Predição da configuração de sombras de árvores em pastagens para bovinos

São propostas equações para a determinação da orientação, comprimento e área da sombra projetada por árvores destinadas ao plantio em pastagens para bovinos, considerando o local, a época do ano e a hora do dia. As equações abrangem árvores com os seguintes formatos de copa: esférica, lentiforme, cilíndrica, elipsóide, cônica e cônica invertida. Um exemplo é apresentado, discutindo-se a aplicação no sombreamento de pastagens.

Fitoplâncton em três lagoas marginais ao Rio Paranapanema e em sua desembocadura no Reservatório de Jurumirim (São Paulo, Brasil) durante um período prolongado de seca

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efeito do tamanho dos grânulos nas características estruturais e físico-químicas do amido de trigo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influência do oxalato de amônio na formação do precursor columbita obtido pelo método Pechini

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Analysis of Ca-PZT powder obtained by the Pechini and partial oxalate methods

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Synthesis, characterization and catalytic properties of nanocrystaline Y2O3-coated TiO2 in the ethanol dehydration reaction

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Synthesis and sintering of PZT ceramics

Lead zirconate powder, with Zr/Ti ratio of 50/50 was prepared by polymeric precursor method and doped with 3, 5 and 7 mol% of Sr+2 Or Ba+2, as well as by 0.2 to 5 mol% of Nb+5. The powder was calcined at 750 degrees C by 4 hours and milled during 1.5 h in isopropilic alcohol. Powders were characterized by surface area measurements (BET method), by infrared spectroscopy and by X-ray diffraction to characterize the crystal structure. Isostatically pressed samples were sintered in a dilatometer furnace by using a constant heating rate of 10 degrees C/min from ambient to 1200 degrees C. Synthetic air and air with water vapor were used as atmospheres. Both Sr+2 and Ba+2 substitute Pb+2 and favor the formation of rhombohedral phase. Otherwise, Nb+5 substitute preferentially Zr+4 favoring tetragonal phase. The concentration of dopants and the atmosphere influence the densification and the microstructure of the PZT, which alters the dielectric and piezoelectric properties of the ceramics.

Sol-gel synthesis of titania-alumina catalyst supports

Titanium oxide is a good candidate as new support for hydrotreating (HDT) catalysts, but has the inconvenience of presenting small surface area and poor thermal stability. To overcome these handicaps TiO2-Al2O3 mixed oxides were proposed as catalyst support. Here, the results concerning the preparation, characterization and testing of molybdenum catalyst supported on titania-alumina are presented. The support was prepared by sol-gel route using titanium and aluminum isopropoxides, chelated with acetylacetone (acac) to promote similar hydrolysis ratio for both the alcoxides. The effect of nominal complexing ratios [acac]/[Ti] and of sol aging temperature on the structural features of nanometric particles was analyzed by quasi-elastic light scattering (QELS) and N-2 adsorption isotherm measurements. These characterizations have shown that the addition of acac and the increase of aging temperature favor the full dispersion of primary nanoparticles in mother acid solution. The dried powder presents a monomodal distribution of slit-shaped micropores, formed by irregular packing of platelet primary particles, surface area superior to 200 m(2) g(-1) and mean pore size of about 1 nm. These characteristics of porous texture are preserved after firing at 673 K. The diffraction patterns of sample fired above 973 K show only the presence of anatase crystalline phase. The crystalline structure of the support remained unaltered after molybdenum adsorption, but the surface area and the micropore volume were drastically reduced. (C) 2002 Published by Elsevier B.V. B.V.

Colonization of a 'Lost World': Encrustation patterns in modern subtropical brachiopod assemblages.

