Biogenic opal content in bulk sediments of ODP Leg 181 sites, southwest Pacific

Biogenic opal concentrations were measured on bulk sediments recovered at Ocean Drilling Program Sites 1123, 1124, and 1125 off North Island of New Zealand in the southwest Pacific. Site 1124 showed opal contents ranging from approximately 2 to 8 wt%, which is relatively high compared to other sites. The subbottom maximum in biogenic opal content located between 1.0 and 1.5 m composite depth can be recognized at each site. Patterns of biogenic opal content in the uppermost parts of the cores appear to reflect the surface ocean settings relating to the migration of the Subtropical Convergence Zone.

(Table DR1) Biogenic silica and chert in the Pacific Ocean, DSDP and ODP data

Evidence for the dissolution of biogenic silica at the base of pelagic sections supports the hypothesis that much of the chert formed in the Pacific derives from the dissolution and reprecipitation of this silica by hydrothermal waters. As ocean bottom waters flow into and through the crust, they become warmer. Initially they remain less saturated with respect to dissolved silica than pore water in the overlying sediments. With the diffusion of heat, dissolved ions, and to some extent the advection of water itself, biogenic silica in the basal part of the sedimentary section is dissolved. Upon conductively cooling, these pore waters precipitate chert layers. The most common thickness for the basal silica-free zone (20 m) lies below the most common height of the top of the chert interval above basement (50 m). This mode of chert formation explains the frequent occurrence of chert layers at very shallow subbottom depths in pelagic sections of the Pacific. It is also consistent with the common occurrence of cherts

(Table 1) Age of Cretaceous seamounts in the Western Pacific

Dynamics of the Pacific Plate is recorded in the systematic variation of location and the 40Ar-39Ar age of seamounts in the Western Pacific from 120 to 65 Ma ago. The seamounts are grouped into three linear zones as long as 5000 km. The seamounts become younger in the southeastern direction along the strike of these zones. Correlation between age and location of seamounts allows to divide the history of their formation into three stages. Rate of seamount growth was relatively low (2-4 cm/yr) during the first and the third stages within intervals of 120-90 and 85-65 Ma, whereas during the second stage (90-85 Ma), the seamounts were growing very fast (80-100 cm/yr). In the midst of this stage, at ~87 Ma ago, magmatic activity increased abruptly. Dynamics of seamount building is in good agreement with (1) pulses in development of the Ontong Java, Manihiki, and Caribbean-Colombian oceanic plateaus; (2) age of spreading acceleration in the mid-Cretaceous; and (3) a short period when the Izanagi Plate ceased to exist and the Kula Plate was formed. Variation in seamounts' age and location are in consistence with the hypothesis of diffuse extension of the Pacific Plate in course of its motion with formation of impaired zones of decompression melting. Direction of extension (325°-340° NW) calculated from the strike of seamount zones is consistent with the path of the Pacific Plate (330° NW) in the Late Cretaceous. Immense perioceanic volcanic belts were formed at that time along the margin of the Asian continent. The Okhotsk-Chukchi Peninsula Belt extends at a right angle to the compression vector. Three stages of this belt's evolution are synchronous with the stages of seamount formation in the Pacific Plate. Delay in origination of the East Sikhote-Alin Volcanic Belt and its different orientation were caused by counterclockwise rotation of the vector of convergence of oceanic and continental plates in the mid-Cretaceous. At the same time, i.e. 95-85 Ma ago, volcanic activity embraced the entire continental margin and tin granites were emplaced everywhere in the Eastern Asia. This short episode (90+/-5 Ma) corresponds to the mid-Cretaceous maximum of compression of the continental margin, and its age fits well a culmination in extension of the Pacific Plate.

Chemistry of biogenic sediments from the equatorial Pacific

To increase our understanding of the mechanisms that control the distribution of Al and Ti within marine sediment, we performed sequential extractions targeting the chemical signatures of the loosely bound, exchangeable, carbonate, oxide, organic, opal, and residual fraction of sediment from a carbonate-dominated regime (equatorial Pacific) and from a mixed opal-terrigenous regime (West Antarctic Peninsula). We observe a systematic partitioning of Al and Ti between sediment phases that is related to bulk Al/Ti. We show that, where we can quantify an Al(excess) component, the dissolved Al is preferentially affiliated with the oxide fraction, resulting in Al/Ti molar ratios of 500-3000. This is interpreted as the result of surface complexation in the water column of dissolved Al onto oxyhydroxides. We also observe a previously undetected Ti(excess) with as much as 80% of the total Ti in the organic fraction, which is most likely a function of metal-organic colloidal removal from the water column. In samples where the excess metals are obscured by the detrital load, the Al and Ti are almost exclusively found in the residual phase. This argues for the paired removal of Al (preferentially by the oxide component) and Ti (preferentially by the organic component) from the water column by settling particulate matter. This research builds upon earlier work that shows changes in the bulk ratio of Al to Ti in carbonate sediment from the central-equatorial Pacific that coincide with changes in the sedimentary bulk accumulation rate (BAR). The ratios that are observed are as much as three times higher than typical shale values, and were interpreted as the result of scavenging of dissolved Al onto particles settling in the water column. Because this non-terrigenous Al(excess) accounts for up to 50% of the total sedimentary Al inventory and correlates best with BAR, the bulk Al/Ti may be a sensitive tracer of particle flux and, therefore, export production. Because we show that the excess metals are the result of scavenging processes, the bulk Al/Ti may be considered a sensitive proxy for this region.

