Effect of clinical use of nickel-titanium springs

Introduction: Our objectives were to determine whether there are changes on the load deflection rate (L/DP) and the average force (FP) of the superelastic pseudoplateau, and whether permanent deformation is changed in nickel-titanium closed-coil springs (CCSs) after 6 months of clinical use. Methods: Twenty-two nickel-titanium CCSs (Sentalloy 100 g; Dentsply GAC, York, Pa) were subjected to tensile mechanical testing at 37 degrees C on activations varying from 3.2 to 16.0 mm before and after 6 months of clinical use. A regression line was fitted over the most horizontal area of the unloading part of the stress-strain graph of every CCS, and its slope was used as L/DP. The FP was determined by the midpoint of the longest segment of the curve that could be fit within the regression line with a R-2 of at least 0.999, and permanent deformation was determined graphically by obtaining the strain value when the measured stress reached zero. The data were analyzed by 3 analyses of variance at 2 levels, with 5% of significance. Results: Time and activation significantly influenced the variables tested (P < 0.001). Time increased the L/DP and permanent deformation but decreased the FP. Activation decreased L/DP, FP, and permanent deformation. Significant interactions between time and activation were detected for FP (P = 0.013) and deformation (P < 0.001). Conclusions: After 6 months of active clinical use, the analyzed springs had a significant but small increase in their L/DP; FP dropped up to 88%, and the CCSs deformed up to 1.26 mm.

Dimensional changes in soft tissues around dental implants following free gingival grafting: an experimental study in dogs

ObjectiveTo study the buccal dimensional tissue changes at oral implants following free gingival grafting, with or without including the keratin layer, performed at the time of implant installation into alveolar mucosa.Material and methodsThe mandibular premolars and first molars were extracted bilaterally in six Beagle dogs. In the right side of the mandible (Test), flaps were first elevated, and the buccal as well as part of the lingual masticatory mucosa was removed. An incision of the periosteum at the buccal aspect was performed to allow the flap to be coronally repositioned. Primary wound closure was obtained. In the left side, the masticatory (keratinized) mucosa was left in situ, and no sutures were applied (Control). After 3months of healing, absence of keratinized mucosa was confirmed at the test sites. Two recipient sites were prepared at each side of the mandible in the region of the third and fourth premolars. All implants were installed with the shoulder placed flush with the buccal alveolar bony crest, and abutments were connected to allow a non-submerged healing. Two free gingival mucosal grafts were harvested from the buccal region of the maxillary canines. One graft was left intact (gingival mucosal graft), while for the second, the epithelial layer was removed (gingival connective tissue graft). Subsequently, the grafts were fixed around the test implants in position of the third and fourth premolars, respectively. After 3months, the animals were euthanized and ground sections obtained.ResultsSimilar bony crest resorption and coronal extension of osseointegration were found at test and control sites. Moreover, similar dimensions of the peri-implant soft tissues were obtained at test and control sites.ConclusionsThe increase in the alveolar mucosal thickness by means of a gingival graft affected the peri-implant marginal bone resorption and soft tissue recession around implants. This resulted in outcomes that were similar to those at implants surrounded by masticatory mucosa, indicating that gingival grafting in the absence of keratinized mucosa around implants may reduce the resorption of the marginal crest and soft tissue recession.

The fitness of copings constructed over UCLA abutments and the implant, constructed by different techniques: casting and casting with laser welding

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Cyclosporin A-induced new cementum formation: a morphometric evaluation in the periapical region of rats

Cyclosporin A (CsA) is a potent immunosuppressor used in organ transplantation and in the management of various autoimmune diseases. Recent studies have shown that CsA stimulates deposition of cementum on root surfaces. The aim of this study was to evaluate the periapical cementum thickness and the apical foramen width in CsA-treated rats. Rats weighing 50 g were treated with a daily injection of 10 mg/kg body weight of CsA in the chow for 60 days. The cementum of the mandibular 1st molars was histologically and morphometricaly examined by analysis of 5-microm-thick serial buccolingual paraffin sections stained with hematoxylin and eosin. Histometric and stereologic analyses revealed the presence of large amounts of cementum in all root surfaces, particularly abundant in the periapical region and obliterating the foramen. The volume density of cementoblasts did not increase. Five to 90 days after the termination of CsA therapy, there was no reduction of cementum thickness. These results suggest that cementum deposition is not reversible after cessation of CsA treatment.

