Instabilities and drop formation in cylindrical liquid jets in reduced gravity

The effects of convective and absolute instabilities on the formation of drops formed from cylindrical liquid jets of glycerol/water issuing into still air were investigated. Medium-duration reduced gravity tests were conducted aboard NASA's KC-135 and compared to similar tests performed under normal gravity conditions to aid in understanding the drop formation process. In reduced gravity, the Rayleigh-Chandrasekhar Equation was found to accurately predict the transition between a region of absolute and convective instability as defined by a critical Weber number. Observations of the physics of the jet, its breakup, and subsequent drop dynamics under both gravity conditions and the effects of the two instabilities on these processes are presented. All the normal gravity liquid jets investigated, in regions of convective or absolute instability, were subject to significant stretching effects, which affected the subsequent drop and associated geometry and dynamics. These effects were not displayed in reduced gravity and, therefore, the liquid jets would form drops which took longer to form (reduction in drop frequency), larger in size, and more spherical (surface tension effects). Most observed changes, in regions of either absolute or convective instabilities, were due to a reduction in the buoyancy force and an increased importance of the surface tension force acting on the liquid contained in the jet or formed drop. Reduced gravity environments allow better investigations to be performed into the physics of liquid jets, subsequently formed drops, and the effects of instabilities on these systems. In reduced gravity, drops form up to three times more slowly and as a consequence are up to three times larger in volume in the theoretical absolute instability region than in the theoretical convective instability region. This difference was not seen in the corresponding normal gravity tests due to the masking effects of gravity. A drop is shown to be able to form and detach in a region of absolute instability, and spanning the critical Weber number (from a region of convective to absolute instability) resulted in a marked change in dynamics and geometry of the liquid jet and detaching drops. (C) 2002 American Institute of Physics.

Effect of a control burn on lizards and their structural environment in a eucalypt open-forest

The composition of an open-forest lizard assemblage in eastern Australia was examined before and after a low-intensity controlled fire and concurrently compared with that in an adjoining unburnt area. The effect of fire on the available structural environment and the habitat used by two focal species, Carlia vivax and Lygisaurus foliorum, was also examined. Lizard species richness was unaffected by the controlled burn as was the abundance of most species. C. vivax was the only species to display a significant reduction in abundance after fire. While the low-intensity fire resulted in significant changes to the available structural environment, there were no compensatory shifts in the habitat preferences of either C. vivax or L. foliorum. The reduction in abundance of C. vivax was congruent with this species' avoidance of burnt areas. C. vivax displayed a non-random preference for ground cover and litter cover, which were reduced in burnt areas. Changes in the availability of preferred structural habitat features are likely to contribute to changes in the abundance of some lizard species. Therefore, even low-intensity disturbances can have an impact on lizard assemblages if critical habitat features are lost or become limiting.

Beneficial effects of air inclusions on the performance of ethylene vinyl acetate (EVA) mouthguard material

Objective: To investigate the impact characteristics of an ethylene vinyl acetate (EVA) mouthguard material with regulated air inclusions, which included various air cell volumes and wall thickness between air cells. In particular, the aim was to identify the magnitude and direction of forces within the impacts. Method: EVA mouthguard material, A mm thick and with and without air inclusions, was impacted with a constant force impact pendulum with an energy of 4.4 J and a velocity of 3 m/s. Transmitted forces through the EVA material were measured using an accelerometer, which also allowed the determination of force direction and magnitude within the impacts. Results: Statistically significant reductions in the transmitted forces were observed with all the air inclusion materials when compared with EVA without air inclusions. Maximum transmitted force through one air inclusion material was reduced by 32%. Force rebound was eliminated in one material, and reduced second force impulses were observed in all the air inclusion materials. Conclusion: The regulated air inclusions improved the impact characteristics of the EVA mouthguard material, the material most commonly used in mouthguards world wide.

The impact of participation in activities while on vacation on senior's psychological well-being: A path model application

This article extends earlier research regarding the relationships between senior travelers’ participation in activities while on vacation, their overall satisfaction with their travel experiences, and their psychological well-being. A path model was developed to depict the direct and indirect relationships between these variables by using a sample of senior tourists traveling on North American escorted tour itineraries. Whereas the direct effect accounted for 98% of the relationships between the senior tourists’ levels of participation in activities and their psychological well-being, the indirect effect was negligible. The study concluded that senior tourists’activity levels were significantly related to their psychological well-being, but their satisfaction with the tours was not.

