Eigenvalues of Casimir invariants for unitary irreps of Uq(gl(m vertical bar n))

A fully explicit formula for the eigenvalues of Casimir invariants for U-q(gl(m/n)) is given which applies to all unitary irreps. This is achieved by making some interesting observations on atypicality indices for irreps occurring in the tensor product of unitary irreps of the same type. These results have applications in the determination of link polynomials arising from unitary irreps of U-q(gl(m/n)).

Vertical Root Fracture in Upper Premolars with Endodontic Posts: Finite Element Analysis

Upper premolars restored with endodontic posts present a high incidence of vertical root fracture (VRF). Two hypotheses were tested: (1) the smaller mesiodistal diameter favors stress concentration in the root and (2) the lack of an effective bonding between root and post increases the risk of VRF. Using finite element analysis, maximum principal stress was analyzed in 3-dimensional intact upper second premolar models. From the intact models, new models were built including endodontic posts of different elastic modulus (E = 37 or E = 200 GPa) with circular or oval cross-section, either bonded or nonbonded to circular or oval cross-section root canals. The first hypothesis was partially confirmed because the conditions involving nonbonded, low-modulus posts showed lower tensile stress for oval canals compared to circular canals. Tensile stress peaks for the nonbonded models were approximately three times higher than for the bonded or intact models, therefore confirming the second hypothesis. (J Endod 2009;35:117-120)

"Cheap and nasty": German goods, socialism, and the 1876 Philadelphia world fair

At the World Fair in Philadelphia in 1876, the German goods on display were described as cheap and nasty, setting off a vigorous debate about the state of German industry. Social democrats attacked policies of increasing competitiveness of German exports through keeping wages low, and claimed that the quality of the goods produced by socialist workers was higher than those produced by others. An analysis of the debate shows the extent to which social democrats not only resorted to arguments stressing the national interest, but also the extent to which nominally Marxist socialists in this period were still attached to traditional artisanal values of pride in the quality of their work.

Media stress intensity analysis for vertical stirred mills

Experimental work has been carried out to investigate the effect of major operating variables on milling efficiency of calcium carbonate in laboratory and pilot size Tower and Sala Agitated (SAM) mills. The results suggest that the stirrer speed, media size and slurry density affect the specific energy consumption required to achieve the given product size. Media stress intensity analysis developed for high-speed horizontal mills was modified to include the effect of gravitational force in the vertical stirred mills such as the Tower and SAM units. The results suggest that this approach can be successfully applied for both mill types. For a given specific energy input, an optimum stress intensity range existed, for which the finest product was achieved. Finer product and therefore higher milling efficiency was obtained with SAM in the range of operating conditions tested. (C) 2001 Elsevier Science Ltd. All rights reserved.

Automatic construction of explicit R matrices for the one-parameter families of irreducible typical highest weight (0(m)vertical bar alpha(n)) representations of U-q[gl(m vertical bar n)]

We detail the automatic construction of R matrices corresponding to (the tensor products of) the (O-m\alpha(n)) families of highest-weight representations of the quantum superalgebras Uq[gl(m\n)]. These representations are irreducible, contain a free complex parameter a, and are 2(mn)-dimensional. Our R matrices are actually (sparse) rank 4 tensors, containing a total of 2(4mn) components, each of which is in general an algebraic expression in the two complex variables q and a. Although the constructions are straightforward, we describe them in full here, to fill a perceived gap in the literature. As the algorithms are generally impracticable for manual calculation, we have implemented the entire process in MATHEMATICA; illustrating our results with U-q [gl(3\1)]. (C) 2002 Published by Elsevier Science B.V.