Evaluation of the cervical vertebrae maturation index in lateral cephalograms taken in different head positions

The aim of this study was to evaluate if upward or downward head inclination might interfere with determination of the growth stage, using cervical vertebrae maturation index (CVMI), in order to verify the accuracy of such diagnosis when radiographs are taken with errors. Forty-nine patients, 26 females and 23 males, aged 9 to 15 years, were submitted to 3 lateral cephalograms: normal (NHP), with 15° upward head inclination (NHP-Up), and with 15° downward head inclination (NHP-Down). Three examiners evaluated the CVMI on the 147 cephalograms. The agreement among examiners was higher in the evaluation of cephalograms taken in NHP. The weighted Kappa test revealed moderate to substantial agreement between NHP and NHP-Up and between NHP and NHP-Down. There was greater agreement between NHP-Up and NHP-Down. It may be concluded that the evaluation of the CVMI on cephalograms in NHP is different as compared with radiographs taken with inclinations. Both NHP-Up and NHP-Down exhibited greater disagreement in the interpretation among examiners, since the evaluation method was not designed for cephalograms with positioning errors.

Prosthetic rehabilitation of a patient with gastroesophageal reflux disease: 4-year followup

The gastroesophageal reflux disease (GERD) is one of the main causes of dental erosion. The aim of this case presented is to describe the prosthetic rehabilitation of a patient with GERD after 4 years of followup. A 33-year-old male patient complained about tooth sensitivity. The lingual surface of the maxillary anterior teeth and the cusps of the upper and lower posterior teeth presented wear. It was suspected that the feeling of heartburn reported by the patient associated with the intake of sports supplements (isotonics) was causing gastroesophageal changes. The patient was referred to a gastroenterologist and was diagnosed with GERD. Dental treatment was performed with metal-free crowns and porcelain veneers after medical treatment of the disease. With the change in eating habits, the treatment of GERD and lithium disilicate ceramics provided excellent cosmetic results after 4 years and the patient reported satisfaction with the treatment.

Comparison of linear measurements and analyses taken from plaster models and three-dimensional images

Digital models are an alternative for carrying out analyses and devising treatment plans in orthodontics. The objective of this study was to evaluate the accuracy and the reproducibility of measurements of tooth sizes, interdental distances and analyses of occlusion using plaster models and their digital images. Thirty pairs of plaster models were chosen at random, and the digital images of each plaster model were obtained using a laser scanner (3Shape R-700, 3Shape A/S). With the plaster models, the measurements were taken using a caliper (Mitutoyo Digimatic(®), Mitutoyo (UK) Ltd) and the MicroScribe (MS) 3DX (Immersion, San Jose, Calif). For the digital images, the measurement tools used were those from the O3d software (Widialabs, Brazil). The data obtained were compared statistically using the Dahlberg formula, analysis of variance and the Tukey test (p < 0.05). The majority of the measurements, obtained using the caliper and O3d were identical, and both were significantly different from those obtained using the MS. Intra-examiner agreement was lowest when using the MS. The results demonstrated that the accuracy and reproducibility of the tooth measurements and analyses from the plaster models using the caliper and from the digital models using O3d software were identical.

Influence of occlusal contact area on cusp defection and stress distribution

The purpose of this study was to evaluate the effect of occlusal contact area for loading on the cuspal defection and stress distribution in a first premolar restored with a high elastic modulus restorative material. The Rhinoceros 4.0 software was used for modeling the three-dimensional geometries of dental and periodontal structures and the inlay restoration. Thus, two different models, intact and restored teeth with three occlusal contact areas, 0.1, 0.5 and 0.75 mm(2), on enamel at the occlusal surface of buccal and lingual cusps. Finite element analysis (FEA) was performed with the program ANSYS (Workbench 13.0), which generated a mesh with tetrahedral elements with greater refinement in the regions of interest, and was constrained at the bases of cortical and trabecular bone in all axis and loaded with 100 N normal to each contact area. To analysis of maximum principal stress, the smaller occlusal contact area showed greater compressive stress in region of load application for both the intact and inlay restored tooth. However, tensile stresses at the occlusal isthmus were similar for all three tested occlusal contact areas (60 MPa). To displacement of the cusps was higher for teeth with inlay (0.46-0.48 mm). For intact teeth, the smaller contact area showed greater displacement (0.10 mm). For teeth with inlays, the displacement of the cusps were similar in all types of occlusal area. Cuspal displacement was higher in the restored tooth when compared to the intact tooth, but there were no significant variations even with changes in the occlusal contact area. RELEVANCE CLINICAL: Occlusal contacts have a great influence on the positioning of teeth being able to maintain the position and stability of the mandible. Axial loads would be able to generate more uniform stress at the root presenting a greater concentration of load application in the point and the occlusal surface. Thus, is necessary to analyze the relationship between these occlusal contacts as dental wear and subsequent occlusal interferences.