Impact numbers: measures of risk factor impact on the whole population from case-control and cohort studies

Objective: To describe new measures of risk from case-control and cohort studies, which are simple to understand and relate to numbers of the population at risk. Design: Theoretical development of new measures of risk. Setting: Review of literature and previously described measures. Main results: The new measures are: (1) the population impact number (PIN), the number of those in the whole population among whom one case is attributable to the exposure or risk factor (this is equivalent to the reciprocal of the population attributable risk),- (2) the case impact number (CIN) the number of people with the disease or outcome for whom one case will be attributable to the exposure or risk factor (this is equivalent to the reciprocal of the population attributable fraction); (3) the exposure impact number (EIN) the number of people with the exposure among whom one excess case is attributable to the exposure (this is equivalent to the reciprocal of the attributable risk); (4) the exposed cases impact number (ECIN) the number of exposed cases among whom one case is attributable to the exposure (this is equivalent to the reciprocal of the aetiological fraction). The impact number reflects the number of people in each population (the whole population, the cases, all those exposed, and the exposed cases) among whom one case is attributable to the particular risk factor. Conclusions: These new measures should help communicate the impact on a population, of estimates of risk derived from cohort or case-control studies.

Impact numbers in health policy decisions

Objective: To outline the major methodological issues appropriate to the use of the population impact number (PIN) and the disease impact number (DIN) in health policy decision making. Design: Review of literature and calculation of PIN and DIN statistics in different settings. Setting: Previously proposed extensions to the number needed to treat (NNT): the DIN and the PIN, which give a population perspective to this measure. Main results: The PIN and DIN allow us to compare the population impact of different interventions either within the same disease or in different diseases or conditions. The primary studies used for relative risk estimates should have outcomes, time periods and comparison groups that are congruent and relevant to the local setting. These need to be combined with local data on disease rates and population size. Depending on the particular problem, the target may be disease incidence or prevalence and the effects of interest may be either the incremental impact or the total impact of each intervention. For practical application, it will be important to use sensitivity analyses to determine plausible intervals for the impact numbers. Conclusions: Attention to various methodological issues will permit the DIN and PIN to be used to assist health policy makers assign a population perspective to measures of risk.

Impact of land-use on soil organic matter quality in south-western Australia - characterization with C-13 CP/MAS NMR spectroscopy

The influence of change in land-use from native vegetation to pasture (20-71 yr after conversion), and subsequent change from pasture to eucalypt plantation (7-10 yr after conversion) on soil organic matter quality was investigated using C-13 CP/MAS NMR spectroscopy. We studied surface soil (0-10 cm) from six sites representing a range of soil, and climate types from south-western Australia. Total C in the samples ranged from 1.6 to 5.5%, but the relative proportions of the four primary spectral regions (alkyl, O-alkyl, aromatic and carboxylic) were similar across the sites, and changes due to land-use at each site were relatively minor. Main impacts of changed land-use were higher O-alkyl (carbohydrate) material under pasture than under native vegetation and plantation (P = 0.048), and lower aromatic C under pasture than under native vegetation (P = 0.027). The decrease in aromatic C in pasture soils was related to time since clearing. (C) 2002 Elsevier Science Ltd. All rights reserved.

Structural ordering of coal char during heat treatment and its impact on reactivity

