Topics in LIGO-related physics: interferometric speed meters and tidal work

In the quest to develop viable designs for third-generation optical interferometric gravitational-wave detectors, one strategy is to monitor the relative momentum or speed of the test-mass mirrors, rather than monitoring their relative position. The most straightforward design for a speed-meter interferometer that accomplishes this is described and analyzed in Chapter 2. This design (due to Braginsky, Gorodetsky, Khalili, and Thorne) is analogous to a microwave-cavity speed meter conceived by Braginsky and Khalili. A mathematical mapping between the microwave speed meter and the optical interferometric speed meter is developed and used to show (in accord with the speed being a quantum nondemolition observable) that in principle the interferometric speed meter can beat the gravitational-wave standard quantum limit (SQL) by an arbitrarily large amount, over an arbitrarily wide range of frequencies . However, in practice, to reach or beat the SQL, this specific speed meter requires exorbitantly high input light power. The physical reason for this is explored, along with other issues such as constraints on performance due to optical dissipation.

Chapter 3 proposes a more sophisticated version of a speed meter. This new design requires only a modest input power and appears to be a fully practical candidate for third-generation LIGO. It can beat the SQL (the approximate sensitivity of second-generation LIGO interferometers) over a broad range of frequencies (~ 10 to 100 Hz in practice) by a factor h/h_SQL ~ √W^(SQL)_(circ)/W_circ. Here W_circ is the light power circulating in the interferometer arms and W_SQL ≃ 800 kW is the circulating power required to beat the SQL at 100 Hz (the LIGO-II power). If squeezed vacuum (with a power-squeeze factor e^-2R) is injected into the interferometer's output port, the SQL can be beat with a much reduced laser power: h/h_SQL ~ √W^(SQL)_(circ)/W_circe^-2R. For realistic parameters (e^-2R ≃ 10 and W_circ ≃ 800 to 2000 kW), the SQL can be beat by a factor ~ 3 to 4 from 10 to 100 Hz. [However, as the power increases in these expressions, the speed meter becomes more narrow band; additional power and re-optimization of some parameters are required to maintain the wide band.] By performing frequency-dependent homodyne detection on the output (with the aid of two kilometer-scale filter cavities), one can markedly improve the interferometer's sensitivity at frequencies above 100 Hz.

Chapters 2 and 3 are part of an ongoing effort to develop a practical variant of an interferometric speed meter and to combine the speed meter concept with other ideas to yield a promising third- generation interferometric gravitational-wave detector that entails low laser power.

Chapter 4 is a contribution to the foundations for analyzing sources of gravitational waves for LIGO. Specifically, it presents an analysis of the tidal work done on a self-gravitating body (e.g., a neutron star or black hole) in an external tidal field (e.g., that of a binary companion). The change in the mass-energy of the body as a result of the tidal work, or "tidal heating," is analyzed using the Landau-Lifshitz pseudotensor and the local asymptotic rest frame of the body. It is shown that the work done on the body is gauge invariant, while the body-tidal-field interaction energy contained within the body's local asymptotic rest frame is gauge dependent. This is analogous to Newtonian theory, where the interaction energy is shown to depend on how one localizes gravitational energy, but the work done on the body is independent of that localization. These conclusions play a role in analyses, by others, of the dynamics and stability of the inspiraling neutron-star binaries whose gravitational waves are likely to be seen and studied by LIGO.

Metodologia para conversão de veículos equipados com motores a combustão interna para tração elétrica: aplicação de motor síncrono de ímã permanente com fluxo magnético radial a um furgão, Brasil. 2009.

