996 resultados para Traditional industries
Resumo:
'Lona ilish', is a traditional salt fermented fish product, widely consumed and very popular in north-east part of India and Bangladesh. It is prepared exclusively from a high fat fish, Hilsa (Tenualosa) ilisha. 'Lona ilish' was prepared in the laboratory following traditional process. After 150 days of fermentation, a better quality 'lona ilish' was obtained. Biochemical characteristics of market sample was estimated and compared with the laboratory prepared one. A variation in biochemical composition was observed. Sensory quality of the final product of laboratory prepared 'lona ilish' was compared with the market sample and found that the laboratory prepared product scored better than the market sample. The moisture (49.89%) and salt (15.48%) of the final product was found to be satisfactory for stability of the 'lona ilish' at ambient temperature. Analysis of volatile compounds of 'lona ilish' was done using GC-MS. It was concluded that, aldehydes, ketones and esters may possibly contribute characteristic aromas to the overall flavour of the salt fermented hilsa.
Resumo:
The sustainable translation of scientific and technical innovation into global products and services is key to capturing value from emerging industries. For industrial practitioners, choosing the appropriate entry mode into these industries will often determine their level of success in sharing in this value capture. © 2011 IEEE.
Resumo:
To address future uncertainty within strategy and innovation, managers extrapolate past patterns and trends into the future. Several disciplines make use of lifecycles, often with a linear sequence of identified phases, to make predictions and address likely uncertainties. Often the aggregation of several cycles is then interpreted as a new cycle - such as product lifecycles into an industry lifecycle. However, frequently different lifecycle terms - technology, product, industry - are used interchangeably and without clear definition. Within the interdisciplinary context of technology management, this juxtaposition of dynamics can create confusion, rather than clarification. This paper explores some typical dynamics associated with technology-based industries, using illustrative examples from the automotive industry. A wide range of dimensions are seen to influence the path of a technology-based industry, and stakeholders need to consider the likely causality and synchronicity of these. Some curves can simply present the aggregation of components; other dynamics incur time lags, rather than being superimposed, but still have a significant impact. To optimise alignment of the important dimensions within any development, and for future strategy decisions, understanding these interactions will be critical. © 2011 IEEE.
Resumo:
Traditional bamboo basket and expanded polystyrene insulated plywood box (second hand tea-chest) were compared for transportation of iced marine, fresh water and brackish water fishes from Kakinada to Madras by rail. Quality of fish at dispatching and receiving centres was assessed by organoleptic, total volatile nitrogen (TVN) and total bacterial count (TBC) tests. Based on the results obtained and the prices fetched, the traditional bamboo basket apart from being cheaper was found to be as good as expanded polystyrene insulated plywood box for short distance transportation of iced fish involving less than 24 hours journey.
Resumo:
Training needs of 80 fishermen in 25 subject areas revealed a mean training need score of 23.0l; 95% wanted to get trained. The training needs were fairly strong in all subject areas, with the highest demand being for fishery engineering. Training need was also high for areas related to fishery technology. Most of the fishermen preferred to have the training at their own village, and in the months of June or July for an average period of 20.85 days. Education and income were positively related to intensity of training needs whereas age, number of family members, number of employed family members and experience in fishing were negatively correlated with it. These six variables explained 27 of the variance in training need intensity.
Resumo:
This paper presents a simple design and the testing of a blackbody prototype. The physical properties and geometry of the cavity produce a radiator or blackbody with an emissivity greater than 0.99. The prototype has the advantages of having a traditional spherical cavity made of alumina refractory cement and a radiative emission very close to that of an ideal blackbody. The prototype can be used as a calibration standard for other radiation measuring instruments or sensors. Experimental measurements of radiant flux of the prototype measured with a calibrated infrared radiometer and a wide spectrum radiometer are also presented. The prototype is easy to construct and the material required are available to most research centers, laboratories, industries, and universities. © 2010 American Institute of Physics.
Resumo:
The response of Chanos chanos fry to moving and stationary nets of different mesh size and colour, underwater visibility of the nets and water filtration were studied. Results indicate that milkfish fry may be driven by nets of mesh size larger than that presently used; larger mesh size decreases the net resistance in the water so that collectors may move the equipment easily. The large mesh nets should be of a dark colour, preferably black for effective driving; bowever white mosquito net is best for the core end, since the fry are more easily visible on a white background.