The effect of heat treatment on the structure of an Australian semi-anthracite char was studied in detail in the 850-1150degreesC temperature range using XRD, HRTEM, and electrical resistivity techniques. It was found that the carbon crystallite size in the char does not change significantly during heat treatment in the temperature range studied, for both the raw coal and its ash-free derivative obtained by acid treatment. However, the fraction of the organized carbon in the raw coal chars, determined by XRD, increased with increase of heat treatment time and temperature, while that for the ash-free coal chars remained almost unchanged. This suggests the occurrence of catalytic ordering during heat treatment, supported by the observation that the electrical resistivity of the raw coal chars decreased with heat treatment, while that of the ash-free coal chars did not vary significantly. Further confirmatory evidence was provided by high resolution transmission electron micrographs depicting well-organized carbon layers surrounding iron particles. It is also found that the fraction of organized carbon does not reach unity, but attains an apparent equilibrium value that increases with increase in temperature, providing an apparent heat of ordering of 71.7 kJ mol(-1) in the temperature range studied. Good temperature-independent correlation was found between the electrical resistivity and the organized carbon fraction, indicating that electrical resistivity is indeed structure sensitive. Good correlation was also found between the electrical resistivity and the reactivity of coal char. All these results strongly suggest that the thermal deactivation is the result of a crystallite-perfecting process, which is effectively catalyzed by the inorganic matter in the coal char. Based on kinetic interpretation of the data it is concluded that the process is diffusion controlled, most likely involving transport of iron in the inter-crystallite nanospaces in the temperature range studied. The activation energy of this transport process is found to be very low, at about 11.8 kJ mol(-1), which is corroborated by model-free correlation of the temporal variation of organized carbon fraction as well as electrical resistivity data using the superposition method, and is suggestive of surface transport of iron. (C) 2002 Elsevier Science Ltd. All rights reserved.

A field study conducted at Kidston Gold Mine, to evaluate the impact of arsenic and zinc from mine tailing to grazing cattle

The grazing trial at Kidston Gold Mine, North Queensland, was aimed specifically to assess the uptake of metals from the tailing and the potential for unacceptable contamination of saleable meat. Further aims included estimating metal dose rates and identifying potential exposure pathways including plant uptake of heavy metals, mine tailings adhered to plants and direct ingestion of mine tailing. It was found that of the 11 metals analysed (As, Zn, Co, Cd, Cr, Sn, Pb, Sb, Hg, Se and Ni) in the animal's liver, muscle and blood during the 8-month trial period, only accumulation of arsenic and zinc occurred. A risk assessment including these two metals was conducted to determine the potential for chronic metal toxicity and long-term contamination, using the estimates of metal dose rate. It was concluded that no toxicity or long-term contamination in cattle was likely at this site. Management procedures were therefore not required at this site; however, the results highlight percent ground cover and standing dry matter (DM) as important factors in decreasing metal exposure from direct ingestion of tailings and dust adhered to plants. (C) 2002 Elsevier Science Ireland Ltd. All rights reserved.

Manipulation of colonic bacteria and volatile fatty acid production by dietary high amylose maize (amylomaize) starch granules

Aims : To study the effects of amylomaize starch and modified (carboxymethylated and acetylated) amylomaize starches on the composition of colonic bacteria and the production of volatile fatty acids, in mice. Methods and Results : Balb/c mice were fed with experimental diets containing various amount of amylomaize and modified amylomaize starches. Colonic bacterial populations and short-chain fatty acids were monitored. Results showed that the increases in indigenous bifidobacteria were detected in mice fed all starches tested; however, the highest numbers were observed in the group fed with 40% unmodified amylomaize starch. The starch type influenced the populations of indigenous Lactobacillus , Bacteroides and coliforms. High Lactobacillus numbers were achieved in the colon of mice fed with high concentration of amylomaize starch. Acetylated amylomaize starch significantly reduced the population of coliforms. In addition, orally dosed amylomaize utilizing bifidobacteria reached their highest levels when fed together with amylomaize or carboxymethylated amylomaize starch and in both cases butyrate levels were markedly increased. Conclusions: These results indicate that different amylomaize starches could generate desirable variation in gut microflora and that particular starches may be used to selectively modify gut function. Significance and Impact of Study: Amylomaize starch appeared to enhance the desirable composition of colonic bacteria in mice, and suggested it possessed the potential prebiotic properties.MTherefore, resistant starch and its chemical derivatives may exert beneficial impacts to the human colon.

Impact of osteoarthritis on individuals and society: how much disability? Social consequences and health economic implications

Osteoarthritis is a major cause of disability in both the developed and developing world. With the population aging, the prevalence of osteoarthritis is increasing and its consequences are impacting significantly on society. This is one of the reasons why osteoarthritis has been adopted as a major focus (along with osteoporosis, rheumatoid arthritis, back pain, and musculoskeletal trauma) by the global initiative-the Decade of Bone and Joint Disease. Adequate studies on the costs of osteoarthritis are urgently required so that cogent arguments can be made to governments to appropriately fund prevention and treatment programs for this condition. Its recognition as a major cause of disability, particularly in the aging population, should increase community focus on this important condition. (C) 2002 Lippincott Williams Wilkins, Inc.