Magnetic alignment of high-aspect ratio microwires into vertical arrays

Fundamental studies of magnetic alignment of highly anisotropic mesostructures can enable the clean-room-free fabrication of flexible, array-based solar and electronic devices, in which preferential orientation of nano- or microwire-type objects is desired. In this study, ensembles of 100 micron long Si microwires with ferromagnetic Ni and Co coatings are oriented vertically in the presence of magnetic fields. The degree of vertical alignment and threshold field strength depend on geometric factors, such as microwire length and ferromagnetic coating thickness, as well as interfacial interactions, which are modulated by varying solvent and substrate surface chemistry. Microwire ensembles with vertical alignment over 97% within 10 degrees of normal, as measured by X-ray diffraction, are achieved over square cm scale areas and set into flexible polymer films. A force balance model has been developed as a predictive tool for magnetic alignment, incorporating magnetic torque and empirically derived surface adhesion parameters. As supported by these calculations, microwires are shown to detach from the surface and align vertically in the presence of magnetic fields on the order of 100 gauss. Microwires aligned in this manner are set into a polydimethylsiloxane film where they retain their vertical alignment after the field has been removed and can subsequently be used as a flexible solar absorber layer. Finally, these microwires arrays can be protected for use in electrochemical cells by the conformal deposition of a graphene layer.

A photographic record of a pre- and post-lake creation event from World War II at Valley, Isle of Anglesey, UK

The article compares a recent aerial photograph of the lowlands of the Isle of Anglesey area with a German surveillance photograph from 1941. The authors aim to infer the environmental changes made to this sand dune and lake system as a direct consequence of constructing the airfield. Part of Tywyn Trewan, the extensive sand dune system, was completely destroyed in order to create runways and the technical and domestic accommodation to house a strategic airfield. As part of the dredging, six new water bodies with a combined surface area of approximately 6 ha were created.

Injection Locked Clocking and Transmitter Equalization Techniques for Chip to Chip Interconnects

Semiconductor technology scaling has enabled drastic growth in the computational capacity of integrated circuits (ICs). This constant growth drives an increasing demand for high bandwidth communication between ICs. Electrical channel bandwidth has not been able to keep up with this demand, making I/O link design more challenging. Interconnects which employ optical channels have negligible frequency dependent loss and provide a potential solution to this I/O bandwidth problem. Apart from the type of channel, efficient high-speed communication also relies on generation and distribution of multi-phase, high-speed, and high-quality clock signals. In the multi-gigahertz frequency range, conventional clocking techniques have encountered several design challenges in terms of power consumption, skew and jitter. Injection-locking is a promising technique to address these design challenges for gigahertz clocking. However, its small locking range has been a major contributor in preventing its ubiquitous acceptance.

In the first part of this dissertation we describe a wideband injection locking scheme in an LC oscillator. Phase locked loop (PLL) and injection locking elements are combined symbiotically to achieve wide locking range while retaining the simplicity of the latter. This method does not require a phase frequency detector or a loop filter to achieve phase lock. A mathematical analysis of the system is presented and the expression for new locking range is derived. A locking range of 13.4 GHz–17.2 GHz (25%) and an average jitter tracking bandwidth of up to 400 MHz are measured in a high-Q LC oscillator. This architecture is used to generate quadrature phases from a single clock without any frequency division. It also provides high frequency jitter filtering while retaining the low frequency correlated jitter essential for forwarded clock receivers.

To improve the locking range of an injection locked ring oscillator; QLL (Quadrature locked loop) is introduced. The inherent dynamics of injection locked quadrature ring oscillator are used to improve its locking range from 5% (7-7.4GHz) to 90% (4-11GHz). The QLL is used to generate accurate clock phases for a four channel optical receiver using a forwarded clock at quarter-rate. The QLL drives an injection locked oscillator (ILO) at each channel without any repeaters for local quadrature clock generation. Each local ILO has deskew capability for phase alignment. The optical-receiver uses the inherent frequency to voltage conversion provided by the QLL to dynamically body bias its devices. A wide locking range of the QLL helps to achieve a reliable data-rate of 16-32Gb/s and adaptive body biasing aids in maintaining an ultra-low power consumption of 153pJ/bit.

From the optical receiver we move on to discussing a non-linear equalization technique for a vertical-cavity surface-emitting laser (VCSEL) based optical transmitter, to enable low-power, high-speed optical transmission. A non-linear time domain optical model of the VCSEL is built and evaluated for accuracy. The modelling shows that, while conventional FIR-based pre-emphasis works well for LTI electrical channels, it is not optimum for the non-linear optical frequency response of the VCSEL. Based on the simulations of the model an optimum equalization methodology is derived. The equalization technique is used to achieve a data-rate of 20Gb/s with power efficiency of 0.77pJ/bit.

Guiding neutral atoms with two current-carrying wires and a vertical bias field on the atom chip

We demonstrate the guiding of neutral atoms with two parallel microfabricated current-carrying wires on the atom chip and a vertical magnetic bias field. The atoms are guided along a magnetic field minimum parallel to the current-carrying wires and confined in the other two directions. We describe in detail how the precooled atoms are efficiently loaded into the two-wire guide. We present a detailed experimental study of the motional properties of the atoms in the guide and the relationship between the location of the guide and the vertical bias field. This two-wire guide with vertical bias field can be used to realize large area atom interferometer.