The encrustation of Paleozoic rhynchonelliform brachiopods has been studied for decades, but modern brachiopods have not received similar scrutiny. The discovery of abundant subtropical brachiopods from the Southeast Brazilian Bight provides an unprecedented opportunity to assess epibiont abundance, diversity, and encrustation patterns in modern brachiopod assemblages. Across the outer shelf, encrustation frequencies vary among taxa, from mean values of 0.45% for Platidia to 9.3% for Argyrotheca. Encrustation frequencies for Bouchardia increase from 1.6% on the outer shelf to 84% on the inner shelf Larger valves are encrusted more frequently, and epibionts preferentially colonize valve interiors. Increased encrustation on the inner shelf may reflect the greater surface area of larger hosts, longer exposure of dead shells, water-mass characteristics, sedimentation rates, productivity, or other factors that vary with depth. Inner-shelf brachiopods exhibit encrustation frequencies comparable to those reported for epifaunal bivalves. The epibiont fauna is dominated by bryozoans and serpulids, with minor roles played by spirorbids, bivalves, barnacles, foraminifera, algae, and other taxa. Epibiont abundance at each site is highly variable, but sites are similar in rank importance of epibiont taxa. A different suite of epibionts colonized Paleozoic brachiopods, but similar patterns of encrustation have been observed, including preferential settlement according to valve morphology. These results provide a baseline for evaluating the encrustation of modern bivalves and ancient brachiopods, and may elucidate the macroevolutionary history of epibionts and their relationship to their hosts.

Mechanically activating formation of layered structured bismuth titanate

Bismuth titanatc-Bi(4)Ti(3)O(12) (BIT) with wide application in the electronic industry as capacitors, memory devices and sensors is the simplest compound in the Aurivillius family, which consists of (Bi(2)O(2))(2+) sheets alternating with (Bi(2)T(i)3O(10))(2-) perovskite-like layers. The synthesis of more resistive BIT ceramics would be preferable advance in obtaining of well-densified ceramic with small grains randomly oriented to limit the conductivity along the (Bi(2)O(2))(2+) layers. Having in mind that the conventional ceramic route for the synthesis can lead to non-stoichiometry in composition, in consequence of the undesirable loss in bismuth content through volatilization of Bi(2)O(3) at elevated temperature, our efforts were addressed to preparation of BIT by mechanical activation the constituent oxides. The nucleation and phase formation of BIT, crystal structure, microstructure, powder particle size and specific surface area were followed by XRD, Rietveld refinement analysis, thermal analysis, scanning electron microscopy (SEM) and the BET specific surface area measurements. (c) 2005 Elsevier B.V. All rights reserved.

Preparation and characterization of LiNi0.8Co0.2O2/PANI microcomposite electrode materials under assisted ultrasonic irradiation

A preparation method for a new electrode material based on the LiNi0.8Co0.2O2/polyaniline (PANI) composite is reported. This material is prepared by in situ polymerization of aniline in the presence of LiNi0.8Co0.2O2 assisted by ultrasonic irradiation. The materials are characterized by XRD, TG-DTA, FTIR, XPS, SEM-EDX, AFM, nitrogen adsorption (BET surface area) and electrical conductivity measurements. PANI in the emeraldine salt form interacts with metal-oxide particles to assure good connectivity. The dc electrical conductivity measurements at room temperature indicate that conductivity values are one order of magnitude higher in the composite than in the oxide alone. This behavior determines better reversibility for Li-insertion in charge-discharge cycles compared to the pristine mixed oxide when used as electrode of lithium batteries. (c) 2005 Elsevier B.V. All rights reserved.