Questões climáticas, atmosféricas e de poluição ambiental têm tornado o uso final da energia assunto de interesse mundial. Sistemas com tração elétrica oferecem a oportunidade de redução de emissões. O mix de energia caracterizado pela matriz energética brasileira viabiliza o desenvolvimento desta tecnologia. É desenvolvida aqui uma metodologia para conversão de veículos equipados com motores a combustão interna para tração elétrica. A metodologia considera fatores como o peso e tamanho, o torque de partida, transmissão e potência, entre outros. Ferramentas matemáticas e a prática corrente fornecem a base para a elaboração deste trabalho, que descreve a análise de desempenho de veículos elétricos, os componentes utilizados, as equações mecânicas e os critérios para escolha do veículo ideal para conversão. É apresentada a execução de um projeto de conversão de uma Kombi para tração elétrica, cujo objetivo tem caráter educativo, buscando assim promover os benefícios da tecnologia veicular elétrica. Para viabilização do experimento, o trabalho conclui que é necessário ampliar a demanda por nacionalização de tecnologia, o que tornaria o projeto uma realidade comercialmente viável. Além disto, há necessidade de políticas públicas para o incentivo da tecnologia veicular elétrica no Brasil. Este trabalho apresenta uma contribuição para converter veículos para tração elétrica, visto que sistematiza as etapas de projeto, a partir das quais outros poderão seguir, utilizando componentes encontrados no mercado nacional.

Interrelated contributions to freshwater science over 78 years: A guide to published work from the Freshwater Biological Association, Institute of Freshwater Ecology and Centre for Ecology and Hydrology, 1929-2006

This article introduces a new listing of published scientific contributions from the Freshwater Biological Association (FBA) and its later Research Council associates – the Institute of Freshwater Ecology (1989–2000) and the Centre for Ecology and Hydrology (2000+). The period 1929–2006 is covered. The authors offer also information on specific features of the listing; also an outline of influences that underlay the research, and its scientific scope.

Metaphysics in the Work of Charles Darwin

It is not hard to see how two visions of nature are intertwined in Darwin’s Journal of Researches: one vision, the province of romantic authors depicting the sentiments awakened by certain landscapes, the other, the domain of natural scientists describing the world without reference to the aesthetic qualities of the scenery. Nevertheless, analyses of this double perspective in Darwin’s work are relatively rare. Most scholars focus on Darwin, the scientist, and more or less ignore the aesthetic aspects of his work. Perceiving the gradual transformation of Darwin’s world view, however, depends on analyzing the two different modes in which Darwin approached and perceived the world. While one can, on occasion, find commentaries on the beauty of the natural world in Darwin’s early work, the passage of time produces a modification in the naturalist’s manner of perceiving nature. This does not, however, mean that Darwin ceases to find beauty in nature; on the contrary, the disenchantment, in Max Weber’s words, that Darwin’s theory produces should not be understood in a pejorative, but rather in a literal sense. The theory of evolution, in effect, divests nature of its magical character and begins to explain it in terms of natural selection, according it, in the process a new and more intense attraction. In the present work, the metaphysical implications of this new vision of the world are analyzed through the eyes of its discoverer.

Infiltration of fine and coarse sand into an open-work gravel bed

The siltation of an experimental gravel bed, with three grades of sand moving in suspension and as bedload, was examined. The rate of infiltration of sand into the void space of the gravel was determined under differing conditions of discharge, water depth, and velocity (jointly expressed as variation in the Froude Number) and suspended sediment concentration. The downstream reduction in siltation from the point source was also examined.

Published work on freshwater science from the FBA, IFE and CEH, 1929-2006

A new listing of published scientific contributions from the Freshwater Biological Association (FBA) and its later Research Council associates – the Institute of Freshwater Ecology (1989–2000) and the Centre for Ecology and Hydrology (2000+) is provided. The period 1929–2006 is covered. The compilation extends an earlier list assembled by in 1979.

We can work it out: an enactive look at cooperation

The past years have seen an increasing debate on cooperation and its unique human character. Philosophers and psychologists have proposed that cooperative activities are characterized by shared goals to which participants are committed through the ability to understand each other’s intentions. Despite its popularity, some serious issues arise with this approach to cooperation. First, one may challenge the assumption that high-level mental processes are necessary for engaging in acting cooperatively. If they are, then how do agents that do not possess such ability (preverbal children, or children with autism who are often claimed to be mind-blind) engage in cooperative exchanges, as the evidence suggests? Secondly, to define cooperation as the result of two de-contextualized minds reading each other’s intentions may fail to fully acknowledge the complexity of situated, interactional dynamics and the interplay of variables such as the participants’ relational and personal history and experience. In this paper we challenge such accounts of cooperation, calling for an embodied approach that sees cooperation not only as an individual attitude toward the other, but also as a property of interaction processes. Taking an enactive perspective, we argue that cooperation is an intrinsic part of any interaction, and that there can be cooperative interaction before complex communicative abilities are achieved. The issue then is not whether one is able or not to read the other’s intentions, but what it takes to participate in joint action. From this basic account, it should be possible to build up more complex forms of cooperation as needed. Addressing the study of cooperation in these terms may enhance our understanding of human social development, and foster our knowledge of different ways of engaging with others, as in the case of autism.

