Thermoluminescence studies of LiBa2B5O10 : RE3+ (RE = Dy, Tb and Tm)

LiBa2B5O10:RE3+ (RE = Dy, Tb and Tm) was synthesized by the method of high-temperature solid-state reaction and the thermoluminescence (TL) properties of the samples under the irradiation of the gamma-ray were studied. The result showed that Dy3+ ion was the most efficient activator. When the concentration of Dy3+ was 2 mol%, LiBa2B5O10:Dy3+ exhibited a maximum TL output. The kinetic parameter of LiBa2B5O10:0.02Dy was estimated by the peak shape method, for which the average activation energy was 0.757 eV and the frequency factor was 1.50 x 10(7) s(-1). By the three-dimensional (3D) TL spectrum, the TL of the sample was contributed to the characteristic f-f transition of DY3+. The dose-response of LiBa2B5O10:0.02Dy to gamma-ray was linear in the range from 1 to 1000 mGy. In addition, the decay of the TL intensity of LiBa2B5O10:0.02Dy was also investigated.

Microstructure and some dynamic performances of Ti0.17Zr0.08V0.34RE0.01Cr0.1Ni0.3 (RE = Ce, Dy) hydrogen storage electrode alloys

Microstructure and some dynamic performances of Ti0.17Zr0.08V0.34RE0.01Cr0.1Ni0.3 (RE=Ce, Dy) hydrogen storage electrode alloys have been investigated using XRD, FESEM-EDS, ICP-MS and EIS measurements. The alloy is composed of V-based solid solution phase with a dendritic shape and a continuous C14 Laves phase with a network shape surrounding the dendrite. Pressure-composition isotherm curves indicate that the alloy with Dy addition has a lower equilibrium hydrogen pressure and a wider plateau region. The alloy electrode with Dy addition has higher discharge capacity, while the alloy electrode with Ce addition has better activation and higher cycle stability. The alloy electrode with Ce addition has better electrochemical activity with higher exchange current density (127.5 mA g(-1)), lower charge transfer resistance (1.37 Omega) and lower apparent activation energy (30.5 kJ mol(-1)). The capacity degradation behavior for the alloy electrode is attributed to two main factors: one is the dissolutions of V and Zr element to KOH solution, and another is the larger charge transfer resistance which increases with increasing cycle number.

Comparative study on the luminescent properties of Y3Al5O12 : RE3+ (RE : Eu, Dy) phosphors synthesized by three methods

By using metal nitrates and oxides as the starting materials, Y3Al5O12 (YAG) and YAG: RE3+ (RE: Eu, Dy) powder phosphors were prepared by solid state (SS), coprecipitation (CP) and citrate-gel (CG) methods, respectively. The resulting YAG based phosphors were characterized by XRD and photoluminescent excitation and emission spectra as well as lifetimes. The purified crystalline phases of YAG were obtained at 800degreesC (CG) and 900degreesC (CP and SS), respectively. Great differences were observed for the excitation and emission spectra of Eu3+ and Dy3+ between crystalline and amorphous states of YAG, and their emission intensities increased with increasing the annealing temperature. At an identical annealing temperature and doping concentration, the Eu3+ and Dy3+ showed the strongest and weakest emission intensity in CP- and CG-derived YAG phosphors, respectively. The poor emission intensity for CG-derived phosphors is mainly caused by the contamination organic impurities from citric acid in the starting materials. Furthermore, the lifetimes for the samples derived from CG and CP routes are shorter than those derived from the SS route.

Synthesis and photoluminescence of Y2O3 : RE3+ (RE = Eu, Tb, Dy) porous nanotubes templated by carbon nanotubes

Y2O3:RE3+ (RE = Eu, Tb, Dy) porous nanotubes were first synthesized using carbon nanotubes as template. The morphology of the coated precursors and porous Y2O3:Eu3+ nanotubes was determined by scanning electron Microscopy (SEM) and transmission electron microscopy (TEM). It was found that the coating of precursors on carbon nanotubes (CNTs) is continuous and the thickness is about 15 nm, after calcinated, the Y2O3:Eu3+ nanotubes are porous with the diameter size in the range of 50-80 nm and the length in micrometer scale. X-ray diffraction (XRD) patterns confirmed that the samples are cubic phase Y2O3 and the photoluminescence studies showed that the porous rare earth ions doped nanotubes possess characteristic emission of Eu3+, Tb3+, and Dy3+. This method may also provide a novel approach to produce other inorganic porous nanotubes used in catalyst and sensors.