Battery-Powered RF Pre-Ionization System for the Caltech Magnetohydrodynamically-Driven Jet Experiment: RF Discharge Properties and MHD-Driven Jet Dynamics

This thesis describes investigations of two classes of laboratory plasmas with rather different properties: partially ionized low pressure radiofrequency (RF) discharges, and fully ionized high density magnetohydrodynamically (MHD)-driven jets. An RF pre-ionization system was developed to enable neutral gas breakdown at lower pressures and create hotter, faster jets in the Caltech MHD-Driven Jet Experiment. The RF plasma source used a custom pulsed 3 kW 13.56 MHz RF power amplifier that was powered by AA batteries, allowing it to safely float at 4-6 kV with the cathode of the jet experiment. The argon RF discharge equilibrium and transport properties were analyzed, and novel jet dynamics were observed.

Although the RF plasma source was conceived as a wave-heated helicon source, scaling measurements and numerical modeling showed that inductive coupling was the dominant energy input mechanism. A one-dimensional time-dependent fluid model was developed to quantitatively explain the expansion of the pre-ionized plasma into the jet experiment chamber. The plasma transitioned from an ionizing phase with depressed neutral emission to a recombining phase with enhanced emission during the course of the experiment, causing fast camera images to be a poor indicator of the density distribution. Under certain conditions, the total visible and infrared brightness and the downstream ion density both increased after the RF power was turned off. The time-dependent emission patterns were used for an indirect measurement of the neutral gas pressure.

The low-mass jets formed with the aid of the pre-ionization system were extremely narrow and collimated near the electrodes, with peak density exceeding that of jets created without pre-ionization. The initial neutral gas distribution prior to plasma breakdown was found to be critical in determining the ultimate jet structure. The visible radius of the dense central jet column was several times narrower than the axial current channel radius, suggesting that the outer portion of the jet must have been force free, with the current parallel to the magnetic field. The studies of non-equilibrium flows and plasma self-organization being carried out at Caltech are relevant to astrophysical jets and fusion energy research.

Avaliação da fidelidade da referência externa em tecidos moles na cirurgia ortognática da maxila

Esse trabalho teve o objetivo de analisar a fidelidade da referência externa em tecidos moles no auxílio do posicionamento vertical da maxila. Foram selecionados 40 pacientes portadores de deformidade dentofacial e submetidos à osteotomia total da maxila. Os indivíduos foram divididos em 2 grupos no intuíto de avaliar duas técnicas de referência externa: a utilização da sutura em tecidos moles e o uso do fio de Kirschner. Esta última foi utilizada como a técnica do grupo-controle. Os dados foram colhidos em duas fases. Na primeira delas, foi realizada a mensuração da posição vertical da maxila antes da osteotomia Le Fort I e após a fixação da maxila, utilizando a referência externa. A partir desses números, foi obtida a alteração vertical de cada caso, colhida durante a cirurgia. Na segunda fase da coleta de dados, foram realizadas mensurações verticais da maxila baseadas nas radiografias cefalométricas pré e pós-operatórias. Assim, foi obtido o valor da alteração vertical de cada caso, baseado na documentação radiográfica. Após esta etapa, foi calculada a diferença entre a alteração vertical obtida durante a cirurgia e a alteração vertical colhida a partir das radiografias. Dessa forma, foram obtidos valores que correspondem às imperfeições no posicionamento vertical da maxila de cada paciente, tendo como base a posição do incisivo central superior. Os resultados foram comparados e analisados estatisticamente. A média aritmética da precisão no posicionamento vertical da maxila no grupo-controle foi de 0,52mm e do grupo da referência em tecidos moles foi de 0,65mm. A aplicação do teste t de Student a 5% revelou que não houve diferença estatística significativa entre o grau de precisão das duas técnicas de referência externa (P=0,429). Como conclusão, observou-se que as duas técnicas foram eficazes no auxílio ao posicionamento vertical da maxila e que a referência externa em tecidos moles apresentou um grau de precisão semelhante ao valor obtido com a técnica do fio de Kirschner.

Investigations on the vertical migration of planktonic Crustacea in the Bodensee-Obersee. [Translation from: Schriften des Vereins fur Geschichte des Bodensees und seiner Umgebung, 87, 177-187, 1969.]

The vertical zoning of the planktonic Crustacea in a lake is the expression of a complex set of different factors. Besides the measurable, external influences such as light, temperature, acid and C02 stratification, a particularly large part is played by internal factors, which co-ordinate a specific reaction in each species depending on state of development, age and sex. Supporting this extensive, predictable, annual course of diurnal depths and the daily vertical migrations, whose extent is again dependent on external conditions, primarily of course on the amount of light. The individual factors mentioned, however, are here also of great significance. Within the scope of a long-term study of the planktonic Copepoda of Lake Constance, some day and night series were in 1963 also carried out in the Obersee, in order to obtain at least volumetric data on the extent of the daily migrations of these creatures.

On drift and diel vertical migration of bottom invertebrates of the Amur. [Translation from: Zoologicheskie Zhurnal 42 1601-1612, 1963.]

Planktobenthos was sampled in 1957-58 in the river Amur. A determination of the kind of organisms drifting in the mass of water of the Amur was carried out. Of special interest for the authors was the activity of drifting of benthic larvae.