La ética en las entidades financieras

Como ha sucedido con las crisis anteriores, el curso del tiempo ha ido clarificando las causas de la reciente crisis financiera. Entre éstas, sin duda, merece una especial atención las de naturaleza ética. El término “ética” deriva del griego “ethos” (ήθος) que significa “costumbre” y, por ello, se ha definido con frecuencia a la ética como la doctrina de las costumbres que van encaminadas a la consecución de un fin justo (Aristóteles). En este sentido, en el presente trabajo pasamos revista a una serie de prácticas de organizaciones financieras y sus directivos y administradores, que son cuestionadas desde un punto de vista ético. Así mismo, es preciso señalar la dificultad a la hora de desarrollar este trabajo ya que resulta imposible comprobar todas las actuaciones cuestionadas de primera mano. Por ello, para desarrollar el trabajo hemos tomado como referencia importante las directivas que manifiesta MiFID y la hemos aplicado a cuatro hechos muy concretos en los que el uso de la ética y la buena práctica queda en entredicho. Mantenemos como ideas integradoras que si la crisis tiene entre sus causas comportamientos inmorales, éstos deben ser controlados y erradicados, y que, además, la perspectiva ética exige ser el elemento vertebrador, tanto en la solución de los problemas actuales, como en la toma de decisiones financieras a futuro.

Summary document of the work being done in 1992-1993 regarding the migratory salmonid fisheries of the River Ribble catchment

This document lists the work on salmonid fisheries in the River Ribble catchment in the north west of England which was done in 1992-93. The document includes the following: analysis of historical catch data from the River Ribble covering 1937-1991; Ribble and Hodder stock assessment surveys 1992-93 including Swanside Beck; Ribble catch data from game angling log books 1993; results of salmon scale sampling 1993; results of microtagging programme in Hodder and Ribble 1993; Waddow Weir dish counter data 1993; Winkley Hall (Hodder), Locks Weir and Waddow Hall (Ribble) fish counter data 1993; number of fish and ova from Witcherwell Hatchery 1993.

Exibição de Propaganda Personalizada com o uso de Realidade Aumentada

É apresentado como problema atual na área de Publicidade e Propaganda a exibição de conteúdo personalizado para nichos específicos. A propaganda acaba se concentrando nos produtos de maior sucesso, tendo como foco alguns públicos-alvo previamente determinados. Assim, o estudo pretende avaliar um novo canal para exibição de propaganda em nível individual, através das perspectivas da Cauda Longa e da Realidade Aumentada (R.A.). O ponto principal desse trabalho é, portanto, mostrar a quantidade de nichos existentes e sugerir uma personalização da propaganda a um nível praticamente individual, como uma ligação direta entre produto e consumidor, usando como suporte tecnológico a R.A. A partir da análise de trabalhos de Romero Tori, Paul Milgram, Ronald Azuma, Cláudio Kirner, Robson Siscouto, Lúcia Santaella, entre outros autores, foi feita uma avaliação dos principais pontos de interesse da tecnologia de Realidade Aumentada para profissionais da área do Design. Discorrendo não só sobre suas características como também identificando problemas e questionamentos atuais, tanto para esses profissionais como para o consumidor final. A tese se enquadra na linha de pesquisa de Design e Tecnologia ao passo que os profissionais desta área de conhecimento são responsáveis diretos por pensar as formas de interação de modo que sejam mais orgânicas e intuitivas para os usuários. Existe muito trabalho a ser realizado, no tocante à Ergonomia e Usabilidade, nas soluções que usam a Realidade Aumentada, principalmente na forma como se dá a sobreposição da informação digital ao ambiente real capturado pela câmera e sua manipulação pelo indivíduo.