Contents of rare earth and other chemical elements in Fe-Mn micronodules, nodules, and bottom sediments from the Clarion-Clipperton ore province in the Pacific Ocean

Processes governing the formation of rare earth element (REE) composition are under consideration for ferromanganese deposits (nodules, separate parts of nodules, and micronodules of different size fractions) within the Clarion-Clipperton ore province in the Pacific Ocean. It is shown that ferromanganese oxyhydroxide deposits with different chemical compositions can be produced in sediments under similar sedimentation conditions. In areas with high bioproductivity size of micronodules has positive correlation with Mn content and Mn/Fe and P/Fe ratios and negative correlation with Fe, P, REE, and Ce anomaly. Behavior of REE in micronodules from sediments within bioproductive zones is related to increase of influence of diagenetic processes in sediments as a response to the growth of size of micronodules. Distinctions in chemical composition of micronodules and nodules are related to their interaction with associated sediments. Micronodules grow in sediments using hydrogenous ferromanganese oxyhydroxides. As they grow, micronodules are enriched in labile fraction of sediments reworked during diagenesis. Sources of material of ferromanganese nodules are governed by their formation at the water bottom interface. Their upper part is formed by direct settling of iron oxyhydroxides from bottom water, whereas the lower part is accumulated due to diagenetic processes in sediments. Differences of REE compositions in ferromanganese deposits are caused by the reduction of manganese during diagenesis and its separation from iron. Iron oxyhydroxides form a sorption complex due to sorption of phosphate-ion from bottom and pore waters. Sorption of phosphate-ion results in additional sorption of REE.

Pliocene-Pleistocene oxygen isotope record DSDP Site 586, Ontong Java Plateau, Pacific Ocean i

Oceanographic changes in the western equatorial Pacific during the past 6 Ma are inferred from oxygen isotopic analyses of planktic and benthic foraminifera from Ontong Java Plateau (DSDP Site 586). The taxa are Globigerinoides sacculifer, Pulleniatina, Cibicidoides wuellerstorfi, and Oridorsalis umbonatus. Cooling and ice buildup are indicated by an 18O enrichment of 0.3 per mil in the planktic species near 3.4 Ma. This shift apparently is compensated in the benthic data by a warming of the deep waters by between 1° and 2° C. We suggest that the dominant source of upper deep water supply to the Pacific changed from Antarctic to North Atlantic at that time, the North Atlantic-derived water being warmer. Near 2.8 Ma (approximately) the planktic foraminifera again record an enrichment in 18O (Delta delta18O=0.25 per mil). We suggest ice buildup in the northern hemisphere as the cause, because of subsequent sharp increase in fluctuations of the delta18O signal, that is, instability. The enrichment is magnified in the benthic foraminifera (Delta delta18O = 0.5 per mil) by a cooling of the deep water by 1.5° at the time, presumably signalling a glacial-type reduction of North Atlantic Deep Water (NADW) production. Episodic divergence between the signals of G. sacculifer and Pulleniatina in the Pleistocene apparently reflects periods of increased upwelling in the western equatorial Pacific. The amplitude of ice volume fluctuations cannot be reconstructed from delta18O data alone, unless there are constraints on temperature variations. The increase in amplitude of fluctuation of the benthic and planktic signals during the Pleistocene may be attributed either to an increase in maximum ice volume, or to an increase in the fractionation of continental ice, or a combination of both causes.

Composition of ferromanganese crusts from the Atlantic, Pacific and Indian Oceans

A collection of layered ferromanganese ores (27 samples) from the Atlantic and Pacific oceans was studied. Trace element and PGE contents were determined layer-by-layer (up to 10 microlayers) in 13 of these samples. The trace, rare earth, and platinum group element distributions, including their layer-to-layer variations, were compared in hydrogenic and hydrothermal crusts from different regions. It was found that the main PGE variations (by a factor of 10-50) are related to their layer-to-layer variations within a given ore field. The distributions of PGE and trace elements are strongly heterogeneous, which is related, first, to different contents of the elements in the layers of different age in ferromanganese crusts (FMC) and, second, to the observed regional heterogeneity and influence of hydrothermal fluids. Geochemical data indicate that CFC formation was mainly caused by the hydrochemical precipitation of material from seawater. This process was accompanied by diagenetic phenomena, water-rock interaction, and influence of volcanic and hydrothermal sources.