Vertical fluxes of sediment in oscillatory sheet flow

Time series of vertical sediment fluxes are derived from concentration time series in sheet flow under waves. While the concentrations C(z,t) vary very little with time for \z\ < 10d(50), the measured vertical sediment fluxes Q(zs)(z,t) vary strongly with time in this vertical band and their time variation follows, to some extent, the variation of the grain roughness Shields parameter 02,5(t). Thus, sediment distribution models based on the pickup function boundary condition are in some qualitative agreement with the measurements. However, the pickup function models are only able to model the upward bursts of sediment during the accelerating phases of the flow. They are, so far, unable to model the following strong downward sediment fluxes, which are observed during the periods of flow deceleration. Classical pickup functions, which essentially depend on the Shields parameter, are also incapable of modelling the secondary entrainment fluxes, which sometimes occur at free stream velocity reversal. The measured vertical fluxes indicate that the effective sediment settling velocity in the high [(0.3 < C(z,t) < 0.4] concentration area is typically only a few percent of the clear water settling velocity, while the measurements of Richardson and Jeronimo [Chem. Eng. Sci. 34 (1979) 1419], from a different physical setting, lead to estimates of the order 20%. The data does not support gradient diffusion as a model for sediment entrainment from the bed. That is, detailed modelling of the observed near-bed fluxes would require diffusivities that go negative during periods of flow deceleration. An observed general trend for concentration variability to increase with elevation close to the bed is also irreconcilable with diffusion models driven by a bottom boundary condition. (C) 2002 Published by Elsevier Science B.V.

Design of microchannel free-space optical interconnects based on vertical-cavity surface-emitting laser arrays

We investigate the design of free-space optical interconnects (FSOIs) based on arrays of vertical-cavity surface-emitting lasers (VCSELs), microlenses, and photodetectors. We explain the effect of the modal structure of a multimodeVCSEL beam on the performance of a FSOI with microchannel architecture. A Gaussian-beam diffraction model is used in combination with the experimentally obtained spectrally resolved VCSEL beam profiles to determine the optical channel crosstalk and the signal-to-noise ratio (SNR) in the system. The dependence of the SNR on the feature parameters of a FSOI is investigated. We found that the presence of higher-order modes reduces the SNR and the maximum feasible interconnect distance. We also found that the positioning of a VCSEL array relative to the transmitter microlens has a significant impact on the SNR and the maximum feasible interconnect distance. Our analysis shows that the departure from the traditional confocal system yields several advantages including the extended interconnect distance and/or improved SNR. The results show that FSOIs based on multimode VCSELs can be efficiently utilized in both chip-level and board-level interconnects. (C) 2002 Optical Society of America.

Interpreting white goods: Kunie women's perceptions of progress in New Caledonia

Acknowledging and describing the ways that women shape relations of power and property can add to understandings of how local communities create and experience globalisation. In this paper I examine how relations of power are actively and discursively constructed within Kunieacute households in New Caledonia, how they are inscribed by gender, and link them to local narrativisations of progress.

Distributional profiles of homologous open reading frames among bacterial phyla: implications for vertical and lateral transmission

If open reading frames (ORFs) have been transmitted primarily by vertical descent, the distributional profile of orthologues of each ORF should be congruent with the organismal tree or a subtree thereof. Distributional patterns not reconciled parsimoniously with tree-like descent and loss are prima facie evidence of lateral gene transfer. Herein, a rigorous criterion for recognizing ORF distributions is described and implemented; it does not require the inference of phylogenetic trees, nor does it assume any specific tree. Because lineage-specific differences in rates of sequence change can also generate unexpected distributional patterns, rate artefacts, were controlled for by requiring pairwise matches between ORFs to exceed a rigorous inclusion threshold, but absence of a match was assessed against a more-permissive exclusion threshold. Applying this dual-threshold criterion to cross-domain and cross-phylum distributional patterns for ORFs in 23 bacterial genomes, a relative abundance of ORFs was observed that find a match in exactly seven other bacterial phyla; 94-99% of these ORFs also find matches among the Archaea and/or Eukarya. In the larger (and some smaller) bacterial genomes, ORFs that find matches in exactly one other bacterial phylum are also relatively abundant, but fewer of these have non-bacterial homologues; most of their matches within the Bacteria are to the Proteobacteria and/or Firmicutes, which cannot be sister lineages to all bacteria. ORFs that are neither distributed universally among the Bacteria, nor necessarily shared with topologically adjacent lineages, are preferentially enriched in large bacterial genomes.