VIV-UV excited luminescent properties of LnCa4O(BO3)3 : RE3+(Ln = Y, La, Gd; Re=Eu, Tb, Dy, Ce)

Calcium lanthanide oxyborate doped with rare-earth ions LnCa(4)O(BO3)(3):RE3+ (LnCOB:RE, Ln = Y, La, Gd, RE = Eu, Tb, Dy, Cc) was synthesized by the method of solid-state reaction at high temperature. Their fluorescent spectra were measured from vacuum ultraviolet (VUV) to visible region at room temperature. Their excitation spectra all have a broadband center at about 188 nm, which is ascribed to host absorption. Using Dorenbos' and J phi rgensen's work [P. Dorenbos, J. Lumin. 91 (2000) 91, R. Resfeld, C.K. J phi rgensen. Lasers and Excite States of Rare Earth [M], Springer, Berlin, 1977, p. 45], the position of the lowest 5d levels E(Ln,A) and charge transfer band E-ct were calculated and compared with their excitation spectra.Eu3+ and Tb3+ ions doped into LnCOB show efficient luminescence under VUV and UV irradiation. In this system, Ce3+ ions do not show efficient luminescence and quench the luminescence of Tb3+ ions when Tb3+ and Ce3+ ions are co-doped into LnCOB. GdCOB doped with Dy3+ shows yellowish white light under irradiation of 254 nm light for the reason that Gd ions transfer the energy from itself to Dy.

Syntheses and crystal structures of bis(tetrahydrofurfurylindenyl) lanthanocene chlorides (C4H7OCH2C9H6)(2)LnCl (Ln = Nd, Sm, Dy, Ho, Er, Yb)

Reaction of anhydrous lanthanide trichlorides with tetrahydrofurfuryl indenyl lithium in THF afforded bis(tetrahydrofurfurylindenyl) lanthanocene chlorides complexes (C4H7OCH2C9H6)(2) LnCl, Ln = Nd (1), Sm (2), Dy (3), Ho (4), Er (5), Yb (6). The X-ray crystallographic structures of all the six complexes were determined and these indicate that they are unsolvated nine-coordinate monomeric complexes with a trans arrangement of both the sidearm and indenyl rings in the solid state. They belong to the same crystal system (orthorhombic) and space group (P2(1)2(1)2(1)) with the same structure. Especially, they are more stable to air and moisture than the corresponding unsubstituted indenyl lanthanide complexes.

Dy~(3+)激活的几种硼酸盐在VUV—VIS范围的光谱性质

本文报道了SrAl2 B2 O7:Dy3+、BaAl2 B2 O7:Dy3+、SrAl3BO7:Dy3+、La2 CaB10 O19:Dy3+的紫外-真空紫外 (UV—VUV)激发光谱和UV激发下的发射光谱。根据发射光谱讨论了Dy3+离子在这几种基质中发光的黄蓝比 (Y/B)。在VUV激发光谱中推测了Dy3+的f-d跃迁及电荷迁移态(CTS)和基质吸收的位置

Eu~(2+),Dy~(3+)共掺杂硼铝锶长余辉玻璃陶瓷

首次介绍了一种新型长余辉材料 :Eu2 + ,Dy3 + 共掺杂硼铝锶长余辉玻璃陶瓷 ,该玻璃陶瓷用紫外灯、日光、荧光灯均可激发 ,发射黄绿色余辉 ,余辉的发射峰位于 5 16nm ,来自于Eu2 + 的 5d→ 8S7/ 2 跃迁。用12 0 0 0lx的荧光灯激发样品 2 0分钟 ,停止激发后 10秒时 ,该玻璃陶瓷的余辉亮度为 3 5 3cd/m2 ,色坐标为 :x =0 2 84 2 ,y =0 5 772 ;停止激发后 5小时 5 5分钟 ,该玻璃陶瓷的余辉亮度为 0 0 1cd/m2 ;停止激发 30小时后 ,余辉在黑暗中仍肉眼可见。文中对该玻璃陶瓷的相关性质进行了表征 ,并提出了可能的长余辉机理

