigate differential grain entrainment and transport rates of magnetic minerals in a range of coastal environments (riverbed, mouth, estuary, beach and near-shore). We analyzed grain-size distributions of representative bulk samples and their magnetic mineral fractions to relate grain-size modes to respective transport modes (traction, saltation, suspension). Rock magnetic measurements showed that distribution shapes, population sizes and grain-size offsets of bulk and magnetic mineral fractions hold information on the transport conditions and enrichment process in each depositional environment. A downstream decrease in magnetite grain size and an increase in magnetite concentration was observed from riverine source to marine sink environments. Lower flow velocities permit differential settling of light and heavy mineral grains creating heavy mineral enriched zones in estuary settings, while lighter minerals are washed out further into the sea. Numerical model results showed that higher heavy mineral concentrations in the bed increased the erosion rate and enhancing heavy mineral enrichment. In beach environments where sediments contained light and heavy mineral grains of equivalent grain sizes, the bed was found to be more stable with negligible amount of erosion compared to other bed compositions. Heavy mineral transport rates calculated for four different bed compositions showed that increasing heavy mineral content in the bed decreased the transport rate. There is always a lag in transport between light and heavy minerals which increases with higher heavy mineral concentration in all tested bed compositions. The results of laboratory experiments were validated by numerical models and showed good agreement. We demonstrate that the presented approach bears the potential to investigate heavy mineral enrichment processes in a wide range of sedimentary settings.

Ba/Ca ratios in Neogloboquadrina pachyderma of sedimet core 94B17

Down-core samples of the planktonic foraminifer Neogloboquadrina pachyderma sinistral from the Mendeleyev Ridge in the western Arctic Ocean have been analyzed for Ba/Ca and d18O. The apparent distribution coefficient for N. pachyderma sin. is estimated at DBa = 0.22 ± 0.02. A meltwater event is identified at around 11.8 14C kyr BP and is coincident with elevated Ba/Ca ratios. The barium enrichment is believed to be the result of enhanced weathering and erosion following glaciation. Additionally, barium may have desorbed from shelf sediments as sea level rose. Changes in Ba/Ca correlate with the retreat of the Laurentide Ice Sheet and the evolution of the Mackenzie River drainage basin. Therefore maximum Ba/Ca in Arctic surface waters at 11.8 ka may be indicative of an increase in the export of freshwater from the Arctic to the North Atlantic, potentially contributing to the onset of the Younger Dryas. This work suggests that Ba/Ca in planktonic foraminifera may be a useful indicator of the timing and processes associated with deglaciation.

Cenozoic terrestrial palynomorphs from the late Oligocene to early Miocene section of sediment core CRP-2/2A (Table 1)

Sparse terrestrial palynomorphs (spores and pollen) were recovered from glacigene Lower Miocene and Oligocene core samples from the Cape Roberts Project (CRP) drillhole CRP-2/2A, Victoria Land Basin, Antarctica. Rarity of palynomorphs probably results from the spares periglacial vegetation in the surrounding landscape at the time of deposition, as well as dilution from rapid sediment accumulation. The Miocene and Late Oligocene vegetation is interpreted as including herb-moss tundra with low-growing woody plants (including Nothofagus and podocarp conifers) in more protected areas, similar to that encountered in the Miocene of CRP-1. Species richness and numbers of specimens increase downhole, a trend that begins very gradually below ~307 mbsf, and increases below ~443 mbsf through the Early Oligocene. These lower assemblages reflect low diversity woody vegetation dominated by several species of Nofhofagus and podocarps, growing in somewhat milder conditions, though still cold temperate to periglacial in the Early Oligocene. The CRP-2/2A core provides new biostratigraphical information, such as the First Appearance Datums (FADS) of Tricolpites sp. a near the Oligocene/Miocene boundary, and Marchantiaceae in the Early/Late Oligocene transition: these are taxa that along with N. lachlaniae, Coptospora spp. and Podocarpidites sp.b characterize assemblages recovered from outcrops of the Pliocene Sirius Group in the Transantarctic Mountains. Some elements of the extremely hardy periglacial tundra vegetation that survived in Antarctica into the Pliocene had their origin in the Oligocene during a time of deteriorating (colder, drier) climatic conditions. The CRP results highlight the long persistence of this tundra vegetation, through approximately 30 million years of dynamically changing climatic conditions. Rare Jurassic and more common Permian-Triassic spores and pollen occur sporadically throughout the core. These are derived from Jurassic Ferrar Group sediments, and from the Permian-Triassic Victoria Group, upper Beacon Supergroup. Higher frequencies of reworked Beacon palynomorphs and coaly organic matter below ~307 mbsf indicate greater erosion of the Beacon Supergroup for this lower part of the core. A color range from black, severely metamorphosed specimens, to light-colored, yellow (indicating low thermal alteration), reworked Permian palynomorphs, indicates local provenance in the dolerite-intruded Beacon strata of the Transantarctic Mountains, as well as areas (now sub-ice) of Beacon strata with little or no associated dolerite well inland (cratonwards) of the present Transantarctic Mountains.

(Table 1) Water-extractable and acid-extractable carbohydrates in DSDP Leg 65 samples

Selected parts of ten frozen core samples from Holes 482A, 482B, 483A, and 485A, Leg 65 of the Deep Sea Drilling Project (DSDP), were analyzed for residual carbohydrates in order to determine the provenance and history of the organic material in the sediments. The samples, which represented silty-clay, shale, and nannofossil- chalk sediments, were analyzed for water-soluble monosaccharides, acid-soluble monosaccharides, and for starch and cellulose. Most samples yielded positive results for acid-extractable (polymeric) arabinose, fucose, xylose, mannose, galactose, and glucose. Amylose was detected in seven of the samples, whereas cellulose was found in only one. Possible explanations for the relatively high levels of free sugars are suggested in the conclusions to this chapter.