Precast Concrete Elements for Accelerated Bridge Construction Final Report Volume 3. Laboratory Testing, Field Testing, and Evaluation of a Precast Concrete Bridge: Black Hawk County,v January 2009

The importance of rapid construction technologies has been recognized by the Federal Highway Administration (FHWA) and the Iowa DOT Office of Bridges and Structures. Black Hawk County (BHC) has developed a precast modified beam-in-slab bridge (PMBISB) system for use with accelerated construction. A typical PMBISB is comprised of five to six precast MBISB panels and is used on low volume roads, on short spans, and is installed and fabricated by county forces. Precast abutment caps and a precast abutment backwall were also developed by BHC for use with the PMBISB. The objective of the research was to gain knowledge of the global behavior of the bridge system in the field, to quantify the strength and behavior of the individual precast components, and to develop a more time efficient panel-to-panel field connection. Precast components tested in the laboratory include two precast abutment caps, three different types of deck panel connections, and a precast abutment backwall. The abutment caps and backwall were tested for behavior and strength. The three panel-to-panel connections were tested in the lab for strength and were evaluated based on cost and constructability. Two PMBISB were tested in the field to determine stresses, lateral distribution characteristics, and overall global behavior.

Laboratory Performance Evaluation of CIR-Emulsion and it Comparison Against CIR-Form Test Result from Phase II, Final Report TR-578 Phase III, December 2009

Currently, no standard mix design procedure is available for CIR-emulsion in Iowa. The CIR-foam mix design process developed during the previous phase is applied for CIR-emulsion mixtures with varying emulsified asphalt contents. Dynamic modulus test, dynamic creep test, static creep test and raveling test were conducted to evaluate the short- and long-term performance of CIR-emulsion mixtures at various testing temperatures and loading conditions. A potential benefit of this research is a better understanding of CIR-emulsion material properties in comparison with those of CIR-foam material that would allow for the selection of the most appropriate CIR technology and the type and amount of the optimum stabilization material. Dynamic modulus, flow number and flow time of CIR-emulsion mixtures using CSS-h were generally higher than those of HFMS-2p. Flow number and flow time of CIR-emulsion using RAP materials from Story County was higher than those from Clayton County. Flow number and flow time of CIR-emulsion with 0.5% emulsified asphalt was higher than CIR-emulsion with 1.0% or 1.5%. Raveling loss of CIR-emulsion with 1.5% emulsified was significantly less than those with 0.5% and 1.0%. Test results in terms of dynamic modulus, flow number, flow time and raveling loss of CIR-foam mixtures are generally better than those of CIR-emulsion mixtures. Given the limited RAP sources used for this study, it is recommended that the CIR-emulsion mix design procedure should be validated against several RAP sources and emulsion types.

Audit report on the Rathbun Area Solid Waste Commission for the year ended June 30, 2012

Audit report on the Rathbun Area Solid Waste Commission for the year ended June 30, 2012

Audit report on the Hamilton County Solid Waste Commission for the year ended June 30, 2011

Audit report on the Hamilton County Solid Waste Commission for the year ended June 30, 2011

Audit report on the Shelby County Area Solid Waste Agency for the year ended June 30, 2012

Audit report on the Shelby County Area Solid Waste Agency for the year ended June 30, 2012

Comparative effects of oleoyl-estrone and a specific b3-adrenergic agonist (CL316, 243) on the expression of genes involved in energy metabolism of rat white adipose tissue

Background: The combination of oleoyl-estrone (OE) and a selective b3-adrenergic agonist (B3A; CL316,243) treatment in rats results in a profound and rapid wasting of body reserves (lipid). Methods: In the present study we investigated the effect of OE (oral gavage) and/or B3A (subcutaneous constant infusion) administration for 10 days to overweight male rats, compared with controls, on three distinct white adipose tissue (WAT) sites: subcutaneous inguinal, retroperitoneal and epididymal. Tissue weight, DNA (and, from these values cellularity), cAMP content and the expression of several key energy handling metabolism and control genes were analyzed and computed in relation to the whole site mass. Results: Both OE and B3A significantly decreased WAT mass, with no loss of DNA (cell numbers). OE decreased and B3A increased cAMP. Gene expression patterns were markedly different for OE and B3A. OE tended to decrease expression of most genes studied, with no changes (versus controls) of lipolytic but decrease of lipogenic enzyme genes. The effects of B3A were widely different, with a generalized increase in the expression of most genes, including the adrenergic receptors, and, especially the uncoupling protein UCP1. Discussion: OE and B3A, elicit widely different responses in WAT gene expression, end producing similar effects, such as shrinking of WAT, loss of fat, maintenance of cell numbers. OE acted essentially on the balance of lipolysislipogenesis and the blocking of the uptake of substrates; its decrease of synthesis favouring lipolysis. B3A induced a shotgun increase in the expression of most regulatory systems in the adipocyte, an effect that in the end favoured again the loss of lipid; this barely selective increase probably produces inefficiency, which coupled with the increase in UCP1 expression may help WAT to waste energy through thermogenesis. Conclusions: There were considerable differences in the responses of the three WAT sites. OE in general lowered gene expression and stealthily induced a substrate imbalance. B3A increasing the expression of most genes enhanced energy waste through inefficiency rather than through specific pathway activation. There was not a synergistic effect between OE and B3A in WAT, but their combined action increased WAT energy waste.

Factors influencing privatization of urban solid waste collection: some evidence from Spain

In this paper we analyse some of the organisational aspects of the urban solid waste collection and, in particular, the privatization modality of contracting out. We start by discussing some of the theoretical aspects of contracting out. We then specify and estimate an explanatory model on a sample of municipalities that we surveyed. Our purpose is twofold: on the one hand, we identify the economic factors at work when deciding to contract out the service and, on the other hand, we analyse the role of ideological factors in choosing between the public production of the service or contracting it out. The results show a significant effect of the demand for waste collection on contracting out. There also appears to be a neighbouring effect as the municipalities close to other cities that contract out are also more prone to do so. Finally, the decisions to contract seem to have been motivated by pragmatic rather than ideological reasons.

Waste Matters, December 1995.

Newsletter for Department of Natural Resources, Waste Management Division

Audit report on the Butler County Solid Waste Commission for the year ended June 30, 2012

Audit report on the Butler County Solid Waste Commission for the year ended June 30, 2012

Audit report on the Pocahontas County Solid Waste Commission for the year ended June 30, 2012

Audit report on the Pocahontas County Solid Waste Commission for the year ended June 30, 2012

Audit report on the Wayne-Ringgold-Decatur County Solid Waste Management Commission for the year ended June 30, 2012

Audit report on the Wayne-Ringgold-Decatur County Solid Waste Management Commission for the year ended June 30, 2012

Audit report on the Crawford County Area Solid Waste Agency Commission for the year ended June 30, 2012

Audit report on the Crawford County Area Solid Waste Agency Commission for the year ended June 30, 2012

Audit report on the Delaware County Solid Waste Disposal Commission for the year ended June 30, 2012

Audit report on the Delaware County Solid Waste Disposal Commission for the year ended June 30, 2012

Audit report on the Great River Regional Waste Authority for the year ended June 30, 2012

Audit report on the Great River Regional Waste Authority for the year ended June 30, 2012