Characterization of foot-and-mouth disease virus types Ο and Asia 1 RNA

Foot-and-mouth disease is an acute and highly contagious febrile disease affecting cloven-footed animals. Identification of the foot-and-mouth disease virus (FMDV), the causative agent of the disease, posed problems because of the occurrence of many types and subtypes of the virus. A molecular approach based on oligonucleotide mapping of FMDV RNA has been used for the identification and characterization of virus isolates obtained in a disease outbreak (King et al., 1981). One-dimensional oligonucleotide mapping was used for rapid analysis of FMDV RNA (LaTorre et al., 1982). FMDV types Ο and Asia 1 of Indian origin are being routinely used for vaccine production in India. This report presents the differences between FMDV types Ο and Asia 1 at molecular level based on one-dimensional oligonucleotide mapping of virus-induced poly (A) RNA.

The vapour pressures of barium and strontium

The vapour pressures of barium and strontium have been measured by continuous monitoring of the weight loss of Knudsen cells in the temperature range 700�1200 K. The results for strontium agree with those reported in the literature, but the vapour pressure of barium has been found to be considerably lower than the generally accepted value. The experimentally determined pressures are in good agreement with theoretical values obtained using the Gibbs-Bogoliubov first-order variational method.

A lock-type cell for NMR studies at high hydrostatic pressures and low temperatures

Details of a simple and convenient high-pressure cell for continuous-wave, wide-line nuclear magnetic resonance investigation at high pressures and low temperatures are described. Experimental results obtained with the cell at 14*108 Pa and 77K for ammonium iodide are presented briefly.

Observation of crack closure using a crack mouth opening displacement gauge

A crack mouth opening displacement (CMOD) gauge has been designed to estimate the crack length as well as the crack opening stress level in an automated fatigue crack propagation test programme. The CMOD gauge accurately predicts crack tip opening levels in K-controlled tests with constant K, K increasing or K decreasing. In all three K-controlled tests with a single 100% overload cycle, the CMOD gauge does not measure the crack tip opening stress level over a large range of crack lengths after the application of the overload. The CMOD gauge measures the stress level at which the overload plastic zone site opens. Caution should thus be exercised in using the crack opening stress level, estimated by the CMOD gauge, to explain fatigue crack propagation under arbitrary load sequences from the viewpoint of crack closure phenomena.

Thermal gap conductance at low contact pressures (<1 MPa): Effect of gold plating and plating thickness

Thermal contact conductance (TCC) measurements are made on bare and gold plated (<= 0.5 mu m) oxygen free high conductivity (OFHC) Cu and brass contacts in vacuum, nitrogen, and argon environments. It is observed that the TCC in gaseous environment is significantly higher than that in vacuum due to the enhanced thermal gap conductance. It is found that for a given contact load and gas pressure, the thermal gap conductance for bare OFHC Cu contacts is higher than that for gold plated contacts. It is due to the difference in the molecular weights of copper and gold, which influences the exchange of kinetic energy between the gas molecules and contact surfaces. Furthermore, the gap conductance is found to increase with increasing thickness of gold plating. Topography measurements and scanning electron microscopy (SEM) analysis of contact surfaces revealed that surfaces become smoother with increasing gold plating thickness, thus resulting in smaller gaps and consequently higher gap conductance. (C) 2010 Elsevier Ltd. All rights reserved.

Characterization and immune response of a protein produced by a cDNA clone of foot and mouth disease virus, type Asia 1 63/72

A 0.9 kb double stranded cDNA of foot and mouth disease virus (FMDV) Type Asia 1, 63/72 was cloned in an expression vector, pUR222. A protein of 38 kd was produced by the clone which reacted with the antibodies raised against the virus. A 20 kd protein which may be derived from the 38 kd protein contained the antigenic epitopes of the protein VP1 of the virus. Injection of 10-20 micrograms of the partially purified 38 and 20 kd proteins or a lysate of cells containing 240 micrograms of the proteins elicited high titers of FMDV specific antibodies in guinea pigs and cattle respectively. Also, at these concentrations, the proteins protected 5 of 8 guinea pigs and 3 of 8 cattle when challenged with a virulent virus.