High volume peritoneal dialysis for acute renal failure

Background. Peritoneal dialysis (PD) is still widely used for acute renal failure (ARF) in developing countries despite concerns about its inadequacy. Continuous PD has been evaluated in ARF by analyzing the resolution of metabolic abnormality and normalization of plasma pH, bicarbonate, and potassium.Methodology: A prospective study was performed on 30 ARF patients who were assigned to high-dose continuous PD (Kt/V = 0.65 per session) via a flexible catheter (Tenckhoff) and automated PD with a cycler. Fluid removal, pH and metabolic control, protein Loss, and patient outcome were evaluated.Results: Patients received 236 continuous PD sessions; 76% were admitted to ICUs. APACHE II score was 32.2 +/- 8.65. BUN concentrations stabilized after 3 sessions, creatinine after 4, and bicarbonate and pH after 2. Fluid removal was 2.1 +/- 0.62 L/day. Creatinine and urea clearances were 15.8 +/- 4.16 and 17.3 +/- 5.01 mL/minute respectively. Normalized creatinine clearance and urea Kt/V values were 110.6 +/- 22.5 L/week/1.73 m(2) body surface area and 3.8 +/- 0.6 respectively. Solute reduction index was 41% +/- 6.5% per session. Serum albumin values remained stable in spite of considerable protein tosses (median 21.7 g/day, interquartile range 9.1 - 29.8 g/day). Regarding ARF outcome, 23% of patients presented renal function recovery, 13% remained on dialysis after 30 days of follow-up, and 57% died.Conclusion: High-dose continuous PD by flexible catheter and cycler was an effective treatment for ARF. It provided high solute removal, allowing appropriate metabolic and pH control, and adequate dialysis dose and fluid removal. Continuous PD can therefore be considered an alternative to other forms of renal replacement therapy in ARF.

Influence of milling time on mechanically assisted synthesis of Pb0.91Ca0.1TiO3 powders

Pb0.91Ca0.1TiO3 powders (PCT) were prepared by mechanochemical synthesis from high-energy ball milling process. The influence of milling time on the phase formation, crystal structure, specific surface area, density and powder morphology was observed. We adopted the Rietveld refinement technique to investigate the crystal structure of the PCT powders. Scanning electron microscopy (SEM) analysis revealed that PCT powders milled for 5 h showed a wide distribution of particle agglomerates while milled for 35 h showed a decrease in agglomerates size. Further prolongation of milling time resulted in the agglomerates growth. (C) 2006 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

Comparative study of digestive cells in different midgut regions of stingless bees (Hymenoptera: Apidae: Meliponinae)

Ultrastructure of the digestive cells was analyzed in three midgut regions (anterior, middle and posterior) of stingless bees. Variations occurs in the presence of lipid inclusions in the cells from posterior midgut and presence of double-membraned vesicles associated to microvilli in the anterior midgut. However, basal plasmic membrane infoldings and augmentation of surface area achieved by microvilli ale very similar in all midgut regions. These results not supported the existence of fluid fluxes in the ectoperitrophic space and suggest that digestive cells in stingless bees are polifunctional, that is, there is not midgut region specialized in secretion ol absorption as observed in other insects.

Evaporative water loss and oxygen uptake in two casque-headed tree frogs, Aparasphenodon brunoi and Corythomantis greeningi (Anura, Hylidae)

Evaporative water loss (EWL) and oxygen uptake ((V) over dot o(2)) was measured in two species of tree frogs with cranial co-ossification, Aparasphenodon brunoi and Corythomantis greeningi. Both species use their head to seal the entrance of bromeliads, tree holes or rocky crevices used as shelters. EWL was significantly reduced in sheltered individuals of both species as compared with those exposed nude to desiccation. EWL per unit area through the head surface was significantly lower than the body skin for A. brunoi but not for C., greeningi. EWL per unit surface area through C. greeningi body skin was about 50% that of A. brunoi, indicating a less permeable skin in the former species. The relationship between cranial coossification and EWL is discussed. ((V) over dot o(2)) in A. brunoi was comparable with other anurans of similar size, whereas in C. greeningi, it was lower than predicted from body mass. Moreover, ((V) over dot o(2)), in C. greeningi showed less sensitivity to temperature increase than in A. brunoi. C. greeningi occurs in a drier environment than A. brunoi, and this appears to be reflected in their EWL and ((V) over dot o(2)) characteristics. (C) 1997 Elsevier B.V.