A mechanical device for eradication of submerged aquatic weeds

This paper embodies details and method of operation of a mechanical device developed for eradication of submerged aquatic weeds. The economics of operation is also discussed.

Comparative account of growth rate of body parts with total length in adult Puntius sarana (Ham.)

The present study on growth rate of different body parts in relation to total length, in the male and female Puntius sarana (Ham.) did not show any significant heterogeneity except in snout length (p.01). The growth rate of snout length was found to be higher in females (b=0.0377) than in males (b=0.0266). Since the growth rate of most of the body parts was found to be homogeneous in both the sexes, the common regression co-efficient "b" was calculated on pooled data to represent the growth rate of different body parts against total length, the linearity of regression lines indicated isometric growth.

Comparative account of growth rate of body parts with total length in Rita pavimentata (Gunther)

The paper deals with sex-wise growth rate of different body parts in relation to total length in Rita paviinentata (Gunther). Growth rates calculated on pooled data by using the common regression coefficient 'b' reveals isometric and homogeneous nature in sexes.

Nanostructuring of materials for device and sensor applications

The recent developments in nanotechnology are reviewed, with particular emphasis on its application in microsystem technology where increased reliability is achieved by integrating the sensor and the readout electronics on the same substrate. New applications may be possible using integrated micromechanical clips to connect optic fibers and components in integrated silicon systems. Some of the key developments in enabling technologies are also described, including the control of thin film deposition, nanostructuring to tailor the properties of thin film, silicon micromachining to make sensors, and microclips for the low-cost assembly of integrated optical microsystems.

Tribological properties of mems materials measured on a small-scale device

Micro-electro-mechanical systems, MEMS, is a rapidly growing interdisciplinary technology within the general field of Micro-Systems Technology which deals with the design and manufacture of miniaturised machines with major dimensions at the scale of tens, to perhaps hundreds, of microns. Because they depend on the cube of a representative dimension, component masses and inertias rapidly become small as size decreases whereas surface and tribological effects, which often depend on area, become increasingly important. Although MEMS components and their areas of contact are small, tribological conditions, measured by contact pressures or acceptable wear rates, are demanding and technical and commercial success will require careful measurement and precise control of surface topography and properties. Fabrication of small numbers of MEMS devices designed to test potential material combinations can be prohibitively expensive and thus there is a need for small scale test facilities which mimic the contact conditions within a micro-machine without themselves requiring processing within a full semiconductor foundry. The talk will illustrate some initial experimental results from a small-scale experimental device which meets these requirements, examining in particular the performance of Diamond-Like-Carbon coatings on a silicon substrate. Copyright © 2005 by ASME.