Resumo:
Studies were conducted to assessment the quality of traditional and solar tunnel dried SIS products. The moisture content of the solar products ranged from 14.38 to 18.48% with the lowest in batashi and the highest value in tengra. The moisture content of the traditional products was in the range of 23.26 to 26.42%. The range of protein contents on moisture free basis was from 67.57 to 71.90% in solar dried fishes with highest value obtained in dhela and lowest value in batashi. These values were more or less similar to those of traditional dried SIS products which were in the range of 68.02 to 73.54% on dry weight basis. Lipid contents of solar dried SIS varied from 14.10 to 16.26% and on moisture free basis the in the range of 11.73 to 21.98 with highest value found in tengra and lowest in puti. These values were more or less similar to those found for traditional dried products on dry weight basis and ranged from were 12.37 to 22.43%. Maximum reconstitution of solar dried products was obtained at 80°C in all samples and was in the range of 65.26 to 70.51% where the percentage of reconstitution increases with the increase of socking time and reach maximum at the end of up to 60 min. The TVB-N content of solar dried fish is low compared with traditional one ranging from 20.30 to 28.40mg/100g and peroxide value in the range of 12. 54 to 19.20meq./kg oil. The TVB-N of traditionally dried products were in the range of 32.50 to 45.45mg/100g and PO values of the traditionally dried products were in the range of 30.00 to 36.00meq./kg oil. The bacterial load of the solar dried products was in the range of 4.0x10 super(3)/g to 3.6x10 super(5)CFU/g and of the traditionally dried products ranged from 1.45x10 super(5) to 2.52x10 super(6) CFU/g.
Resumo:
Studies on the quality assessments of three traditional, rotary and solar tunnel dried SIS products were conducted. Organoleptic quality of traditional dried SIS products available in the markets was poor compared to those produced in rotary and solar tunnel dryer. Reconstitution of samples were in the range of 54.26% to 75.24%, 69.37% to 83.73% and 55.08% to 80.24% when soaked at 80°C for traditional, rotary and solar tunnel dried products, respectively. The percentage of reconstitution increased with the increase of soaking time and the uptake of water was maximum after 60 min of soaking. The moisture contents of traditional, rotary and solar tunnel dried products were in the range of 26.02% to 27.33%, 16.23% to 22.84% and 13.71% to 19.30%, respectively. The protein contents were in the range of 60.78% to 72.59%, 62.17% to 76.27% and 61.11% to 76.00%, respectively; lipid contents were in the range of 12.26% to 22.60%, 14.00% to 24.71% and 13.92% to 22.39%, respectively and ash contents in the range of 15.11% to 16.59%, 8.32% to 13.51% and 8.71% to 16.45%, respectively on dry matter basis. The TVB-N content of rotary and solar tunnel dried products was low compared to traditional one ranging from 10.64 to 17.52 mg/100g and 14.34 to 15.68 mg/100g, respectively whereas the TVB-N content of traditional samples was in the range of 15.46 to 20.36 mg/100g. The bacterial load of traditional, rotary and solar tunnel dried products were in the range of 1.43x10 super(8) CFU/g to 2.89 x10 super(80 CFU/g, 1.91x10 super(8) CFU/g to 2.84x10 super(8) CFU/g and 1.95x10 super(8) CFU/g to 2.59x10 super(8) CFU/g, respectively. The results of the study indicated that dried fish products from rotary dryer and solar tunnel dryer were found to be of better quality in nutritional and food quality aspects than those of traditional dried products.
Resumo:
Shrimp culture in Bangladesh has emerged as an important aquaculture industry over the last three decades although its culture in greater parts of the farming area is done in traditional ways. In the meantime, the government of Bangladesh has taken necessary measures along with the private sectors to increase production, upgrade processing industries and to promote export performance. Long supply chain in raw material collection, inadequate infrastructure facilities, poor level of cool chain and lack of adequate HACCP-based training on hygiene and sanitation of different groups of people involved in the field level are the main problems of quality loss of raw materials. Shortage of raw materials results in poor capacity utilization of the processing plants. The growth of bagda (P. monodon) hatchery has expanded rapidly over the last few years, remaining mostly concentrated in Cox's Bazar region is enough to meet the target production. However, there is a shortage of pelleted shrimp feed in Bangladesh. A large number of export processors are now producing increasing amounts of value-added products such as individually quick-frozen, peeled and divined, butterfly cut shrimp, as well as cooked products. The export earnings from value added products is about half of the total export value. About 95% of total fish products are exported to European countries, USA and Japan and the remaining to the Southeast Asia and the Middle East. Most of the EU approved shrimp processing industries have been upgraded with laboratory facilities and provided HACCP training to their workers. As of now, HACCP is applied on the processing plants, but to ensure the quality of raw materials and to reduce risks, shrimp farms are also required to adopt HACCP plan. There is increased pressure time to time from importing countries for fish processors to establish effective quality assurance system in processing plants. Fish Inspection and Quality Control (FIQC) of the Department of Fisheries while having moderately equipped laboratories with chemical, bio-chemical and microbiological testing facilities and qualified technical personnel, the creation of facilities for testing of antibiotics is underway. FIQC mainly supervises quality aspects of the processing plants and has little or no control over raw material supply chains from farm to processing plants. Bangladesh export consignments sometimes face rejection due to reported poor quality of the products. Three types of barriers are reported for export of shrimp to EU countries. These are:(1) government participation in trade and restrictive practices (state aid, countervailing duties, state trading enterprises, government monopoly practices), customs and administrative entry procedures (anti-dumping duties, customs valuation, classification, formalities, rules of origin); (2) technical barriers to trade or TBT (technical regulations, standards, testing, certification arrangement); (3) specific limitations (quantitative restrictions, import licensing, embargoes, exchange control, discriminatory sourcing, export restraints, measures to regulate domestic prices, requirements concerning marking, labeling and packaging).