YAG∶Nd中Pr,Sm,Dy杂质对其光谱的影响

采用溶胶 -凝胶法合成了YAG∶Nd ,Re(Re =Pr,Sm ,Dy)系列化合物 ,研究了它们的光谱性质 .结果表明 :Pr3 + ,Sm3 + ,Dy3 + 对YAG基质中Nd3 + 的发光具有猝灭作用 ,属于有害杂质 ,在激光晶体原料中必须除去

Calculation of chemical bond parameters in RBa2Cu4O8(R = Dy,Ho,Er,Tm,Yb) and Y2Ba4Cu7O14.3

Chemical bond parameters in RBa2Cu4O8(R = Dy, Ho, Er, Tm, Yb) and Y2Ba4Cu7O14.3 were calculated by using complex chemical bond theory. The results indicated that the bond covalency in CuO chain was larger than that in CuO2 plane. For metal atoms, the bond covalency of five coordinated case was larger than that of six coordinated case.

RBa_2Cu_4O_8(R=Dy,Ho,Er,Tm,Yb)和Y_2Ba_4Cu_7O_(14.3)的化学键参数计算

使用复杂晶体上化学键理论计算了 RBa2 Cu4 O8(R=Dy,Ho,Er,Tm ,Yb)和 Y2 Ba4 Cu7O14 .3 的化学键参数 .结果表明 ,Cu O链上的 Cu O键共价性大于它们在 Cu O2 面的共价性 .当金属元素与氧形成五配位时 ,其共价性的数值大于这些元素在六配位时的情形

用3种方法合成Y_3Al_5O_(12)∶RE~(3+)(RE=Eu,Dy)发光粉的对比研究

以金属硝酸盐为反应原料 ,分别采用柠檬酸 凝胶法、共沉淀法和固相法制备了YAG和YAG∶RE3+ (RE =Eu ,Dy) (1% ,摩尔分数 )发光粉 ,并通过XRD ,TG DTA和发光光谱对样品进行了表征。柠檬酸 凝胶法、共沉淀法和固相法制备的YAG和YAG∶Eu的晶相形成温度分别是 80 0和 90 0℃。Eu3+ 在非晶态和晶态YAG中其激发和发射光谱有明显差异 ,在一定温度范围内 ,发光强度随烧结温度的升高而增强。由于碳杂质的存在 ,90 0和 10 0 0℃下柠檬酸 凝胶法制备样品的发射强度较其他两种方法低。

Bond covalencies in R2BaCuO5 (R = Sm, Gd, Dy, Ho, Y, Er, Tm, Yb, Lu)

Bond covalencies in R2BaCuO5 (R = Sm, Gd, Dy, Ho, Y, Er, Tm, Yb, Lu) were calculated by means of a semiempirical method. This method is the generalization of the dielectric description theory of Phillips-Van Vechten-Levine-Tanaka scheme. The present paper presents the formula concerning the decomposing of complex crystals which are usually anisotropic systems into the sum of binary crystals which are isotropic systems. It can be seen that although the bond covalency is related to many physical quantities, it is mainly influenced by bond valence or bond charge, and a higher bond valence will produce higher bond covalency.

The bond ionicity in RBa2Cu3O7 (R=Pr, Sm, Eu, Gd, Dy, Y, Ho, Er, Tm)

RBa2Cu3O7 (R = Pr, Sm, Eu, Gd, Dy, Y, Ho, Er, Tm) has been studied using complex chemical bond theory. The results indicated that with the decreasing of R radius, the ionicities for all considered types of bond decrease. This is in good agreement with the experimental fact that T-c decreases with the decreasing of R radius. PrBa2Cu3O7 with no Ba-site Pr in this calculation is also predicted to be a superconductor. This supports the conclusion obtained by Blackstead et al. The ionicity for each bond obeys the following order: Ba-O > R-O > Cu(2)-O(1) > Cu(2)-O(2,3) > Cu(1)-O(4) similar to Cu(1)-O(1).