Orthodontic extrusion as treatment option for crown-root fracture: literature review with systematic criteria

To review the literature searching for a consensus for the choice of orthodontic extrusion as treatment for crown-root fracture. An electronic search was performed in the databases PubMed, Cochrane Central Register of Controlled Trials and Scopus and a manual search of the Journal Dental Traumatology. Forty articles were found in PubMed and 38 in Scopus and after removal of duplicate sample 51 contained articles. Of these, 48 were excluded for not having orthodontic treatment, no follow-up or follow-up less than 6 months, or not report the presence of crown-root fracture. In manual search in Dental Traumatology 20 articles were found, but none of them met the prerequisites established. So, three articles formed the basis of the study. The choice of how to treat orthodontic extrusion of crown-root fracture was effective and stable, without root and periodontal changes. Factors, such as root formation and presence of pulp vitality were decisive for determining the stages of treatment, however, there is no consensus based on scientific evidence about these protocols.

Avaliação da capacidade seladora apical de um adesivo dentinário, acrescido ou não de hidróxido de cálcio, comparada à de um cimento endodôntico à base de hidróxido de cálcio, na obturação de canais radiculares

Pós-graduação em Odontologia Restauradora - ICT

Estudo in vivo e in vitro da incidência de bifurcação do canal radicular de incisivos inferiores pelo método radiográfico digital direto

Pós-graduação em Biopatologia Bucal - ICT

Influência de agentes clareadores na resistência de união de um sistema restaurador ao esmalte em função do tempo de armazenamento em saliva artificial

Pós-graduação em Odontologia Restauradora - ICT

Segmental osteotomy for the correction of a malpositioned single implant: an 8-year follow-up

This case report is an 8-year follow-up of a malpositioned single implant, which was treated with segmental osteotomy, to confirm the treatment's characteristics, indications, and advantages. Deep buccal positioning of an endosseous implant placed in the maxillary left central incisor area did not permit acceptable prosthetic rehabilitation, despite its favorable bone insertion with no significant marginal bone loss. The surgical procedure included osteotomy and block movement performed toward the lingual and cervical position, fixed with a provisional prosthesis and miniplates and mini-implants. A connective tissue graft was necessary for esthetics optimization and was performed in a second stage. Advantages including the prevention of alveolar ridge damage, the improvement of gingival contour, and the use of an already integrated implant are presented. Clinically satisfactory hard and soft tissue stability permitted us to consider segmental surgery as a reliable alternative for malpositioned osseointegrated implants.

Surgical-orthodontic tractio for impacted maxillary canines: a critical review and suggested protocol

Maxillary canine impaction is a common occurrence, especially in the palate, despite sufficient space in the arch for tooth alignment. A proper approach requires knowledge of different specialties of dentistry, such as orthodontics, surgery, radiology, and periodontology, which are generally not centered on a single professional. The causes for canine impaction may be either generalized or localized, and the diagnosis should be made through specific clinical and radiographic examination. The prognosis of surgical-orthodontic treatment depends on the position of the canine in relation to the neighboring teeth and height of the alveolar process, in addition to careful surgical technique, considering that there are risks involved, such as ankylosis, loss of tooth vitality, root resorption of the involved tooth and adjacent teeth, and damage to supporting tissues. Given the important role played by impacted maxillary canines, their traction is the treatment of choice in orthodontically treated patients. The present study reviews the literature on important factors to be considered when approaching impacted canines, such as therapeutic possibilities, their advantages and disadvantages.

Halitose na geriatria: diagnóstico, causas e prevalência

Halitosis is the unpleasant odor of exhaust air through the mouth and lungs. There are over 50 causes, and approximately 90% of cases, is of oral origin. May have physiological origin (stress, breath of morning, fasting, and inappropriate diets), local reasons (bad oral hygiene, bacterial plaque retained on the tongue and/or tonsils, lower production of saliva, gum disease) or systemic reasons (diabetes, kidney or liver problems, constipation, etc.). In the Third Age, this problem tends to increase significantly. Thus, the aim of this study was to detect the presence of halitosis in the geriatric group attended in the dental clinic of UNIRP, identifying their incidence and principal causes. The sample consisted of 48 volunteer patients aged 60 years or older and included more than 90% of patients treated in this age group. It was performed a anamnesis and physical examination. The intra-oral halitosis was detected using a breath meter (halimeter). In the group studied, approximately 54.16% had halitosis, 84.61% of these were users of the prosthesis. The tongue coating was present in 80.76% of individuals with halitosis. After brushing the tongue, 88.46% of patients with halitosis have had the initial index oral malodor decreased. Based on the results of this study it was concluded that factors as dental prostheses and tongue coating are critical factors in causing halitosis.