Electrical-Resistivity Studies on GE-SE Glasses at High-Pressures and Low-Temperatures

High pressure electrical resistivity measurements were carried out on GexSe100-x (0 less-than-or-equal-to x less-than-or-equal-to 40) glasses at ambient and low temperatures using the Bridgman anvil system. All the melt quenched glasses show a discontinuous glassy semiconductor to crystalline metal transition at high pressures. The high pressure phases of Ge-Se samples do not correspond to any of the equilibrium phases of the system. Additionally, the variation of transition pressure (P(T)), ambient resistivity (rho0) and the activation energy (DELTAE(t)) with composition, exhibit a change in behaviour at x = 20 and 33. The unusual variations observed in these glasses are discussed in the light of chemical and percolation thresholds occurring in the glassy system.

Solubility of sulfur dioxide at low partial pressures in dilute sulfuric acid solutions

Equilibrium of dissolution of sulfur dioxide at ppm levels in aqueous solutions of dilute sulfuric acid is analyzed, and a general expression is derived relating the total concentration of sulfur dioxide in the liquid phase to the partial pressure of SO2 in the gas and to the concentration of sulfuric acid in the solution. The equation is simplified for zero and high concentrations of the acid. Experiments at high concentrations of sulfuric acid have enabled the direct determination of Henry’s constant and its dependency on temperature. Heat of dissolution is -31.47 kJ/mol. Experiments in the absence of sulfuric acid and the related simplified expression have led to the determination of the equilibrium constant of the hydrolysis of aqueous sulfur dioxide and its temperature dependency.The heat of hydrolysis is 15.69 kJ/mol. The model equation with these parameters predicts the experimental data of the present work as well as the reported data very well.

The Role of Electronic Word of Mouth in Shaping Consumer Attitudes

The purpose of this research was to investigate the role of electronic word of mouth (eWOM) in shaping consumer attitudes towards various products and services with concentration on the consumer attitude change. eWOM has long been proven to play an important role in influencing consumer attitudes and has been researched from a variety of perspectives. This study attempts to look deeper into the process of consumer attitude change by applying as the central theory of the study the Elaboration Likelihood Model of Persuasion by Petty and Cacioppo. In the processes of examining the background academic and empirical research the Internet and Web 2.0 are closely depicted in order to understand how throughout the past centuries technology allowed the rise of various mediums where consumers can not only share their opinions online about products and services but also communicate with other consumers. Manuel Castel’s Internet Galaxy, Gildin’s, Carl and Noland’s, Hennig-Thurau, Gwinner, Walsh and Gremler’s researches on eWOM are the central works that helped to shape both the theoretical and empirical parts of this study. The mixed method approach was chosen as a research method for this study. An online survey was conducted via the Surveymonkey.com platform and eight qualitative in-depth interviews were conducted. The results of the study show that central route queues as text quality and text argumentativeness are more prominent among the research subjects and the peripheral route queues: source credibility and source expertise did not show considerable significance. Also more experience and participation consumers have with user-rating websites and applications more inclined they are to elaborate on the central route cues and are more likely to search for opinions that they consider rational and credible. Also these respondents are less inclined to search for ratings that confirm their existing beliefs about products or services. Less experience/participation they have about eWOM more likely they are to search for reviews confirmatory to their own.

Structural changes in single-walled carbon nanotubes under non-hydrostatic pressures: x-ray and Raman studies

Using in situ x-ray diffraction and Raman scattering techniques, we have investigated the behaviour of single-walled carbon nanotubes bundles under non-hydrostatic pressures. It is seen that the diffraction line corresponding to the two-dimensional triangular lattice in the bundles is not reversible for pressures beyond 5 GPa, in sharp contrast to earlier results under hydrostatic pressure conditions. Most interestingly, radial breathing and tangential Raman modes of the pressure-cycled samples from 21 and 30 GPa match very well with those of the starting sample. Raman and x-ray results put together clearly suggest that the ordering of tubes in the bundles is only marginally regained with a very short coherence length on decompression.